My iPad stopped working and I turned it off,and now after charging it won't turn on!It shows the apple logo that's all...What to do?
My iPad stopped working and I turned it off,and now after charging it won't turn on!It shows the apple logo that's all...What to do?
Have a look at the following document, I believe your iPad's condition is explained at its end:
http://support.apple.com/kb/TS3281
Similar Messages
-
My iPhone 3 is not seen on iTunes when I connect it. It is also showing low battery but is not even charging and continously showing the Apple logo... What should I do? Thanks in advance, Jahnavi...
Jahnavi,
two things to be looked upon in this case. First thing is about the battery. Once the battery has enough charge in it we can try a force restore on the phone to re-install the iOS.
> Try a hard reset of the phone (Press and hold the HOME button and the Sleep/Wake button until the phone restarts and comes up with Apple logo). After trying this step, try charging the phone and see if the battery holds the charge.
> Once battery has enough charge in it then we can force it to DFO mode and perform restore. For restore refer to this link. -
MacBook won't start up it shows the apple logo and just keeps the "wheel" spinning
MacBook won't start up it shows the apple logo and just keeps the "wheel" spinning
Usually means that critical system files are corrupted. Start by:
Boot into Safe Mode if possible. If it boots into safe mode, then restart the computer to see if it will boot normally. Otherwise, reinstall OS X. Unfortunately, you've not provided any information in your profile about what version of OS X you have installed. -
while updating my ipod touch something happened and now the screen only shows the apple logo that goes on-off. i dont know what to do,please somebody help me!
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I always leave my iMessage on. It stopped working so I shut it off and turned it back on. The switch says on but it won't activate.
Imessage js between ios devices and macs only.
Ipads do not send sms as it requires a connection to the voice channel of the cellular service. -
My Ipad stop working and is just showing the apple logo and right after that the ITunes logo , I connected it to my PC but it ask me to restore it. Is there any trick to do not loose all my pictures if I restore it?
Once the Device is in Recovery Mode... it is too late to save anything...
To minimise loss... after the successful Recovery... Restore from the most recent Backup...
See Restore from Backup here
http://support.apple.com/kb/ht1766 -
My iPad is not charging when I pluged in and its keep turning off and on (it just shows the apple logo). I even changed the charger so what else can I do to start my iPad?
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY. -
My iPad constantly turns off and restarts, showing the apple logo on the screen. How do I fix this?
My iPad constantly shuts down, then restarts showing the apple logo. This happens over and over. I have tries resetting and restarting. What to do next?
Make sure IOS is updated to latest version
Reboot device by pressing both the home button and sleep/wake (power) buttons at the same time for 10-15 seconds until the apple logo appears on the screen, then let go.
If that doesn't work then reset the device by going to settings/general/reset/reset all settings
(no media or data will be deleted from the device, this will only take a minute).
If that doesn't work then backup and then restore the device as new first (to isolate cause of the issue). Then from backup if necessary.
How to back up and restore (iCloud and iTunes)
http://support.apple.com/kb/HT1766 -
iPad stops responding, showing the Apple logo only,i tried to place into recovery mode and attempted to restore again but after downloading the software, it brings error in downloading s/w message.can anyone help please.Thanks
http://support.apple.com/kb/TS3694#error14
These errors are typically resolved by performing one or more of the steps listed below:
Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different USB 30-pin dock-connector cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network. -
I've tried charging it for days. it doesnt do anything. I'll hold the home and power button for 10 seconds and it just shows the apple logo and then goes black. and when i plug it into my computer it wont recognize it.
Does it charge when you connect it to the adapter? If yes, make sure it is charged for about 10min, then connect in recovery mode, shown here: iPhone and iPod touch: Unable to restore
If still not recognized, try the troubleshooting here: iOS: Device not recognized in iTunes for Windows -
Phone keeps turning on and off, showing the apple logo, then repeating...
Phone keeps turning on and off, showing the apple logo, then repeating...
Try this. It worked for a few users after a drop.
Turn the iPad over and give it a very HARD slap on the back. May take several slaps.
Cheers, Tom -
My ipad 1 isnt working it is just showing the apple logo on the screen can anyone help me?
my ipad 1 isnt working it is just showing the apple logo on the screen can anyone help me?
If you can help me facetime me at [email protected] or msg me.It would help to know whether it ever did work, or is this a new iPad for you? If new, you need to connect it to a Mac/PC that's running iTunes in order to register and initialize it. If it used to work, try doing a reset.
-
My ipod touch will not charge or register in itunes. It keeps turning off and then shows the apple logo. I have tried holding down the button and plugging it in. It will show the red battery for a second and then turn off? Any other suggestions?
I have checked for problems with the connections, but from what i can see with the naked eye, nothing appears abnormal. It is very strange, and very sudden. It just stopped in the middle of a charge. The apple store is my next step. I just wanted to see if anyone on here had some extremely eye-opening solution or check. thanks though!
I'm also within warranty, so it's not a huge problem. -
My ipod is stuck at step 9 in this guide. Itunes told me to keep my ipod connected to itunes, and my Ipod shows the Apple logo as it should (though I can´t see any progress bar). Do anybody know how long step 9 takes. I have turned off my firewall.
Please Help!If it happens again and the reset (home + power buttons) doesn't work, just let the battery drain; you'll know when the screen shuts off. Charge it back up and it should be fine. Frankly, I'm surprised this worked for you. Usually I hear people with this problem say that holding both buttons doesn't work, and they have to do the battery drain.
If the issue is incurable next time, you have a one-year warranty from the date of purchase. -
My Iphone doesnt start normally it turns on, shows the apple logo and then turns off again but only while its charging. Before it turned on completely and i saw the charging tag that it was chraging normall but then it turned off again? I have tried totall reset nothing works! Im lost please help!
Try this to help
http://support.apple.com/kb/HT1808
Maybe you are looking for
-
Again with the odd behavior. I found the code below while studying for a Java certification exam. ************************ START ************************ import java.io.*; class OutputTest { public OutputTest() { super(); public static void main(java
-
My iphone no longer shows in itunes. When I try to connect my iPhone 4 to iTunes on my computer the following message appears: "this iPhone cannot be used because the Apple Mobile Device Service is not started." Is it some setting i need to change o
-
Pdf file printing causes printer to reboot
Hello! I got this nasty problem. I'm running OS X 10.9.5 on MBPro. I have HP LaserJet M1536dnf MFP (printer-scanner-fax-copier) connected over USB. All drivers and software installed and running ok. But. If I scan some document (with HP own utility)
-
XML to Binary Performance Issues
All - I'm in the process of trying to convince a client to move toward WLI for their workflow needs. One major function of their business is the transformation of binary files to XML. These binary files are typically pipe-delimited with 22 fields per
-
While on reading a post on Facebook my new ipad 4 will reset back to safari or aol and i have to sign in again. this is a reoccuring problem. i have the latest update installed already.