My iPad will not boot up or charge.

Hello,
I haven't used my iPad for a couple of months and wanted to turn it on. When I tried to, it wouldn't! I have plugged it in to the wall outlet for 30 minutes but still nothing. I tried plugging it into my computer but it will still not charge nor show up on itunes.

Have you tried a reset ? Press and hold both the sleep and home buttons for about 10 to 15 seconds, after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.

Similar Messages

  • HT201412 My iPad will not boot up, has a think logo running but will not start. Any ideas?

    My Ipad will not boot up, has a think logo running all the time...any ideas. Also had trouble upgrading to ios.6 the computer is not the original one I synved my ipas too. It started OK then failed. Now it will not connect at all to computer...comes up with an error.!!!

    Try DFU Mode Restore. Open iTunes on computer, connect iPhone to computer. Hold both Home and Power buttons for exactly 10 seconds, release Power button, keep holding Home button until iTunes recognizes iPhone in Recovery Mode. Usually about 20 seconds time. Restore iPhone Firmware.

  • It rained in my window last night, on my power strip.  My macbook adaptor (charger) and iphone adaptor were both plugged into the strip.  The power strip is dead.  Iphone is fine.  Macbook will not boot up and charger light doesn't go on.

    It rained in my window last night, on my power strip.  My macbook adaptor (charger) and iphone adaptor were both plugged into the strip.  The power strip is dead.  Iphone is fine.  Macbook will not boot up and charger light doesn't go on. I borrowed another charger and still no luck.  What should I do?  (Charger wasn't plugged into Macbook until I dried it off.)

    Spill Cleaning
    And, don't think that just because it was two teaspoons and not a glassful that there is a difference.
    Some liquid has just spilled into your Mac. What should you do?
    Do
    Immediately shut down the computer and unplug the power cord.
    Remove the computer's battery (if you can)
    Disconnect any peripherals (printers, iPods, scanners, cameras, etc.)
    Lay the computer upside down on paper towels to get as much liquid as possible to drip out.
    Note what was spilled on your Mac.
    Bring the computer into an Apple store or AASP as soon as possible.
    Don't
    Don't try to turn it back on. Liquids can help electrical current move about the components of your Mac in destructive ways.
    Don't shake the computer (this will only spread the liquid around).
    Don't use a hair dryer on it (even at a low setting a hair dryer will damage sensitive components).
    Do not put in a bag of rice in as much as rice will get into the ports and optical drive and do further damage.

  • My IPad will not turn on, despite charging all night and all day. The Apple pops up then goes away. What is wrong and how can I fix it?

    My IPad will not turn on despite charging all night and all day.  The Apple pops on but then shuts off again.  It does this over and over. How can I fix this and get it up and running again?

    Hey bellabeanbag,
    Thanks for the question. The following resource outlines troubleshooting steps if your iPad is not responding:
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    If iPad won't turn on, or the display stops responding
    Follow these steps, testing after each:
    1. Turn the iPad off and turn it on again. Press and hold the Sleep/Wake button on top of iPad for a few seconds, until a red slider appears. Then slide the slider. Then press and hold the Sleep/Wake button until the Apple logo appears.
    2. Reset iPad. Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears.
    If iPad still won't respond after you restore it
    Follow these steps, testing after each:
    1. If you receive an alert in iTunes while restoring your iPad, refer to this article for instructions on how to resolve common issues with updating and restoring.
    2. If you cannot restore your iPad in iTunes, or if iTunes does not recognize the device, refer to this article for instructions on restoring using recovery mode.
    Thanks,
    Matt M.

  • My ipad will not boot up. Hard reset just gives the Apple Logo. Help

    My ipad will not respond to hard reset

    Hello Ridgeway57,
    Thanks for using Apple Support Communities.
    At this point since the iPad will not boot nor respond to a reset, go ahead and restore your iPad by following the article below.
    Use iTunes to restore your iOS device to factory settings
    http://support.apple.com/kb/HT1414
    Take care,
    Alex H.

  • HT1766 My iPad will not boot up. When I press the on/off button, nothing black screen. Does anyone have a suggestion?

    My iPad will not boot up. When I press the on/off button, nothing black screen. Does anyone have a suggestion?

    Try reset iPad
    Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
    Note: Data will not be affected.

  • Ipad mini will not boot up after charging

    ipad mini will not boot up after charging

    Hi luckysue,
    If your iPod mini isn't booting up or responding after charging, you may find the troubleshooting steps outlined in the following articles helpful:
    Reset your iPod - Apple Support
    iPod only shows an Apple logo and doesn't start up - Apple Support
    Regards,
    - Brenden

  • Ipad will not boot up after 7.1.2 update

    updated to 7.1.2 yesterday and I pad will not boot up. it turns on and I get the logo but will not completely boot back on into home screen. I tried hold both button down and it would turn off but when turn on it did the same time.  let it run all night while plugged in to see if it would boot but would not. don't want to have to restore because of loosing all my data I have on ipad.  What can I do?

    If the reboot by holding both the power and home buttons until the apple logo appears does not help, there is not much you can do except restore via the recovery mode per the instructions in http://support.apple.com/kb/HT1808

  • My ipad will not turn on or charge

    Hello, my ipad will not turn on or take a charge. i have tried new cords, into the computer and wall outlet and nothing. Any ideas?

    1. Try a reset
    2. Clean docking port with clean tooth brush
    3. Try another wall socket
    4. Try another cable (make sure it's an original Apple cable)
    5. Try another charger (make sure it's an original Apple charger)

  • HT201412 my Ipad will not turn on to charge, the apple symbol appears then it blank out

    Ipad will not turn on to charge

    Try a reset:
    Hold the Sleep and Home button down (approximately 10 seconds) until you see the Apple logo.
    Note: Data will not be affected.

  • Playbook will not boot even after charging

    Hi All,
    I have this problem for nearly a week and can not resolve.  I think this is a MAJOR ISSUE of playbook since there are a lot of complains here but NO VALID SOLUTION is offered.  I consulted all the related posts here and tried every possible solutions but nothing works.  
    My Playbook can be charged until LED indicator showed a soilid GREEN.  According to Playbook manual this indicates that the battery charging process is done.  However, I can not boot up my Playbook.  When I press POWER button , LED indicator shows a red light for 4 seconds then it goes off.  LED indicator then goes dead and nothing start.
    THIS IS A MAJOR PROBLEM OF PLAYBOOK.  
    My question now for everybody is:
    Does anyone have this problem fixed ?
    Is it worth it to pay more money to get support from RIM to fix this problem ? (because if this problem can not be fixed then I will stop using my Playbook and look for an Android tablet available on the market. If this problem can be fixed, I will give another shot...)  

    playbook2012 ha escrito:
    Hi,
    Thanks for your quick reply.
    I tried pressing Power and + and - simutaneously but nothing works.  I got several of my friends involved (some help pressing down buttons, etc)
    Here is some more observations:
    1/Sometimes the LED shows a red light for 10 seconds and everything goes dead (nomre LED)
    2/Sometimes while pressing 3 buttons (Power and + and -)  I heard a sound similar to the sound when you press the button capture of a digital camera but not as loud.
    Anymore idea ?
    I think this a a MAJOR PROBLEM OF PLAYBOOK . RIM MUST HAVE REGCONIZED THE PROBLEM BY NOEW
    Hi,
    RIM knows about this.
    Please, can you tell me what OS version do you have so I can pass it along to them? It's important. 
    One last thing please, have you tried holding down the power button 10 secs while charging the PB?
    Thanks

  • Ipad will not turn on without charging cable

    IPAD First Generation power on and power off issues:
    Will turn on unless plugged into charging cable.
    Will not turn off without pressing Sleep/Wake button and Home button

    The battery is probably dead.

  • My iPad will not turn on or charge using the 10 w standard charger. I do not get the charge tone at hook up. It was fully charged when I took it to work yesterday. used it once and turned it off. Charger good, "tones" my iPhone when connected.

    iPad completely inop. Paperweight now. Was fully charged when last used yesterday. Charger works with iPhone, but will not give provide "tone" when connected to iPad. Any suggestion?

    I'm not so sure that this will work but it is always worth a try. Reset the iPad.
    Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons.

  • Ipad will not turn off when charging

    When I charge my iphone I usually plug it in and then power it off. I cant get this to work with ipad; it will power down and then restart. How can I get it to stay powered down?

    I posted this on a previous thread a couple of day ago. I don't know exactly how the iPad is supposed to behave, but I was able to experience not being able to shut the device off completely after having done so for weeks. For me it seems to be related to how low the battery is ....
    I experienced this very "bug" last night when I started to charge my iPad. I had never run the battery down to 15% prior to last night. When I plugged in the charger, it would restart, I would turn it off and then it would restart. I repeated this process four or five times and then I finally decided to simply put the iPad to sleep while it was charging, before I turned in for the night.
    When I woke up this morning to a 100% charge I decided to try to repeat the process. I unplugged the iPad from the charger, turned it on and then turned it off again. Then I plugged the charger back in, the iPad turned on and then I turned it off and it stayed off this time.
    My suggestion is that it may be that the iPad is supposed to behave this way when the battery power drops below a certain percentage. I too became a bit concerned at first as I had never experienced that before. Now that the iPad is behaving "normally" again, I am assuming that the device is built to continue to restart while recharging when the battery drains to a low level.
    Mine is working fine, no worries and all is good. Happy holidays!

  • IPad will not boot update after the latest update.

    AAfter he update the iPad will start, it just wants to connect to iTunes. Is there any way to correct this without iTunes

    If the reboot by holding both the power and home buttons until the apple logo appears does not help, there is not much you can do except restore via the recovery mode per the instructions in http://support.apple.com/kb/HT1808

Maybe you are looking for

  • HP Laserjet 2820 - print spooler was unable to connect

    Working in Microsoft 2003 and printer is on a wireless network. In over a year - never had a problem until 5 days ago an error message appeared when I attempted printing which stated... print spooler was unable to connect to your printer. This can be

  • How to create object from Table?

    Hi all, Is there any command to create an object type from a table? I i want to that command to create object type from emp table insted of typing the following command: CREATE TYPE emp_t AS OBJECT (empno NUMBER(6), ename VARCHAR2(25), job VARCHAR2(1

  • MAC Code is Invalid

    I am on BT Infinity but after going through a total nightmare including taking money out of my bank account in 'error' then refusing to refund my bank account, I am leaving BT.   I was given a MAC Code but guess what???? Yep it's invalid.  Ofcom stat

  • Looking for plug ins

    I'm an Adobe After Effects user and I'm looking for some 3rd party plug in effects to use with my After Effects. Photoshop has Eye Candy and Alien Skin. Are there any out their for After Effects?

  • Sapinst: Portal Deployment Monitor has reached the timeout of 1800

    Hello All, I am installing SAP EP 6.0 and in the Step 11 of 13 its continuosly giving me the following message. "Portal Deployment(0 of 298 files done. 0 with errors .Time elapsed: xxxx seconds).Wait..." and after 1800 secs its gets time out. It is n