My ipad won't charge. All I get is picture of white USB cable and iTunes Logo.
My ipad won't charge. I must admit, I did use it until there was only 2% power left and then went and plugged directly into power and not through PC... but it won't charge. All I get is picture of white USB cable, an arrow and the iTunes Logo. I have turned off and on again as previous posts but all I get is the picture of the USB cable, arrow and iTunes logo. Please help...
I have been relatively patient - 3 hours on charge but all it does is show picture of USB cable and itunes logo. It it were charging you would think that a picture of the charge would come up to indicate status of charge - wouldn't you think?
Similar Messages
-
Hi, I have a problem with my ipad, I want to restore it but I can not. When I plug the ipad (off) it is not recognized by itunes, I turn the ipad, There are apple and the apple after you see the usb cable and itunes logo for just 1 minute and turns off and is no longer recognized by itunes.
thank you for your help.Hi there beni_m,
You may find the troubleshooting steps in the articles below helpful.
iOS: Not responding or does not turn on
http://support.apple.com/kb/ts3281
iOS: Device not recognized in iTunes for Mac OS X
http://support.apple.com/kb/ts1591
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/ts1538
-Griff W. -
I just updated my phone and it is now stuck with usb cable and itunes logo and itunes on my computer says I have to restore. Can I get my phone working again without loosing my photos?
There is no other way than to plug into a computer to restore the phone. You can use another computer to do so, but in case you did not back up to iCloud your data and settings will be gone.
Follow this article to connect in recovery mode:
iOS: Unable to update or restore -
itouch was updating software and failed, now all i have is a screen showing usb plug and itunes logo,cant reset or restore.help
Type "unable to restore" into the search bar at the top of this page by Support and read the resulting help article
-
HT1766 My Ipad shows a USB cable and Itunes logo. My Ipad will not work
My Ipadshows a Itunes logo and A picture of a USB cable and will not work. What do I do?
1) Connect to iTunes on the computer you usually Sync with and Restore
http://support.apple.com/kb/HT1414
2) If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/ht4097
Note on Recovery Mode.
You may need to try this More than Once...
Be sure to Follow ALL the Steps...
Once you have Recovered your Device...
Re-Sync your Content or Restore from the most Recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766
Make sure you have the Latest Version of iTunes (v11) Installed on your computer
iTunes free download from www.itunes.com/download -
My ipod is displaying a usb cable at the top of it is itunes,i get a message on my computer saying the usb is not reconized.my ipod will not go back to the original when i unplug it from the computer, help
See Here...
Unable to Update or Restore
http://support.apple.com/kb/HT1808
This will not necessarily work if the Device has been modified. -
When my iphone was updating it operating software, the USB cable came out of the port. Now the screen will only show the USB cable and the itunes icon. It is not recognized by the itunes store. I unintalled the USB driver for the iphone, but it still does not work. I have turned off the phone and performed a reset.
Try another Reset, hold both Home and Power buttons until the iPhone restarts. This usually takes about 10 seconds of holding both buttons. If still problem you should Restore your iPhone with iTunes on computer. Here are simple steps. Open iTunes on computer. Connect iPhone to computer. Hold both home and power buttons until iTunes recognizes iPhone in Recovery Mode. Usually takes about 20 seconds of holding both buttons. Click Restore Button of iTunes.
-
I Mac freeze: When powered on all I get is a blank white screen with the apple logo. No "beach ball" nothing more. Tried all the usual restarts. Help?
Tried all the usual restarts. Help?
Care to share?
Please detail ALL you have done so far in the way of troubleshooting? Need this info to avoid the been there done that scenarios.
===========
Your profile is a complete blank!!!!
When posting in Apple Communties/Forums/Message Boards.......It would help us to know which Mac model you have, which OS & version you're using, how much RAM, etc. You can have this info displayed on the bottom of every post by completing your system profile and filling in the information asked for.
CLICKY CLICK-----> Help us to help you on these forums
***This will help in providing you with the proper and/or correct solutions.*** -
My Firefox is not working (All I get is a blank white screen with the firefox logo. If I have to reinstall Firefox 3.66, how can I transfer my old profile to the new installation?
== This happened ==
Every time Firefox openedDavid. Thank you very much. The problem was not with the canvas but rather the Viewer. But the solution was the same. Somehow, the Viewer window was re-set to Alpha. I changed it back to RGB.... and the picture is back. These issues are often very simple.... but they can drive you bats if you don't know the answer. Very grateful. Tim
-
I got a new Ipad 2 and I am trying to get it work in vain. I have downloaded the iTunes on my PC, but even after executing the program nothing happens to the IPAD. I still get the image of the USB cable and the iTunes logo. What am I doing wrong?
You know that you have to connect the iPad to your PC with the cable that came with it - and then iTunes should start automatically and it will guide you through the set up process?
If you have already tried to connect the iPad - and you have launched iTunes - and you still have no luck - reboot your PC and then begin the process again. -
I seem to have fried my ipad--i went to itunes to update it and now it wont do anything? the ipad has a picture of a usb cable and it says to connect to itunes but when I do it does not show up as a device??
You'll want to completely restore the device using iTunes.
http://support.apple.com/kb/ht1414
Keep in mind, at this point anything you had on the iPad you did not backup to iCloud or your computer is most likely lost.
It may be best to contact AppleCare by phone from 7am-10pm Central if you need more help on the matter. -
I tried to update my iPhone 6 to the newest version today. I got a message that the update failed. I now only see a picture of the data cable and the red iTunes picture. All updates and restores fail.
I had a similar problem with one of my phones yesterday. It went I to recovery mode. I could not get it to complete the restoration process. I had to restart my computer in order to complete the restoration through iTunes. I don't know if that will help but it is worth a try. Good luck.
-
After trying to charge my iphone, I'm getting a picture of the USB plug on the bottom with an arrow pointing upwards to an itunes icon, but I cannot get phone to go to it's normal display. Please help.
Put the device in DFU mode (Google it) and restore.
-
My Ipod touch only shows a usb wire and itunes symbol when i turn it on. it does not show up on my itunes or in my computer. ive tried the troubleshooting stuff(reseting the ipod, reinstalling the newest itunes, restarting the computer) and nothing has changed. my ipod shuffle connects to my itunes just fine though.
First, try a system reset. It cures many ills and it's quick, easy and harmless...
Hold down the on/off switch and the Home button simultaneously until the screen blacks out or you see the Apple logo. Ignore the "Slide to power off" text if it appears. You will not lose any apps, data, music, movies, settings, etc.
If the Reset doesn't work, try a Restore. Note that it's nowhere near as quick as a Reset. Connect via cable to the computer that you use for sync. From iTunes, select the iPad/iPod and then select the Summary tab. Follow directions for Restore and be sure to say "yes" to the backup. You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod. Again, say "yes."
At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod. As before, say "yes." Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time. If that happens, only the apps that are part of the IOS will appear on your device. Corrective action is simple - choose manual "Sync" from the bottom right of iTunes.
If you're unable to do the Restore, go into Recovery Mode per the instructions here. -
My ipad shows nothing but usb cable and itunes
My ipad shows the cable and itunes symbol on it and it will not respond to the instructions on here. Any other ideas?
You are in Recovery Mode.
Follow step 1 to 5 closely to recover your iPad.
http://support.apple.com/kb/HT1808
Note: You may have to repeat the above a few times
Maybe you are looking for
-
How to sop all loops in the application (While, For and subvis ) with a single button? Use the event sturucture?
-
W2K12-R deduplication optimization job stuck at 100% for days
Hello, I've W2K12-R server (VM, 4 vCPU, 14 GB vRAM) with a 7 TB D: drive, deduplication is enabled for this drive. I use this drive for backing up virtual machines, at the moment 3,6 TB are used. Each night ~2 TB new data is backed up, only the C: dr
-
Dual Monitor support on thin-clien​t
Company provides thin client (T5520) for work at home environment. Security provides for no local storage, no driver additions or software/windows configuration. Is there a way to support dual monitors? Perhaps using device such as DualHead2go by
-
Credit management with different sales organization
hi, one cusotmer master code with different sales area, can i separate the credit limit? pls advice. thanks
-
Quick question on re-linking or changing media in Color. I've got an FCP sequence that I've "Sent to Color". It has opened fine, and I can color the sequence as normal. Now, I've taken one of the shots into After Effects and fixed some issues, and sa