My iPhone 3GS is not turning on, what am I suppose to do?

Hello, i reset my iphone, and when it is was restarted, and the Apple appeared, only appeared that was loaded and after that, not only lighted stops and now already it cannot be started, some help?

Hi,
Could you please answer these questions for me?
- Is the phone charged (You never know...)
- Have you recently dropped your phone?
- Has your phone recently come into any conatct with water?
Try charging it and then holding the Sleep button (The one on the top) and the home button at the same time for a few seconds and see if it does anything!
If this doesn't work, try plugging it into your computer and see if you get any response from it, for example, if the computer reconizes the phone or not.
We need to detirmine whether it is a fault with the display or if it is a technical problem in the phone (If you have dropped it or any water has gotten inside etc)
Because it is an iPhone 4 I doubt you will have any warrenty on it now, so if it needs repairing I am afraid you will have to pay for it! You could either take it into apple or you could take it to a 3rd party phone repair company.
Hope this helps =)
Thanks
Max

Similar Messages

  • Iphone 3gs does not turn on after ios 6 update

    After the ios6 update, my iphone 3gs does not turn on. I see the apple logo, after a minute, it boots again and i see the logo again. This process seems to continue like a circle. After a search the net, i see that i am not the only one. A quick fix and suggestions please, as i need my phone of course.
    Btw, Apple, i know that this is an old hardware and i will buy the new iphone 5 when it is available here in my country in December. But of course, you claşmed this update supports my 3gs, you should immediately find a fix
    Regards..

    Well, i don't see an another solution possible; you should try again and again to restore. Btw, my phone seemed to operate strange (even the stock mail app began to crash) so i tried hard reset (home button + sleep/wake button until seeing the apple logo). After that i found my phone again in dfu mode this night so began restoring again now.
    It seems that apple didn't tested ios6 enough with the 3GS. I have a 32 GB phone so this will be near 60 gb download from the icloud over my broadband connection.

  • My iphone 3gs will not turn on. I plug it in to the wall and still get nothing...I plug into my computer and itunes nor my computer recognizes it, any ideas?

    My iphone 3gs will not turn on. I plug it in to the wall and still get nothing...I plug into my computer and itunes nor my computer recognizes it, any ideas?

    Could be a problem with the 30-pin connector port or the cable. Is there an Apple Store or Apple authorized support center nearby?

  • HT4972 I upgrade my phone via itune and now i got the msg on my phone "activating your iphone in 3 minutes......could not activate your iphone" i've iphone 3gs. Can somebody suggest what am i suppose to do to make it work

    I upgrade my phone via itune and now i got the msg on my phone "activating your iphone in 3 minutes......could not activate your iphone" i've iphone 3gs. Can somebody suggest what am i suppose to do to make it work

    Read the article below:
    iPhone: Troubleshooting activation issues

  • My iphone 4s will not turn on what can i do

    My  new iphone 4s will not turn on, what should i do

    Has it been fully charged since you brought it out the box?  if you have fully charge it.
    Try a reset holding down the home/power button togetther for 10 to 15 secs or until you see the apple logo and then release.   Wait for phone to boot back up.

  • TS4148 My iphone 3gs is not turning on when I connect to my itunes in pc its just responding that No service and No sim inserted

    My iphone 3gs is not turning on when I connect to my itunes in pc its just responding that No service and No sim inserted.

    This my sound too simple, but I just kept clikning on the arrow next to the selected music and it finally "Kicked" in.
    I live in Europe ,So Be persistent and don't give up !  Aug. 2013

  • My iPhone 3gs will not turn on unless it is plugged in and battery says 68% any thought

    my iphone 3gs will not turn on unless it is plugged in. battery says 68%. it will not connect to internet. will not make or recieve calls? any thoughts?

    I have tried to restore and it still wont come on unless plugged in

  • Iphone 3gs will not turn on after attempting a factory restore

    My iphone 3gs will not turn on after attempting a factory restore, all that happens is the apple logo appears the timer goes round then stops.  It then switches itself on and off several times to no avail.
    The only way I can turn it off now is by holding the off button and the home button, but then it goes into the cycle again.
    Any advice gretly appreciated.

    http://support.apple.com/kb/HT1808

  • Iphone 3gs will not turn on or charge, iphone 3gs will not turn on or charge

    Iphone 3gs will not power up, or charge, or connect to computer. what to do?

    I have the same problem, my phone is not jailbroken ( since i dont know what this means)
    Was working ok but has gone off & wont connect to the computer either

  • My iPhone 3gs will not turn on, charge, or allow me to perform a hard reset. iTunes nor my computer recognizes it andthe screen wont light up at all. What can I do to fix this?

    I have an iPhone 3gs that is out of warranty. I purchased this phone from AT&T. Last night my phoone went completely dead (battery percentage was at 96% just moments before) and now will not turn back on. I have tried just about everything I have found on discussion boards- trying hard reset, plugging into itunes, charging for15-20 mins then holding down sleep and homebuton..... NOTHING works. This phone will not light up AT ALL. My computer wont even recognize it. Is there anything else I can do?

    Make an appointment at an Apple store if there is one nearby.

  • My iPhone 3GS will not charge. What can I do?

    When I plug my iPhone 3GS into my apple charger, it charges for about 15 seconds then says "charging is not supported by this accessory". What can I do? I have restarted my phone and tried to restore it but it won't stay connected long enough for me to dowload it, much less install it. Any other suggestions?
    Thanks.

    That's often an indication that the dock connector at the bottom of the phone is either dirty or damaged.  Blow compressed air on it and/of gently brush it with a clean, dry toothbtush.  Also be sure the usb cable is able to make a good connection to the connector without being obstructed by your case.  If it's a tight fit, try removing your case.

  • My iphone 5 is not turning on, what should i do

    my phone is not turning on. I've tried charging it but its still not working

    Hi there KevinKwarteng,
    You may find the troubleshooting steps in the article below helpful.
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/ts3281
    -Griff W. 

  • My iphone 3gs will not turn on or charge what do i do?

    please help..ive done everything i can think of and i need help..nothing has worked so far

    Make an appointment at an Apple store if there is one nearby.

  • My iphone 3gs will not turn on. it keeps saying to plug into itunes but this doesn't have any effect. help please

    my iphone keeps shuting down and now refuses to turn back on, it comes up with the message to plug into itunes but this doesnt help?! i dont know what i should do? is it beyond repair help please

    JasmineHill1 wrote:
    my iphone keeps shuting down and now refuses to turn back on, it comes up with the message to plug into itunes ...
    See Here  >  http://support.apple.com/kb/HT1808
    You may need to try this More than Once...
    Be sure to Follow ALL the Steps...
    But... if the Device has been Modified... this will Not necessarily work.

  • My iphone 3GS will not turn on

    So, my partner was using my iphone when it all of a sudden turned itself off. I have tried to charge it with numerous chargers: NOTHING. I have tried holding down the home + power button for a restart: NOTHING. I have just tried to do a restore through itunes, got through the whole sequence, had a white screen then came up with an error advising that it was unable to complete the restore. HELP! I do not want to take it into an apple store as it is no longer under warranty. Is there anything I can do to get it working again ??

    You could try to connect in recovery mode to restore: http://support.apple.com/kb/HT1808
    If this does not help, you'll have to get it serviced. Are there any error numbers given when the restoring process stops?

Maybe you are looking for

  • Read a CSV file and dynamically generate the insert

    I have a requirement where there are multiple csv's which needs to be exported to a sql table. So far, I am able to read the csv file and generate the insert statement dynamically for selected columns however, the insert statement when passed as a pa

  • How to create a table using subform if  lifecycle designer 7.1 not availabl

    hi, plis tell me how to create a table because i am using adobe lifecycle 6.1 and in the library there is no object for table.. also tell me that if i have adobe lifecycle designer then which is better option and why? use table from library directly

  • Improving retrieval performance of essbase server in unix environment

    HI, Our production environment is unix system. can any one suggest settings which impact the retrieval performance and how to do these settings in unix environment.

  • How to export both masters and versions w/ metadata?

    When traveling I import photo files into Aperture on my laptop and edit them.  When I get home I would like to export "everything" - masters, versions, and metadata, so that I can then import all of this into Aperture on my desktop.  Or, perhaps ther

  • BADI for MIGO & BAPI_GOODSMVT_CREATE

    Hello Experts, I want to find out a BADI which fills MSEG-LGPLA with MARD-LGPBE at the time of creation of a Material document from MIGO or a BAPI. Could you please suggest me a solution for this. I am working 4.6c Version Thanks in Advance Regards,