My iphone 3GS slide lock unresponsive,also will enter random text just getting close to screen,twitches when scrolling, My iphone 3GS slide lock unresponsive,also will enter random text just getting close to screen,twitches when scrolling
My iphone 3GS slide lock unresponsive,also will enter random text just getting close to screen,twitches when scrolling, My iphone 3GS slide lock unresponsive,also will enter random text just getting close to screen,twitches when scrolling any ideas?
Reset, hold at same time Home and Power buttons until the iPhone restarts itself. If you have a screen protector on, consider removing it.
Similar Messages
-
i have the iphone 3gs and ive dropped it a few times. when i press the home and lock button, it will not turn on, but when i plug it in, it says in big font IOS 6 and when i slide it open it says connect to itunes or emergency call. it wont turn on when i plug it in to my pc. tips?
roush12345 wrote:
i ... it wont turn on when i plug it in to my pc.
Place the Device into Recovery mode... All data / Content will be Erased.
http://support.apple.com/kb/HT1808
Note on Recovery Mode.
You may need to try this More than Once...
Be sure to Follow ALL the Steps...
Once you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup
http://support.apple.com/kb/ht1766
But... if the Device has been Modified... this will Not necessarily work -
I have a iPhone 4 and lately it has been shutting down randomly when I still have battery left. It also doesn't turn back on, until I plug it in to the charger. But when I plug it in, the low battery sign shows up then comes to the lock screen with like 68% left.
Morning Clementine Lin,
For more information this, please see this article:
iPhone: Hardware troubleshooting
http://support.apple.com/kb/ts2802
Take a look at the Will not turn on, will not turn on unless connected to power, or unexpected power off section.
Have a nice day,
Mario -
HT4623 when i update iPhone 4S i can open my app and if i m open it its will close why?
when i update iPhone 4S i can open my app and if i m open it its will close why?
Read this: iOS 4: Updating your device to iOS 5 or later
... oh I think it is a 3gs or a 3
This makes a difference. What does it say in Settings > General > About? -
My iphone 3gs will not connect to itunes and it says that I need to do a system restore. It also says that I need to enter my password on the iphone to connect to itunes but I can not do this because the phone is in emergency phone call mode only.
Turn your phone off and connect your cable to the computer, but not the device just yet. Start up iTunes. Now, hold down the home button on your phone and plug it in to the cable - don't let go of the button until iTunes tells you it's detected a phone in recovery mode. Now you can restore to factory settings.
Unfortunately, the data on your phone is already gone if you're seeing the connect to iTunes logo. -
I use MacbookPro late 2011 with Maverick, when i put iPhone 5 or another cellphone askew on left corner of touch pad and slide it to keyboard, the macbook will sleep, i don't know what the problem is, it occur on another macbook pro late 2011
It may well be a driver issue but considering the loading: Xorg trying to load different drivers is somewhat normal. @cafe you can see that these are autoconfigured by X above the loading in the log:
Jul 20 19:48:24 arch gdm-Xorg-:0[216]: (==) Matched intel as autoconfigured driver 0
Jul 20 19:48:24 arch gdm-Xorg-:0[216]: (==) Matched intel as autoconfigured driver 1
Jul 20 19:48:24 arch gdm-Xorg-:0[216]: (==) Matched modesetting as autoconfigured driver 2
Jul 20 19:48:24 arch gdm-Xorg-:0[216]: (==) Matched fbdev as autoconfigured driver 3
Jul 20 19:48:24 arch gdm-Xorg-:0[216]: (==) Matched vesa as autoconfigured driver 4
As long as one of the drivers gets loaded, which it apparently does the failing of the others is fine.
Was there an update maybe ? -
I have a 4S and in the lock screen it is coming up with a screen (Not Enough Storage - This iphone cannot be backed up because there is not enough iCloud storage available. You can manage your storage in settings) it then has option close or settings.....but i am unable to click on either or turn off the phone. I have plugged it into itunes on the computer and manually backed it up but i cannot use my phone as i cant get past this message
Welcome to the Apple Community.
You might try a forced shutdown to begin with, hold down the top and home buttons together until the device shuts down, then restart it. -
When I am on the internet, my screen will suddenly scroll all the way to the bottom and will not respond to any commands. All of the other programs are then affected the same way and you cannot even use the commands at the top of the screen becayse they all scroll to the bottom. After a while, the screen resets by itself. Help.
It sounds like a problem wih the backlight inverter. Usually they just go, instead of on and off.
In a dark room hold a flashlight on the display when it blacks out. If you can see the items on the desktop, it's probably the backlight. -
i plugged in my iphone 5S and locked the screen 20 minutes later I tried to open the phone it will not turn on i treid reset and that wont work I have a black screen,
I tried just holding down the power key...NOTHINGDo a reset, hold down the home/sleep button together until you see the apple logo and then release.
-
Can I set my iphone 6 up so that when I delete an email from my computer it will also delete from my phone?
To do that you need to be using an IMAP type email account rather than a POP type. Check with your email provider to see if they provide this service and, if so, switch to it on all your devices.
See here for info: http://www.pop2imap.com -
In System Prefereneces, when I am in Desktop and Screen Saver, I am unable to remove folders. I can click the "-" and the folder appears to be gone, but when I close and then reopen System Preferences, and open Desktop and Screen Saver, the folder reappears in the list. I have tried deleting preferences "plist" but I am totally unable to remove the folders.
I've seen one other report like yours, and I think the issue is caused by a bug, but I don't know what triggers it.
Please read this whole message before doing anything.
This procedure is a diagnostic test. It’s unlikely to solve your problem. Don’t be disappointed when you find that nothing has changed after you complete it.
The purpose of the test is to determine whether the problem is caused by third-party software that loads automatically at startup or login, by a peripheral device, or by corruption of certain system caches.
Disconnect all wired peripherals except those needed for the test, and remove all aftermarket expansion cards. Boot in safe mode and log in to the account with the problem. Note: If FileVault is enabled, or if a firmware password is set, or if the boot volume is a software RAID, you can’t do this. Ask for further instructions.
Safe mode is much slower to boot and run than normal, and some things won’t work at all, including sound output and Wi-Fi on certain iMacs. The next normal boot may also be somewhat slow.
The login screen appears even if you usually log in automatically. You must know your login password in order to log in. If you’ve forgotten the password, you will need to reset it before you begin. Test while in safe mode. Same problem? After testing, reboot as usual (i.e., not in safe mode) and verify that you still have the problem. Post the results of the test. -
I updated my iPhone 3G today and after the update it said on iTunes that my sim was not compatible and my iPhone screen went on to slide for emergency/connect to itunes. Ive tried restoring it but it hasnt worked. Please help!
Unless the iPhone was purchased as unlocked very recently directly from an Apple Store (the only place in the US where unlocked iPhones are sold, and then only since June), which from the symptoms I doubt is the case, then it was locked to AT&T and jailbroken to make it work with an Irish cell carrier. Updating the operating system has now relocked the iPhone back to AT&T.
Only the cell carrier can institute an official unlock, one which will hold across updates of the operating system, and AT&T will not do so for any reason. All we can advise here is that you return the iPhone to your uncle and purchase an iPhone there in Ireland.
Regards. -
My iphone charged but when it turns on does not continue charging also windows and itunes do not identify my iphone!!!
please helpMacafee security center is may be the culprit.
Open Macafee then: select;
Internet & Network > configure
Firewall > Advanced
Programm Permissions > scroll down to Itunes
Highlight (click on)
Then Grant full access to Itunes.
APPLY then OK
When you select store from Itunes you will need to register with Itunes.
Try that or:
Disable your firewall.
I Hope I Was Able To Help You Or Solve Your Question.
Simmm
3/12/2012
If Someone Helped You, Click
"This Helped Me"
If Someone Solved Your Question, Click
"This Solved My Question" -
When I open iTunes it will automatically go to full screen mode. I can't work out how to turn this off. Only iTunes opens to full screen mode.
Go to System Preferences (under the Apple logo in the menu bar). Choose "General". Click "Always close windows when quitting an application".
That should fix it. -
I have a 3GS iphone. It was jailbroken and working alright.But I was not able to upgrade its IOS frrom 4.0.1 to higher versions and many applicatopns were not compatible with this version of the IOS. So I decided to do a factory unlocking. From an website, based in Mumbai, I unlocked it. When I check now in different websites from my IMEI number, my iphone is unlocked. So I became happy that I can now upgrade my iphone. But the events turned to be different.When I connected to iTunes, iTunes stopped working and my iphone did not appear in the iTunes. I uninstalled and reinstalled iTunes after cleaning previous registry of all relatedd components like Quicktime, Bejour,Apple software updates and mobile softwares. I also used msconfig to troubleshoot conflicts in software of Windows 7 ultimate but still my iTunes is not working, when I connect the iphone. If I do not connect the iphone, iTunes is working alright. Can any friend give me some advice how to proceed. I do not like comments like Jailbreaking is illegal and should not have been done. Please advice me what should I do right now. Thanking you all and expecting some valuable suggestions from this expert community.
There are multiple reasons that lead to issue. You should read the troubleshooting guide to get the right solution to solve the issue: iPhone, iPad, or iPod touch not recognized in iTunes for Windows - Apple Support
Maybe you are looking for
-
How do I get an MP4 video file to autoplay instead of download
I am using Dreamweaver CS5.5. I am trying to embed an .mp4 video on my website to autoplay. When I take it to "Live View" the file plays - if I use the "Play" function in Properties I get the following message - "Unable to find the plugin that hand
-
Sorting TV shows by Episode number instead of alphabetically.
I have an 80GB classic. I have loaded 3 seasons of the office onto it, and each season is seperated, which is great, but inside of each season the episodes are sorted aphabetically and not in order of the episodes. After I uploaded them I went into t
-
SAMSUNG LN22A450 - bought last autumn. HD MBP - version 10.4.6, 2.16 Ghz Intel Core Duo, 2006. i have a connecting wire going from the 'headphone' jack to external speaker system now, to listen to better sound while watching movies, and for digital m
-
LDOM SUN Cluster Interconnect failure
I am making a test SUN-Cluster on Solaris 10 in LDOM 1.3. in my environment, i have T5120, i have setup two guest OS with some configurations, setup sun cluster software, when executed, scinstall, it failed. node 2 come up, but node 1 throws followin
-
LR4: Soft Proofing Batches Of Unique Pictures?
Hi. I was wondering if there is a way to do batch processing for soft proofing different pictures similar to the sync functionality? I created a customer user preset however it seems to copy over the existing settings vs updating the +/-'s in the d