My iPhone 4 shut off and will not come back on. How do I fix it?

My iPhone 4 has not had any problems before and all the sudden froze then the scream slowly started fading away into black. Amd now will not turn back on at all.

See Here for  >  Frozen or unresponsive iPhone
Try this First...
Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
Wait for the Apple logo to Appear...
Usually takes about 15 - 20 Seconds... ( But can take Longer...)
Release the Buttons...
More Info here  >  https://discussions.apple.com/message/19521062

Similar Messages

  • My ipod has shut off and will not come back on, i have pluged it in and still nothing what do I do?

    I have a ipod touch and it shut off and will not come back on. I have pluged it in and still get nothing what can i do?

    Let it charge for an hour or two.
    If it doesn't Coe back on, try a Reset.
    Press and hold both the Sleep/Wake button and the Home button for at least ten seconds, until the Apple logo appears (ignore the Slide to Power Off option that shows up first).

  • HT4528 My IPhone will not turn on, I charged it last night and during a phone call it shut off and will not come back on.

    My IPhone will not turn on, I charged it last night and it had a complete charge and during a phone call it just died and will not come back on.

    Connect iPhone to Wall Charger for 10 minutes, it may turn ON itself. If still nothing, keep on charger and Reset, hold both home and power buttons for about 20 seconds until the iPhone begins to respond.

  • My IPhone shut off and will not turn back on!!!!

    SO here's what happened,
    I was texting a friend and listening to music on my iphone... Then all of a sudden I get this pop up notification that says "This adaptor is not supported"
    I didnt have my phone plugged in and then all of a sudden it turned off and will not start back up.
    I tried the following:
    Charge my phone for an hour
    Pressed the sleep/power+home button for 20 seconds
    Pressed the home button and plugged it in my computer while doing so
    Now with that said, I need to know the following:
    Is there hope for my Phone?
    And if I have to replace it, can I go to my cell phone provider-ATT and have them replace it ( I have insurance on it) because the closest Apple store to me is 3 hours away.
    All the advice the better!

    SIDE NOTE!!!!!!!!!
    This phone does NOT have water damage and was working just fine until i had this problem

  • TS2634 MY IPHONE SHUT OFF AND WILL NOT TURN BACK ON

    my phone crashed and will not turn back on - phone has been charged still will not power on

    Try reseting by holding in the home and power button till the apple logo appears!
    http://support.apple.com/kb/TS3281
    This should help, if still no resolution, try:
    http://support.apple.com/kb/HT1808
    If either or does not work, seek apple for servicing

  • HT201263 my phone just shut off and will not come back on no matter what I do. It was working fine then just went compeltely dark and is unresponsive. Help!!

    My phone was working fine, then just went completely blank, and now is totally unresponsive

    Plug it in to mains power for at least 15 minutes.  If it doesn't automatically come on, try a Reset... press the home and sleep/lock buttons until you see the Apple logo, ignoring the slider. Takes about 5-15 secs of button holding and you won't lose any data or settings.

  • I just received my mac book pro for christmas and it shut off and will not come back on does anyone know hoe to fix this?

    can someone please help me?

    Not with that little information.
    It is probably best for you to take it to the Apple Store and have them look at it. You can find the nearest Apple Store and make an appointment there online.
    Allan

  • HT1766 My iPhone 4S suddenly shut down and will not come back on.  Does anyone have an answer for this problem?

    My iPhone shut down and will not come back on. Can anyone give me an answer on how to correct this problem?

    Connect to a wall outlet so you have solid power, then do a reboot by holding both the power and home buttons until the apple logo appears, ignore the red slider if that appears.

  • Iphone 4 turned off and will not come back on

    HAd 30% battery, phone just turned off and will not come back on.
    how would you recommend that I try turning the phone back on, yes I have to put the power back to it and it still will not turn on?

    Hold down the home/sleep button together until you see the apple logo and then release, then wait for the phone to boot back up.

  • TS1538 my iphone shut down and will not turn on.  how do i get it to turn on?

    my iphone shut down and will not turn on.  how do i get it to turn on?

    Connect iPhone to Wall Charger for 10 minutes it may turn ON itself. If still OFF, keep on charger and Reset, hold both home and power buttons for about 20 seconds until the iPhone begins to start.

  • My phone just turned off and will not come back on?

    my i phone 4 just went off and will not come back on?

    Make sure it's charged...plug into a wall outlet for at least 30 minutes, then reset it: Press the Sleep/Wake button & Home button at the same time, keep pressing until you see the Apple logo, then release.

  • HT1414 my phone shut off and will not turn back on whats with it?

    my phone shut off and will not turn back on

    Try resetting the device by pressing and holding the home and power buttons for 15-20 seconds until the white Apple logo appears.
    If that does not work, plug it into a wall outlet for about 20 minutes then try a reset.
    If it still will not turn on, take it to Apple.

  • My iPhone was 100% charged. Mysteriously shut off and will not turn back on. Help!!!

    My 1 week old iPhone 4s was charged 100%.  Worked perfectly one minute, the next it had shut itself off and will not turn back on.  I tried putting it on the charger with no change. I hit the power button on top, nothing.  I've tried everything is it just dead?

    Try leaving it plugged in for at least 10 minutes. Then try to do a hard reset of the device: Hold the Power button and the home button until you see the Apple Logo... may hold for at least 10 seconds if you don't see the Apple Logo popup.
    If that doesn't work force recovery mode.
    Press and hold the home button and connect the phone to your computer with iTunes open.
    iTunes should see the phone in recovery mode and allow you to restore it.
    If it still does not work, the phone may need service at this point. Call Apple Care or setup an Genius Bar appointment at a Apple Retail Store.

  • While printing on my canon MX892 it shut off and will not come on even after checking plug ins.

    While my canon MX892 was printing it shut down and will not turn back on.  What could have happened to cause this problem?

    Hi Painter6, Please follow these steps to resolve this issue: 1. Please confirm other devices plugged into the electrical outlet power on. At this time, please do not disconnect the printer at the electrical outlet. If there is an empty electrical slot, plug in a lamp to make sure the outlet is working. 2. Disconnect the power cord completely at the back of the printer. 3. Please push the power cord back into the receptacle ensuring that the cord is pushed in as far as it will go. 4. Pull the cord and see if it easily slips out from the connector or if it seems secure. 5. If the machine does not power on automatically, press the ON/OFF button. 6. If the machine does not power on after the power cord was pushed in all the way at the back of the printer and the ON/OFF button was pressed, please unplug the power cord from the machine and leave it unplugged for no less than 20 minutes. 7. Please then reconnect the power cord, ensuring that the cord is pushed in as far as it will go. 8. Press the ON/OFF button. If your PIXMA MX892 does not power on, it is recommended that you contact live technical support . There is NO charge for this call. Real time feedback of a live technical support call would be very beneficial in this case.
    Please dial 1-866-261-9362, Monday - Friday 10:00 a.m. - 10:00 p.m. ET (excluding holidays). A Canon technical support representative will be able to resolve this issue faster.

  • My iphone4 turned itself off and will not come back on.

    I had been using it for awile, updated, sync. I unhooked it from my PC and 5 min later is was off and will not come on or respond at all. It is pluged into the wall now and still nothing. What do I do?

    The Basic Troubleshooting Steps are:
    Restart..  Reset..  Restore from Backup..  Restore as New...
    Try a Reset of the Phone... You will Not Lose Any Data...
    Turn the Phone Off...
    Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
    The Apple logo will Appear and then Disappear...
    Usually takes about 10 - 15 Seconds...
    Turn the Phone On...
    If that does not help... See Here:
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414

Maybe you are looking for

  • Using a jQuery list box placed onto a tab control doesn't seem to work for posting?

    Hello, I developed a U.I. in Dreamweaver for a  product and have several list boxes that use the onChange modifier to collect what the user selects from the list. I use the onChange=this.form.submit() function to grab the user's selection from the li

  • How to change the web page title of a web dynpro app?

    Hello, I would like to change the HTML page title of a web dynpro application without renaming the application component itself - but how? Thanks for your comments!

  • Calling custom BAPI from VB/VBA

    Hello, all, I have written a custom business object and its associated function module.  I can single-test the business object inside native SAP, and it works successfully.  I can also establish a handle to the business object from VBA (using the .Ge

  • Where do i make  the array???

    I have an a problem for my class.i need to make a room class, a house class that extends a building class. i am making the room class first with the instance vaiables of length and width. The house class is suppose to add the array of the rooms to ac

  • Where to store the attachments before sending a mail

    can any one help me when user clicks on attachfiles where to store the attachments before sending an email thanks in advance