My iphone 4s having problm after i updated to ios 8
i upgraded to ios 8 but it became problm for me pgone getting slow crushing of applications
Hm... Try this----> http://support.apple.com/kb/ht1808 or http://osxdaily.com/2010/12/04/ipad-dfu-mode/
Similar Messages
-
My iphone 4 is dead after I updated to ios 6.1.3 it doesnt turn on and doesnt respond to itunes also. Visited Apptronix service desk but they say there is nothing they can do about it, and they have charged INR 10640 for a new one. Is there anybody with similar problem....
Hm... Try this----> http://support.apple.com/kb/ht1808 or http://osxdaily.com/2010/12/04/ipad-dfu-mode/
-
My iphone 4s cant activate after i update the ios to 6.0.1, always shows this message " Your request couldn't be processed" we are sorry but there was an error processing your request, Please try again later........please someone help me???
It sounds a lot like your phone was jailbroken or hacked to unlock it before you updated.
Was it? -
IPhone 3Gs: Error (-1) after attemped update to iOS 5
After attempting to update to iOS 5 on my 3Gs, my iphone becomes bricked and enters recovery mode. The update proceeded as normal without issue untill it asked me to for a restore. Now, after every attempt to restore I receive the message: unknown error (-1).
theiphonewiki.com lists error (-1) as:
"Error occurs when one uses the "last ditch" method for preventing baseband updates on the iPhone 4. The baseband does not get updated using this method. Use TinyUmbrella to kick it out of recovery mode."
My 3Gs is not jailbroken and I am unsure of thrid party software when it comes to my apple devices. Also error (-1) shows to be an error message for the iPhone 4, which is not the case in my situation.
I have attempted these procedures:
Removed the sim card, attempted recovery without sim card (x1): No change.
Reinstalled the sim card, attempted recovery (x1): No change.
Rebooted computer, attempted recovery (x5): No change.
Switched USB ports, attempted recovery (x4): No change.
Attempted recovery on multipule computers (x6): No change.
Reinstalled iTunes, rebooted, attempted recovery (x1): No change
Has anyone else experienced this issue? If so, has any procedure that I haven't tried worked for you? Any insight or recommendations would be very helpful.
Thanks in advance!Here's what fixed it for me. Pretty simple mistake I overlooked.
I turned off the firewall that was running in the back ground through my virus protection control panel. I then proceeded to make another attempt and it finished as it should have. I did loose all my settings, pictures and videos although, I still have the 2 notes I made in the Notes app. I would have gladly sacrificed the measurements I took for the gutters on my house for the pictures I took of my nephew the day he was born. This is a wake up call to import my photos more offten and/or before another update. Win some, loose some I guess. At least I can make phone calls now. >.<
I hope this will work for anyone else having the same issues.
Good luck! -
Cannot sync iphone 4 with itunes after new update to ios 7
Help..
After update to IOS 7 on my Iphone, and Itunes update to 11.1.1... I am unable to sync my Iphone 4.
Itunes detects my iphone and does a clean backup. It also starts sync and shows upto 5 steps. Reaches the last step and keeps on working on that step in itunes. The sync indication on the iphone is lost during this last process.
Result i cannot sync new songs on my iphone. I also have an ipod and it sync well with the itunes. NO PROBLEM WITH IPOD..
Any suggestions.. Pls help me...
Thanks to all in advance..Problem solved
I restarted iTunes ! -
IPhone 4S: Keyboard disappeared after latest update to iOs 8.
After this latest iOS update ( 8 ) the keyboard on my iPhone 4S has gone missing. When I go to type something the emoji screen appears but is unresponsive. An acquaintance told me to power down the iPhone, take out the battery for a few seconds, re-insert battery and power back up. I'm hesitant about doing this.
That is a new feature described in Connect your iPhone, iPad, and iPod touch using Continuity
You can turn it off by going to Settings > FaceTime and turn "iPhone Cellular Calls" to off.
The quote below is from the above link and gives more description of when it would work with that setting turned on.
Phone calls
To make and receive phone calls on your iPad or iPod touch, here's what you need:
Your iPhone and your iPad or iPod touch need to use iOS 8 or later.
Both devices must be on the same Wi-Fi network.
Both devices must be signed in to FaceTime using the same Apple ID.
This means any iOS device that shares your Apple ID will get your phone calls. Look below for instructions on how to turn off iPhone cellular calls.
Wi-Fi Calling needs to be off. -
I am having a lot of issues syncing anything to my iPhone 4, just after i updated to iOS 5.
So i updated to ios 5 and i was having issues with everything. my photos and contacts and everything synced alright, but none of my music worked. so i restored it back to just after i updated to ios 5, and my music and ringtones and everything was working. but now, when i try to apply the ringtones - and some of them are even purchased - it plays what the ringtone is, but it just stays as marimba. any other default ringtones work, but none of my custom ones. do i have to keep restoring my iphone every time i want anything on it? cuz im worried ill ruin all my progress if i restore it again. when will an update be out, or does anyone have a solution?
bump? Is bumping allowed? Lol.
I just really need some help here. -
i am having problems with my burst mode on my iphone 6 plus it is slower than the facetime camera after i updated to ios 8.3 apple please fix this issue i am fed up with all your mistakes
Gerald
If you had taken time to read the Terms of Use you agreed on joining this Community today you would have realised that Apple is not here
neither reading nor responding on this User Community
http://www.apple.com/feedback/ -
i lost my iphone4 yesterday..i have find my iphone apps in there and its updated to IOS 5. i wonder if they would be able to still access my accounts in there after i remote locked it.? its offline whenever i checked till now.. im wonderin if ist safe coz all my emails are there and all personal info..i hope someone could answer me..i reported to the police the ist step..coz when it happened ..policemen are there..then i went to the nearest MAC center and tried to track it..but its offline..so they asked me if i want to remote lock it..then i did...which i think the mcreason why i cant track my phone beacause its locked?? or not until they connect to wifi or 3g but its unabling them because i locked it..?
but when i do remote wipe ..it will erase everything in there and i cant track down the phone anyomore?
-
TS1567 I cannot activate my iphone 3gs after I updated to ios 6.
I cannot activate my iphone 3gs after i updated to ios 6.0.1 and all it shows when i start the phone is connect to itunes. I have tried
several time to get it back as normal but its the same all the time. Can someone please help...
ThanksThe typical cause is that the device has been hacked or jailbroken.
-
Like everyone else today, I attempted to make the move to iOS 8, using my Mac's iTunes. All was running smoothly, the progress bar was nearing the end when I received the error that "the iPhone software update server could not be contacted." With a now useless phone, I restarted it, hoping for the best as I could do nothing. I am now stuck with a phone which will turn on to the white startup screen and black Apple Logo, then instantly shut down, leaving me to repeat the process. If I hold down the home button, I can enter what seems to be "Recovery Mode," with a red iTunes Logo, as opposed to the usual blue. From here, all internet sources I have found suggest that I should restore the phone, but that's really where I hit the problem. When I plug the phone in, when in Recovery Mode, I simply receive the "iPhone software update server could not be contacted" error again, leaving the phone not recognized by iTunes. In non-recovery mode, the phone appears to simply turn off so fast that iTunes has no time to find it.
Any one with similar problems or solutions?This what happened to my iPhone 5 after I updated to iOS 8.0;
The update process was done smootly without problems thru
Over the Air.
Now when I cold start/boot my iPhone 5, my apple logo appears as it was
in iOS 7, but after 30 seconds or so, my Apple Logo dissappears the
screen goes black for 5-6 seconds, but then viola! I am at the Log-On
screen... Then I start using my iPhone.
Just like Chris above, I have done 10 reboots, (complete shut down and
restart), its always the same...
Other than this, my iPhone works just fine. I will not re-install the iOS.
From my past experience, re-installing the iOS does not change
these minor differences... -
After I updated to iOS 7.0.2, my iTunes keeps telling me to restore my iPhone, after I restored it. Can someone tell me what I can do to fix this?
The Basic Troubleshooting Steps are:
Restart... Reset... Restore from Backup... Restore as New...
Restart / Reset > http://support.apple.com/kb/ht1430
Backing up, Updating and Restoring > http://support.apple.com/kb/HT1414
If you try all these steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
Be sure to make an appointment first... -
I bough an iPhone from Internet and after an update it got locked. Please anyone help.
You can either figure out what carrier it's locked to and contact them to see if they offer unlocking, or you can throw it away or sell it and buy an unlocked iPhone from a legitimate source.
-
Take pictures, but are not taken to save them in a photo album. This problem occurred after you update to ios 6.0.2. My phone is iPhone 5
That's corrected, they save to your camera roll.
-
why my iphone are not responding after i update the latest ios? and the screen displaying itunes icon
You are in Recovery Mode. Follow the instructions below to recover your iPad.
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button.
5. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: You need to be patient and repeat the above many times to recover your iPad. Data will be lost.
Maybe you are looking for
-
OMS is up and running but unable to get the console page through web browser
Hi All, I have a wierd issue here. I have my OMS running successfully, but I am not able access it through HTTPS connection in web browser. My version of OEM is 11.1.0.1 It was working till yesterday, I am not sure what happened suddenly that its n
-
WM interface to external system
Have anybody ever configured WM interface to external system (t-code OMKY)? I have a question here and hope you can help: What's the naming rule when define Logical System, RFC destination, Port and Partner Profile? Should all be defined under one na
-
I've been sending music from spotify out to my pioneer vsx-1121 through my WAN to a WAN adaptor on the reciever, but I've been getting annoying drop outs in the transmission. I've been told I can hook up a hdmi cable to my imac route the sound into
-
hi everybody , i have redhat 6.1 / mandrake 7.0 i, i have two quest. : 1- which linux i choose for 8i ? 2- how install both designer 6i and developer 6i above the 8i ? thank u , mohamed
-
4 Aironet 1252's with 2.4 & 5 GHz Radios
I just deployed 4 1252 Aironets. I had some reports of connections coming up and dropping. I think the issue is how the radios are tuned in them. I am using multiple SSID's and VLAN's. One of the SSID's is configured for both the 2.4 & 5 GHz. My