My iphone is in recovery mode.... how i can make it work again? ...help please thank you

my iphone is in recovery mode , after i try to hard reset it nopw  my computer didnt show the phone after is plug inn to it , my question is how im gona reinstall the ios?

If the computer doesn't show it in after you plugged it in
1: Try another USB Port
2: Try another computer
3: Try another USB cable
If all of this doesn't resolve your issue; you sir have a hardware failure

Similar Messages

  • Hello, my iPad's power button has stopped working. Does anyone have a solution as to how I can make it work again

    Please help. My iPads power button has stopped working. I cannot take it to sleep mode or switch it off

    Try a reset even though the Sleep/Wake button is not woring.
    Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
    Note: Data will not be affected.

  • Iphone is in recovery mode how do i get it out?

    iphone is in recovery mode how do i get it out of recovery mode

    I was going to say restore it... then you posted mentioning it got dropped in water.
    Get it replaced or buy a new phone. You might be able to dry it out by placing it in a bag of uncooked rice or silica gel for a few days to a week, but it will most likely suffere permanent damage.

  • My iphone is on recovery mode and i can´t turn on it, when i try to recover it from itunes i get: "unknown error (36), i´ve tried to do lot of things but i can´t  solve my problem. please help!!

    my iphone is on recovery mode and i can´t turn on it, when i try to recover it from itunes i get: unknown error (36), i´ve tried to do lot of things but i can´t solve my problem. please help!!

    Hi, i had the same problem. Try to find the file "apple" or "itunes" don't know it anymore exactly. Ahm well you need to delet any information or just plug in your iphone into an other computer. important is that your iphone never has been pluged in this computer before. This was what i did, and it worked!

  • The middle button on my iphone stoped working and i think it is stuck because when i restart it , it goes straight to voice commands. how do i make it work again?

    The middle button on my iphone stopped working and i think it is stuck down because whenever i restart it the voice command thing comes right up, like when you hold the middle button down for a few seconds. How do i make it work again?

    If this has happened more than once the problem is likely on your PC.
    See here: http://www.apple.com/support/iphone/assistant/itunes/

  • Hi! I just bought a new iPhone and I was wondering how i can make sure all my pictures and music will be transfered from my old iPhone to my new one?

    Hi! I just bought a new iPhone and I was wondering how i can make sure all my pictures and music will be transfered from my old iPhone to my new one?

    Pictures are held in the iPhone backup. If you backup the old device just prior to the activation of the new one, then restore from that backup, the photos will be there. Music is in iTunes on the computer and when you do the restore, it will download the music from iTunes to the device during the restore. Make sure any music purchased on the iPhone that has not been transfered to iTunes on the computer is done before beginning the restore.
    You can also view information in this support document http://support.apple.com/kb/HT2109

  • HT4972 i cant update my iphone 3gs to a more newer ios? it says here error! and the phone flashes some connect to itunes.. an if i connct nothing happens.. help me.. the ipgone wont open . and work pls help me thank you!

    i cant update my iphone 3gs to a more newer ios? it says here error! and the phone flashes some connect to itunes.. an if i connct nothing happens.. help me.. the ipgone wont open . and work pls help me thank you!

    Hello AlexCornejo,
    Thanks for using Apple Support Communities.
    The screen you're seeing on your iPhone indicates it is in recovery mode.  Now since the device is not appearing in iTunes on your PC, first follow the steps in this article:
    iOS: Device not recognized in iTunes for Windows
    http://support.apple.com/kb/TS1538
    After following those steps, you should be able to restore your iPhone.
    Take care,
    Alex H.

  • TS4225 I have just shifted to iOS 7 but i believe i lost the audio output through the earphone terminal. How do I make it work again?

    How do I make it work again? I tried with the apple earphones provided and the stereo jack in my car, both didn't seem to work. The thing is, if functioning normally, after I insert the earphone jack in the terminal, the sound from the speaker should disappear and be rerouted to the earphones, this didn't happen.
    Shall I reset my iphone?

    it's not ios7 it's not software it's a hardware issue
    it's this
    https://discussions.apple.com/thread/1343532
    just the opposite where rather then the switch being stuck in one way it's stuck in the other
    more hits
    https://www.google.dk/search#q=iphone+stuck+in+headphone+mode

  • Hello, my main button has stopped working .. how do I make it work again?

    Hello,
    my main button has stopped working.. how do I make it work again?
    thank you

    Try a system reset.  It cures many ills and it's quick, easy and harmless...
    Hold down the on/off switch and the Home button simultaneously until the screen blacks out or you see the Apple logo.  Ignore the "Slide to power off" text if it appears.  You will not lose any apps, data, music, movies, settings, etc.
    If the Reset doesn't work, try a Restore.  Note that it's nowhere near as quick as a Reset.  From iTunes, select the iPad/iPod and then select the Summary tab.  Follow directions for Restore and be sure to say "yes" to the backup.  You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod.
    There's more to try but let's go a bit at a time.

  • To turn on my ipod, I get an image of connection to iTunes, but when you update iTunes, nothing happens. I restarted the iPod manually several times peero still appears the same image. how I can make it work?

    to turn on my ipod, I get an image of connection to iTunes, but when you update iTunes, nothing happens. I restarted the iPod manually several times peero still appears the same image. how I can make it work?

    Restore the ipod

  • I have a canon multifunction printer that used to work with snow leopard but since I updated to mountain lion my printer stop working, How do I make it work again?

    I have a canon multifunction printer that used to work with snow leopard but since I updated to mountain lion it stoped working. How do I make it work again?

    This problem is not unheard of when upgrading from Snow Leopard. It is usually solved by completely deleting the existing printer in System Preferences > Print & Scan, and adding it again.

  • TS1559 I stop receiving I message in my iPad recently I changed my apple password how can make it work again?

    I stop receiving I message in my iPad recently I changed my apple password how can make it work again?

    Using FaceTime http://support.apple.com/kb/ht4319
    Troubleshooting FaceTime http://support.apple.com/kb/TS3367
    The Complete Guide to FaceTime + iMessage: Setup, Use, and Troubleshooting
    http://tinyurl.com/a7odey8
    Troubleshooting FaceTime and iMessage activation
    http://support.apple.com/kb/TS4268
    iOS: About Messages
    http://support.apple.com/kb/HT3529
    Set up iMessage
    http://www.apple.com/ca/ios/messages/
    Troubleshooting Messages
    http://support.apple.com/kb/TS2755
    Setting Up Multiple iOS Devices for iMessage and Facetime
    http://macmost.com/setting-up-multiple-ios-devices-for-messages-and-facetime.htm l
    FaceTime and iMessage not accepting Apple ID password
    http://www.ilounge.com/index.php/articles/comments/facetime-and-imessage-not-acc epting-apple-id-password/
    Unable to use FaceTime and iMessage with my apple ID
    https://discussions.apple.com/thread/4649373?tstart=90
     Cheers, Tom

  • I have ipad 2. Safari stopped working. Screen appears with light gray cover. Some websites show errors when debug is on. But how actually can I debug or fix it? Thank you.

    I have ipad 2. Safari stopped working. Screen appears with light gray cover and is frozen. Some websites show errors when debug is on.
    But how actually can I debug or fix it? Thank you.

    Here are a couple suggestions:
    1.  Go into Settings > Safari and Clear Cookies Clear Cache
    2.  Fully close Safari:  from your home screen, double tap your home button and the most recently used Apps will show up.  Hold your finger on the Safari App until all Apps start jiggling.  You'll see a minus sign on the upper left side of Safari.  Touch the minus and Safari will fully close.  Touch your home button again to stop apps from jiggline, then touch your home button again to return to your home page.
    3.  Reboot your iPad:  Press and hold BOTH the power and home buttons at the SAME time for at least 10 seconds (ignore the red slider) until the Apple Logo appears, then let go of both buttons and your iPad will restart, but no data or settings will be lost.
    After iPad comes back up, try Safari again, and you should be good to go.

  • I bought the pack for students adobe creative cloud, already made the payment three days ago but when opening programs like photosop and illustrator puts the trial period has expired, how I can make them work?

    I bought the pack for students adobe creative cloud, already made the payment three days ago but when opening programs like photosop and illustrator puts the trial period has expired, how I can make them work?

    Hello Ibonedm,
    Sol 1. Please try sign out from Creative cloud Desktop App and quit it.
    1. Launch Creative Cloud application manager.
    2. Click the gear icon in the upper-right corner and select Preferences.
    3. In the Preferences menu, under General, click the Account tab.
    4. Click Sign Out from Creative Cloud.
    Then re-sign in and launch Photoshop CC 2014 and check.
    Sol 2. Check your Hosts file.
    Windows
    1. Choose Start > Run, type %systemroot% \system32\drivers\etc, and then press Enter.
    2. Locate Hosts file and move it to Desktop
    3. Right-click the hosts file and select Open. Select Notepad for the application to open the hosts file.
    4. Back up the hosts file: Choose File > Save As, save the file as hosts.backup, and then click OK.
    5. Search the hosts file for entries that reference activate.adobe.com (for example, 127.0.0.1 activate.adobe.com) and delete these entries.
    6. Save and close the file and move it back to Etc folder.
    Mac OS
    1. Log in as an administrator to edit the hosts file in Mac OS.
    2. In a Finder window, choose Go > Go To Folder.
    3. Type /etc.
    4. Select the hosts file and move it on Desktop  open it.
    5. Back up the hosts file: Choose File > Save As, save the file as hosts.backup, and then click OK.
    6. Search the hosts file for entries that reference activate.adobe.com (for example, 127.0.0.1 activate.adobe.com) and delete these entries.
    7. Move Hosts file back to etc folder
    8. Save and close the file.
    Then try launching Photoshop CC 2014 or Illustrator CC 2014
    If prompt for License this software, please click on it and sign in with the Adobe ID and Password which you have used to purchase the subscription and check if you can activate and use the products.
    Please respond , if any issue.
    All the best
    Loveneesh.

  • After download IOS 8.0.2 my iPad went to recovery mode. how i can turn it on

    After download iOS 8.0.2 my iPad went on recovery mode, how do i come back to regular use ?

    Use iTunes on your computer to restore it.
    ~Lyssa

Maybe you are looking for

  • Transport of ALE Interfaces for Function Module

    hi, i have a Z function module, Z business object type and z message type identifying ALE interface. i need to move all the objects from Dev R3 to QA R3. What are the steps involved? Thanks, Tirumal

  • Using SDK objects(coded in VB) .dll

    Hi Dukes, I have to import & export data into Pastel using it's SDK objects that are written in VB. I've read all I can about JNI(tutorial) and went through most of the previous topics regarding this issue and found some usefull information, but noth

  • How do I stop firefox from opening every link I click on in a new window instead of loading it in that window?

    Whenever I click a link to bring me to a game or maybe a different website, it opens it into a new window which keeps certain things from working. == This happened == Every time Firefox opened == I clicked "open in a new window" on a tab so i could h

  • Can't generate the tiled Iamge

    hii, i m genereting and display the tiled image on Canvas. Tiled image displays properly as the applet load first time.. but as i scroll down or scrollup ,the next tile is not displayed. i don't know why the image is not going to display properly.. c

  • Uninstalling Final Cut Express 3.5 after installing 4.0

    After installing FCE 4, I noticed that version 3.5 is still present. The Apple web site contains instructions on how to uninstall version 3.5 <http://support.apple.com/kb/TA38198?viewlocale=en_US> but how many of those locations are used by both vers