My iphone screen is broke and i cant see anything but it still rings how can i unlock it ?
My iphone 4s is broke the screen has gone complety blank and its all cracked but when people ring me and text me things like that you can hear it and answer but to back up my phone for when i get a new one i need to unlock it any ideas how ?
Other than finding a third-party repair shop to replace the screen, you can't. Apple doesn't replace iPhone 4S screens, they replace the whole phone, so going to an Apple store won't help you.
Similar Messages
-
Please help, my iphone screen was repaired with a faulty screen and my screen has went sheet white with all coloured lines so i cannot see anything on the screen at all. My phone is still on and i can still hear all my messages coming through, is there any way i can read those messages before dumping the phone?
Only if:
1. It's iMessages
2. You have a newer Mac and iMessage is configured
3. You use the same Apple ID -
I dropped my ipod 5 and screen is black and i cant touch anything but siri still works
i dropped my ipod 5 and screen is black and i cant touch anything but siri still works
Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
Apple Retail Store - Genius Bar -
im locked out of itunes because i need to put my passcode in but my display screen is broken. i dont know how to fix it because im tying to back up my old iphone but i cant without putting in my passcode.
If you have synced the device on a computer in the past, you can back it up without the passcode. If you have not synced/backed up the device before, then you are out of luck. No way to back it up or sync it without the passcode.
-
Clicking on Microsoft Update opened Firefox, but Microsoft Update couldn't run from Firefox; when I closed Firefox I lost all my tabs and couldn't restore anything but the Microsoft page; how can I restore the tabs from an earlier session?
Hi Diovizor,
Make sure that you do not use [http://support.mozilla.org/en-US/kb/Clear%20Recent%20History Clear Recent History] to clear the 'Browsing History' when you close Firefox.
Also please make sure that you not run Firefox in (permanent) Private Browsing mode.
You enter Private Browsing mode if you select: Preferences > Privacy > History: Firefox will: "Never Remember History"
To see all History and Cookie settings, choose: Preferences > Privacy > History: Firefox will: Use custome settings for history. Uncheck "Always use permanent Private Browsing mode"
Hope that helps! -
What can i do when my ipod screen goes white and i cant see anything?
Please! Somebody give me some advice on what to do when my ipod is white and i cant see anything? i can listen to music but i cant see what i am listening to?
If none of the usual 5 R's of troubleshooting do any good, you'll need to have the iPod either serviced or replaced as the LCD screen or ribbon cable is damaged or faulty.
http://www.apple.com/support/ipod/five_rs/nano3gen/
B-rock -
My iphone is on silent but it still rings how can I stop this?
My iphone rings even when it is on silent, how can I fix it?
If you have the silent switch set to on, then your phone should not ring. No need for changing settings.
If the silent switch is definitely fully on, then you should try resetting the phone by holding down the sleep button and home button at the same time, keep them held down til you see the Apple logo, ignore the 'slide to power off' message and release after a few seconds.
If that doesn't work, then I would visit an Apple Store. -
My Ipod kinda works it just has a white screen and i cant see anything.
I can turn it on and slide it to unlock i can just to that from memory but it is white and you cant see anything but white. it also lets me play music but nothing else
have you tried the troubleshooting hints:
http://www.apple.com/support/ipodtouch/troubleshooting/ipodtouch/ -
My iphone 4s blacked out you cant see anything but I white line, how do you transfer everything from your iphone to a computer
Next time make regular backups of your computer. The iPhone is not a backup device, and I'm sure you lost more than your iTunes library. See this user tip for your options: Syncing to a "New" Computer or replacing a "crashed" Hard Drive
-
My Iphone 4 has a black screen it still works I just cant see who Is calling or texting how can I fix this ?
You can actually fix this by posting this in the iPhone forum and NOT an iWeb forum which is for building websites.
Check which forum you are posting in before doing so. -
I have forgot my Iphone passcode. Itunes will not let me restore it, i do not have icloude,or find my iphone,and the closest itunes store is 4 hours away how can i unlock, or reset my phone?
Try this:
Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
until the red slider appears, then slide the slider. Wait for the device to turn off.
* If you cannot turn off the device using the slider, press and hold the
Sleep/Wake and Home buttons at the same time. When the device turns off,
release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
device. The device should turn on. Note: If you see the battery charge warning,
let the device charge for at least ten minutes to ensure that the battery has some
charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Additional Information:
If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
I have new iphone and all data were restored but my music! How can I add my music from Itunes and new iphone?
Connect the old phone to your computer, right click on it in iTunes, and choose Transfer Purchases. That should put all of your music in iTunes except any tracks that were not purchased from iTunes. If you have any such you will have to retrieve them from the original source, or see: https://discussions.apple.com/docs/DOC-3141.
Apple also has this tip for copying data from an old phone to a new one. -
I restore my iPhone from a backup , and I lost the photos on the device. How can I restore them ?
I restore my iPhone from a backup , and I lost the photos on the device. How can I restore them ?
is there anyway to help to :"?I thinks , I pressed restore, and then it restored everything from the previous backup. Unfortunately the most recent photos and videos were not included so I reckon they are lost forever...
Unless you have any suggestions? -
Hi i have a iphone come from japanese i cant use in belgium because its locked how can i unlocked?
hi i have a iphone come from japanese i cant use in belgium because its locked how can i unlocked?
Did you sign up for a cellular service plan when you purchased the iPhone?
You'll probably have to contact the carrier.
Take a look at this Apple doc for all the details -> iPhone: About unlocking -
TextEdit is not working. I have tried repairing and I have tried reinstalling but it still says "You can't open the application TextEdit.app because it may be damaged or incomplete."
Can anyone give me some other ideas as to how to fix. Thanks.Thats the first thing I tried last night. And reinstalled just textEdit but no luck, then I deleted TextEdit and reinstalled it again and I was still getting the same message. Tried pacifist this morning again but this time I tried reinstalling the whole apps package half way through its says it cant reinstall due to multiple missing files.
Tried the repair option on the OS disc it says everything is fine
Maybe you are looking for
-
Trouble with xsd:any and web services
I am trying to generate client code from a WSDL for a getter and setter for a chunk of XML. The getter:<s:element name="GetData"> <s:complexType> <s:sequence> <s:element minOccurs="0" maxOccurs="1" name="id" type="s:string"/> </s:sequ
-
I just bought a mac mini(2010) and connected mini to samsung P2270HD(Full HD 1920 X 1080) via HDMI gives a very bad picture quality. Took the mini back to the store and they reproduced the problem on the same monitor. Then the guy took a dvi cable an
-
For invoice verification transicion key
as for gr bsx key is related, so for invoice verification which key is related?
-
Hi, When creating PM order user is not sure about responsible purchasing group. Once PM order is converted to P.Requisition, the purchasign department should put the responsible purchasign groups and process PO. Our issue is the P.Requisitions havi
-
Authentication for user weblogic denied problem when starting managed serve
Hi All, I have a strange situation here. I installed WLS and SOA and BAM servers. Initially I could start both WLS and SOA. Later I changed some files (possibly startManagedWebLogic.sh or deleted soa_server1/data/ldap/ or AdminServer/security/boot.pr