My iphone will not power off

My Iphone 4s will not power off and the battery is draining with a couple of hours ? Help please

Try an iPhone reset first which is done by pressing and holding the home button and the sleep/wake or on/off button simultaneously until you see the Apple logo and then release. This is similar to a computer restart.
Try powering the iPhone off again after doing so.

Similar Messages

  • My iPhone will not power off. It automatically turns back on after trying to shut it off. Any Ideas?

    My iPhone 5 will not power off. I hold the power button down and it lets me turn it off but then it automatically turns back on. It is as if I am just restarting it. Any ideas on how to fix it? I already had it exchanged and the replacement is now doing it.

    I had this same problem about a year ago. It is most likely because debris has been caught in the cable connector. Get a cotton bud or something soft so that you don't cause any damage, and gently clean the inside of the dock connector of your phone. Do not use any liquids. Hope this helps.

  • IPhone Will Not Power Off or Go Into Silent Mode

    Yesterday I discovered that I had my phone switch flipped to Silent Mode, and my phone was still making the General Sounds and Still Ringing. No matter what I do I can't get it to Vibrate instead of ring.
    Also it will not power off, no matter how long I hold the button nothing happens, it wont even lock. I tried performing a hard rest by holding the Home Key & Power Button, but instead of reseting the Voice Control pops up and my iPod starts playing.
    Any Help Is Greatly Appreciated ♥

    - Try another cable.
    - Try on another computer
    - Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
    - Make an appointment at the Genius Bar of an Apple store.
      Apple Retail Store - Genius Bar

  • IPhone will not power off, app will not change , two screens display at one time

    Hello, I have a phone that is stuck on one app. Can hold the off button for 3 minutes and will not turn off. Will hold the lower button to change app's and nothing. Can change subjects in the app stuck in and can see both screens while scrolling. Going to let the phone run out of power to see if that will help, but very inconveinent

    I seem to have found the answer by my own foolishness....
    I held down the on/off button on top and the "belly button" on the front bottom and whoosh! it came back to life.
    It would sure be nice if Apple would restore the Troubleshooting area of their website and include information like this so Luddites like myself could keep a lower blood pressure....

  • HT1349 Phone will not power off or take picture

    My iPhone will not power off.

    Try to reset it: hold the on/off and home buttons until you see the Apple logo (ignoring the off slider that appears first), then release.  If it won't reset just let the battery run down until it turns off, then recharge it.

  • My iPad will not power off

    I have a 32GB iPad 1st Gen. It sits with a pinwheel rotating, but will not power off. When I tried connecting it to iTunes, it says there is an unknown problem connecting this iPad. What Can I do?

    I'm sure you've tried the hard reset using the home and power button?  If that won't work, next check your cables.  If you own a iPod, or iPhone and have mixed up the sync cables, that can sometimes cause an issue depending on how old they are.  If that doesn't work, I'd try a different computer with iTunes on it, if you have it, or a buddy to see if it recognized then.
    Let us know how it goes.

  • HT201401 4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out l

    4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out loud.

    The Basic Troubleshooting Steps are:
    Restart... Reset... Restore from Backup...  Restore as New...
    Restart / Reset
    http://support.apple.com/kb/ht1430
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414
    If you try all these steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
    Be sure to make an appointment first...

  • IpodT auto redirects to the power off (slide) option while in use. Then while not using it, it will not power off to conserve the battery. I have to enable the assistive touch to save battery life. Software is up to date with 6.1.6.  PLEASE  HELP!

    version 6.1.6(10B500); model#MC547LL/A; 60GB (40 used/20 avail)
    IpodT auto redirects to the power off (slide) option while in use. Then while not using it, it will not power off to conserve the battery. I have to enable the assistive touch to save battery life. Software states up to date with iOS 6.1.6.  PLEASE  HELP!

    Try:
    - Reset the iOS device. Nothing will be lost      
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings                            
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                               
    iOS: Back up and restore your iOS device with iCloud or iTunes      
    - Restore to factory settings/new iOS device.                       
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
      Apple Retail Store - Genius Bar

  • My iPad will not power off. Buttons won't work

    My iPad will not power off. Buttons won't work

    Hi Try a Reboot press & hold power button & menu button hold both down until you see Apple Logo Try this with ipad conected to charger. Cheers Brian

  • My lock button is broken and my iphone will not power back on when I charge it, how do I turn it on?

    My iphone will not power on when I plug it into charger in the wall, computer, or car. My lock button is broken and I do not know how to turn it back on. My phone did not die it just went black and has not been dropped, cracked, or gotten wet. What do I do?

    Normally one would do a reset, however without the lock button, which is the sleep/wake button, you cannot do a reset. You could always wait until the battery dies to see if it will start when plugged in, but the sleep/wake button is an integral part of the phone and needs to work to do a number of functions. I suggest that you make an appointment at the Genius Bar to get it fixed.

  • HT201412 My ipad mini will not power off. The ICloud Backup  reminder is stuck on the screen and will not clear off.

    My ipad mini will not power off, nor will it respond to any commands.  The ICloud Backup reminder (which I do not use and have not activated)is stuck on the screen and will not clear.

    Hold down the sleep and home keys for about 20 seconds and see if you can get it to reboot.

  • My iphone will not power on. I have handled it very carefully. I checked my message on it in the morning. Any ideas?

    My iphone will not power on. I have handled it very carefully. I checked my message on it in the morning. Any ideas?thank you

    It  worked!!! Thank you so much
    helpful advice. But why does this happen?

  • IPhone will not turn off.

    My iPhone will not turn off. I did a restore about a week ago to repair the problem following which the phone would turn off albeit with some difficulty: I had to hold the top button down and not merely click it before the phone turned off but not so long that I would get the shut-down screen.
    Now, however, even after doing another restore, the iPhone will simply not turn off, no matter how long I hold down the top button. Nor do I ever get the shut-down screen. I've had to turn on the auto-lock option so that while I'm carrying the phone around it does not randomly dial or go online.
    I'm guessing this might be a hardware failure but wanted to check first to see if anyone else has run into this problem.

    If it's doing that after a restore, it more than likely issue on your logic board. I would contact Apple and get it serviced.
    1-800-MY-IPHONE
    Dave M.
    MacOSG Founder/Ambassador  An Apple User Group  iTunes: MacOSG Podcast
    Creator of 'Mac611 - Mobile Mac Support' (designed exclusively for an iPhone/iPod touch)

  • The light on my iPhone will not turn off

    The light onmy iphone will not turn off.

    do a quick reset by holding your sync and home button for 10 seconds it should turn off the led light.... if not completely restore your iphone and back it up it should turn off by doing 1 of these 2 steps

  • My iphone is frozen. will not power off or respond even after charging.

    My iPhone is Frozen. Does not power off as well. What can be done to fix this?

    Try a soft reset, press and hold in the homescreen key (Circle button at bottom of the iPhone) and power key (One that locks the screen as well as turns it off and on) at the top, together and hold it till the screen shows the Apple logo, then release the keys, this should hopefully resolve.
    Let us know how it goes.

Maybe you are looking for

  • Critical Error: An unhandled error has occurred. Please contact your system administrator.

    Hi all, Does anyone have any idea what the following error relates to? "Critical Error: An unhandled error has occurred. Please contact your system administrator. Debug information: System.IO.FileNotFoundException; Could not load file or assembly 'Mi

  • How AI Hardware Config.vi into Acquire&Proc N Scans - Trig.vi amplify gain?

    I am using Acquire&Proc N Scan - Trig.vi program. I tried using AI Hardware Config.vi to add into the block diagram so as to increase the ECG waveform gain but it seems useless. How can it be done to amplify the gain of the waveform. Thanks for the h

  • Filtering on a dimension table

    Hi all, I am trying to bring in a field from a dimension table-to be used in my mapping. This is based on a condition.(All attributes belong to the same level in the dimension). I brought in the dimension using the 'dimension' operator and tried to '

  • SAXParser reading external Schema - how to add addtional namespaces

    Hi, I have an application where the XML-Schema has to be read from somewhere else if the XML file does not have a reference to a Schema. Usually, my XML-file starts with: <ODM xsi:schemaLocation="http://www.cdisc.org/ns/odm/v1.2 ODM1-2-0.xsd" xmlns="

  • Adobe Captivate 8.1 - Player options

    Very new to Captivate 8.1 We have a slide that kicks off our course.  If they click the Watch Lesson button it plays a video.  Once the video plays, there appears to be two player controls.  Is there a way to remove the one that seems to control the