My ipod classic 6th gen. has a dark blinking screen with lines over it.

My ipod classic 6th generation has a dark blinking screen. Any suggestions?

Greetings MarkSaved1989,
Thanks for visiting Apple Support Communities.
If your iPod only shows a blinking screen, first try to reset it using the steps at this link:
Reset your iPod - Apple Support
If the iPod can't be reset using these steps, try restoring using the instructions found here:
Restoring iPod to factory settings - Apple Support
Best Regards,
Jeremy

Similar Messages

Does iPod Classic 6th Gen support a headphone remote for pausing/playing, adjusting volume, and advancing the track?

I know that the 7th Gen does support this feature, and my iPod video (5th Gen) does not.

The listing for Apple's EarPods
http://store.apple.com/us/product/MD827LL/A/apple-earpods-with-remote-and-mic
under Compatibility, shows it supporting back to "iPod classic 120GB (2008)."
The official list of iPods does not actually name iPods after the 5th gen model by a "gen" name, but if you look at the list
http://support.apple.com/kb/HT1353
it is clear which one "iPod classic 120GB (2008)" refers to. There is an earlier "iPod classic" ("6th gen") model from 2007 that is apparently NOT supported by the EarPods. But it's possible that Apple's older headphones with remote control works with it.

My ipod nano 6th gen has white screen

please help my ipod nano 6th gen has white screen and wont go away, ive put into disk mode (dfu) and restored on itunes and still no resolution....ive tried hard reseting and still nothing

It might also be a good idea to let the iPod's battery fully drain. Then charge it back up and restore it once more in iTunes.
Otherwise, it's likely a hardware issue with the iPod's LCD display, meaning you'll need to take or send your iPod in for service either via Apple or a third party repair service. Here is Apple's repair pricing.
http://www.apple.com/support/ipod/service/prices/
Note that they don't actually repair the device, but exchange it for one of the same generation, model, and capacity. A third party service will actually replace the damaged part for a little less. Google "iPod screen repair" and you should get a number of results to work with.
B-rock

My ipod nano 6th gen. is showing a blank screen

My ipod nano 6th gen. is showing a blank screen and nthing happens while pressing volume down button and on or off button HELP PLEASE.........

Same issue. Have tried connecting it iTunes to see if it's recognising it for restore?

Hey, the stand-by button on my iPod nano 6th gen has been randomly stuck/pushed into the ipod were it does no longer work. How do i fix it?

Hey, the stand-by button on my iPod nano 6th generation has been pushed into the iPod, I guess after being pressed a lot, to the point were it doesn't work, what do I do to fix this???

You'll need to take or send the iPod in for service or repair either via Apple or a third party company that does repair work on iPods.
B-rock

160GB ipod classic 6th gen cant be recovered by itunes 12

My 160GB iPod Classic (6th Generation) cannot be recovered by iTunes 12. I plug the iPod into my Macbook Pro and it shows up in Finder. Then an iTunes message appears: "iTunes needs to prepare your iPod for recovery. Please leave your iPod connected." Then it is says that it is preparing my iPod for Recovery and then that dialog window closes and the iPod screen is a flashing Circle with slash and the line "Do not disconnect." under it. At this point the iPod is not visible in the side bar in iTunes 12 and this message goes on with no progress. I have left it for a while doing this and there is no change. After a while I'll disconnect and it if I try again the same thing happens. I have a dual-booted computer with both Mac OS Yosemite and Windows 8.1 and on the Windows 8.1 side iTunes is able to restore and set-up the iPod, therefore I know the iPod, the USB, and iTunes are all working. All my music is on my Mac side though, so I need to get this working on the mac side. I need help getting iTunes 12 on the Mac Side to restore my iPod.
Thanks in advance for help!

disk utility is normally correct. you can try putting ipod in disk mode and control + click > get info on the ipod. see what the capacity is and it should have the 160 GB. in disk utility you can try verify disk. I would try to return the hard drive.

My new iPod Classic (6th gen) is completely frozen. Should I send it back?

My iPod seems to be defective. I just upgraded from my last iPod classic (4th gen) to the newest model for more space, so I now all the tips and tricks to reset and restore a malfunctioning iPod. I have tried everything: checked the hold button, reset it, connected it to various adaptors, connected it to the computer, but nothing seems to work. I bought it maybe two weeks ago, and I don't have the receipt (stupid move, I know), so I'm wondering, since I registered the product, if I can send it to apple for fixing or replacement. Thanks.

I'm an idiot. Thanks to anyone that was willing to help anyway:)

TS1363 My iPod nano 6th gen has stopped syncing with my laptop (windows 8)

My iPod nano 6th generation has stopped synicing with my laptop (Windows 8)
It worked fine before, but is now coming up with 'An iPod has been detected, but it could not be identified properly'
I've tried unplugging it, and re-trying, restarting my computer and uninstalling and reinstalling iTunes but it's still coming up with the same message... any help?

I've tried unplugging it, and re-trying, restarting my computer and uninstalling and reinstalling iTunes
Doublechecking. Have you tried a complete uninstall of both iTunes and all the other related software components and then a reinstall? If not, try the instructions from the following document:
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8

Receive error message, The iPod cannot be synced. The required disk cannot be found. iPod nano 6th Gen, all latest updates, Macbook Pro, with OS 10.6.7

Receive error message, "The iPod cannot be synced. The required disk cannot be found. This is a iPod nano 6th Gen, all updates on iTunes and iPod, Macbook Pro OS 10.6.7. This is getting frustrating. I have changed USB ports, cables, reset, restored and was able to sync one time in parts, not all songs at once. I have seen a lot of this same issue, will Apple please find a solution, nothing works, I think I wasted my money with this iPod. I have the iPod touch, iPod shuffle, 4th gen iPod nano, iPhone and iPad. This is the only device that has this issue.

I was actually able to investigate and solve the problem myself. After readng many posts, I found that someone else's tips worked for me:
Re: 30gb 5th gen. Probs syncing.
Posted: Oct 13, 2009 8:48 AM in response to: johnnyfrommars
Try running a disk check out the iPod using the tools provided by windows.
To do this:
1. Plug in your iPod and close iTunes.
2. Go to "My Computer". Click on the iPod drive once. Go to File, and then click Properties.
3. Go to the Tools tab. Under "Error Checking", click Check Now.
4. Check both boxes. One says "Automatically fix file system errors" and the other says "Scan for and attempt recovery of bad sectors". Place a check mark next to each of these options and hit Start.
The scan may take several minutes or more to complete, but once it has, go ahead and restart iTunes, and try re-syncing files to your iPod.
B-rock

IPod Classic 6th Gen - Distorted sound :-(

Hey folks, my friends iPod Classic 80gb 6th Generation iPod has a crappy distorted sound when tunes are played from it.
He sent it away to get fixed thinking it would be the headphone jack that was the problem - they got back to him and said that it was the Logic board at fault, and charged over £79.99 +VAT for this repair.
When it came back, all seemed to work okay, except a very short battery life.
A week later, the iPod froze with no backlight (the menu was still visible but not reacting to any button presses)
Nothing happened when the charger was plugged in, so we held the Menu Button + the Select button, and it rebooted successfully however the orginal problem came back of distorted sound....:-(
Very unhappy as £79.99 was a lot to pay for it be broken again so soon.
Can anyone shed any light onto why this may of happened?
Was he right by saying it was the logic board at fault?
Cheers
James

I haD the same issue, and was thoroughly ticked off until doing some research and then trying couple things.
I was able to change the volume limit, that WAS set at half. I adjusted it to max volume, set a lock passcode, and away I drove.
Then, upon hitting "play", I began to get a little ticked off. I realized after a few minutes, I couldn't hear anything playing.
It was so quiet- and I-95 is noisy, with me regretting buying another Apple product, after is wrote not to.
So- after reading through a couple of these threads, I just adjusted the volume limit, and VOILA!
It reverted to 50%.
So, I did a total wipe, factory-reset it as new iPod. I checked setting=>volume limit and it was at the 50% point again. First thing that I did was go to the last selection under settings menu, "reset settings" and noted it doesn't delete sync days, solely sys settings.
I adjusted the volume limit to 100% immediately afterwards, set a new passcode and then.....
Hit play.
It worked. Plays just as loud as my original 3rd Gen iTouch.
So Dylan1219, maybe try that? It's so simple, I am shocked that's how I fixed it. It had been set- and always snapped back to the 50% mark.
So, MAYBE that could solve the problem..? I have hearing loss from rock & roll and concerts, etc...so, thankfully this isn't a bunk product. Just had a bunk setting.
It has stayed at Max level for hours now, and can state it solved it for me.
I would hypothesize, all iPod classics are made the same, except for the "options" of storage and color. Maybe a small "governor" or a piece of extra firmware is added after the fact, or only "every 9th iPod" who knows for sure...?

How do you if you ipod nano 6th gen has water damage

I got an ipod 6th gen for xmas and the sleep/wake button has stopped working, i have contacted apple and they have takin my cc details are sending me a box to send my ipod back to them. i will get a new ipod if its not water damage, i asked how to tell if it was water damage or not and i was told to check where the earphones go and what colour is at the end of the docking hole, the colour on mine is a silvery white does anyone know if it was water damage what colour would it be???
Thanks in advance
Jade.

Hello Jade,
The color would be of a pink shade.
B-rock

Ipod Classic 6th gen problems with HDD upgrade

I have a Ipod 6th gen and left it in rain. I got a red X the next week after having it in rice.
Ordered a SD Card for the iFlash with SD card adapter. I still get the red X. Why? I formatted the 64GB SD with FAT32. I dont know what else to do. I also cleaned the HDD ribbon cable with rubbing alcohol and flipped the connections but still no avail.

disk utility is normally correct. you can try putting ipod in disk mode and control + click > get info on the ipod. see what the capacity is and it should have the 160 GB. in disk utility you can try verify disk. I would try to return the hard drive.

My iPod Classic 6th gen won't charge on wall charger and it's not even recognized on iMac or Windows

Hi! I hope someone can help me with this. I have had this 160 Gigs iPod Classic for a couple of years now and never had this problem before. I have tried to connect my iPod with several cables (which work fine with my iPod Touch and iPhone, by the way), two wall chargers, 2 windows computers and an iMac and none of them recognize my iPod anymore, it doesn't even appear in Disk Mode. I have also reseted it several times and still nothing.
It's was working fine but it ran out of battery now so it just says "Connect to Power" when I try to turn it on. What else can I do?

The iPod itself has bent pins or the cable?
If the connection on the doc connection inside the iPod is bent you'll need to get that part replaced.
Indeed that problem would lead to a false indication and give you the problems you just mentioned above.
Can you take a picture of the connector and upload it here?
I've repaired many iPod classics so, I think I can help you out. !!!

IPod nano 6th gen has deleted all content three times now

When I bought my new nano about 3 weeks ago I synched it up with iTunes (using Windows Vista) with no hassles. After a week or so I re-synched (as I do each day to get new podcasts) and when I unhooked the device it had no content on it. The only way to get the content back was a restore. It then worked fine then the same thing happened about 5 days later. Today the same thing has happened again. Each time I have to go through the synch summary screens and tell the machine which plyalists and audio books and podcasts to synch and of course the **** thing doesn't remember where I was up to in any of my podcasts or audio books which is extremely annoying. I'm using the same computer as I used with my old iPod classic which never had a problem like this, I'm hooking up directly from the device to the computer (not going through any USB hub or anything)...can anyone suggest why this might be happening and what I might do to ensure it doesn't happen again?

Thank you for your help, much appreciated
Summary screen has 5 options
Open iTunes when this iPod is connected - ticked
Sync only ticked songs - ticked
Convert higher bit rate songs to 128kbps AAC - not ticked
Manually Manage Music - not ticked
Enable disc use - not ticked
On the Music tab I have ticked the big sync music box at the top then in the box under that have selected the radio button for Selected playlists, artists and genres. There is nothing else ticked in that top box. In the boxes underneath I have only got ticked items in the playlists box
On the Podcasts tab I have ticked the big Sync podcasts box at the top and have it set to automatically include all unplayed episodes of selected podcasts then in the box below that I have ticked the podcasts I play on this iPod
On the Audiobooks tab I have ticked the big Sync Audiobooks tab at the top and have selected the radio button for selected audio books. The in the box below that I have one or two books from my library ticked at any one time.
On the Photos tab I have nothing ticked.

How can I use my iPod Classic (6th Gen) as a voiice recorder?, How can I use my iPod Classic (6th Gen) as a voice recorder?

I just bought an iPod Classic, and in the shop, the demo model had a "Voice Recorder" option on the menu, and I read somewhere that my ipod could be used as a voice recorder, and I was just wondering how to do this? Do I need a microphone??

Yes, you'll need to purchase a microphone for it. Just do a simple Google search for iPod Classic microphone, and should get a number of good hits. Here is one such product that would work.
http://store.apple.com/us/product/H3295VC/A?n=ipod6_3&fnode=MTY1NDA3NA&mco=MTk5O Dk3NDU&s=topSellers#compatibility
B-rock

My ipod classic 6th gen. has a dark blinking screen with lines over it.

Similar Messages

Maybe you are looking for