My iPod doesn't get the advertised Battery Life.

I have had this 4th generation iPod for a few months and at first it started out great, but now it's battery life has decreased significantly. I now only recieve a little over a day on standby. I always shut down the running apps via the multitasking bar. It really irks me that the battery doesn't last as long as it used to because before I could leave the apps on without worrying about the batterlife and I would get a good 3 days on standby. Now I have to turn everything off and I only get one day. Does anyone know what is wrong? It would really appreciate the help!

Have Apple Care? Give them a call...
Otherwise, walk it into the nearest Apple Store and ask for an opinion there.
Good luck in any case.

Similar Messages

  • Not getting the advertised battery life on Macbook Pro Retina Late 2013

    Hello world, This is my first time on the forum and I finally have a question to post lol.
    So I just got Macbook Pro Retina and its only like 1 month old and Ive been getting really crappy battery life.
    Im only getting about 4 hours and 35 mins on a full charge not the advertised 9 hours like Apple says.
    What should I do to bring it to that?

    Depends on what you are using.
    Read here:
    Mac notebooks: All about batteries

  • I replaced my battery and am still getting the same battery life

    Battery Information:
    Model Information:
    Serial Number: 6N8450F7B13E
    Manufacturer: SMP
    Device name: bq20z951
    Pack Lot Code: 0000
    PCB Lot Code: 0000
    Firmware Version: 002a
    Hardware Revision: 000a
    Cell Revision: 0100
    Charge Information:
    Charge remaining (mAh): 3566
    Fully charged: No
    Charging: No
    Full charge capacity (mAh): 4215
    Health Information:
    Cycle count: 0
    Condition: Normal
    Battery Installed: Yes
    Amperage (mA): -1465
    Voltage (mV): 11824
    I just replaced my battery yesterday, but I am still getting the same battery life of about 2.5 hours. When I first got the laptop, I was getting atleast 6-7 hours.
    Can anyone tell what is wrong? The stats are from the newly replaced battery

    Hi katsoccer92,
    The first thing I suggest you do is read neuroanatomist's excellent battery FAQ at http://discussions.apple.com/thread.jspa?threadID=1764220
    New batteries can take a few cycles to work up to maximum capacity (and your figures indicate that the batteries maximum capacity is a little lower than you would expect, so maybe it still has some room for improvement).
    In a situation like yours it is important to calibrate the battery when you first get it - see http://support.apple.com/kb/HT1490 I also often recalibrate again after the first week when the battery has settled down a bit, and then every couple of months thereafter. If your battery's full charge capacity isn't up around 4500mAh after a week then it may have been old stock or otherwise defective.
    But usage patterns have a huge impact on charge life.
    If , for example, you are watching a lot more "flash" based videos on line these days then you can expect a dramatic fall in computer run time. "Flash" plugins chew up a heap of CPU time, and accordingly can flatten your battery faster than a politician can break a promise!
    Bluetooth is another real battery muncher, and so, of course, is anything like an external drive or other device powered by the computers USB or firewire ports (Elgato EyeTVs , unpowered hubs, bus powered scanners, etc etc). The internal iSight camera is a real power chomper too.
    Cheers
    Rod

  • HT3207 My Macbook Pro (Mid 2009) doesn't have the "Better Battery Life" and "Higher Performance" option?

    I'm running Lion and am in the same energy saver window but it's not there. If I could switch to higher performance I think it may solve the Quicktime 7 green screen when paused bug. Any ideas?

    Did you reset the SMC? Do this by removing the battery and all plugs connecting to your computer and holding down the power button for 5 seconds.

  • Am having problems with my Zeppelin music player and iPod classic. The Zeppelin, bought Dec '12, and the iPod, bought same time, used to work fine but now when I attach iPod to Zeppelin I get a message that says the iPod doesn't support the accesory!

    I bought a Zeppelin music player and iPod classic in December 2012, and all went well until I last synched the iPod with iTunes, and now I get a message saying that the iPod doesn't recognise the attached accessory when I try to connect it to the Zeppelin. I did recently update to the latest iTunes version-could this be the problem, and if so how do I cure it? All help appreciated.

    It's still charging when you plug it in. That just means it won't play music out the speaker. If that's what you were looking to do, they have speakers for iPods.
    -Molly

  • My ipod doesn´t charge the battery with ios6, what should i do?

    I have updated the system to ios 6, but after that change I have noted that my ipod doesn´t charge the battety, I have checked the cable with other ipod (ios5) and it´s working, also when I connect it to my computer, it can´t be detected, what should i do? I can´t find how to solve it.. please help me

    See the not-charging topic of:
    iPod touch: Hardware troubleshooting
    Look at the dock connector on the iPod. Look for abnormalities like bent or corroded contacts, foreign material and cracked or broken plastic.

  • HT4623 I have an iPod with iOS 4.2.1 and would like to up date version 5. The pc I normally sync with has XP operating system. So I can't up date to iTunes 10. And my iPod doesn't show the software update button shown in the article. What can I do?

    I have an iPod with iOS 4.2.1 and would like to up date to version 5. The pc I normally sync with has XP operating system. So I can't up date to iTunes 10. And my iPod doesn't show the software update button shown in the article. What can I do?

    You cannot update it if you can't get the latest version of iTunes. Actually, the latest version of iTunes will run in XP if you have Service Pack 2. Also, you posted in the iPad forum, and your profile shows you have an iPad, but in your post, you say it is an iPod. Is it an iPad or an iPod?

  • TS3297 when I press the iTunes button on my ipod touch I get the message 'cannot connect to iTunes store' .  My wifi is working fine, I can connect to safari & you tube, no parental setting in place, and time and date are correct. Can anyone help please?

    When I press the iTunes button on my ipod touch I get the message 'cannot connect to iTunes store' .  My wifi is working fine, I can connect to safari & you tube, no parental setting in place, and time and date are correct. Can anyone help please? I have restored my ipod to factory settings and rest it.

    I also tried moving the date forward by a year and then moving it back to normal and it still doesn't work.  i can't find an automatic update of time zones on my itouch to turn this off.

  • TA44551 my gen 4 iPod doesn't charge, the usb cable is good(works on other apple products) What should i do?

    my gen 4 iPod doesn't charge, the usb cable is good(works on other apple products) What should i do?

    What normally happens is most people take showers and listen to thier ipods or live around many sources of humidity.  Moisture corrodes the 30 pin connector on the ipod touch.  Clean and inspect the ipod touch's connection pins to resolve most charging/ sync issues.. The pins could also be dirty, bent or broken.  If dirty: Take 91% rubbing alcohol, dip a tooth brush into it, shake the excessive alcohol off leaving the brush damp(don't use to much alcohol, it should not be dripping).  Careful!!! The Pins are Very Fragile! Gently brush the connector pins, long ways, left to right in a few second bursts, inspecting the pins as you go...   If you have an eye loop or magnifying glass you can see inside the connector easily and see if the pins look dirty or bent or broken.  If they are bent you have to VERY GENTLY stand them back up.  If they are bent very far down, chances are you will snap them off trying to straighten them back up.  If they are not severely bent over, use a very small flat head precision screw driver to bend the pin back parallel with the good pins.  Pease note: certain pins are used by the wire for different things such as sync or charging... If your pins are broken off, do a search and find out what the individual pins on the ipod 30 pin connector do to see what is affected.  Worst case is your pins are broken off.  U can attempt to solder the broken pins back on without opening the ipod touch, which is super difficult to do, or you can open the touch and repair/replace to 30 pin connector entirely.  U will need to do some micro soldering to say to least! Don't attempt unless you are confident in your soldering skills and research how to open an ipod touch? You will need some specific tools and watch out for floating LINT!  Get some canned air ;) use a small 1/2 second bursts from 4-6" away because it will steam up you touch if used for to long. Good luck!

  • My ipad2 is getting lazy with the wifi. On any router it doesn't get the signal by itself, unless I'm so close that the pad and the antenna are touching. Other solution, to turn off and on again the wifi button on the iPad. This strange behavior is new...

    My ipad2 is getting lazy with the wifi. On any router it doesn't get the signal by itself, unless I'm so close that the pad and the antenna are touching. Other solution, to turn off and on again the wifi button on the iPad. This strange behavior is new, before my iPad was blazing fast at getting any known wifi connection. Sme help please ??

    it sure sounds like the battery is defect

  • Can not update or restore my ipod touch, keep getting the error message 13019

    can not update or restore my ipod touch, keep getting the error message 13019

    Start here:
    iTunes: Error 13019 during sync

  • When updating my ipod Nano, I get the error message Unknown Error 9006. Any help is appreciated.

    When updating my iPod Nano, I get the error message: Unknown Error 9006.  Any help is appreciated. 

    See this
    http://support.apple.com/kb/TS3694#9006

  • Trying to update my ipod but i get the error message network timed out.  I've already uninstalled and reinstalled the latest version of itunes. I also do not have software update in settings on the ipod. How do i get the ipod to update?

    trying to update my ipod but i get the error message network timed out.  I've already uninstalled and reinstalled the latest version of itunes. I also do not have software update in settings on the ipod. How do i get the ipod to update?

    Try the manual method specified here:
    iDevice Troubleshooting 101 :: iPhone, iPad, iPod touch

  • HT1363 my ipod doesn't show the black screen . it immediately shows the apple logo

    i want to put my ipod into disk mode and when i reset it my ipod doesn't show the black screen . it immediately shows the apple logo

    The iPod touch does not have a disk mode.
    This is the iPod touch forum

  • I can't connect my mac to my TV, I have the right cables and have done it right but I still doesn't get the macscreen on the Tv, what should I do?

    I can't connect my mac to my TV, I have the right cables and have done it right but I still doesn't get the macscreen on the Tv, what should I do?

    What are you getting on the TV?  Are you getting a completely blank screen, or are you getting a message similar to 'no input detected'?  Or are you seeing the spiral galaxy desktop?  If you go into System Preferences -> Displays then do you have an 'Arrangements' tab?

Maybe you are looking for

  • Creating a dvd

    Is there a simple way to create a dvd from a sony handycam other than the iMovie? I find it comlicating to transfer the scenes from the camera and then how to make it work as a continious movie?

  • Icondom,  where can I buy it?

    Hi, seems that every one here using the Icondom protector, where can I find it? thanks John

  • CREATE TYPE address_type AS OBJECT - ERROR

    I am not able to create type objects tried with different versions of oracle too. Currently I am using Oracle 11g enterprise edition (2.9GB). The problem is when i create a TYPE object and when i terminate the command with a semicolon ';',oracle sql

  • How to use ClassPath defined in META-INF/MANIFEST.MF in an EAR

    Hi, We have an EAR Shared Library (Name = AA) deployed in Weblogic. EAR contents are like -> APP-INF/lib/directoryA/<<50 JAR Files>> META-INF/MANIFEST.MF --->> Has Class Path to above JAR files, Spec Version, Impl Version etc META-INF/application.xml

  • Advantages of GOA

    Hi All, What are the advantages of using Global Outline Agreements in SRM. As per my knowledge 1. We can distribute to multiple backend system, but my client have only one backend. 2. We can create backed contracts and SA using GOA from Bidding. Are