My ipod is locked ause i put an app on and it will not unlock
i have ilock on my ipod and it will not unlock what should i do
Connect the iPod to its syncing computer and restore via iTunes. If iTunes asks for the passecode and you can't enter the passcode or if you do not have the syncing computer, place the iPod in recovery mode and then restore. For recovery mode see:
iPhone and iPod touch: Unable to update or restore
Similar Messages
-
Suddenly 2 of my apps (Facebook and Skype) will not function on my ipod touch. They just close down when I touch the ikons.
If that does not work try resetting your iPod:
Reset iPod touch: Press and hold the On/Off Sleep/Wake button and the Home
button at the same time for at least ten seconds, until the Apple logo appears. -
its stuck please help i just bought my new ipod touch 4g less than a month ago. and now im scared its like broken forever.
Just restore it.
It will restore to the latest available software -
HT1320 My i pod is locked and it will not unlock nor run down. What do i do?
Question.
My i-pod is locked andwill not work nor run down.
What do I do?What do you mean by locked? Is it frozen or has the hold switch been enabled? Is there a little padlock on the iPod's display?
B-rock -
TS3992 ipad locked up with instructions to back up, but ipad will not unlock - help
Ipad is locked up with instructions to back up, how do I get it unlock to back up cloud?
Perform a Reset...
Reset ( No Data will be Lost )
Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
http://support.apple.com/kb/ht1430 -
Yes, my cousins iPod is disabled. It says "ipod is disabled, connect to iTunes", I did that and it will not connect to iTunes, because it needs the pass code. The pass code key board will not show up and I cant connect. Please help me figure this problem out, my cousin is depending on me. Thanks, a concern customer.
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings -
I'm assuming I'm screwed here. I locked my iPod and it will not unlock. I can't use the click wheel or centre button at all. I've tried charging, syncing and restoring the factory settings and nothing had worked. Any help or advice would be much appreciated.
Did you try a Reset? Hold the top and center buttons together for up to 10 seconds. Look fo rthe Apple logo to appear. You may have to try this several times. Might not work...but it can't hurt.
-
My daughter has changed her ipod touch password and it will not allow her to put in letters so therefore she is locked out! How can she fix this?
Connect the iPod to its syncing computer and restore via iTunes. If iTunes asks for the passcode and you can't enter the passcode or yu do not have the syncing computer, place the iPod in recovery mode and then restore. For recovery mode see:
iPhone and iPod touch: Unable to update or restore -
Had my ipod locked and put it on charger, now it will not even turn on and does not even register connected to the puter? Any ideas???
You just need to reset the ipod by holding down the sleep button and home button for ipod touch or the menu and centre button on others for about 10 seconds
-
my ipod touch is locked up we dont know how it happened and it will not restore also could i trade a ipod touch 3g for a 4g and pay the rest for it
my sister got on my ipod and i have never put a passcode on it but we bought it from someone and havent had it long and i've tried to restore it and it said it needed a update. it update but it didnt restore, i tried it agian it did the same thing
how much would be 10% oof it -
ok guys i need help anyone with my ipod it froze during an update now it will not work at all i ahve put it into the recovery mode or dfu and it will not reset it self it comes up with an error message 1603 the number is and says the ipod cannot be reset anyone please help me i have tryed everything googled you tubed everything
Error 1604
This error is often related to USB timing. Try changing USB ports, using a different dock connector to USB cable, and other available USB troubleshooting steps (troubleshooting USB connections. If you are using a dock, bypass it and connect directly to the white Apple USB dock connector cable. If the issue persists on a known-good computer, the device may need service.
If the issue is not resolved by USB isolation troubleshooting, and another computer is not available, try these steps to resolve the issue:
Connect the device to iTunes, confirm that the device is in Recovery Mode. If it's not in Recovery Mode,put it into Recovery Mode.
Restore and wait for the error.
When prompted, click OK.
Close and reopen iTunes while the device remains connected.
The device should now be recognized in Recovery Mode again.
Try to restore again.
If the steps above do not resolve the issue, try restoring using a known-good USB cable, computer, and network connection.
Error 1600, 1601, 1602
Error 1603
Follow the steps listed above for Error 1604. Also, discard the .ipsw file, open iTunes and attempt to download the update again. See the steps under Advanced Steps > Rename, move, or delete the iOS software file (.ipsw) below for file locations.If you do not want to remove the IPSW in the original user, try restoring in a new administrator user. If the issue remains, Eliminate third-party security software conflicts. -
i put an emoji in my ipod name , and itunes will not recongize my ipod. could the emoji be the cause to my problem? what should i do?
If you think the emoji is the cause of the problem, why not remove the emoji from your name?
-
my iphone 4 will not charge in the plug or connect to my laptop but my ipod 4th gen does. what could the problem be because the screen to show it needs charging will not come up and it will not restart by holding the home button and lock button. thanks
Hi there,
I would recommend taking a look at the troubleshooting steps found in the article below.
iPhone: Hardware troubleshooting
http://support.apple.com/kb/ts2802
-Griff W -
I have a white ipod touch 4 and it will not go into DFU mode. I know I am doing it right as I have 2 other black ones that I can put into DFU anytime no problems. The ipod works perfect besides that. Can anyone help?
DFU or Device Firmware Upgrade mode allows all devices to be restored from any state.
Above from:
DFU Mode - The iPhone Wiki -
My daughter locked my iPod with a code and now she does not remember it It is locked and it will not work connected to iTunes
Locked Out, Forgot Lock or Restrictions Passcode, or Need to Restore Your Device: Several Alternative Solutions
1. iOS- Forgotten passcode or device disabled after entering wrong passcode
2. iPhone, iPad, iPod touch: Wrong passcode results in red disabled screen
3. Restoring iPod touch after forgotten passcode
4. What to Do If You've Forgotten Your iPhone's Passcode
5. iOS- Understanding passcodes
6. iTunes 10 for Mac- Update and restore software on iPod, iPhone, or iPad
Forgotten Restrictions Passcode Help
You will need to restore your device as New to remove a Restrictions passcode. Go through the normal process to restore your device, but when you see the options to restore as New or from a backup, be sure to choose New.
Also, see iTunes- Restoring iOS software.
Maybe you are looking for
-
Wakes from sleep while lid closed
I got my MBP three weeks ago and I have noticed that when I have the lid closed and it is sleeping and I set it down it begins to make noise and when I open the lid I see that has already come out of sleep mode. I know that the MBP's have a motion se
-
Commercial Invoice in not Popping up during MIGO
Against One Purchase Order I have performed Planned Delivery cost of imported material with T. Code MIRO for 1000 No Qty. Now first i have done Goods Receipt of only 500 no and while doing this commercial invoice window popped up (which was generate
-
-->i have getting assignment to debug the j2ee project . -->but i am unable to capture jsp related errors. -->how can I debugg project by which I can eliminate errors related jsp from my project. -->while I am using ecllipse editor . Message was edit
-
Hi Friends, Can any one provide me some inputs on 1.How to install MDM. 2. On DBMS settings. Thanks & Regards, Vinay Yadav
-
Dolby Digital 5.1 pass-through and Quicktime
All, I have found a perplexing issue and I'm not sure what to make of it. I have some movies which, if played through my AppleTV and receiver, outputs Dolby Digital 5.1 quite nicely. If i take the same exact movie file and play it through Quicktime o