My iPod is locked now after being connected to my JVC receiver in my truck?

I have had my ipod connected via the usb to my JVC recevier in my truck. It has been like this for sometime as I dont always take it out the truck or unplug it from the receiver all the time. The other day after starting the truck the JVC screen said " no usb" and the ipod froze up,it would not do anything. It does not work connected to my mac or anything else. Can the ipod be unfrozen so to speak or is it toast?

Well hopefully it's not toast but if you can't restore via USB on your Mac...  you could try taking it to an Apple store or Apple certified repair shop. Make sure the battery is charged before connecting the iPod to your Mac then try the 5R's here >  Apple - Support - iPod classic Troubleshooting Assistant
For iPod >  Apple - Support - Service Answer Center

Similar Messages

  • IPod Touch 5 jitters after being connected to Bose Series III

    iPod Touch 5 music jitters after being connected to Bose Series III

    Reset the Bose device
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings      
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up           
    - Restore to factory settings/new iOS device.

  • IPod loses "Last Played" after being connected to another computer

    I've done a lot of searching on this, but it's a hard thing to search for since it's difficult to explain. Hopefully someone has heard of this before. If it's already been posted somewhere, I apologize.
    Basically, I sync my iPod classic 80gb with my work computer. I use a lot of smart playlists to manage what I listen to. "Last Played" is an integral part of my smart playlist system.
    If I connect my iPod to any computer other than my work computer, the iPod will forget any of the songs I listened to since the last time I synced. I would like to be able to use the iPod as a portable hard drive, but when I do I lose this information. I just tested this to be sure, but when this happens, I don't lose any ratings that I've given to songs since my last sync. So far I've only noticed "Last Played" being dropped.
    Any information would be a huge help. Thanks!

    Disabled
    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                         
    If recovery mode does not work try DFU mode.                        
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings        
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: How to back up     
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload most iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store        

  • Ipod disconnects immediately after being connected to computer

    Every time I plug my iPod into my computer it says "Connecting" then it says "Ejecting" and then "OK to disconnect"! WHY????? It does not show up in the sidebar in iTunes, and it does not show up in My Computer.
    I have plugged it into every USB port on my computer, none of them worked
    I have already updated iTunes.
    I have already put the iPod in disk mode.. that did NOTHING.
    I know it's not a problem with my USB ports, because other devices work JUST FINE in them
    I know it's not an issue with the USB cable because I plugged my iPod into another computer and my iPod did not disconnect right after being connected
    PLEASE help me get my iPod to work on this computer. And I don't want answers telling me to use the other computer. My Library is on THIS computer. Not only that, iTunes doesn't even work on the other computer.

    Reset the Bose device
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings      
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up           
    - Restore to factory settings/new iOS device.

  • Hi I recently dropped my ipod touch and now it wont connect to itunes. Everytime i plug it in, i get an error message saying that the usb device is not recognized

    hi I recently dropped my ipod touch and now it wont connect to itunes. Everytime i plug it in, i get an error message saying that the usb device is not recognized

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar                                     

  • My ipod feel and now everytime i connect it 2 my computer i fet the n/a on my desktop n when i go to restory it ... it say error 28 n the screen is black but when i do the recovorey steps the screen still looks the same so i dnt think it a black screen

    my ipod feel and now everytime i connect it 2 my computer i get the n/a on my desktop n when i go to restory it ... it say error 28 n the screen is black but when i do the recovorey steps the screen still looks the same so i dnt think it a black screen so idk if the fireware is messed up or what n idk if it broking or what n if ipod store will take it n give me a new 1

    From the link at the bottom of my post:
    Error 23, 28, 29: These errors may indicate a hardware issue with your device. Follow the steps in this article. Also attempt to restore while connected with the white USB Dock Connector cable that shipped with your device, on a known good computer and network to isolate this issue to the device. The MAC address being missing or the IMEI being the default value, (00 499901 064000 0), can also confirm a hardware issue. Out-of-date or incorrectly configured security software can also cause these errors
    iOS: Resolving update and restore alert messages
    I would do what the article and if unsuccessful make an appointment at the Genius bar of an Apple store since you likely have a hardware problem.

  • I selected restore factory settings on my ipod touch but now after restart it stuck on apple icon what will i do anybody help me out plz,even it's not appering on itunes on my p.c

    i selected restore factory settings on my ipod touch but now after restart it stuck on apple icon what will i do anybody help me out plz,even it's not appering on itunes on my p.c

    Try:
    - iOS: Not responding or does not turn on
    - If not successful and you can't fully turn the iPod fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.

  • HT201412 My iPhone 4S stops charging a few seconds after being connected to the USB, it will, however, charge when it is switched off.

    iPhone stops charging a few seconds after being connected to a USB slot, it will charge when switched off is I think it must be a software issue.

    HAve you tried using a different power chord? If the power chord is not the issue, it could be the power supply inside your mac.

  • My ipod always freezes now after i restored it ?

    my ipod always freezes now after i restored it ?

    If you have the problem after restoring the iPod to factory defaults/new iPod then you likely have a hardware problem and an appointment at the Genius Bar of an Apple store is in order.

  • IPod Touch shuts off after being locked 4 a while

    Hello, My iPod touch 4th generation will shut off after being locked. Sometimes when I lock it for 3 minutes it'll shut off I will click the sleep/wake button or home button and it'll do nothing, So I have to reset it by holding sleep/wake button for 30 seconds or something. One time I set a alarm for 3 minutes and it went off and it showed on the iPod's screen and froze! What I did was: settings, general, auto-lock and put to never because if I'll let it lock for more than 3 or 5 minutes it'll shut off. Any one know a reason this might be happening?
    Thanks for reading

    Try:
    - Reset all settings                            
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                               
    iOS: Back up and restore your iOS device with iCloud or iTunes      
    - Restore to factory settings/new iOS device.                       
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar                                                              

  • IPod doesn't work after mac connection

    i don't know why my mini ipod doesn't work anymore (it doesn't read the songs!) after i connected it with an imac g3. i started my ipod with a pc... and transfered a program for mac with it... then i connected it with the mac and now it doesn't read the mp3... suggestions?

    Try to do a Reset and a Restore, bear in mind please make sure that you have all the music with your iTunes on your computer, as doing a Restore will erase all the data in your iPod

  • My ipod touch locked on display itunes connection

    Hello,
    I bought my ipoud touch 8gb last week and at the first time I connect it on itunes, my ipod results locked.
    I try to unlocked it, but now I cant put into my music...the bottom "apply" result unaviable...
    please can help me!!!!

    What do you mean by locked?
    Do you mean that it asks for the passcode to to unloce the screen so you canuse the iPod?
    Are you connecting the iPod to a computer other that one you used last time?

  • Flash drive no longer works after being connected to a Windows XP machine.

    After being opened on a Windows XP machine, the contents of my flash drive now shows up on my Macbook pro as a single .lnk file. What happened? It's MS-DOS (FAT32).
    Is there any way out of this or has all my data been lost? I've never experienced this issue previously.

    Thanks. I've now scanned it with both Sophos and ClamXav and both have come up negative for infection.
    At least while the scan was running I could see that all my data is still there as the name of each file appeared as it was going through the scan.
    My efforts to sort this out seem to have made things worse as now it opens up word whenever I try to see the contents. I'll try it on a PC tomorrow and see if I can figure out what happened. Looks like the file system has been damaged in some way.

  • Connecting ipod nano to pc after being on a mac

    help me please just got new labtop ipod will not connect when i first got it was connected to a mac
    ipod nano 1gb first generation    

    You need to restore the iPod on the PC or use software such as XPlay to use your iPod with the PC.
    (18456)

  • Airport not showing "lock" on wifi after being connected to a secured network

    Our power went down and I had to set-up our router once again....
    I created the secure wifi SSID on the Linksys router....my MacBoo Pro sees the network "with the lock icon" indicating it has been secured properly, I am prompted for the WEP password and upon entering it connect fine to the secured network.
    What is stange is when I look under my wifi connections its shows the SSID that I am connected to but does "NOT" show the lock icon.
    Has anyone else seen this....I have never had this happen before.
    Thanks,
    Derek

    I have had similar problems. I had a time machine malfunction. Went back to Airport Extreme and creted a new network. It works for fine for a while. Then I come back the next day its not working.  Asking for a Apple 80211 Agent. Entered password and won't work. I then started from scratch restting the airport. It works fine. I then create a password WPA2 and it accepts it but I can't lock changes. I also click the need a password to change networks, but it is automatically going to another network. I have deleted that network form my list. Still can't lock the changes.

Maybe you are looking for

  • My ical will not open

    I instailled .mac but it was 04 editon and ever secne then it will not open and the image has change to two peices of paper with a pen and a ruler and a burah i have tired to reinstaill it but it says try insatilling it again plaese help

  • How do I add my another Ipod to my Itunes?

    I currrently use Itunes with my Ipod Nano. I recently got another Nano for my daughter. She was initially set up on another computer/Itunes, but now we want to manage her Ipod using my Itunes. How can I manage her Ipod and only load a specific play l

  • ITunes 11.1 for Windows 64 bit not downloading, says a problem occurred with the installer.

    iTunes starts to download and the pop-up asking to allow Apple Inc. to make changes to the hardrive comes up but the installer then says "The installer encountered errors before iTunes could be configured. Errors occured during installation. Your sys

  • Refresh view for snapshot

    Hi I have a problem with xml import. I'm using InterfacePtr<ICommand> importCmd(CmdUtils::CreateCommand(kImportXMLFileCmdBoss)); to import xml in tagged document but I try to make a snapshot directly after : CmdUtils::ProcessCommand(importCmd); The t

  • Some DSC developing relating questions

    Hi, I am new with DSC and have some questions relating to building the custom periodic I/O DSC server: 1. After building the custom VI and implementing it as an I/O DSC server, I found there are some mistakes inside the custom VI. I would like to mod