My ipod is stuck on erase mode

my ipod will not turn off after i hit the erase all data thing in settings

Try:                                               
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable       
- Try on another computer                            
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar                                     

Similar Messages

  • HT4623 my ipod is stuck in recovery mode?How do I repair

    M ipod is stuck in recovery mode after update, how can i repair without losing my info

    Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
    Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
       1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
           other end of the cable connected to your computer's USB port.
       2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
           until the red slider appears, then slide the slider. Wait for the device to turn off.
                  * If you cannot turn off the device using the slider, press and hold the
                    Sleep/Wake and Home buttons at the same time. When the device turns off,
                    release the Sleep/Wake and Home buttons.
      3. While pressing and holding the Home button, reconnect the USB cable to the
           device. The device should turn on. Note: If you see the battery charge warning,
           let the device charge for at least ten minutes to ensure that the battery has some
           charge, and then start with step 2 again.
      4. Continue holding the Home button until you see the "Connect to iTunes" screen.
           When this screen appears you can release the Home button:
      5. If necessary, open iTunes. You should see the following "recovery mode" alert:
      6. Use iTunes to restore the device.
    If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
    Additional Information:
    If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
    Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information.

  • I plugged IPOD in to sync ( first time in over a year) it auto started with the "Do Not Disconnect", but did not sync.  Now the IPOD is stuck in that mode, won't shut off, won't sync, won't work.  is there a way to reboot it?

    I plugged IPOD in to sync ( first time in over a year) it auto started with the "Do Not Disconnect", but did not sync.  Now the IPOD is stuck in that mode, won't shut off, won't sync, won't work.  is there a way to reboot it?

    It has already been 6 days from your post, my apology for responding so late, but it is my habit to help only the leftovers, which the other contributors missed.
    Toggle the hold switch make sure there is no red showing.
    To reboot an iPod. (Or RESET in Apple iPod jargon)
    Press Menu and Center button for about 10 secs till the Apple logo comes ON , this would not erase any data from your iPod.
    I would advice you to leave the iPod charging for about 4 hours, if it has been discharged for 1 year or more, and also Apple recommends that you charge the iPod at least once a month, to prevent a discharged battery leakage, which may corrrode the circuitry in the iPod.
    Hopefully you don't get the dreaded RED X on the iPod screen.
    Good Luck!

  • HT1212 My iPod is stuck in recovery mode and it keeps asking me to input my passcode which is impossible if it's stuck in recovery mode.

    My iPod is stuck in recovery mode and it keeps asking me to input my passcode which is impossible if it's stuck in recovery mode.
    HELP!!!!

    Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
    iOS: Wrong passcode results in red disabled screen                         
    If recovery mode does not work try DFU mode.                        
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings        
    For how to restore:
    iTunes: Restoring iOS software
    To restore from backup see:
    iOS: How to back up     
    If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
    You can redownload most iTunes purchases by:
    Downloading past purchases from the App Store, iBookstore, and iTunes Store        

  • Ipod touch stuck in recovery mode and will not restore. error code 3194

    ipod touch stuck in recovery mode, will not restore and comes up with error code 3194, itunes is up to date, please help

    Hi @rchangel - Thanks for the ideas...
    Yes - it won't let you install the 32 bit version on a 64 bit machine.
    I've had a cursory look at the SP1 release notes, and couldn't spot anything vital - what critical stuff do you know of in SP1?
    I don't want to have to go through all the pain of setting up VM's, reinstalling iTunes, getting all my album art back in etc. (though I could, as I do have Win7 pro). I've also heard that running iTunes in Windows 7 compatibility mode might help. Can anyone confirm whether that actually works?
    I think it's in Apple's gift to fix this issue, given that they say that they support Windows 7. So far I've had no feedback from a mail I sent to Apple, and the number of users reporting this problem keeps going up and up.
    I want Apple to recognise that there is a problem, and then I want them to fix it.

  • My Ipod is stuck in recovery mode with the plug in to itunes thing on the screen I tryed to restore it but I keep getting a error 28 and I tryed to do the reset thing but it did not work what do I do?

    My Ipod is stuck in recovery mode with the plug in to itunes thing on the screen I tryed to restore it but I keep getting a error 28 and I tryed to do the reset thing but it did not work what do I do?

    Hi,
    You could see if this helps...
    DFU Mode / Unable to Update or Restore
    http://support.apple.com/kb/HT1808
    DFU Mode
    Open iTunes and Connect the iPod to your Mac
    Press and Hold the Sleep/Wake Button and the Home Button at the Same Time
    After 10 Seconds release the Sleep/Wake Button until iTunes tells you it has Detected an iPod in Recovery Mode...
    The Phone Screen will remain Black... Now Restore.
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414

  • TS1538 Ipod is stuck in recovery mode, and not recognized by iTunes. Tried all of the recommended resets and combinations mentioned, but the ipod is still not recognized.  Genius said it may be a hardware error, but all of the buttons and cords work. Now

    iPod is stuck in recovery mode, and not recognized by iTunes.
    Tried all of the recommended resets and combinations mentioned, but the ipod is still not recognized.  Genius at apple said it may be a hardware error, "The button is broke" but all of the buttons and cords work and i proved it to him. He then said he doesnt know, ma Now what?

    If it does not work on other computers then I agree with the Genius

  • HT201210 my ipod is stuck in recovery mode, how do I restore it?

    my ipod is stuck in recovery mode, how do I restore it?

    What happens when you connect the iPod to your computer and restore via iTunes?
    iTunes: Restoring iOS software

  • I have an 1st Generation Ipod Touch stuck in recovery mode.

    I have an 1st Generation Ipod Touch stuck in recovery mode. Error message shows "The Ipod "Ipod" could not be restored.  An unknown error occurred (1).  No back up.

    ERROR (1)
    - Place the iPod in DFU mode and then restore
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - Try on another computer
    - Try another cable           
    - Also, confirm your security software and settings are allowing communication between your device and update servers.
    - https://discussions.apple.com/thread/5922457
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar     

  • TS1441 ipod touch stuck in recovery mode

    attempted to upgrade to OS8 and my ipod touch is stuck in recovery mode

    The best way to get out of this situation is to use a well-known tool called TinyUmbrella.
    First of all download TinyUmbrella  http://thefirmwareumbrella.blogspot.in/
    Now, making sure your device is connected to your computer, launch TinyUmbrella
    It will automatically detect that your iPod is stuck in recovery mode
    Select the Exit Recovery button and it should throw your iPod touch out of recovery.
    Alternatively, you can right-click on your iPod name from a list at the side
    of TinyUmbrella and select Kick out of recovery.

  • HT201210 ipod touch stuck in recovery mode...try updating says server not available try again later

    ipod touch stuck in recovery mode...try updating says server not available try again later

    Try:
    iTunes for Windows: iTunes cannot contact the iPhone, iPad, or iPod software update server
    It could be that the servers are down/overloaded

  • My ipod is stuck on hold mode....i tried plugging into a power source but it doesn't respond and iTunes doesn't recognize it...i also tried playing with the hold key but nothing happens...i have a iPod classic plz help :(

    my ipod is stuck on hold mode....i tried plugging into a power source but it doesn't respond and iTunes doesn't recognize it...i also tried playing with the hold key but nothing happens...plz help

    Have you tried holding the centr button and menu. This will force a shutdown.

  • IPod Touch stuck in recovery mode. Help!?

    My iPod Touch 4th Generation would not update with iTunes. Everything was up to date, so I did a back up and restore, thinking something must be wrong with the iOS. Well, now the iPod is stuck in restore mode. It acts like it wants to restore but it always fails. Help? I have tried many options. I don't need to restore it to the way it was, just to get it working again and I can start from scratch.

    Try disabling the computer's antivirus and firewall.
    - Next try the manual install method of:
    iDevice Troubleshooting 101 :: iPhone, iPad, iPod touch
    - Then try on another computer
    If you get another error message, remember the wording of the error messages. When it says unknown error, usually an error number is also given.

  • IPod Touch stuck in recovery mode and not detected in iTunes

    I was trying to update my iPod Touch (currently 3.1.3), so I downloaded the 4.3.3 firmware (I didn't want to download the 4.3.5) and connected my iPod to my computer, opened iTunes and hit Shift+Restore. Then, I chose the 4.3.3 firmware and proceeded with the restore.
    However, the following appears:
    Error 1602
    I pressed OK and the restore process stopped. But, my iPod is stuck in recovery mode. Every time I reboot it, the recovery mode shows up. It's also not detected in iTunes although my computer recognize it as iPod Touch Recovery Mode.
    Please help me solve this. I can't use my iPod.

    Error 1602: Try the following steps to resolve this error:
    Ensure proper USB isolation troubleshooting has been performed, and test with a known-good cable.
    Follow the steps listed for Error 1604.
    This error may be resolved by disabling, deactivating, or uninstalling third-party security, antivirus, and firewall software. See steps in this article for details on troubleshooting security software.
    Above from:
    http://support.apple.com/kb/TS3694
    Also, when updating/restoring an iDevice, iTunes contactact the Apple sever to verify that you have the latest iOS version.  If not, it will not allow an install if an earlier version.

  • My iPod is stuck in recovery mode with a error code 1

    my ipod is stuck in recovery mode with a error code 1

    ERROR (1)
    - Place the iPod in DFU mode and then restore
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - Try on another computer
    - Try another cable
    - Also, confirm your security software and settings are allowing communication between your device and update servers.
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar     

Maybe you are looking for

  • Exception Handling in ADF

    Jdeveloper version 11.1.1.5.0 Use Case : My application has :- 1 Jspx page ( testPage.jspx ) , 1 taskflow ( testExceptionFlow.xml ) , 1 pageFragment ( testOperation.jsff ). I have employee table dragged as table on testOperation.jsff with 4 buttons :

  • Execution Permissions cannot be required error when opening SharePoint Central Administration

    The following is the stack trace can anyone share what might be causing and how to resolve this. Execution permission cannot be acquired. Description: An unhandled exception occurred during the execution of the current web request. Please review the

  • The user Directory publishing service reported an error

    Some but not all of my users get this error when trying to connect to my CPS managed server: Directory publishing service reported an error. Error Details: End of file or no input:'Operation interupted or timed out' I've deleted, and recreated the us

  • Alternative explantations for "provider failure" with MS SQLServer plug-in.

    I am attempting to set up the SQL Server plugin. After much messing about, I have got to the stage where the agent can connect to the sql server, but all the metric collection queries show an 0x80041004 error. e.g. em_error='SELECT name,sqlservername

  • Portlet unavailable

    I'm working on the WebCenter Framework Tutorial. I was able to deploy and run my portlet in Step # 6. In Step # 7 (Adding Some Simple Logic ot the Portlet) I now get a "Portlet Unavailable" error when I try to run my portlet. I checked to verify that