My iPod isn't turning on nor is it flat because I've had it on charge for a few hours. My computer isn't picking it up and it worked fine last night.
I've never had this problem before and it was fine a few hours ago!
Try here:
iOS: Not responding or does not turn on
Similar Messages
-
This morning, my macbook pro laptop won't turn on even though the battery is charged and power cord is working. it worked fine last night. what can i do?
Try the suggestions in this support article:
http://support.apple.com/kb/TS1367
Ciao. -
My ipad2 was working fine last night, but this morning when I woke it up... it no longer was connected to my network. While it can detect networks, it cannot connect to any (have tried at home and at work). I have tried: resetting router, resetting ipad, forgetting network, renewing lease on network, ensuring airplane mode is off, resetting network settings, turning wifi on/off. None of the typical solutions I can find online seem to work. HELP!
You've gone through all of the basics. You might look at this document regarding potential issues with wi-fi environments.
http://support.apple.com/kb/HT4199
If none of that works, and if a device restore doesn't work, it's time for a trip to the Genius Bar. -
I have had Itunes on my pc for years. Worked fine last night. Today it gave me a message missing MSVCR80.dll, tried reinstalling, didn't work. Removed Itunes completely, reinstalled. Didn't work. Same message. Any fix ideas?
Click here and follow the instructions. You may need to completely remove and reinstall iTunes and all related components, or run the process multiple times; this won't normally affect its library, but that should be backed up anyway.
(99196) -
"Unable to find PPoE server" - worked fine last night!
*The set up:*
Belkin ADSL modem (with ethernet jack)
TC 500gb
MacBook Air
I have the Belkin ADSL modem (not a router) connected to the Time Capsule using an ethernet cable. When I set up the modem, I used a web based interface to enter the username/password settings for my connection. The modem connected ok, and works fine.
During the Time Capsule set up procedure, I was asked how I wanted to connect to the internet. I was given the option of Ethernet, or PPoE.
Assuming Ethernet was the correct option to use, I selected this. However, an error message was received telling me that the amber light would not stop blinking until this was resolved.
I therefore changed the setting to the only other one available, which was PPoE. On the next screen, I was asked to enter my username/password for my internet connection, which I did.
This was successful, the light went green, and I could access the internet.
That was last night.
*The problem:*
This morning, I decided to change the name from "Chris's Time Capsule" to just "Time Capsule". After clicking update settings, I am now receiving the message about the amber blinking light again. I am told this issue needs to be resolved, and I can no longer access the internet.
So I have tried chosen Ethernet from the menu again, however this does not work. Choosing PPoE no longer works now either.
I'm confused why the device has suddenly decided to not work, despite working fine last night with exactly the same settings. Also, all I changed was the name of the device- I'm suprised this has resulted in the Time Capsule not working anymore.
Can anyone perhaps suggest a solution?
Thanks in advance!
-ChrisHi Uma,
Open your SAP MMC and from menu option select file->add/remove snapin...
Click on add button and then select "SAP Systems manager".
Click next on the next screen and then specify System ID, Instance (as hostname instanceNumber) and then click on add button.
It will add this system in the list in sapmmc.
Regards,
Bhavik -
Fairly new to mac, and today my charter email account keeps asking me for password which was working fine last night when I went to bed. Now today it states that it is not the correct password and I cannot get my mail? What should I do here?
Thank youHello zeern2003
Start with the article below to troubleshoot issues with Mail sending and receiving email. You may not have to do every step, but pay attention to what is relevant. Start with using Connection Doctor to bring up a window that will tell you what could be the issue.
OS X Mail: Troubleshooting sending and receiving email messages
http://support.apple.com/kb/TS3276
Regards,
-Norm G. -
My ipod nano was working fine until i uploaded some new tunes today. It sync properly and once disconnected it just switched off and would not even turn on. I have put it on charge for a few hours but nothing happens, infact the charger is getting hot. Pleaseeeeeeeeeeee help I need my ipod.
The backlight burned out from getting it wet. You will have to replace the screen at a 3rd party shop, buy a screen and replace it yourself, or make a Genius Bar appointment at your nearest Apple Store and do an out-of-warranty replacement for $199 USD.
-
My daughters iPod touch does not turn on even after hooked up to charger for over 24 hours. Tried to hold the power button and home button at same time for 10 seconds and still did not turn on.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
Any idea why a 3 month old Ipad will not turn on? It has been charged and I haved tried the sleep/mute button and the on/off button on the front. Nothing is
happening. It was working fine last nigh?1. Hold both the Sleep/Wake and Home button down together
2. For 10 to 15 seconds
3. Until you see the Apple logo
4. Ignore the red slider
Note: Repeat it if it doesn't work the first time -
I can't get my trackpad on my MacBook to click. It was working fine last night.
I'm not sure if its the battery expanding (but since it was fine last night), it could be the battery expanding.
Apple representatives told me that the battery expands to let us know the battery needs to be replaced and when it expands the enlarged battery won't allow the trackpad to click, when your pressing it.
Clicks also won't happen when the area under the trackpad gets dirty.
Does anyone know if there is a way to check to see if the battery is good without taking the MacBook apart? Also, there is no error Exclamation Point, on the top right of the screen. That happened to my MacBook Pro, as well as an inability to click the trackpad.
Any advice is greatly appreciated, SeanKaneoheSean wrote:
Apple representatives told me that the battery expands to let us know the battery needs to be replaced and when it expands the enlarged battery won't allow the trackpad to click, when your pressing it.
That's just not correct. Swelling in the battery is caused by overheating of one or more cells in the battery, followed an exothermic chemical reaction of the anode (usually lithium cobalt oxide). It can cause simple swelling or even complete failure in the battery (including fire). It is NOT something by design to tell us that the battery needs to be replaced. It is a runaway thermal process in the battery.
Minor swelling might be ignored with no further issue. When in doubt, have the battery checked by Apple or an authorised repair centre. -
Hi,
So I have a late 2006 1.83 ghz Intel Core 2 Duo MacBook A1185. And last night I upgraded my software to Mac OS X Snow Leopard 10.6.8. And then this morning when I went to start doing work on it, my trackpad wouldn't allow me to click on anything. It would only scroll my little mouse icon around, so pretty much making my trackpad useless:/ So then I kind of had a panic attack and rebooted at least 10 times (no joke), and then remembered I had a external mouse I could use to plug in. So I plugged that in, and it worked fine as long as I didn't touch the trackpad at all. And then I got annoyed of that because it started to hurt my wrist, so I took out my battery(6 month old 3rd party battery), and then my trackpad started to work? I was slightly aggravated, and confused. So then I put the battery back in, and it stopped working again. So I am puzzled if it is just I need a better battery? Or to replace my trackpad and keyboard? Any advice would be greatly appreciated, so thank you in advance:)
ThanksOk, that's what I have done... I have Snow Leopard Installed, 10.8.6 and it's got Boot Camp 3.0.4... my questionis the Mac Windows Install Drivers you add after installing Windows. Windows looks terribly awkward and I'm guessing it has something to do with the ATI graphics card sofware the mac disk installed. Is is ok to use the one I created years ago? I can't seem to find a place to create a new one using the 10.8.6 and 3.0.4.
When I orignially installed Boot Camp you had to create a disk using Boot Camp that you installed in Windows after the initial OS installation. -
MBP won't turn on or charge, working fine last night
I've got a 2009 MBP that has been working totally fine, I was using it last night and all was well. I closed the lid, went to bed, then came out this morning to a computer that wouldn't turn on. No light on the charging cable, no response from the power button, nothing. I then plugged my MBP into another charger from my wife's MBP-- nothing. Any help would be very much appreciated!
If you push the little battery test button on the side of the computer (About the battery indicator lights on MacBook...), what does it show you?
You can try Resetting the System Management Controller, but you will most likely have to take the machine in to a service place for testing/repair. -
ICloud won't sync to my iPad. Worked fine last night!?
My iCloud works fine on my iPhone5, but it won't sync with my iPad. It started last night. I have followed the instructions on the support site, deleted and reinstalled several times and nothing. Argh! Any advice?? I have an important email hanging in the outbox. Thanks!!! :)
Is this how you sync them back to iPad? (Tap to enlarge image)
-
IPad won't turn on...worked fine last night.
iPad is blank and not turning on. Tried resetting pushing g home and sleep button
Try a reset a few more times. Make sure you see the Apple Logo.
Hold the Sleep and Home button down for about 10 second until you see the Apple logo. -
My MacBook Air 13" dors not start or receive power. And it worked fine last time I used it.
Last time I used my Mac, I upgraded my IPhone and Powered up my IPod shuffle. The 2nd before the first. I was charging my Mac. Powered off and closed it. No it is dead. And the charger does not light whilst trying to charge. Black and dead.
Take it in for service.
Maybe you are looking for
-
Can you transfer apps/songs already purchased from iTunes to iPad
Hi I used to have an iPhone where I purchased/stored various apps and song. These are now stored on iTunes as I sold my phone. Can I put these on my new iPad??? I have tried to attach my iPad to my computer and it doesn't seem to recognise its the
-
Hi All, I created a new project using EB3 to develop a photoshop extension. In that panel, I added the drop down box as follows, <body onLoad="onLoaded()"> <select> <option value="">1</option> <option value="">2</option>
-
My Notes from iPhone are not being saved to Notes in Outlook when i sync. How can I get Notes to back up in Outlook?
-
Hello, I have a problem with ExchangeServiceBinding.CreateAttachment(...) method (EWS with Office 365) When I try to add a small attachment (e.g. 5 MB), then the method works fine. When I try to add a big attachment (e.g. 12 MB), then the following e
-
Open Adobe form through workitem in UWL
Hi, We have a requirement in which a workitem is gettng generated from workflows, And it comes in UWL, So when we execute that workitem it should open a adobe form for notificaton so that approver can reject or approve that notificaton, But it is ope