My ipod leaves the conection with airport express when i start to play a music. My iphone works correctly when I repeat the same operation. What is happening?

I can'treproduce musics through the aipor express with my ipod touch

Hi there alfelippe,
You may find the troubleshooting steps in the article below helpful.
iOS: Troubleshooting Wi-Fi networks and connections
http://support.apple.com/kb/TS1398
Be sure you're in range of your Wi-Fi router (access point).
Tap Settings > Wi-Fi and turn Wi-Fi off and on. If your Wi-Fi setting is dimmed, follow these steps.
Confirm that your Wi-Fi router and cable or DSL modem are connected to power, turned on, and connected to the Internet. If not, refer to your network administrator or Internet service provider (ISP) for assistance.
Restart your iOS device.
Tap Settings > Wi-Fi and locate the Wi-Fi network to which you're connected.
Tap and Forget this Network.
Try to connect to your desired Wi-Fi network.
Note: You may need to enter your Wi-Fi password again if your network requires one.
Turn your Wi-Fi router off and on2. If your ISP also provides cable or phone service, check with them before attempting this step to avoid interruption of service.
Update your device to the latest version of software.
Update your Wi-Fi router to the latest firmware2. For AirPort Base Stations, install updates using the AirPort Utility.
Wi-Fi disconnects or signal strength is less than expected
Move closer to the Wi-Fi router (access point).
Check for sources of potential interference.
Remove any case, stand, or other accessories from your iOS device and see if signal strength improves.
Reset network settings by tapping Settings > General > Reset > Reset Network Settings. Note: This will reset all network settings including
previously connected Wi-Fi networks and passwords
recently used Bluetooth accessories
VPN and APN settings
Additional Information
Find information on connecting to a Wi-Fi network.
Some third-party routers may not be compatible with all iOS devices, even after updating to the latest firmware. If your iOS devices can successfully connect to other Wi-Fi networks, contact your router's manufacturer to ensure that your router is compatible with your iOS device
See recommended settings for configuring your Wi-Fi router for use with iOS devices.
-Griff W.

Similar Messages

IMac losing wiffi connection with airport express when sleeping. I can't wake the iMac with the remote app on the iPhone. What is wrong?

iMac losing wiffi connection with airport express when sleeping. I can't wake the iMac with the remote app on the iPhone. when i open airportconfiguration on the iphone is see that the imac isn't connected anymore. Normaly the airport express wake up the iMac but it doens't. What is wrong?

anyone knows a reason for the item above?

I have a Sony Sa ns300, will it work with airport express to allow me to play iTunes in another room?

I have a Sony NS 300 will it work with airport express?

Not from the iPad, but you can from a computer.

I have two ipods on the same account. what do i have to do to redeem itunes cards sperately to each one?

My two kids each have an ipod on the same pc on the same itunes account. now they are beggining to recieve itunes cards as gifts and want to redeem them seperately.what is the easiest/best way to do this?

None. iTunes gift cards are redeemed to iTunes Store accounts, not individual devices.
(73212)

IMac not conecting with airport express

Could you help me because i have some problems with my IMac that not connecting with air port express even if wifi signal going on....

Look for the model number on your AirPort Express. It's on the side of the device in the faint print.
It will likely be either A1084 or A1088, which are older versions of the product produced up until 2007.
If you have either of these models, AirPort Utility in the Mountain Lion operating system no longer supports these older versions of the AirPort Express.
If you have another Mac there using the Leopard 10.5.x or Snow Leopard 10.6.x operating system, you can use that Mac (or a PC) to administer the old AirPort Express.
It might also be possible to use a workaround......not supported by Apple, so success cannot be guaranteed. If you want to try that, check out this thread:
https://discussions.apple.com/message/21397085#21397085

Extend Wifi with Airport Express when Airport Extreme is in Bridge Mode

Hello,
I'm trying to make my Wifi network easier at home but Im having some trouble.
My Internet Provider installed a Router at home. So I had to connect my Airport Extreme to the IP Router via cable and setup in Bridge Mode.
In my Airport Extreme I created a Wifi Network called WIFI HOME.
Than I connected two Airport Express into my Airport Extreme via cable and created two new wifi networks: WIFI HOME 2 and WIFI HOME 3.
But, in my opinion, this is not cleaver way to have my Wifi Network setup, since I have to change networks all the time.
The problem is that every time I tried to extend my current WIFI HOME setup into one of the Airport Express, the Airport Express crashes during the setup reset and my network starts to behave wrongly.
I'm starting to think that is something related to the Bridge Mode in my Airport Extreme. but I want to check with you guys if that makes any sense.
Thanks a lot!

Power off both of the AirPort Express devices
Disconnect the Ethernet cables
Wait a minute
Power up one of the AirPort Express devices for a few minutes
Hold in the reset button on the Express for 10 seconds and release
Allow a full minute for the AirPort Express to restart to a slow, blinking amber light
Connect the Ethernet cable to the WAN "O" port on the AirPort Express if it is a two port version
Click the AirPort icon at the top of the Mac's screen
Look for a listing of New AirPort Bsee Station
Click on AirPort Express
The setup utility will open up automatically and take a minute to analyze the network. Then, it will suggest that the Express be configured to Extend the AirPort Extreme network.
Type in a name that you want to call the AirPort Express. Example........Express1
Click Next
Then, the screen message will change to indicate that the AirPort Express is being configured to extend using Ethernet.
When you see the message of Setup Complete, click Done.
The first Express is now set up and working correctly.
Set up the second Express exactly the same way........except give it a different name to avoid confusion.....Example......Express2.

When i try to reload the same data what will happen in my ods?

Hi all,
Someone has already loaded the data from flat file into the respective ods.
for instance:
customer number customer name cust address
   10001          xav          123
   10002          xac           234
And this has been loaded by some one else.
If i am going to load the same data in the ods. will it create 2 entries nor just going to be only one entry.
i meant will it be like this
customer number customer name cust address
   10001          xav           123
   10002          xac           234
   10001          xav           123
   10002          xac           234
nor like this
customer number customer name cust address
   10001          xav          123
   10002          xac           234.
Thanxs
Haritha

Hi,
If two Records of same key combination is there then over writing will happn in ODS. Within the request overwriting is done in the updation(from change log table to active data table). Within different request overwriting is done during activation(new data table to change log table) Zero record mode is doing this.
read this along with other replies
Thanks and regards
Obily

How do i use my time capsule and extend the network with airport express

I have a new iMac and Time Capsule, how do i extend the network with airport express. My time capsule does have a guest net work, and logins and passwords? I am no computer person. So for me it would have to be spelled out.

Use the search as this has been done to death ..
Bob Timmons is the expert on this.. look at his answers here.
https://discussions.apple.com/thread/4274187?start=0&tstart=0
https://discussions.apple.com/message/21856077#21856077
This has been automated in the v6 utility. I am used to doing it manually in v5 utility which is also fairly easy.
Apple doco is also good to read.
http://support.apple.com/kb/HT4145
http://support.apple.com/kb/HT4259
Note.
You cannot extend the guest network unless everything is up to date 7.6.3 firmware. And that is only with the TC as the main router in the network.
All apple routers can be configured as the main wireless or as the extend wireless.. so don't worry if a post uses express or extreme or TC.. they are for wireless, the same thing.

Itouch with airport express?

Can you use the itouch with airport express. So you can play music from the itouch on your stereo?
That would be great!

Thanks for that!
Do I navigate to the Signal website via the Safari browser on my iTouch, and then install Signal onto the iTouch? Or do I install Signal onto my desktop Mac, open the app, and then navigate to the URL provided by Signal using Safari on the iTouch?
Kurt
*There is a cunning workaround!*
*Read this article:*
*http://lifehacker.com/software/hack-attack/remote-control-your-computer-with-you r-iphone-300762.php*
*Basically you run a web server application on your Mac (remember to open the ports in 'Sharing') it allows you to log in via Safari (on the iPhone or Touch or any browser) and remotely control iTunes, which of course can be connected to Airport Express.*
*I tried Signal last night and it's pretty impressive, I haven't tried the opensource application mentioned but will do later.*
*So you'll be remotely controlling iTunes, which will probably contain more music than your iPod.*

I have an iPad 2 connected to airport express so that I can play and change music whilst I am teaching ballet class. Recently, I keep losing connection and the airport express gets quite hot. I have alway used Archos but changed to Apple for reliability!

I have an ipad 2 with airport express that I use to play and change music whilst teaching ballet class. Recently, I keep losing connection and the airport express appears to be getting quite hot. I did use Archos but changed to Apple for reliabilty! Can anyone help or should I just buy a new airport express.

I agree that it's probably interference. Only other possibility, since you mentioned it, it overheating. Is the express situated so that it is well ventilated? That is to say, not buried under other equipment and laying on its side? What does the status light do when you lose connection?
CB

Will ipod touch work with airport express?

will ipod touch work with airport express?

Is your Touch running iOS 5.n? If so, you can administer the AX with the AirPort Utility which you can download directly from the Apple App Store.

Ipod touch os4.2 working with Airport Express

hi, need some help!!!
Trying to connect ipod touch with os4.2 to airport express. when i go to use airtunes by clicking on the icon to the right of the play funtions, my touch sees my apple tv but fails to see my airport express. I have managed to connect once but now it does not appear in the list to choose from, any ideas???

That definitely helped a bit. I guess I get one more bar than I got before. However, it is still significantly weaker than the iPhone and is still a bit inconsistent. That was a very good tip though, thanks

Can i use my ipod touch with airport express?

I will be staying in a hotel that only offers hard wire internet connection. Can I use my ipod touch with airport express to have have WiFi? I won't have my computer with me.
Thanks!

Yes, you can. However, you will not be able to administer the AirPort from the iPod Touch. Thus you would need to pre-configure the AirPort Express to work at the particular hotel that you will be staying at. Note: Most hotels now offer Wi-Fi in the rooms and the Express may not be necessary.

We have a Lexmark Pinnacle Pro901 and cannot get the printer to work with airport express - any suggestions?

Can anyone give us suggestions on how to get our Lexmark Pinnacle Pro 901 to work with airport express? We cannot get airport express to recognize the printer.

Refresh all your devices before reconfiguring printer to connect to your computer.
a Shutdown computer
b Pull out printer power cord from the socket. Let it stay for at least 30 seconds then plug it back.
c Powercycle your router (unplug your router for at least 30 then plug it back. This will not change the settings of the router. This will just refresh the device)
d Once router is ready , put back brick at the back of the printer to turn it on
e Wait one minute
f Turn on computer
Repair your disk permission: http://bit.ly/OeD7U3
Run Cleanup tool http://bit.ly/vnukXY
Download updated driver from Lexmark website http://bit.ly/ToA1fo
Run firmware update http://bit.ly/AcNqbg

Configuring the time capsule airport wlan function as "connect to wlan", the time caspule gets a correct IP adress from the other wlans IP range, but does not assign this to the ethernet ports. With Airport Express it worked!

Configuring the time capsule airport wlan function as "connect to wlan", the time capsule gets a correct IP adress from the other wlans IP range, but does not assign this to the ethernet ports. With Airport express it worked, the single Ethernet port got the IP Parameters passed through!
My setup is a Vodafon Esaybox connected to ISP. Time Capsule is not able to extend the wlan of the easybox, neither airport express can do.
Only the option "connect to wlan" is succesful.
With airport express I was able to connect my Sony Bravia TV to the lan via ethernet to stream pictures, the TV set got an IP adress from the easybox.
With the time capsule the easybox dosn't find devices connected to the ethernet ports to submit IP adresses. The TV set get another IP adress (169.xxx.x.x.) in subnet mask 255.255.0.0 and I don not now where from.
My notebook is a MacBook pro.
Any idea????
Thank a lot in advance!
Kind regards
Ingo

Neverthe less, could there be the chance, that this feature could be implemnented with an firmware update?
That would appear to be a question for Apple to answer. You can make suggestions to Apple here:
Apple - AirPort Extreme - Feedback
If the AirPort Extreme and Time Capsule are configured to "extend a wireless network" they will provide additional wireless coverage....and...the Ethernet ports are enabled in this type of setup.
The "catch" here is that you must have an Apple router providing the network to be extended.

My ipod leaves the conection with airport express when i start to play a music. My iphone works correctly when I repeat the same operation. What is happening?

Similar Messages

Maybe you are looking for