My iPod nano (6th generation) will not sync because of Error 13019.

Why won't my iPod nano sync? Error 13019 keeps showing up. I've tried to sync over and over. Help me!!

See here: iTunes: Error 13019 during sync
Some users have had luck by rebuilding their iTunes library.
iTunes: How to re-create your iTunes library and playlists
B-rock

Similar Messages

  • My ipod nano 6th generation will not turn on.

    My iPod nano (6th generation) will not turn on. I have charged it (attached to my computer) for 30 minutes. I have tried to reset it (held down Wake and Volume Down for 8 seconds)- no response. I have factory restored it (through iTunes)- no response. It shows up as connected to my computer and will sync in iTunes, but the display on the iPod will not turn on. Any ideas?

    Hey s.mccarter2010,
    Thanks for the question. After reviewing your post, it sounds like you have tried a lot of things and the iPod still will not turn on. I would recommend that you read this article, it may be able to help you resolve or isolate the issue.
    iPod won't turn on
    If you have tried the solutions above and iPod still won't turn on, check the following:
    Make sure iPod is the only device in your FireWire or USB chain. Disconnect everything but the mouse, keyboard, and your iPod, then see if it will turn on.
    Make sure you are using the FireWire or USB cable that came with your iPod, and that the cable is in good condition.
    Try connecting iPod to the built-in port of a different computer to see if that works. Note: If using a portable computer, make sure it is plugged in to a power source and that the lid or display is open. If the lid is closed the computer may go into either standby, sleep, or hibernation mode and iPod will not charge properly.
    If you still can't turn iPod on after performing these steps, it may need to be repaired. You can arrange for repair at the iPod Service Website.
    Thanks for using Apple Support Communities.
    Have a nice day,
    Mario

  • HT1459 MY IPOD NANO 6TH GENERATION WILL NOT TURN ON I GOT IT FOR CHRISTMAS AND PLAYED THE RADIO ON IT WITH OUT PLUGING IT INOT ITUNES AND I WAS WONERING HOW TO FIX IT ?

    hi my ipod nano 6th generation will not turn on what should i do ...no batery left and never pluged it into itunes

    Hi meganisawsome,
    If your iPod will not turn on and you are getting indicators that there is no battery left, the first step would be to make sure that the iPod has been charged correctly. You may find the following article useful:
    Apple Support: Charging your iPod battery
    http://support.apple.com/kb/HT1384
    If you are still having issues after charging, you may want to look at this article:
    iPod nano (6th generation): Hardware troubleshooting
    http://support.apple.com/kb/TS3474
    Regards,
    - Brenden

  • My Ipod nano 3rd generation will not sync with itunes or show up on windows, but other ipods do when connected

    My Ipod nano 3rd generation will not sync with itunes or show up on windows, but other ipods do when I connect them using the same setup.

    Hey Biglou1,
    Thanks for the question, and welcome to Apple Support Communities.
    I understand that your iPod nano(3rd generation) is not recognized in iTunes. The following troubleshooting assistant may provide a resolution:
    Apple - Support - iPod - iPod nano (3rd generation) Troubleshooting
    http://www.apple.com/support/ipod/five_rs/nano3gen/
    If the above did not resolve your issue, choose an applicable article below that best describes your issue.
    Windows
    iPod appears in Windows but not in iTunes
    iPod not recognized in 'My Computer' and in iTunes for Windows
    iTunes reports that "iTunes cannot recognize this iPod at this time"
    Thanks,
    Matt M.

  • My ipod nano 6th generation will not work connected to my car radio?

    my ipod nano 6th generation will not work connected to my car radio? My wife's ipod nano 4th generation works perfectly.

    Hey CorineNL,
    If your iPod not recognized by iTunes or computer, I would follow the directions here:
    Follow this troubleshooting assistant.
    Also see these articles for further assistance:
    iPod not recognized in 'My Computer' and in iTunes for Windows
    iPod not recognized in iTunes and Mac desktop
    from: iPod nano (6th generation): Hardware troubleshooting
    http://support.apple.com/kb/TS3474
    Welcome to Apple Support Communities!
    Best,
    Delgadoh

  • My Ipod nano 7th generation will not sync.

    My Ipod nano 7th generation will not sync, I have updated itunes very recently. Everytime I try to sync anything, playlists, music, podcasts, or even photos from my computer, It does not sync. However before It syncs it tells me that I need to authorize my computer so that I can play purchased songs, so I log in with my apple ID and it says that the computer is now authorized but then when I press the sync button again the same message pops up over and over. Can anybody fix this?

    Hello stowie10,
    I would make sure that music is checked to sync, or any other data at that. Check out the following article to get the squared way with this setup.
    iTunes 11 for Windows: Set up syncing for iPod, iPhone, or iPad
    http://support.apple.com/kb/PH12313
    Thanks for using Apple Support Communities.
    Regards,
    -Norm G.  

  • My ipod nano 6th gen will not sync.

    My ipod nano 6th gen will not sync. I have uninstalled and reinstalled itunes; I have reset the nano; I have used a different USB port and connector; I have rebooted my computer. Any suggestions?

    I just did the same. Spent at least two hours trying different actions. Then uninstalled and reinstalled itunes. Also used a different USB port, etc. Also rebooted computer.   No option for syncing is showing up on Itunes and when I run diagnostics it says there is no device detected- yet it is plugged into a USB port and the screen on the Nano says connected. HELP

  • My new ipod nano 7th generation will not sync with i tunes, followed all the apple on line trouble shooting ideas, this device will not show up in itunes but i can see it from explorer, windows 7 user.

    ipod nano 7th generation will not sysc with i tunes is updated , device does not show up in itunes under devices but shows itself in explorer.ran diagnostics failed sync. about ready to take this back to best buy.

    yes i have a solution to my problem only because of a recent phone call from apple they were great.......... in the right hand side of itunes my i pod was displayed.  click on the ipod symbol........at the top of the page you will see summary,,,,,,music,,,,,,movies,,,,,,tvshow,,,,,,photo,,,,,on this ipod.
    click on music check mark music done and sync
    problem solved
    thanks apple

  • IPod Nano (6th gen) will not sync.

    Okay, I have an iPod Nano (6th generation) that won't sync. I've reset the iPod many times, uninstalled and reinstalled iTunes, done all the suggestions given by the troubleshooting assistant, and still nothing. When I plug it in, it turns on and begins charging, but the computer doesn't do anything. It doesn't make a little sound, it doesn't say it recognized a device. It just does nothing. I'm not in a serious rush to fix this, but I recently got some new podcasts that I REALLY want to sync on there. Does anybody have suggestions? I seriously need help.

    I just did the same. Spent at least two hours trying different actions. Then uninstalled and reinstalled itunes. Also used a different USB port, etc. Also rebooted computer.   No option for syncing is showing up on Itunes and when I run diagnostics it says there is no device detected- yet it is plugged into a USB port and the screen on the Nano says connected. HELP

  • My ipod nano 6th generation is not  syncing  the videos, can any one help me

    Hi,
    My ipod Nano 6th Geeration is not able to sync the videos  from itunes library, please help me out on this.

    Videos are not compatible with a 6G Nano.  Sorry.
    B-rock

  • Ipod Nano 6th Generation will not turn on.

    My brother bought my mother the new Ipod Nano 6th Gen as a gift yesterday. We plugged in to charge (like the instruction booklet says) and found the Ipod wasn't turning on. Everything on the computer and syncing side works. We managed to register the Ipod and everything like that but when it comes to controlling the actual Ipod, it doesn't seem to be working.
    I have tried resetting (Volume Down Button + Sleep/Awake Button) it but still nothing.
    The repairing Ipod has been cast on me which is unfortunate because my mother doesn't take things breaking very well and I would rather sort it out for myself than have to hike up to my nearest Apple Store for the Genius Bar to look at it.
    I would like to know if this is a problem with the screen or with the actual power in the ipod.
    The tiniest of help and I would be very greatful. thanks,
    Ross Jordan.
    ps. it has been charging for a good 3/4 hours now.

    If you do a restore on it from itunes on your computer and it still does not work....then it's a defective unit and you'll have to take it in for an exchange.
    Try to restore first before taking it in.
    Here is how you do it:
    http://support.apple.com/kb/HT1339
    Good luck!
    M.

  • HT201413 apple ipod nano 7th generation will not sync with itunes

    My new apple nano 7th generation ipod does not sync with itunes. can you suggest something other than reinstalling itune?

    yes i have a solution to my problem only because of a recent phone call from apple they were great.......... in the right hand side of itunes my i pod was displayed.  click on the ipod symbol........at the top of the page you will see summary,,,,,,music,,,,,,movies,,,,,,tvshow,,,,,,photo,,,,,on this ipod.
    click on music check mark music done and sync
    problem solved
    thanks apple

  • My ipod nano 4th generation will not sync

    I am trying to sync the photos onto a new computer but it does nothing

    it is usually one way from pc to ipod nano, not the other way around

  • My iPod Nano 6th generation will not turn on when off of the a power source. I've tried to restore it, but that didn't work. Any suggestions?

    I also tried holding the sleep/power button along with the minus button to reset it and that did not work either. Any help would be great, thanks.

    If you update the iPod software to the latest version (1.1) you should be able to power off the iPod. If that doesn't work especially since you restored it's most likely a hardware issue with the iPod. If so, contact AppleCare or visit an Apple Retail Store so they can setup a repair for you.

  • My iPod nano, 6th generation, will not stop playing and none of the buttons will work

    I listen to audiobooks.  My iPod was fine, I just checked how far I was in this chapter.  I checked again 2 minutes later and I cannot get the screen to lite up nor can I control the volume.  But my book continues to play.  I plugged it in to charge with a wall charger, nothing.  I plugged into my computer and again nothing.
    It is only 3 weeks old, I use it about between 1-3 hours a day.
    Anyone else have this problem?

    Have you tried resetting it by pressing and holding both the Sleep/Wake and Volume down buttons together long enough for the Apple logo to appear.
    B-rock

Maybe you are looking for

  • Cannon CR2 raw files not opening in Preview.

    Just upgraded to Mountain Lion, and now my Cannon CR2 files are no longer opeing in Preview or QuickLook. Opeing in Preview causes Preview to open, and the crash, and clearing the Preview prefrence files did not help. Looking at the file in QuickLook

  • Tour de Flex Samples needed Adobe AIR plugin to PC to run ?

    Where I may find free/open-source sample autonomus Adobe AIR Apps? How I test if Adobe AIR success installed? Tour de Flex Samples needed Adobe AIR plugin to PC to run ?

  • RMD metadata for R3D clip not always loaded

    I'm getting a bug where 'sometimes' the RMD metadata for a clip is not automatically loaded by Premiere for R3D clips (from Red cameras).  I have to right click on the clip, select 'source settings', and then click on 'Reload from RMD'.  These R3D fi

  • Cisco Building Automation Technology

    Good afternoon, I am researching into the building automation technologies that Cisco offers for our buisness. We are a university campus in Ontario, Canada and theoretically I am proposing the Energywise solution, which means that we would need to r

  • WRE54G with a Playstation 3

    The range expander has been working perfectly for about a month or so, I came home from a weekend trip and now the link light is red. I have unplugged it and reset it and tried to auto-configurate it multible times and I get the same result, a blue a