My ipod nano 6th generation will not work connected to my car radio?

my ipod nano 6th generation will not work connected to my car radio? My wife's ipod nano 4th generation works perfectly.

Hey CorineNL,
If your iPod not recognized by iTunes or computer, I would follow the directions here:
Follow this troubleshooting assistant.
Also see these articles for further assistance:
iPod not recognized in 'My Computer' and in iTunes for Windows
iPod not recognized in iTunes and Mac desktop
from: iPod nano (6th generation): Hardware troubleshooting
http://support.apple.com/kb/TS3474
Welcome to Apple Support Communities!
Best,
Delgadoh

Similar Messages

  • My ipod nano 6th generation will not turn on.

    My iPod nano (6th generation) will not turn on. I have charged it (attached to my computer) for 30 minutes. I have tried to reset it (held down Wake and Volume Down for 8 seconds)- no response. I have factory restored it (through iTunes)- no response. It shows up as connected to my computer and will sync in iTunes, but the display on the iPod will not turn on. Any ideas?

    Hey s.mccarter2010,
    Thanks for the question. After reviewing your post, it sounds like you have tried a lot of things and the iPod still will not turn on. I would recommend that you read this article, it may be able to help you resolve or isolate the issue.
    iPod won't turn on
    If you have tried the solutions above and iPod still won't turn on, check the following:
    Make sure iPod is the only device in your FireWire or USB chain. Disconnect everything but the mouse, keyboard, and your iPod, then see if it will turn on.
    Make sure you are using the FireWire or USB cable that came with your iPod, and that the cable is in good condition.
    Try connecting iPod to the built-in port of a different computer to see if that works. Note: If using a portable computer, make sure it is plugged in to a power source and that the lid or display is open. If the lid is closed the computer may go into either standby, sleep, or hibernation mode and iPod will not charge properly.
    If you still can't turn iPod on after performing these steps, it may need to be repaired. You can arrange for repair at the iPod Service Website.
    Thanks for using Apple Support Communities.
    Have a nice day,
    Mario

  • HT1459 MY IPOD NANO 6TH GENERATION WILL NOT TURN ON I GOT IT FOR CHRISTMAS AND PLAYED THE RADIO ON IT WITH OUT PLUGING IT INOT ITUNES AND I WAS WONERING HOW TO FIX IT ?

    hi my ipod nano 6th generation will not turn on what should i do ...no batery left and never pluged it into itunes

    Hi meganisawsome,
    If your iPod will not turn on and you are getting indicators that there is no battery left, the first step would be to make sure that the iPod has been charged correctly. You may find the following article useful:
    Apple Support: Charging your iPod battery
    http://support.apple.com/kb/HT1384
    If you are still having issues after charging, you may want to look at this article:
    iPod nano (6th generation): Hardware troubleshooting
    http://support.apple.com/kb/TS3474
    Regards,
    - Brenden

  • My ipod nano 6th generation is not working anymore :( HELP

    I have an ipod nano 6th generation. Was working perfectly. One day I wake up and is showing me a screen I have never seen  before..It reads:N20 Snowfox 4A0432
    When I plug it, itunes doesnt recognize it. It recognized it once but it says problem 1621 and I follow the instructions but still my ipod is frozen and not even my computer can read it.
    I really miss my music for my morning run!

    Have a look at comment # 4 and 5 on this page iPod nano 6G diagnostic mode to get it out of this mode again.
    Pressing the volume minus button and power button should help.

  • Ipod Nano 6th Generation will not turn on.

    My brother bought my mother the new Ipod Nano 6th Gen as a gift yesterday. We plugged in to charge (like the instruction booklet says) and found the Ipod wasn't turning on. Everything on the computer and syncing side works. We managed to register the Ipod and everything like that but when it comes to controlling the actual Ipod, it doesn't seem to be working.
    I have tried resetting (Volume Down Button + Sleep/Awake Button) it but still nothing.
    The repairing Ipod has been cast on me which is unfortunate because my mother doesn't take things breaking very well and I would rather sort it out for myself than have to hike up to my nearest Apple Store for the Genius Bar to look at it.
    I would like to know if this is a problem with the screen or with the actual power in the ipod.
    The tiniest of help and I would be very greatful. thanks,
    Ross Jordan.
    ps. it has been charging for a good 3/4 hours now.

    If you do a restore on it from itunes on your computer and it still does not work....then it's a defective unit and you'll have to take it in for an exchange.
    Try to restore first before taking it in.
    Here is how you do it:
    http://support.apple.com/kb/HT1339
    Good luck!
    M.

  • My iPod Nano 6th generation will not turn on when off of the a power source. I've tried to restore it, but that didn't work. Any suggestions?

    I also tried holding the sleep/power button along with the minus button to reset it and that did not work either. Any help would be great, thanks.

    If you update the iPod software to the latest version (1.1) you should be able to power off the iPod. If that doesn't work especially since you restored it's most likely a hardware issue with the iPod. If so, contact AppleCare or visit an Apple Retail Store so they can setup a repair for you.

  • HT1369 IPod Nano 6th generation sync not working

    I've run all the diagnostics, troubleshooting, reset the device.  Device shows as being connected to computer and network.  But, fails sync test.  Help!!...Thanx...Michael

    If a restore of the device to factory settings in iTunes, did not resolve the issue, it points to a hardware issue with the display's backlight. This means you'll need to take or send your iPod in for service either to Apple or a third party service.  Here is Apple's pricing.
    http://www.apple.com/support/ipod/service/prices/
    Google "iPod Nano repair" for third party service centers who would actually replace the damage part.
    B-rock

  • My iPod nano (6th generation) will not sync because of Error 13019.

    Why won't my iPod nano sync? Error 13019 keeps showing up. I've tried to sync over and over. Help me!!

    See here: iTunes: Error 13019 during sync
    Some users have had luck by rebuilding their iTunes library.
    iTunes: How to re-create your iTunes library and playlists
    B-rock

  • My iPod nano, 6th generation, will not stop playing and none of the buttons will work

    I listen to audiobooks.  My iPod was fine, I just checked how far I was in this chapter.  I checked again 2 minutes later and I cannot get the screen to lite up nor can I control the volume.  But my book continues to play.  I plugged it in to charge with a wall charger, nothing.  I plugged into my computer and again nothing.
    It is only 3 weeks old, I use it about between 1-3 hours a day.
    Anyone else have this problem?

    Have you tried resetting it by pressing and holding both the Sleep/Wake and Volume down buttons together long enough for the Apple logo to appear.
    B-rock

  • The power button on my iPod Nano 6th Generation is not working. Any suggestions?

    Is this worth repairing?

    Depends on how you do it and how much you like the size and the clip.
    An out-of-warranty replacement at your nearest Apple Store (make a Genius Bar appointment before you go) will cost your $65/$75 USD depending on the size of your Nano. You can find a 3rd party repair site that will do it for less buy you won't be able to do an out-of-warranty replacement if something else fails.

  • My iPod Nano 6th gen will not restart?

    My iPod Nano 6th generation will not start, after being recharged, My PC doesn't recognize it and it's screen doesn't alight,
    can anyone help?
    greengra55

    If the solutions found in the article iPod not recognized in 'My Computer and in iTunes for Windows, take the iPod Nano to an Apple store or an AASP.  Whichever is more convenient for you. 

  • IPod Nano 7th Generation will not turn on

    My 10 month old iPod Nano 7th Generation will not turn on - all of a sudden.
    All songs on the device have disappeared.
    Shows in iTunes - even shows as having a fully charged battery.
    Holding Home Button and Sleep/Wake button down, even for a long time, doesn't help.
    Have changed USB ports, from computer to AC powered USB charging station.
    Help?

    Just saw elsewhere on the forum to press and hold the power and home buttons and it fixxed it for me

  • My new ipod nano 7th generation will not sync with i tunes, followed all the apple on line trouble shooting ideas, this device will not show up in itunes but i can see it from explorer, windows 7 user.

    ipod nano 7th generation will not sysc with i tunes is updated , device does not show up in itunes under devices but shows itself in explorer.ran diagnostics failed sync. about ready to take this back to best buy.

    yes i have a solution to my problem only because of a recent phone call from apple they were great.......... in the right hand side of itunes my i pod was displayed.  click on the ipod symbol........at the top of the page you will see summary,,,,,,music,,,,,,movies,,,,,,tvshow,,,,,,photo,,,,,on this ipod.
    click on music check mark music done and sync
    problem solved
    thanks apple

  • My Ipod nano 3rd generation will not sync with itunes or show up on windows, but other ipods do when connected

    My Ipod nano 3rd generation will not sync with itunes or show up on windows, but other ipods do when I connect them using the same setup.

    Hey Biglou1,
    Thanks for the question, and welcome to Apple Support Communities.
    I understand that your iPod nano(3rd generation) is not recognized in iTunes. The following troubleshooting assistant may provide a resolution:
    Apple - Support - iPod - iPod nano (3rd generation) Troubleshooting
    http://www.apple.com/support/ipod/five_rs/nano3gen/
    If the above did not resolve your issue, choose an applicable article below that best describes your issue.
    Windows
    iPod appears in Windows but not in iTunes
    iPod not recognized in 'My Computer' and in iTunes for Windows
    iTunes reports that "iTunes cannot recognize this iPod at this time"
    Thanks,
    Matt M.

  • Any ideas why my ipod nano 6th gen is not working with Sony SRSGU10IP docking station pls

    any ideas why my ipod nano 6th gen is not working with Sony SRSGU10IP docking station please ? classic working fine, so not the fault of the station itself ? it's been bought as a present for my father & he's confused !

    Check the headphone jack with a flashlight and clean it if necessary. The jack on a new Nano is very tight, be sure you push the headset jack all the way in, the plastic on the headset jack should be flush with the body of the Nano.

Maybe you are looking for

  • Why does the music on my iPhone 5 seem to stop unexpectedly, but actually keep playing without volume.

    My iPhone 5s's (which is only 3 days old) music will unexpectedly stop in the middle of playback. Upon examination of the screen, the iTunes app is still playing the music, but there is no volume. The only way to rectify this is to unplug the headpho

  • Using Mac as local wireless webserver (without internet connection)

    I want to use a freestanding Mac as a wireless webserver. The mac couldn't be connected to the internet but would hold all its content locally, which would be accessible to other devices on a wireless network. I feel sure this should be possible some

  • IMovie no longer auto-saves?

    I have imovie '09 and lately my videos don't save automatically. If I close imovie and open it back up again any projects I have been working on are gone. Also, all past projects I have worked on are not viewable. This first starting happening when I

  • Downloading 92010NT_Disk1.zip

    I have downloaded the 92010NT_Disk1.zip file twice and each time the file download has completed successfully. However, when I go to unzip the file, I get an "invalid archive" message. The size of the file on the http://otn.oracle.com/software/produc

  • Properties files in a Java package not included in DC build

    We are developing a Portal Standalone DC and i have a JspDynPage component within it. and i need to do internationalization in  it. so as part of that i want to keep multiple resource bundles(properties) so that i could manage my properties files eas