My ipod on my iphone 3gs is not working, what do i do?

please help.. my ipod on my iphone 3gs is not working, what do i do?

thank you for your answer. its just that when i press the music icon its just shows a blank white page=
then close again. its like its crashing whenever i tried to open it. tried=
to restart. it still did the same problem. i'm trying to restore it now. h=
opefully it'll work. what else can i do if that doesn't work?

Similar Messages

  • My iphone 3gs is not working properly, when switched on it says 'Update Completed' as though it has just been updated. On the next screen it says to 'Connect to iTunes'. It doesn't, however, connect to iTunes and more often than not just resets itself.

    My iPhone 3gs is not working properly and hasn't been since about September of last year. When switched on (Quite often it won't even turn on) it says 'Update Completed' as though it has just been updated. On the next screen it says to 'Connect to iTunes'. It doesn't, however, connect to iTunes and just resets itself over and over until power is gone. Occasionally after switching on and off a few times it functions normally for a few hours and some times even a couple of days but eventually always turns itself off and goes back to the 'Update Completed' screen. Does anyone know what might be causing this and/or a way of fixing it?

    Morning JordenR,
    Thanks for using Apple Support Communities.
    You can resolve many restore issues using the troubleshooting steps documented here.
    For more information on this, take a look at this article:
    iOS: Resolving update and restore alert messages
    http://support.apple.com/kb/ts1275
    Best of luck,
    Mario

  • Facetime on my iphone 4s is not working what can i do

    facetime on my iphone 4s is not working what can i do

    Even new purchases are not always fully up to date.  Check and see by going to Settings > General > Software Update and see if it says it is up to date or not.
    Also keep in mind that you need a WiFi connection for FaceTime.

  • After restoring definitions iphone 3gs does not works, after restoring definitions iphone 3gs does not works

    after restoring definitions iphone 3gs does not works

    What do you mean by "restoring definitions"?
    What EXACTLY is your problem?
    "does not works" is just a bit vague.

  • Dear sir we are using iphone 3gs, loudspeaker not working.so where is change its speaker

    dear sir,
           i am using 3gs iphone , but loudspeaker not working , so what we do for working of speaker
    regards,
    mukesh/ infoneon
    <Personal Information Edited By Host>

    Hi there infoneon,
    You may find the troubleshooting steps in the article below helpful.
    iPhone: No sound or distorted sound from speaker
    http://support.apple.com/kb/ts5180
    -Griff W. 

  • Iphone 3gs is not working at all

    i got my dad's old Iphone 3gs, and wanted to deleate all content and settings.
    once i did so, it got black-screened for about 2 hours, then the apple logo appeared, and it just froze. it's been like that for about 24 hours now, obviously not working.
    i tried reseting it by pressing the sleep buttun and home button, but all it did was go black, then the apple logo would come back again with the litlle blinking "thinking" circle, and freeze again after aprox. 10-15 seconds.
    tried connecting it to the computer so that maybe my itunes would recognize it, but it had no effect.
    what can i do now?

    Make sure the battery is charged before trying to sync with your computer.
    Could be the USB cables or ports...  Powering Apple and third party peripherals through USB
    Windows or Mac?
    iOS: Device not recognized in iTunes for Windows
    iPhone, iPad, iPod touch: Device not recognized in iTunes for Mac OS X
    Make sure your iTunes software is up to date. Launch iTunes. From the menu bar click iTunes / Check for Updates.

  • If my IPhone 3GS is not working,when I go speak to Apple will they exchange it for an IPhone 4 or will I just get another 3GS?

    I am wondering this because today I went to an AT&T store since my IPhone 3GS is working not so well and I barely got it about four months ago,they said that I would have to go to an Apple store which I am going to do Sunday but my IPhone 3GS be exchanged by an IPhone 4 or the same model as right now?Also,if I don't get the IPhone 4 is there any chance I would be able to buy it from them,no higher than 100 dollars?

    Replacements are same model, size, and color.  99.9999999% of the time there is no exception and the exception is always Apple's decision.  This has only ever happened when Apple does not have sufficient quantities of service units for replacement of a specific model.
    Apple does not offer "upgrades" or exchanges during the warranty replacement part.  If you want a newer model, you must purchase it at full retail (or subsidized price from your carrier if you qualify).

  • My iPhone 3gs its not working I erased and there is missing a software i need a help to solve it

    Hi , I have an iPhone 3gs 16gb . Long time ago i just give to my wife so she can use it and after that she didn't need it anymore so i took it back the iPhone to use it but it didn't take my SIM Card so i try to erase everything inside the iPhone so i can use mine , I'll try to connect my Iphone to my PC to make an update with my SIM Card through iTunes , after 2 second i saw there that i must put another SIM Card that supported  operator . I think its stucked there so i can do nothing about my Iphone & i need an solution about my Phone . The "iOS 6.1.3 " i think & I'm not sure , is there someone can help me about my iPhone? Please and thanks.

    It sounds like at some time the device was hacked to be able to work with the carrier you were using. Are you using a different carrier now than you were using before? Restoring a hacked device would restore the carrier lock that was on the phone. If you are seeing that particular error, the only alternatives are to either use the carrier it is locked to, or contact them to see if they provide unlocking services and if you qualify for unlocking.

  • IPhone 3gs wifi not working

    I'm using an iPhone 3GS and an airport express (the first version to have 802.11n capability) with the latest firmware/iOS on each.  I've set up my airport express which is working fine with my macbook.  When I go to connect my iPhone to the network, I can go into the WiFi settings, find the network, enter the password, but then instead of connecting all the way, the "loading spinner" just sits next to the network forever and the top left corner of the screen continues to say "3G".  I can use Airport Utility on my phone to manipulate the airport settings and I can even use AirPlay, but for data my phone continues to rely on 3G.  I've tried turning off cellular data, at which point the "connected to WiFi" icon shows up at the top of the phone, but no app is able to use any data functions (safari says I'm not connected to the internet).
    I know my router is working fine since I'm able to connect with my laptop and use the internet as I always would.  I've tried changing channels, making sure that 802.11 b/g is enabled, "forgetting the network" in my phone, restarting my phone, restarting the router, and restarting the modem, and trying to connect my phone when it is the only device on the network.  Any thoughts on what else might be causing this problem?

    Open the setup page of rouer,under the security tab..Uncheck Block Anonymous Internet Requests and click on Save Settings...Under the Wireless tab,click on the subtab Advance Wireless Settings tab and Change the Beacon Interval to 75,Change the Fragmentation Threshold to 2304,Change the RTS Threshold to 2304 and Click on Save Settings...
    Now see if you can locate your Wireless Network and attempt to connect...

  • Camera on new iPhone 3GS does not work

    My husband got a brand new iPhone 3GS yesterday from the iShop here in Gateway Durban, and the camera does not work at all. You can see through the lense, but non of the touchscreen controls work (ie access to camera roll, take picture, swap to video.) Am I missing something obvious? This is perculiar, in that it is his second iPhone and I have the iPhone 4 so you would think between us we would be able to figure it out, but it does seen truly STUCK. Any ideas?

    Have you tried to restore the phone?

  • Iphone 3GS keyboard not working????

    i just got a new iphone 3GS yesterday and i took the plastic that wraps around the phone off. The lady i bought it from said if there is plastic on it it might not type right. so is there another coating of plastic on it?? whenever i type the keyboard doesnt do what i want. for example if i type backspace it types the letter p. some letters dont work and if i hit one letter a different letter on the otherside of the keyboard gets typed instead. is there something wrong with the phone or is there a coating of plastic im not able to get off? should i return it or what...?

    Basic troubleshooting steps clearly outlined in the User Guide are restart, reset, restore from backup, restore as new.  If you've been through ALL these steps sequentially and you still have the problem, then you'll need to make an appointment at the Genius Bar and have your phone evaluated.

  • The touch on my iphone 3gs does not work. the only time it works is when i slide it to turn it off. I've tried resetting it multiple times and it will still not work. I need help!

    Hello, I've got a question about my Iphone 3gs. Well one day i woke up and i tried to slide to unlock my phone but the touch was unresponsive. So, i turned off my phone and back on, the unlock screen came back one and same problem happened. The only time the touch works is when I slide to turn off my phone. When people call me, i can't answer. When people text me, I can't answer. I do have the latest update for the phone. I've looked everywhere on the internet and have got no answers. I have dropped my phone a couple of times and it does have some cracks on the screen. Please help!

    Your only chance besides getting it serviced would be setting it up as new device:
    http://support.apple.com/kb/HT4137

  • My vibration on my iphone 3gs is not working

    i have had my iphone 3gs for about 1year and half and today the vibration has just died on me anyone no why or what i should do to repair it ? x

    Try resetting...
    Hold the On/Off Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears.

  • IPhone 3GS GPS not working

    So I am gonna try this because I know others haven't got a response they have liked or helped…
    I have a 3GS, running iOS on my iPhone 3GS, but still am having issues with the GPS, I am sure others are still having this issue. I found this thread awhile ago, but there wasnt much follow-up on this from Apple, Go to a Genius Bar, plus people in this thread have said that they did that and nothin has worked, or the Mac Genius suggested it might just need the SIM card replaced… I really dont think that would help
    http://discussions.apple.com/message.jspa?messageID=11248780
    So… Apple can you guys just give some clarity on whats is up with this, I mean I am loyal and keep buying your products, but it is only fair that you share just a lil bit of info like: "an update is coming soon to fix this or its a hardware issue, come on in and it will be resolved."
    Let me know if anyone else is still having issues or has a resolution
    Thx

    What Modem Firmware are you using on the phone?

  • MY iphone ram is not working what can i do?

    HI i am ahmad my iphone 5s ram is not working  my iphone is suddenly get down from my hands and get power of plz tell me what can i do

    Hey there Ahmad.altaf27,
    It sounds like you are unable to turn on your iPhone 5s. I would recommend the troubleshooting from the following article to help you get the issue resolved:
    iOS: Not responding or does not turn on
    If the device remains unresponsive or does not turn on (or power on),  reset your device.
    If there is no video or if the screen remains black, verify that the device has enough charge to turn on:
    If you are using an iPad, ensure that it's connected to the USB Power Adapter supplied with the device.
    Let it charge for at least twenty minutes, then see if it starts normally.
    If there is no image on the screen, press the Sleep/Wake button to attempt to wake the device.
    If the screen displays a red battery icon, continue charging the device until the battery is fully charged. Learn more about charging iPhone and iPod touch, or iPad.
    If the above steps do not resolve the issue, or the if the screen remains black or shows a persistent Apple logo, try restoring with iTunes:
    Connect the device to your computer and open iTunes.
    If the device appears in iTunes, select and click Restore on the Summary pane. Learn more about restoring iOS software.
    If the device doesn't appear in iTunes, try to force the device into recovery mode, and then restore it.
    If the above steps do not resolve the issue, contact Apple.
    Thank you for using Apple Support Communities.
    Regards,
    Sterling

Maybe you are looking for

  • Error -50400 occurred at Invoke Method: FIFO.Read in Host.vi

    Hey there, we have sensors on an Engine which are connected to a NI cRIO 9014 board (with a NI9411 6-channel digital input modul) and go from there via network to a host computer. cRIO board: the cRIO board collects the data from the engine and store

  • The disk can not be read or written to!

    So this is the setup: Latest version of iTunes running on the wifes PowerBook under 10.4.X I'm using a new 4th Gen iPod Nano and I'm trying to sync the iPod to the library. Its gets about 400meg in and then comes up with error 'The disk can not be re

  • How do I set up the XCode Debugger so that it does not drop into asm?

    How do I set up the XCode Debugger so that it does not drop into asm? I want to step through my Cocoa Objective-C code and I do not want to see the underlying assembly. When I hit step over, I want it to step to my next line of objective-C code, not

  • How to make Robohelp 9 forget anything

    How can I start RH9 such that it behaves as being started without any MRU or remembering about its history? I found that when I had a fresh project coming from RHX5 and started RH9 once on the .xpj file it noticed, that it was from an older RH versio

  • Adressbook hang Exchange 2010 - Outlook 2010,2013

    Hi Forum we have Exchange 2010 and Clients with Office 2010, 2013 on all client we can't use adressbook, when we open it and change the adresslists Outlook hang i think the problem is since Exchange Rollup 8 v2