My ipod said to restore when I did it went black and wont turn on plz help?
I have an older ipod touch 32GB this morning it said to connect to itunes and restore and when I did it went black and wont turn on. What happened?
If not successful try the remaining items of:
iOS: Not responding or does not turn on
Similar Messages
-
My ipod went black and wont turn on or show up on itunes- please help
heyy all--my ipod went black and wont turn on it wont show up when i plug it into itunes or even a charger please help me thanks
Try resetting it by holding the sleep/wake and home buttons simultaneously for 10-15 seconds.
Hope this helps! -
My iPhone 5c has suddenly turned off and went blank. I then tried to plug it up to the computer to restore it but i cant because my phone has a password on it and i CANT TYPE IT IN. Also when i plugged it up it started vibrating again and again constantly. What should i do?
It is probably still worth while taking it to an Apple store for a possible OOW replacement and let them make the decision, as it was broken before the OP took the back off.
See note below... -
i need help. i tried updating the software on my ipod touch, and it looked like it was working fine, because it said "verifying update", but suddenly the screen went black and when i tried to turn it back on, it only had a picture of a usb chord pointing to the itunes icon. what do i do?
Your iPod has dropped into Recovery mode. You'll need to restore it via iTunes on your computer.
http://support.apple.com/kb/ht1808
Regards. -
HT4972 My ipods screen is black and wont turn on unless plugged into the wall
My ipods screen is black and wont turn on unless plugged into the wall not the computer but when i plug it into the computer and put it in DFU mode it wont restore there is an error 3194 and error 1602 and nothing i do helps
Here's what I found about error 1602:
Error 1600, 1601, 1602: Try the following steps to resolve this error:
Ensure proper USB isolation troubleshooting has been performed, and test with a known-good cable.
Follow the steps listed for Error 1604.
This error may be resolved by disabling, deactivating, or uninstalling third-party security, antivirus, and firewall software. See steps in this article for details on troubleshooting security software.
Error 1603: If you receive this error and the iOS device is not automatically placed into recovery mode, it may be necessary to do so manually. Refer to iPhone and iPod touch: Unable to restore for steps on placing iPhone into forced recovery mode. Also, remove the IPSW and attempt to restore again. If you do not want to remove the IPSW in the original user, try restoring in a new administrator user.
Error 1604: This error is often related to USB timing. Try changing USB ports, uninstalling and reinstalling USB ports, and other available USB troubleshooting steps (troubleshooting USB connections, device not recognized properly, computer won't recognize a FireWire or USB device). If you are using a dock, bypass it and connect directly to the white Apple USB dock connector cable. If the issue persists on a known-good computer, the device may need service.
This device is not eligible for the requested build: Also sometimes displayed as an "error 3194." If you receive this alert,update to the latest version of iTunes. Third-party security software or router security settings can also cause this issue. To resolve this, follow Troubleshooting security software issues.
Downgrading to a previous version of iOS is not supported. If you have installed software to perform unauthorized modifications to your iOS device, that software may have redirected connections to the update server (gs.apple.com) within the Hosts file. First you must uninstall the unauthorized modification software from the computer, then edit out the "gs.apple.com" redirect from the hosts file, and then restart the computer for the host file changes to take affect. For steps to edit the Hosts file and allow iTunes to communicate with the update server, see iTunes: Troubleshooting iTunes Store on your computer, iPhone, iPad, or iPod—follow steps under the heading Blocked by configuration (Mac OS X / Windows) > Rebuild network information > The hosts file may also be blocking the iTunes Store. If you do not uninstall the unauthorized modification software prior to editing the hosts file, that software may automatically modify the hosts file again on restart. Also, using an older or modified .ipsw file can cause this issue. Try moving the current .ipsw file, or try restoring in a new user to ensure that iTunes downloads a new .ipsw.
Error 3194 is also seen when somebody is trying to restore jailbroken devices. -
What do i do if my ipod touch screen went white and wont turn off?
what do i do if my ipod touch screen went white and wont turn off?
- Try a reset.
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Connect to computer and restore if it appearsin iTunes.
- If screen still white let the battery fully drain. After charging for an hour repeat the above. -
its just all black and wont turn on or show any light. ive had it for about 2 years now. its a ipod touch 5th generation and blue not sure what to be but it has everything on it thats so important.. i need help and im unsure about the IOS :/
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
Ipod cannot be recognized by pc and wont turn on! help
my ipod video is only a month and a half old and then just yesterday i was still using it around 12 noon then around 1 pm it wont turn on! i tried to reset it, made some simple troubleshooting but it wont respond waaaa when i connect it to my pc the pc cannot recognize the ipod that as if nothing is connected to the port! help please very freaked out ;(
Hi geaneshe!
Have you seen if these articles help with that issue of your iPod not turning on?:
iPod won't turn on
iPod stops responding or won't wake from sleep
-Kylene -
My ipod 5 has a broken power button And wont turn back on Help!
My ipod 5 has a broke poer button and was dead. I tried plugging it in to my computer and it charged normally now it wont turn back on and the computer says that its 100% charged how can i turn it bacl on without the power button? HElP!
Try:
- iOS: Not responding or does not turn on
When it says place the iPod in recovery mode
Place the iPod in recovery mode using one of these programs:
For PC
RecBoot: Easy Way to Put iPhone into Recovery Mode
or
http://joshuabailey1997.wordpress.com/2010/09/02/recboot-v1-3/
If necessary:
Download QTMLClient.dll & iTunesMobileDevice.dll for RecBoot
and
RecBoot tip
RecBoot may have problems on 64X windows, then try:
Tenorshare ReiBoot – Enter & Exit iPhone, iPad, iPod Recovery Mode with a Single Click
For MAC or PC
The Firmware Umbrella - TinyUmbrella
Installs blootware on PC too
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
So i was using the itunes already provided on my ipod and i was previewing a song and my ipod just shut off. Then, when i tried to turn it back on, the screen flashed quickly a light grey color and shut back off. Now it wont do anything and i cant make it come back on....what should i do?
Try here:
iPod touch: Hardware troubleshooting -
i realy want it to be fixed its my life
Have you try to:
> Charge your iPod?
> Plug it to your computer?
> Hold the Power button to turn on?
If so and none work, you may need to replace your battery.
iPod Owners
Your one-year warranty includes replacement coverage for a defective battery. You can extend your coverage to two years from the date of your iPod purchase with the AppleCare Protection Pan for iPod. During the plan’s coverage period, Apple will replace the battery if it drops below 50% of its original capacity. If it is out of warranty, Apple offers a battery replacement for $49 (iPod shuffle), $59 (iPod nano and classic), $79 (iPod touch) plus $6.95 shipping, subject to local tax. Apple disposes of your battery in an environmentally friendly manner.
Source: http://www.apple.com/batteries/replacements.html
NOTE: If you do get the battery replaced yourself, becareful when removing the screen because there is a special cable connecting to the iPod itself and the screen and its very fragile. If that break, then you also need to replace the screen as well.
Message was edited by: keeferaf -
Ipod touch screen went white and wont turn on
help!!
the ipod touch went white on its screen and the laptop cannot recognise the ipod it says unknown device! now the ipod wont even switch on
can any1 help meI am not sure if I know enough about iPod's to be able to help you completely but I can offer a few suggestions. First of all, you can try restarting your iPod (by holding the OFF button and the HOME button at the same time for a long period of time.) If that doesn't work then you could try connecting your iPod up to your computer and if it shows up on iTunes you can RESET your iPod. Hope that helped a little!
-
please help i beg of you
The link that Ingo posted makes sense.
I once accidentally left my iPhone in the washing machine for a full 48 minute spin cycle.
It didnt work for a few days, but after about a week when it dried it started working again ----> That was 4 years ago! -
so to start i had a ipod i didnt touch it for 2 weeks then i turned it on after then it was stuck on lock mode for like a billlion hours or mins idk then i gave up on it i put it away for like 2-3 months then i try to turn it on and i tryed every thing dfu hard reset and everything else i guess oh and i forgot to tell you the pins of the charger hole were broken so it wont connect to itues and charges really slow if there is no solution to my problem then just tell me to take it to the apple store and it is a ipod touch 4g 8gb
I tried the five R's. and pretty much everything i saw. I think its important to note that it stopped working after updating from 1.0 to 1.1 with ipod updater. It is now not detected by windows.
-
is anyone else experiencing this problem? what do I do to fix it? I can't revert back to 6.... HELP!
Try Reset iPad
Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
Note: Data will not be affected.
Maybe you are looking for
-
Packing at delivery note & billing
Let me put my req: I have created delivery, ( am using Packing process in delivery) I have done packing ,its working fine. When I take the output ( output type:LD00- delivery note) , main item & sub item ( packing item ) also appearing in delivery no
-
Error while creating transformation from DSO to InfoCube
Hi Gurus, When i am creating tranformation from DSO to InfoCube getting an error, " The unit/currency 'Source Currency 0CURRENCY ' with the value 'space' is assigned to the key figure 'Source Key Fig. ZAMT_PLC ' with the value '8.50 ' "
-
Workflow notificaiton mailer Does Not Start, Remains In Status Starting
Hi Gurus, Workflow notification mailer is not getting started and its showing status starting.I have tried to bounce the service componets still its showing starting.My application version is 12.0.6 and OS is AIX.I got a metalink reference"Notificati
-
Apps That you cause use for making video interactions
Hey there Ipad users. Im wondering if anyone know of an App in the itunes store thast will Allow you to take a bunch of pictures adn use a UI interface to get the the next image. Basically i would like to make a small Interaction using images. Exampl
-
help!