My ipod touch is disable and it says connect to itunes i did so what to do now
i dont know wht to do canyall please help me
WIth a Disabled iPod you first have to place the iPod in Recovery mode to allow a restore via iTunes on your computer.
Similar Messages
-
my ipod touch is disabled because i forgot my passcode i syncd it to itunes and now it says to enter a passcode but i dont have one.
You should be able to reset it and then put everything back from a backup in iTunes (one you hopefully got).
If you can't, I guess you could put it in DFU mode and try again...
Good luck! -
My Ipod Touch is disabled and when I connect to Itunes to recover it, it states that itiTunes could not connect to the iPod touch “iPod touch” because it is locked with a passcode. You must enter your passcode on the iPod touch before it can recover.
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Forgot passcode or device disabled
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: Back up and restore your iOS device with iCloud or iTunes
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store
If problem what happens or does not happen and when in the instructions? When you successfully get the iPod in recovery mode and connect to computer iTunes should say it found an iPod in recovery mode. -
HT1212 My ipod touch is disabled and it said connect to iTunes
My ipod touch have a password and my kid disabled it, and I can't use it.. How can I unlock it?
Recovery Mode
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
3.While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: Data will be lost. You may have to repeat the above many times. -
I'm updating my iPod Touch 5th Gen and it says "Connect to iTunes" and I have, but nothing happens.
Okay, so, I unlocked my iPod and it said an update was available, so I tapped install. It wasn't connected to a power source, and I didn't think it'd make any difference if I was or not. So, I tapped it, blah, blah, blah, and then it said to connect to iTunes. So, I did, but my laptop didn't make the noise it usually does when I plug in the USB cable, so I tried it over and over again, but still the same result. I've updated iTunes to the newest version, and nothing happened still. So I decided to just cancel the update. But, now, "Connect to iTunes" will not go away from my screen no matter what I try. I've tried looking for solutions online, but none help. So, if someone could PLEASE help me fix this.
Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
until the red slider appears, then slide the slider. Wait for the device to turn off.
* If you cannot turn off the device using the slider, press and hold the
Sleep/Wake and Home buttons at the same time. When the device turns off,
release the Sleep/Wake and Home buttons.
3. While pressing and holding the Home button, reconnect the USB cable to the
device. The device should turn on. Note: If you see the battery charge warning,
let the device charge for at least ten minutes to ensure that the battery has some
charge, and then start with step 2 again.
4. Continue holding the Home button until you see the "Connect to iTunes" screen.
When this screen appears you can release the Home button:
5. If necessary, open iTunes. You should see the following "recovery mode" alert:
6. Use iTunes to restore the device.
If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information. -
My daughter's iPod touch is disabled and I cannot connect to iTunes
My daughter's iPod went crazy the other day making noises (she was no where around) and when I found it the message said that the iPod was Disabled and that it should be connected to iTunes.I tried this and it said that it might need an upgrade and possibly to be restored. I clicked ok but it only got so far through the software upload before it returned to Disabled. I did a little searching and tried the connect while holding the home button thinking this would work but alas - no joy! I've repeated this and gone in circles looking at discussions and now discovered that I cannot even turn off the iPod (with the slider) I held done the home button and on/off, restarted and then... you guessed it, disabled. Any help?
Have you tried following the recovery mode instructions in http://support.apple.com/kb/HT1212 and summarized as:
-
I need help. I tried to update this ipod i have and it just restarted and said connect to itunes. I cant access itunes so is there anyway i can restore or factory reset this.
Use a friend's computer or make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar
That is the oly way. -
My ipod touch has been disabled and it says connect to itunes, and I dont have any access to the primary computer that i used first , what do I do ?
put it into recovery mode
See here
http://www.apple.com/support/ipodtouch/assistant/restore/
Then restore
http://support.apple.com/kb/HT1414
You'll probably lose all your data -
My ipod touch is disabled and it says to connect to itunes but itunes says it can't sync because it is locked. Any way to unlock and keep data? (apps, gaming levels, music).
Hi,
Take it to you nearest Apple Store and see what they have to say. You should back up you data before you go in but in your case you can not.
xxmitchxx90 -
I dissabled my ipod touch 4th generation. It says connect to itunes, and i did what it say to do but the "connect to itunes" screen never shows up...it just goes back to the "ipod is dissabled connect to itunes screen. What do i do?????
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: How to back up
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store -
My iPod is disabled and it says connect to iTunes. The only way i found to fix it is to restore it but i don't want to loose all my data. What should i do?
You must restore it, losing anything you have failed to backup or store on your computer or cloud service.
-
How do you turn your ipod touch on when the screen says connect to itunes?
How do you turn your ipod touch on when the screen says connect to itunes?
You connect the iPod to your computer with iTunes and restore via iTunes. If iTunes does not see the iPod try:
iPhone, iPad, iPod touch: Device not recognized in iTunes for Mac OS X
or
iPhone, iPad, or iPod touch: Device not recognized in iTunes for Windows
If iTunes asks for the passcode and you can't enter it or if iTunes does not see the iPod, manually placing the iPod in recovery mode and then restore. For recovery mode:
iPhone and iPod touch: Unable to update or restore -
I have locked my iPhone 5 and forgot my password . Phone is disabled and is saying connect to iTunes ! I have tried but never did I synced my phone to any computer but when installed used iCloud how do I get it back on???
See here
http://support.apple.com/kb/HT1212 -
my iphone 4 is disable and it says connect to iTunes so I connect it to iTunes and nothing happens I have done this a couple of times and it is really ******* me off and I need help
when I connect the USB plug into the computer it tells me iphone is in recovery mode you need to unlock before connecting to iTunes then when it say restore and update it does it for like 10-15 min then it turns on the phone then I have to do it all over again
-
My ipad mini was disabled and kept saying connect to itunes how do i do that
my ipad mini was disabled and kept saying connect to itunes how do i do that
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. If you did not do step 4 properly, start all over again.
Maybe you are looking for
-
How to Print Bar codes in SAP script.
Hi Experts, Could you please tell me how to print bar codes through sapscript (the steps basically)? <<text removed by moderator>> Thanks in advance, Suchi. Edited by: Matt on Nov 13, 2008 2:04 PM - do not use ASAP or urgent.
-
How to upload the Company logo in the Enterprise Portal
Hi, I want to upload the company logo in the ESS (EP 7.0). Can anybody tell me the procedure for uploading the logo please. Thanks & Regards Aman
-
Creation Of Custom Directory Tree
Hi My client has a requirement of creating multiple realms. The first Realm should contain the standard DIT which is installed as a part of the OID installation. The second Realm should contain only the Custom dit which the client has created. but th
-
Can a standby DR database in different datafile access path?
We are going to setup a standby DR database for the primary DB. The primary DB is in Oracle ASM. Can we setup the standby DB in regular flat file system, instead of using ASM? Thanks,
-
I too rely on reading my sons text messages and feel that as long as I am paying the bill my son has no privacy. Sometimes I just want to look at the messages at my convenience and not by the availability....