My Itunes errors when I try to pull it up
Okay its been going on for a month now, whenever I try to open itunes this comes up,
"The instruction at 0x003f001c referanced memory at 0x003f001c. The memory could not be written"
I dont know what that means. Ive tried re-installing the program like some people told me, but it dosnt work. Help!
Okay. Checking on a few systemwide possibilities that might conceivably cause an error like that that aren't on the list.
Let's try running a chkdsk over your C drive. There's instructions in the following document. Select both automatically fix file system errors and scan for and attempt recovery of bad sectors or use chkdsk /r (depending on which way you decide to go about doing this). You'll almost certainly have to schedule the chkdsk to run on startup. The scan should take quite a while ... if it quits after a few minutes or seconds, something's interfering with the scan.
[How to perform disk error checking in Windows XP|http://support.microsoft.com/kb/315265]
Does the chkdsk find/repair any damage? If so, does it help with the error?
Message was edited by: b noir
Similar Messages
-
When I try to open video files purchased through iTunes in Quicktime, I get the message: 'Error 23132: an unknown error occurred. This never happened until I updated iTunes, but when I try to go back to the previous version, I still get the message. It is more convenient for me to play videos in Quicktime since iTunes is such a memory hog. Please help.
You may get better results if you switch to this alternate version: iTunes for Windows (64-bit - for older video cards) and, if needed, reinstall QuickTime. The new (nearly) all 64-bit version doesn't seem to play well with QuickTime. Perhaps if DRM authentication is required QuickTime needs to be able to see something that is part of the older 32-bit code.
tt2 -
My 2nd generation ipod touch is giving me the following error when I try accessing Itunes or the app store. "Cannot connect to the Store. A secure connection could not be established. Please check your date & time settings" I am on a secure networkl.
Can't connect to the iTunes Store
Make sure that time zone is correct in addition to date and time -
I just upgraded my mac book to 10.6.8 and downloaded the new version of itunes. When I try to open it and error message appears saying, "The iTunes Library file cannot be found or created. The default location for this file is in the "iTunes" folder in the "Music" folder."
I have tried a few things but iTunes closes right after i click okay. Anyone know anything?Look in your Home > Music folder. There should be an iTunes folder there and it should have a number of files and folders including one called library.itl You want to guide iTunes to that file. If you don't see that file or folder then in your next post you will have to be very specific as to what you do see or how you have your iTunes set up because that's where it should be according to default settings.
-
Just installed itunes but when i try to open it this error message pops up: "apple application required" then it suggests uninstalling and reinstalling which i've done a few times but nothing works
When you say you have tried everything, it would help if you told us what you have tried to avoid duplication.
When you installed iTunes did you get any error messages?
Anyway, on the face of it it may be worth trying a separate install of Apple application support.
Uninstall iTunes again. Now open Apple Software update, assuming it is working.
It should offer to download iTunes. Don't do it yet, go to the Tools menu and select Download only.
Then download iTunes. Then go to the tools menu again and select Open download folder and you should see a collection of six files.
Before going on, can you get to this stage OK?
One further thing I would like you to check, are you ahving any problems with Windows updates? Could you check in Windows Update to see if there are any failures. -
When I was updating my ipod touch 4g 8g 4.3.3 the USB came out and now it just shows connect to itunes and when i try to update it comes with error 6. I do all of the help things and nothing happoned
First see if placing the iPod in Recovery Mode will allow a restore.
Next try DFU mode and restore.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
If not successful then time for an appointment at the Genius Bar of an Apple store. You are not alone with this problem. -
hey guys,i tried to install the latest version of itunes but when i try to open it,it just comes up windows error 2 apple application support was not found,can anyone help me out and tell me what i need to do pls ?
If you run into the "another installation" message even after the reboot of the PC (which is an excellent idea by HTP ProXy), reregistering your Windows Installer Service is worth a try.
First, launch a command prompt as an administrator. In your Start search, type cmd then right-click on the cmd that comes up and select "Run as administrator".
At the command prompt:
Type %windir%\system32\msiexec.exe /unregister and hit enter.
Type %windir%\syswow64\msiexec.exe /unregister and hit enter.
Type %windir%\system32\msiexec.exe /regserver and hit enter.
Type %windir%\syswow64\msiexec.exe /regserver and hit enter.
Restart the PC and try another reinstalll. -
I keep getting and error when I try to start my iTunes. "Apple Application Support was not found. Apple Application Support is required to run iTunes. Please uninstall iTunes, Then install iTunes again. Error 2(Windows error 2)".... I have uninstalled and reinstalled several times and the error still occurs!!! This started happening after I installed the 10.3 update
I took the time to research it and come across a couple of people who experienced the same trouble and so I listed some of there steps(with Credits) and some people said that they worked.
Here is the original Link:
https://discussions.apple.com/thread/2151777?start=0&tstart=0
OK, this worked for me:( Original Post by r0tt3n4pp13)
1. Save iTunes install file to your desktop.
2. Disconnect from internet.
3. Disable Firewall/Security software.
4. Run install. Note that it installs Application Support and a bunch of other software this time.
5. Run iTunes.
6. Enable Firewall/Security software.
7. Reconnect to internet.
8. Download Watchmen Director's Cut post haste.
OR!
(Original post by Cr4z33)
1. Download and install WinRAR.
2. Right-click the iTunesSetup.exe icon and choose "Open with WinRAR".
3. Once the EXE is opened in WinRAR, double-click AppleApplicationSupport.msi and when the installer window is open choose "Repair".
4. Done! You can now run iTunes normally. -
I am trying to update my iPhone software but to do so I needed to update iTunes. When I try to do that, I keep getting this error message" "There is a problem with this Windows Installer Package. A program required for this install to complete could not....
Try the following user tip:
"There is a problem with this Windows Installer package ..." error messages when installing iTunes for Windows -
I have a 2GB IPOD with only 385 songs on it. I downloaded 2 CD's to iTunes and when I try and sync the IPOD I'm getting an error message that says I don't have enough free space. I thought a 2GB IPOD held at least 500 songs. I've even deleted songs from from iTunes library.
The figures that Apple used to use when saying how many songs coud fit onto any particular iPod were based on a 4 minute song at a Bit Rate of 128Kbps and that's the bit rate that songs sold by iTunes used to be in. However, now the iTunes Store sells songs at 256Kbps (as do many other MP3 stores) - which means that each song now uses twice as much storage space than before.
So if your songs have a bit rate of higher than 128Kbps, and/or they are all longer than four minutes each, that's why 385 songs is filling up your iPod. You can check how much space is being used when the iPod is connected to iTunes Library. Look on the Device panes for the capacity bar at the bottom of the window. How much space is being used by Music?
The solution is either:
Use iTunes to make 128Kbps versions to go onto your iPod - or,
Sync the iPod using Playlists and then choosing which Playlists you want on it. Smart Playlists may be the answer - you can set Smart Playlists up so that they automatically add and remove songs from your iPod, so that there is a constant change of songs (according to the rules you set) -
AFTER DOWNLOADING THE LATEST VERSION OF ITUNES, I CAM GETTING AN ERROR WHEN I TRY TO OPEN IT. MSVCR80.DLL WAS NOT FOUND. UNABLE TO LOCATE COMPONENT. BEFORE I REMOVE THIS VERSION AND TRY TO RELOAD AGAIN, JUST WANTED TO BE SURE I WOULDN'T LOSE ALL 200 PURCHASED SONGS ON MY PC.
Click here and follow the instructions. You may need to completely remove and reinstall iTunes and all related components, or run the process multiple times; this won't normally affect its library, but that should be backed up anyway.
(99220) -
I get a runtime error when I try to open itunes, any help?
I get a runtime error when I try to open itunes, any help?
Go to Control Panel > Add or Remove Programs (Win XP) or Programs and Features (later)
Remove all of these items in the following order:
iTunes
Apple Software Update
Apple Mobile Device Support (if this won't uninstall move on to the next item)
Bonjour
Apple Application Support
Reboot, download iTunes, then reinstall, either using an account with administrative rights, or right-clicking the downloaded installer and selecting Run as Administrator.
The uninstall and reinstall process will preserve your iTunes library and settings, but ideally you would back up the library and your other important personal documents and data on a regular basis. See this user tip for a suggested technique.
Please note:
Some users may need to follow all the steps in whichever of the following support documents applies to their system. These include some additional manual file and folder deletions not mentioned above.
HT1925: Removing and Reinstalling iTunes for Windows XP
HT1923: Removing and reinstalling iTunes for Windows Vista, Windows 7, or Windows 8
tt2 -
When i try to start itunes i get a message saying that the MSVCR80.dll file is missing and to reinstall itunes. When I try to reinstall itunes it tells me that I have an Error 7 (windows error 126). Can anybody tell me what this means? Thanks
Go to Control Panel > Add or Remove Programs (Win XP) or Programs and Features (later)
Remove all of these items in the following order:
iTunes
Apple Software Update
Apple Mobile Device Support (if this won't uninstall move on to the next item)
Bonjour
Apple Application Support
Reboot, download iTunes, then reinstall, either using an account with administrative rights, or right-clicking the downloaded installer and selecting Run as Administrator.
The uninstall and reinstall process will preserve your iTunes library and settings, but ideally you would back up the library and your other important personal documents and data on a regular basis. See this user tip for a suggested technique.
Please note:
Some users may need to follow all the steps in whichever of the following support documents applies to their system. These include some additional manual file and folder deletions not mentioned above.
HT1925: Removing and Reinstalling iTunes for Windows XP
HT1923: Removing and reinstalling iTunes for Windows Vista, Windows 7, or Windows 8
tt2 -
Received the following error message while trying to install icloud 3.1 and my iTunes stops when I try to access the iTune store, Microsoft.vc80.CRT,type="win32",ver="8.0.50727.6195",processorArchitecture="amd 64".HRESULT:0x800703EE. Recently upgraded to windows 8.1 then everything just wouldn't work properly
Could you solve this problem? I have similr problem. I can't upgrade Itune it generat the error below. I already unistall de all version but the error still appear. Could you help?
-
I downloaded itunes but when i try to install i get an error saying "There is a problem with the windows install. A programe needed to install could not be open"
can anyone help?Ok, Below is what worked for me somewhat.
Okay ... try downloading and saving a copy of the iTunesSetup.exe to your PC from the Apple website:
http://www.apple.com/itunes/download/
Now download a trial version of WinRAR:
http://www.rarlab.com/download.php
Open the iTunesSetup.exe with WinRAR, and try to run the standalone install of Apple Application Support from the AppleApplicationSupport.msi you find in there.
It works now BUT there are still problems. It is not allowing or recognizing my Cd/DVD player and i CANT burn. Looking still for this fix.
Maybe you are looking for
-
How to get data off a G4 mini with a failing hard drive.
For the record, here's how I ended up solving the problem - I had to invent this combination of approaches and it's not documented on any Web postings I could Google up during a week of working on this: Situation: Your G4 mini's hard drive dies (unbo
-
A problem to display a jsp Using MVC approach
Hello everybody I have got a problem with RequestDispatcher and I would like to get your help. I excpect the servlet to display the index.jsp page but the server displays a blank page. web.xml's <servlet> and <servlet-mapping> are set correctly at th
-
Run into issues moving an installation.
A few months ago I put a fresh install of arch on my laptop. I used an lvm in an extended partition, and used luks. I have a dual boot with windows 8. As I needed to give windows 8 more space I decided to backup my install and repartition the drive.
-
New tab page thumbnails are blank - always blank
I've updated to FF 13.0 (Linux) and was keen to have a look at the Opera-like tthumbnails when opening a new page from the tab bar. I open the page that should have small renderings of recently visited sites and I'm presented with empty squares with
-
I just updated the software in Pages to 5.1 on my iMac OS (Mavericks) but the Pages Application is giving me an error saying that I cannot open a document recently updated until I perform a software update! When I am in Pages and to go About Pages it