My Itunes will not reinstall

Itunes will not reinstall on my computer

It is telling me that the MSVCR80.dll driver is not on my computer

Similar Messages

  • Itunes will not reinstall.

    I backed up my iphone, downloaded a new version of itunes and went to open itunes again and it would not load.
    I received the error message: "the program can't start because MSVCR80.dll is missing from your computer. try reinstalling the program to fix this problem." I tried reinstalling it twice with no luck. How can I reinstall itunes on my computer. I have set the registry to administrative full priviledges."

    Hi tantrum65,
    If you are having issues with iTunes after an attempted update, you may find the following article helpful:
    iTunes 11.1.4 for Windows: Unable to install or open
    http://support.apple.com/kb/TS5376
    Regards,
    - Brenden

  • Itunes will not reinstall any ideas

    I went to sync my ipod to the the itunes on my HP laptop, windows vista. First warning "ipod won't sync" then it told me itunes doesn't recognize ipod.  This is all after working well for 6 months.  I got on line to the windows tech I use and they came to the conclusion that my windows vista installer was corrupt and I needed the original operational cd to restore the computer.  Of course the vista program was preprogramed from the factory!  I have installed other programs since and they acted all right.  I tried to use windows media center but that told me I needed the itune driver in order to sync the ipod with windows media center.  Of course I can't down load that!  ANY IDEAS?

    thanks! this sound like no solution at all. technically speaking sound slike i am not able to fix it

  • HT5654 Just tried 3 times to update iTunes on my PC running Vista.  There was an error.  It stopped the installation.  Now iTunes will not start at all.  The error message tells me to reinstall which I tried but did not work.  What should I do?

    Just tried 3 times to update iTunes on my PC running Vista.  There was an error.  It stopped the installation.  Now iTunes will not start at all.  The error message tells me to reinstall which I tried but did not work.  What should I do?

    Hello, Jdragone. 
    Thanks for the question.  Start with completely uninstalling iTunes and all of it's components in the order specified in the article below.  Once this is done, download and install iTunes.
    Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
    http://support.apple.com/kb/HT1923
    If you receive any errors when uninstalling any components of iTunes, try the steps in the article below for each component that gives you an error.
    "The feature you are trying to use is on a network resource that is unavailable" alert appears when removing Apple software in Windows
    http://support.apple.com/kb/TS3704
    Cheers,
    Jason H.

  • My itunes will not work at all. i have deleted and reinstalled in over ten times, i have ended the process, i have reinstalled quicktime i few times, i have deleted many folders. What else can i do? Please help:(

    My itunes will not work at all. i have deleted and reinstalled in over ten times, i have ended the process, i have reinstalled quicktime i few times, i have deleted many folders such as TEMP, itunes helper et What else can i do? Please help:(

    Now it sometimes keeps coming up and working but once i plug an ipod in it freezes my whole computer up and no i dont get any response from itunes at all

  • My Itunes will not stay open, I have uninstalled it and reinstalled it and it still won't stay open

    My Itunes will not stay open. Everytime I open it it just gives me a wait signal and then closes down on it's own. I have uninstalled it and reinstalled it and it still won't stay open.... what should I do now?

    Try removing the Genius database.  In the "Finder" go to the /username/Music/iTunes/ folder and delete the "iTunes Library Genius.itdb" file. This may allow the program to launch again. This file will be recreated upon first use of the "Genius" feature.

  • My itunes will not open when I click on the icon. An system error appears. "the program can't start because MSVCR80.dll is missing from your computer. Try reinstalling the program to fix this problem." Any ideas on how to resolve, I have tried installing

    My itunes will not open, it displays an error that MSVCR80.dll is missing. I tried reinstalling itunes but it fails because the service is not able to start.

    Same thing happened to me. I ended up completely uninstalling itunes then downloaded it again from http://www.apple.com/itunes/.   If you're using firefox, for some reason itunes will not download and  I  don't know if using googlechrome will also have problems,so just to  be  sure that it will work on your first try, use internet  explorer  when you download itunes. Good LUCK!!

  • My itunes will not start in Win XP. I get an error that says MSVCR80.dll can't be found. I am scared if I just reinstall iTunes that I will lose all my music and apps that are in the old itunes. What can I do.

    My iTunes will not start in Win XP. I am getting an error that says MSVCR80.dll can't be found. I am concerned that if I just do a reinstall
    of  iTunes it will overwrite or delete all the music and apps I have on the current app that won't start. When I boot the PC I get the following:
    APSDaemon.exe - unable to locate. MSVCR80.dll not found. Reinstalling application may fix this problem. How can I get iTunes started without losing
    all my music and apps? Thanks

    It won't unless a problem occurs. Back them up, uninstall iTunes and all related components, and reinstall them.
    (100013)

  • My iTunes will not start.  The box on the error message APSDaemon.exe,  And message says "This application failed to start because MSVC80.dll was not found.  Reinstalling may fix."  I did the reinstall and I get the same error.

    My iTunes will not start.  The box on the error message APSDaemon.exe,  And message says "This application failed to start because MSVC80.dll was not found.  Reinstalling may fix."  I did the reinstall and I get the same error.  The error first happened after I approved the an iTurns update.

    Same problem today. Took five times to reinstall without any error messages. Apple has posted a way to fix and you should follow their's first. I finally got to upldate correctly by doing their fix but with one difference. I did the following:
    1) Went to the C:\program files (x86)\iTunes and C:\program files\iTunes folders and moved every file ending in .dll to the desktop (even if two files in same location had the same name, just replace)
    2) Restarted computer and still got error message
    3) Uninstalled all apple programs possible in the following order......itunes, apples software update, apple mobile device support, bonjour, and apple application support.....all performed using the microsoft control panel
    4) put all the .dll files on the desktop in the trash and emptied (this is a step apple support did not specifically put in their fix but for a final try I wanted to delete everything apple).
    5) Restarted computer.
    6) Re-installed itunes from apple website
    No error messages during re-install and was able to open shortcut in one try. Even updated my ipad to make sure everything was working.

  • My Itunes will not start after the latest update. I keeo getting error message tEventType : InPageError     P1 : c000009c     P2 : 00000003 . I have tried to reinstall but no joy. Any advise?

    My Itunes will not start after the latest update. I keeo getting error message tEventType : InPageError     P1 : c000009c     P2 : 00000003 . I have tried to reinstall but no joy. Any advise?

    'The installer has insufficient privileges to modify this file C:\Program Files (x86)\Common Files\Apple\Apple Application Support\Web kit.resources\inspector\Images\Spinner Inactive Selected.gif.'
    That one's consistent with disk/file damage. The first thing I'd try with that is running a disk check (chkdsk) over your C drive.
    XP instructions in the following document: How to perform disk error checking in Windows XP
    Vista instructions in the following document: Check your hard disk for errors
    Windows 7 instructions in the following document: How to use CHKDSK (Check Disk)
    Select both Automatically fix file system errors and Scan for and attempt recovery of bad sectors, or use chkdsk /r (depending on which way you decide to go about doing this). You'll almost certainly have to schedule the chkdsk to run on startup. The scan should take quite a while ... if it quits after a few minutes or seconds, something's interfering with the scan.
    Does the chkdsk find/repair any damage? If so, can you get an install to go through properly afterwards?

  • HT1459 Serial number is faded and too small to read. Itunes will not recognize my IPod Classic. How can I delete the current iPod software and reinstall it to see if this would solve the problem?

    I recently upgraded my Itunes softeware, now itunes will not recognize my IPod Classic. If I delete the current IPod software and reinstall it, would this solve the problem, and if so, I'll need step by step instruction.

    Yep.
    Take a look here:
    http://www.snsforums.com/index.php?showtopic=235
    It appears that SANmp is indeed the most likely source of your problem.

  • ITunes will not open on my Windows 7 computer.  I've uninstalled it and reinstalled it, but it still won't open?

    iTunes will not open on my Windows 7 computer.  I've uninstalled it and reinstalled it, but it still won't open.  I'm trying to synch my iPad and iPhone, which I haven't done for awhile, but right now I'm having no luck.  I'm sure there is a switch I need to turn on or off, but have no idea where to find it.  Can someone help?

    In the course of your troubleshooting to date, have you worked through the following document?
    iTunes for Windows Vista or Windows 7: Troubleshooting unexpected quits, freezes, or launch issues

  • Hi- I applied the iTunes up to my Windows 7 86bit PC last Wednesday and iTunes will not load due to a Runtime error r6034Access to C Runtime Library Incorrectly. Then I get an windows error code 1114. I have tried rollling back and reinstalling but no joy

    Hi- I applied the iTunes up to my Windows 7 86bit PC last Wednesday and iTunes will not load due to a Runtime error r6034Access to C Runtime Library Incorrectly. Then I get an windows error code 1114. I have tried rollling back and reinstalling but no joy

    Hi Keen itunes User,
    Thanks for using Apple Support Communities.  This article has steps you can take for the error you're seeing:
    iTunes 11.1.4 for Windows: Unable to install or open
    http://support.apple.com/kb/TS5376
    Cheers,
    - Ari

  • I have windows 7 64 bit but the new itunes will not install because it can't find itunes64.msi.  I have searxhed evertwhere on my pc. In addition, I can't uninstall the itunes and reinstall for the same reason.

    I have windows 7 64 bit but the new itunes will not install because it can't find itunes64.msi.  I have searched evertwhere on my pc. In addition, I can't uninstall the itunes and reinstall for the same reason. I can't upgrade for my icloud account.

    Try the following steps:
    1. Go to Microsoft website to fix install and Unistall problems. Click "Run now" from Fix it to remove all iTunes & related installer files:
    http://support.microsoft.com/mats/Program_Install_and_Uninstall
    Be aware that Windows Installer CleanUp Utility will not remove the actual program from your computer. However, it will remove the installation files so that you can start the installation, upgrade, or uninstall over.
    2. You should remove all instances of iTunes and the rest of the components listed below:
    it may be necessary to remove all traces of iTunes, QuickTime, and related software components from your computer before reinstalling iTunes.
    Use the Control Panel to uninstall iTunes and related software components in the following order:
    iTunes
    QuickTime
    Apple Software Update
    Apple Mobile Device Support
    Bonjour
    Apple Application Support (iTunes 9 or later)
    Follow the instructions from Apple article listed here: http://support.apple.com/kb/HT1923 to remove all components
    3. Reboot your computer. Next, download iTunes from here:http://www.apple.com/itunes/download/ and install from scratch

  • My itunes will not connect to the itunes store?? and when I open itunes it runs my cpu at 100%??? I have uninstalled and reinstalled. It only started doing this when I updated it....what do I do???

    my itunes will not open the itunes store...it will will attempt to open and then simply stop trying.... also everytime I open Itunes it will run my cpu up to 100%...this makes my computer run really slow. my frustration is it didn't do this untill two days ago when I downloaded the suggested apple updates....I already uninstalled it in the order suggested online and reinstalled, but I still have the same problem I am kind of frustrated and just want to know how to fix it?????? please help

    It worked for me, for iTunes Store and Safari both!
    amandav2 wrote:
    I found a solution to my problem.
    > start menu
    > accessories,
    > right click on the command prompt icon and choose "run as administrator". 
    Once it opens, type in the following command...
    netsh winsock reset
    hit enter
    You should get a message that the winsock reset successful and you will need to reboot your computer. 
    Reboot and when I reloaded itunes the store loaded fine.

Maybe you are looking for

  • Slow mac mini

    Mac Mini G4, 1.33 GHz 512 MB OS 10.4.11 Has suddenly begun slowing down when I have been loading web pages. This occurred a day or two after I installed Apple's Sept. 15 Security Upgrade. Also, I found a drop-down message in my network preferences th

  • Photoshop CS4 Crash

    This is going to be pretty general because I have really have no clue and no error messages to go on. I went on vacation a week ago.  I got back and Photochop CS4 doesn't work. It starts up ok and then when I try to open a file (File>Open) it crashes

  • Calculation based on two result columns in combined report

    Hi all - I have a combined analysis and I need to add a result column based on two of my result columns. The calculation involves one column from my first report and one column from my second report. The first report has # of opportunities and my sec

  • Preparing and getting error in remote copy

    Dear experts, now we decided to do client copy in quality to development in that process now i completed test run and result is showing completed successfully. but in below it is showing 3 tables as rfc error ... what it means is that test run is com

  • Why I can't do that?????

    Why i can't download the firmware update (build 23.0.F.1.82) through OTA why only by pc companion? Please idon't have pc because outboard for month is there a way?????