MY LINKSYS WIRELESS ROUTER STOPPED WORKING AND WILL NOT CONNECT !!!! HELP

SIMPLE FIX :  PRESS AND HOLD THE RESET BUTTON FOR 30 SECONDS.  THE RESET BUTTON IS LOCATED ON THE BACK OF THE LINKSYS MODEM.  DONE !!!!!!!  YOU'RE WELCOME !!!!

Maybe one fix however there maybe other problems or interferences that may cause devices not to connect or inhibit proper router operations. Entails more troubleshooting then doing a factory reset. Sometimes it could help though.
Thanks for your suggestion though.

Similar Messages

  • Since downloading iOS 8 on my iPad 2 it has stopped working and will not connect to iTunes

    Since downloading iOS 8 on my iPad 2 it has stopped working and will not connect to iTunes to do a restore.  I have tried to do a reset using the sleep button and home key and all I get is a white band across the screen and then it boots into the main system but it is just a series of white lines going across the screen, how can I do a restore on this?

    Hey dbwithers,
    Thanks for the question. I understand that you are experiencing issues with your iPad after attempting to update to iOS 8. To isolate these issues, let’s try placing your iPad in recovery mode and attempting a restore with iTunes:
    If you can't update or restore your iPhone, iPad, or iPod touch
    http://support.apple.com/kb/HT1808
    Thanks,
    Matt M.

  • Airplay stopped working and will not restart?

    A new airplay stopped working and will not restart - it is not recognized in the airport utility - yellow light flashing

    Thank you and yes it is an Airport Express.
    Reset router; could not locate the unit using the Airport Utility.....took back for an exchange under warranty as it was only a week old....no problems at store - exchanged for a new one

  • In Photoshop Elements 11, the editor workspace has stopped working and will not open.

    In Photoshop Elements 11, the editor workspace has stopped working and will not open.

    Operating system? and how are you opening it? From a shortcut, from the welcome screen, from the organizer, from the program/application file itself?

  • My new iPhone randomly just stopped working and will not turn on what should i do?

    My new iPhone randomly just stopped working and will not turn on what should i do?

    thanks paul, i just had a similar problem, had to hold it for 30 seconds and the apple sign has come up, my phone was vibrating for over two hours completly unresponsive, now my lap top seems to be comunicating too, oh hello, its back on again...thank you!!!!

  • Suddenly all of my Office-programs have stopped working and will not launch on my MacBook. Could anyone give an amateur from Norway a hint of what may cause the problem? And I can not find the installation-disc for Office...Super! :)

    Suddenly all of my Office-programs have stopped working and will not launch on my MacBook. They were all already installed when I bought the computer. Could anyone give an amateur from Norway a hint of what may cause the problem? (And I can not find the installation-disc for the Office Programs...Super!)

    Have you contacted Microsoft support - http://www.microsoft.com/mac/support ? 

  • My one day old nano 6 has stopped working and will not restart can you help?

    my one day old nano 6 has stopped working and will not restart can you help?

    try this........ http://www.apple.com/support/ipodnano/assistant/itunes/

  • HT201413 my ipad stopped working and will not start error message 1601 comes up when i try to restore any one have advice on what to do

    my ipad 4 stopped working, it will not switch on, charge nor will it allow me to restore, the errror message 1601 comes up when trying to restore does anyone know how to help as i am not near an apple store to get help

    You have already seen this for Error 9
    This error occurs when the device unexpectedly loses its USB connection with iTunes.  This can occur if the device is manually disconnected during the restore process.  This issue can be resolved by performing USB troubleshooting, using a different USB dock-connector cable, trying another USB port, restoring on another computer, or by eliminating conflicts from third-party security software.
    For a new machine Error 11 !
    Check Hosts file if it is diverting iTunes away from Apple servers.

  • My phone completely stopped working and will not turn back on

    My iPhone 5S turned off (on its own) and will not turn back on.  It is fully charged.

    Try this: What to do if your iPhone or iPad will not turn on

  • Itunes has stopped working and will not open

    itunes stopped working for unknown reason and would not open. after several tries I used system restore taking it back to an earlier date.  when that failed to work, I uninstalled and downloaded new version, several times. still would not open and I am pretty sure I lost my library which is frustrating because I use it for work. completely confused about what to do next. I am running windows 7.

    Not completely sure. But if you think it is an iTunes issue...... follow through this: Removing and reinstalling iTunes, QuickTime, and other software components for Windows Vista or Windows 7
    ALSO, if you feel like all your music will be gone as well follow through these 2:
    > Downloading past purchases from App Store, iBookstore, and iTunes Store
    > How to use your iPod to move your music to a new computer
    IF YOU THINK ITS A COMPUTER ISSUE, RESTART YOUR COMPUTER BEFORE DOING ALL THIS.

  • Satellite Pro L20: WLan adaptor stopped working and will not enable

    Hi,
    I have a Satalite Pro L20 which has been working fine. However, just before Christmas 2006, the wireless adaptor, (Atheros AR5005G), stopped working.
    Windows XP Pro SP2 can see the adaptor, and network connections shows it as being enabled, but it doesn't see any networks.
    The Atheros Client Utility Troubleshooter says that the adaptor pases it diagnostics up to the Radio test, when it says that the Radio is disabled and needs to be enabled in the Client Utility.
    "Excellent!", I thought, opening up the utility with anticipation. Looked under the Action menu to find 'Enable Radio' is greyed out!!!
    HELP!!
    Any assistance is very welcomed.
    Cheers,
    Barry Smith.

    Is there any hardware option to turn on and off your Wlan card? (switch)
    Did you upgrade your Wlan driver recently? (if yes, maybe with wrong driver?)
    I've had a similar issue once and solved it through driver updates... wanna give it a try?
    You can download the generic Atheros driver (Version 5.0.0.107) available from here:
    http://www.dd-wrt.com/dd-wrtv2/down.php?path=downloads/drivers/&download=Atheros5_0_0_107.zip
    Regards
    electrochain

  • Pavilion DV6 1320sl stopped working and will not boot

    Pavillion DV6 1320 was beiing used.  Had been running hot - fan was on all the time. The left mouse pad button was pushed and the screen went black with a blinking cursor. It will not boot.  There have been no software or hardware changes, a nd it hasn't been dropped.  Win  7 64 bit is installed and it has run OK since new in 2009.  There are no error messages.  Turning off the machine is with i single depress of the power button.
    Turning machine on disk=plays BIOS message to sel esc to enter BIOS.  From BIOS, system check of memory, hard disk and hard disk SMART have been run.  All passed.
    No other BIOS function works - ie f9, f8 ,or f11 all do nothing.
    I ran the hard reset to no avail.  The buttons glow but the screen remains black with blinking cursor.  I followed the HP guideline for trouble shooting a black screen with glowing buttons.  Didn't help.  swapped each memory bank and tried each possible bank configuration.  Didn't help.  Replaced the RTC battery and reset BIOS to default.  Didn't help.  Hooked up another monitor but that didn't help either. 
    I did not try system restore, but f11 doesn't work and booting from cd was unclear as to results - I didn't have  a boot disk so I used disk 1 of the restore set.  Nothing happened.
    I used canned air to blow out the cooling holes but they didn't seem clogged (although the fan was on much of the time these past few months).
    I'd appreciate any ideas.  Perhaps a component has been burned.  What would be the visible symptoms of a CPU failure?  What about the chip set - if the Northbridge fails, what would it look like? 
    I don't think it has actually loaded and is a video chip failure but who knows?  I'm open to suggestions.
    Rob

    Thank you and yes it is an Airport Express.
    Reset router; could not locate the unit using the Airport Utility.....took back for an exchange under warranty as it was only a week old....no problems at store - exchanged for a new one

  • PSE 12 has stopped working and will not open.

    PSE 12 suddenly stopped working while editing.  I tried restarting the Organizer which opens but does not finish loading after a few seconds, and gives an error message ... "A problem caused the program to stop working correctly.  Windows will close the program and notify you if a solution is available."  I've received no notifications.  Any suggestions?  Do I download another copy?  How do I locate and retain my Catalog which is really important?  Thanks in advance.

    Operating system? and how are you opening it? From a shortcut, from the welcome screen, from the organizer, from the program/application file itself?

  • Adobe Air stopped working and will not install on my macbook

    Hello, i have been having an issue with adobe Air for several hours where it will not launch any applications that use Adobe Air and then when i try and install a new version of Adobe air it will not lets me install the new version and gives me the error message
    "This application requires a version of Adobe AIR which cannot be found.
    Please download the latest version of the runtime from
    http://www.adobe.com/go/getair,
    or contact the application author for an updated version."
    Now i have been looking for an answer to my problem all night, i tried several solutions to no avail these solutions include turning off automatic graphics switching, uninstalling all my adobe softwares and trying to reinstall Air, Downloading the Adobe Air with Firefox, Safari, and Google Chrome. None of these solutions worked and this is very frustrating.
    Please can anyone give me a solution to my problem.

    JacobEPhillips please try the steps listed in Troubleshoot AIR installation | Mac OS - http://helpx.adobe.com/air/kb/troubleshoot-air-installation-mac-os.html.

  • My Wi-Fi randomly stopped working and will not turn on.

    So one night, I closed all my applications and did the regular routine, "procedures" if you will. The next morning, I turned on my MacBook and the Wi-Fi said it was off, and so I turned it on, but it wouldn't turn on. The little icon would stay at the off position while the menu is stating it is on and it isn't! It also doesn't search or join other networks. I decided to take matters into my own hands and rebooted into Recovery mode, I disconnected the Ethernet (Which works perfectly fine EVEN THOUGH the Wi-Fi doesn't work) and turned my Wi-Fi on, and I was blown-away. The Wi-Fi was full strength and was working fine. I checked my Facebook and Twitter without a beep. What is the problem here? I have installed the 10.8.5 Supplemental Update and it still doesn't work.
    Please help!
    Computer description: MacBook (Late 2008 Aluminum)
    500GB HD
    OS X Mountain Lion (I think? LOL)

    Result. My wifi is back working again.
    After a number of evenings trawling through the support pages, I found a youtube clip from a chap taking his macbook apart and locating the airport adaptor and connecting cables.
    The cable in question is located in the black plastic bar below the display and is a pain to get to. Apprently the most common cause of this issue is the cable becoming dislodged through an impromptu knock. I can see how this happened to me by travelling on the London Underground everyday with my mac in my shoulder bag.
    Anyway, having seen the video, I bottled it and went to the genius bar obviously having seen the clip. I had a worst case scenario quote of £95.00, but a quote for a replacement cable and reseal being much less. I'm quite savvy but my mac is sacred and i'd rather the pros did it. Turned out to be £37.00 and my mac came back fixed and clean.... £37.00 for piece of mind is well worth it.
    Here's the youtube clip but please don't take unnecessary risks. http://www.youtube.com/watch?v=UsSIUs7jzQc
    Best of luck all.
    Al

Maybe you are looking for

  • IDVD '04 will not burn disk

    I've done a second install of iDVD on my 2nd HD. When I tried to burn a DVD-R disc from imovie, it went through all the motions then gave me this error: The recording device reported the media error: Power calibration area error (0x73, 0x0.3) I've go

  • Epson Stylus Photo 750 not working  after upgrade to,  X.5.2

    I'm not sure as to what has happened since my update, however I can't print any type of documents. However my printer will run a test page on head cleaning, so I know it's not the printer. I'm thinking it has something to do with the driver, because

  • Adobe Indesign CC2014 and mac freeze crash at dialog box "nouveautés"

    Hi ! Adobe Indesign CC2014 and the mac freeze crash when the dialog box "nouveautés" appears ! The Indesign CC work fine and doesn't crash, but the CC2014 freeze on this dialog box ! Is there a possibility to do this dialog box don't appears ? In pre

  • Alternative Selection Options:

    Hello, I searched through the questions and did not find a question comparable to what i am looking for. I want to have a radio button selection screen. Based on the radio button they choose, then display further selection criteria for that button( p

  • Broadcast Wav Format

    Hi there, A client of mine has asked me to supply some audio in .BWF format. The way I understand it, a broadcast wav is the same (ish!) as a 'normal' wav but with extra metadata, timestamping, etc. I can't offhand think of an application that will a