My Macbook Pro will not start with battery connected.

I have a Macbook Pro which I purchased in 2011 and recently it would not start. I later disconnected the battery and plugged it in and it now works but only without the battery disconnected. When it would not work and the battery was connected, the battery lights indicated that it was fully charged. Any suggestions?

Was this a used MBP, the 2011 MBPs only have internal batteries. How did you disconnect the battery?
This behavior sounds like a failure or fault in the batttery circuit and the only way to diagnose that is by taking the MBP to an Apple store genius bar or Apple authorized service center to have the techs run their tests.

Similar Messages

HT3964 macbook pro will not start on battery power works fine when plugged in

My macbook pro 15 inch early 2008 model will not start on battery power but works fine when plugged in.

check the battery info.. >about this mac>more info>system report and select "power" on the lefthand column. How many cycles? What does it say about the condition? etc.

My MacBook Pro will not start. When I started it goes to a gray screen with the Apple logo and has the spinning dial. When I started in safe mode it will not start. In safe mode it as an error message that says MacBook Launch_msg():Socket is not connected

My MacBook Pro will not start. When I started it goes to a gray screen with the Apple logo and has the spinning dial. When I started in safe mode it will not start. In safe mode it as an error message that says MacBook Launch_msg(): Socket is not connected

If running 10.7 or later hold down Command-R at Startup.
This should invoke recovery Mode.
Choose Disk Utility.
Select your Hard drive. Inspect the SMART Status in the lower right of the window for "Verified".
Select the Mac OS X Volume (originally Macintosh HD) click (Repair Disk)
If errors, run again until it comes clean or gets stuck.
Report any error messages.

My MacBook Pro will not start up after entering correct password.

My MacBook Pro will not start up after entering password. Circle with an X in it and 'cancel' below it is on bottom of screen. When clicking on cancel, nothing happens. This just started last night.

Hi MJTOOTS,
Since you are getting to the login screen, it is booting past the "gray screen" phase, so try the steps in this article, like a Safe Boot.
Resolve startup issues and perform disk maintenance with Disk Utility and fsck
http://support.apple.com/kb/ts1417
You may also want to see if any of your Login Items are causing an issue.
OS X Mavericks: Open items automatically when you log in
http://support.apple.com/kb/PH14173
Thank you for visiting Apple Support Communities.
Nubz

MacBook pro, will not start up- drive begins

MacBook pro, will not start up- drive begins?

OK, then try this:
Repair the Hard Drive and Permissions
Boot from your Snow Leopard Installer disc. After the installer loads select your language and click on the Continue button. When the menu bar appears select Disk Utility from the Utilities menu. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list. In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive. If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported click on the Repair Permissions button. Wait until the operation completes, then quit DU and return to the installer.
If DU reports errors it cannot fix, then you will need Disk Warrior and/or Tech Tool Pro to repair the drive. If you don't have either of them or if neither of them can fix the drive, then you will need to reformat the drive and reinstall OS X.
Since you can boot into safe mode successfully, I'm assuming the problem may be with a bad third-party extension or plug-in (such as a driver for third-party hardware or a bad Flash plug-in, for example.) It can also be a problem with a bad cache or preference file. If the above doesn't help then use a utility like Lion Cache Cleaner 6.0.5, Cocktail, TinkerTool Sys..., or OnyX to clean out user, system, and font caches.

Mac Book Pro will not start on Battery Power

Mac Book Pro will not start on Battery Power although battery at 98% need to connect charger. When started date and time incorrect, comes up as 1st Jan 2012.

What is the exact model of your MBP? The date change often is an indication of power loss to the MBP, such as disconnecting the battery.
If the SMC reset does not solve the situation, post this from your MBP:
Make certain that the power adapter is connected.
Ciao.

After instaling the update for OS yesterday (saturday 7.10.2012) my macbook pro will not start. The instaling proses start but stopp after 2-3 minutes. I have started mayby 10 tims know but it stops every time. Help, its just a monts ago my iMac hard fail

After instaling the update for OS yesterday (saturday 7.10.2012) my macbook pro will not start. The instaling proses start but stopp after 2-3 minutes. I have started mayby 10 tims know but it stops every time. Help, its just a monts ago my iMac hard fail

Actually it sometimes gets a little further, the display will dim and the pointer will appear and then whoop it will turn off. if i do a verbose start up, it will finish all the steps, the white screen will appear and dim and then it will turn off.

My MacBook Pro will not start up - it was just on last night - what do I do?

My MacBook Pro will not start up. I used it last night and it was fine. What should I do?

Try a SMC reset.
http://support.apple.com/en-us/HT201295
Do you get anywhere in the startup sequence?
Ciao.

My macbook pro will not start up. stuck on grey loading screen and spinning dial. HELP

my macbook pro will not start up. stuck on grey loading screen and spinning dial. i shut it down last night and now when i try to turn it on it will not get past this page. lights and sounds work but nothing happens. please help

Power it down by holding the power button down. Then try to power it up again. Post back. It would help if we knew what OS you are running, the model MBP...

My macbook pro will not start up or turn on. any suggestions?

My macbook pro will not start up or turn on. Any suggestions?

I had the same issue I bought my MacBook Pro in Jan. my harddrive was bad and they had to replace it. I know the guy held down the shift botton for a little then pressed the power botton while still holding down the shift botton and it turned on but not completely since my hard drive was bad.

My MacBook Pro will not powerup (even when connected to power supply).

My MacBook Pro will not powerup (even when connected to power supply). The caps lock key is the only light on.

Hi PatB11902,
Thank you for visiting Apple Support Communities.
If your MacBook Pro does not seem to power on, but the caps lock key will light up when you press the caps lock key, you are likely seeing a video issue.
There are several steps that can help troubleshoot this behavior, found at this link:
Apple computers: Troubleshooting issues with video on internal or external displays - Apple Support
Start with these steps:
Reset the system
You can reset the Mac's parameter RAM and SMC.
Start up in Safe Mode.
If your Mac does not start up normally after these steps, here are some additional tips that can help:
Troubleshooting: My computer won't turn on - Apple Support
Verify you have a good connection from your Mac to the wall outlet by confirming the power cord and adapter if present are securely connected and plugged in. To check if the wall outlet is working, plug in a lamp or other electrical device.
If the wall outlet is working and you continue to have no power try another power cord or adapter if available. If it works you may need a replacement cord or adapter.
Disconnect all accessories that are plugged in to the computer, such as a printer, hub, or other mobile device.
If your Mac supports user-installable memory, solid state drive, or hard drive, and you recently installed any of these, make sure they are installed correctly and are compatible with your computer. If possible, reinstall the original memory or drive into the computer to find out if the behavior persists afterwards.
If you are still unable to start up your computer after trying each of these steps, visit an Apple Store or Apple Authorized Service Provider (AASP) for further diagnosis. If you plan to visit an Apple Retail Store, make a reservation at the Genius Bar using http://www.apple.com/retail/geniusbar/ (available in some countries only).
Note: Diagnostic fees may apply for issues not covered under warranty or the AppleCare Protection Plan (APP).
Sincerely,
Jeremy

HT1379 My Macbook Pro will not start at all. I automatically get the Apple Icon and a pinwheel that keeps clocking. How do I fix?

If anyone can assist with why my Macbook Pro will not pass the first screen, please respond. I have been getting the spinning pinwheel for a few days and cannot lg on now. In recent days I deleted some files and thought that would help the computer move a little faster but now it will not sllow me to access my account. Any suggestions on how to get pass the initial screen?

Could be many things, we should start with this...
"Try Disk Utility
1. Insert the Mac OS X Install disc, then restart the computer while holding the C key.
2. When your computer finishes starting up from the disc, choose Disk Utility from the Installer menu at top of the screen. (In Mac OS X 10.4 or later, you must select your language first.)
*Important: Do not click Continue in the first screen of the Installer. If you do, you must restart from the disc again to access Disk Utility.*
3. Click the First Aid tab.
4. Select your Mac OS X volume.
5. Click Repair Disk, (not Repair Permissions). Disk Utility checks and repairs the disk."
http://docs.info.apple.com/article.html?artnum=106214
Then try a Safe Boot, (holding Shift key down at bootup), run Disk Utility in Applications>Utilities, then highlight your drive, click on Repair Permissions, reboot when it completes.
(Safe boot may stay on the gray radian for a long time, let it go, it's trying to repair the Hard Drive.)
If perchance you can't find your install Disc, at least try it from the Safe Boot part onward.
If 10.7.0 or later...
Bootup holding CMD+r, or the Option/alt key to boot from the Restore partition & use Disk Utility from there to Repair the Disk, then Repair Permissions.
If that doesn't help Reinstall the OS.

My MacBook Pro will not start up, any suggestions?

My MacBook Pro will not boot up. I was aware of something odd when I switched it off a couple of hours ago now when I push the 'on' switch something starts - fans I think, and the little indicator light on the front. Does anyone have any suggestions on how to solve this problem?

I had the same issue I bought my MacBook Pro in Jan. my harddrive was bad and they had to replace it. I know the guy held down the shift botton for a little then pressed the power botton while still holding down the shift botton and it turned on but not completely since my hard drive was bad.

My macbook pro will not start up. I get the apple logo and the little start up waiting avitar. I tried everything including starting with my back up drive and nothing happens.

My macbook pro mid 2012 will not start up. I was running bitdefender and when I went to see if it was done, I had the apple logo and the loading (winding circle) on the screen. I can not get out of this. I used my back up external drive and it did nothing. It did light up.

samnleosgpa,
you may have faulty RAM. Are you able to boot into your MacBook Pro’s Apple Hardware Test (“AHT”)? If so, try running it to see if it can detect a problem. If you’re not able to run its AHT, and you’ve upgraded your MacBook Pro’s RAM before, try reïnstalling its original RAM and see if you can get past the “-6002F” error code. If you aren’t able to run its AHT, and you haven’t upgraded its RAM or you no longer have its original RAM, then I’d recommend that you make an appointment at your nearest Apple store to have them diagnose the problem.

My macbook pro will not start after pressing the power button

I have bought a macbook pro last year and now, I have a great problem since a few months.
My macbook does not boot up, I hear no fan noices and no LED lights are blinking...
Battey is full, but nothing happens (means system will not start up).
I have also tried to start with the Power button - but the similar effect "NOTHING HAPENS".
What I don't understand is, if I do nothing for one or two days and press then the power button, the system will start up and full functionality for a few days.
And anytime I get the same problem again... and must wait also for a few days.
Can anybody support me please.
Thank you all in advance and looking forward to a fast reply.

Try reseting SMU as suggested in link below
http://support.apple.com/kb/ht3964
Allan

My Macbook Pro will not start with battery connected.

Similar Messages

Maybe you are looking for