My nano has a white screen cannot reset

My nano has a white screen I tried the menu select buttons to do a reset it resets but the screen is still white. I could faintly see the apple sysmbol if I look at the nano at a sharp angle.

I erased all the files on it put it in the charger overnight and it got better.  Sorry I wish I had a better answer but basically the ipod just started working again.

Similar Messages

  • Nano has a white screen

    My Nano has a white screen, I tried everything get it off. I need some help please

    I erased all the files on it put it in the charger overnight and it got better.  Sorry I wish I had a better answer but basically the ipod just started working again.

  • My ipod nano has a white screen and beeps twice, Can i fix it?

    I left my ipod in my pants and they went througth th washer and dryer, I put them in white rice for two days and it still has the white screen and beeps twice, Can i fix it?

    Hello Emmuhhlieee,
    Thanks for using Apple Support Communities.
    For more information on this, take a look at:
    iPod nano (6th generation): Hardware troubleshooting
    http://support.apple.com/kb/ts3474
    Display shows a white screen
    Try putting the iPod into disk mode:
    Reset the device (press the Sleep and Volume Down buttons simultaneously until the display turns black—about eight seconds).
    When the display turns black, hold down the Volume Down and Volume Up buttons simultaneously until the device enters Disk mode.
    While the device is in disk mode, sync it to iTunes and try to restore.
    Best of luck,
    Mario

  • HT4528 my phone has a white screen and resetting it wont do anything?

    My iphone has a white screen that will not go away. I have tried to reset it and it just goes black then turns on again and goes back to the white scree?

    Sounds like it's broken, doesn't it?  Bring it to Apple for evaluation.

  • My ipod nano has a white screen, how do i fix this?

    My Ipod nano has acted weird for the past week, then yesterday the screen goes white!! I don't know how to fix it or what to do.

    If a hard reset of the device or a restore of it via iTunes does not resolve the issue, it's likely hardware related.  Could be a damaged LCD or a loose ribbon cable that connect to your iPod's logic board.
    Either way, your iPod will need servicing in order to gain full functionality of it.
    B-rock

  • My wifes Ipod Nano has blank white screen but still works

    As the topic says, the nano has a blank white screen but still plays songs and works with iTunes. i have tried reseting it via holding menu and select for 10 seconds without success also i have tried holding select and play/pause after reseting (hard reset i guess) without any success.
    I have tried restoring factory defaluts and loading different versions of iPod update without success.

    You can check you service options here: Apple - Support - Service Answer Center

  • My ipod nano has a white screen and after i restarted it it beeped twice

    what does this mean i mean after looking on the internet for hours now i got no help what so ever, helpp please

    Hello Emmuhhlieee,
    Thanks for using Apple Support Communities.
    For more information on this, take a look at:
    iPod nano (6th generation): Hardware troubleshooting
    http://support.apple.com/kb/ts3474
    Display shows a white screen
    Try putting the iPod into disk mode:
    Reset the device (press the Sleep and Volume Down buttons simultaneously until the display turns black—about eight seconds).
    When the display turns black, hold down the Volume Down and Volume Up buttons simultaneously until the device enters Disk mode.
    While the device is in disk mode, sync it to iTunes and try to restore.
    Best of luck,
    Mario

  • Help! My ipod nano has a white screen and won't unfreeze!

    I have tried holding down the menu and the centre button, but the apple screen doesnt appear, it just stays blank. If you tilt it in a certain light, you can see lines, and the music plays when plugged in the docking station, so something is there, and i have also restored to factory settings on itunes, but its still a blank white screen

    Try holding down the power button on the top with the home button in (round one) wait about 10-15 seconds to see if the apple logo comes up>if it does let go if it doesnt >open iTunes on computer plug iPod in & se if iTunes see's it. If it does restore AS NEW> if it doesnt try remove iPod from computer but leave cable connected to computer hold down round button & connect again Keep round button held down wait about 15 seconds & see if you see the iTunes symbol on iPod with usb cord>if you do keep the round button held down & wait for iTunes on computer to give you message to restore>restore ...If symbol does not show up & you are not able to restore device will need to be replaced

  • HT1320 I have a white screen cannot read anything and does not play any advice

    My ipod nano has a white screen and I cannot see anything on it any advice

    Reset iPad
    Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
    Note: Data will not be affected.

  • Ipod has a white screen . tried to reset it. did not work. just lost all of my music

    ipod has a white screen. tried to reset it. still has a white screen and now all of my music is gone

    Hi PINKPASSION,
    If you are having issues with your 2nd Gen iPod Nano, you may want to try the troubleshooting steps from the following page:
    iPod nano (2nd generation) Troubleshooting Assistant
    http://www.apple.com/support/ipod/five_rs/nano2gen/
    Regards,
    - Brenden

  • Today  my iPod touch 4 generation was dropped. now it just has a white screen. i tried reseting it by clicking the home and lock buttons but nothing helped. what is my problem and how do i fix it?

    Today  my iPod touch 4 generation was dropped. now it just has a white screen. i tried reseting it by clicking the home and lock buttons but nothing helped. what is my problem and how do i fix it?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar              

  • My ipod touch has a white screen and I am unable to reset it.  Can anyone help?  I

    Hi...  any help would be appreciated.  My iPod Touch has a white screen.  I have tried resetting it following the directions on Apple's site and have not been successful.
    Can anyone help?

    Try:                                               
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable       
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar                              

  • TS2771 my sons ipod has a white screen and will not turn  off reset etc  What should I do?

    My sond Ipod 4g  has a white screen  and will not turn off reset etc. Ive tried everything  please help

    - Let the battery fully drain. After charging for at least an hour try:
    iOS: Not responding or does not turn on
    - If still problem time for an appointment at the Genius Bar of an Apple store.

  • I have and ipod touch 4th gen that has the white screen of death but my home button doesnt work. how do i reset it?

    i have and ipod touch 4th gen that has the white screen of death but my home button doesnt work. how do i reset it?

    Restore, if iTunes will let you.  Everything except the password will be restored.  Connect via cable to the computer that you use for sync.  Be forewarned that it takes a long time.  From iTunes, select the iPad/iPod and then select the Summary tab.  Follow directions for Restore and be sure to say "yes" to the backup.  You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod.  Again, say "yes."
    At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod.  As before, say "yes."  Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time.  If that happens, only the apps that are part of the IOS will appear on your device.  Corrective action is simple -  choose manual "Sync" from the bottom right of iTunes.
    If you're unable to do the Restore, go into Recovery Mode per the instructions here.

  • HT1414 ipod has a white screen.  already reset/ restore.  any other options??

    ipod has a white screen.  already reset/ restore, but this did not work.  any other options??

    If the restore was successful (went through all steps without errors) then
    - Make an appointment at the Genius Bar of an Apple store.
      Apple Retail Store - Genius Bar 

Maybe you are looking for

  • Pages docs not showing on ipad

    Downloaded Mountain Lion ... edited a doc in pages on mbp ... saved to icloud ... can see it on icloud.com and in pages on mbp ... but it does NOT appear on my ipad.  Other docs which were there before DO show up.

  • RAID - wrong drive size displayed...

    Hi I am setting up RAID for the first time on a MacPro, and am confused about the way the available space on the drives is displayed. It seems to display too much available space. I have two 500Gb drives in bays 2+3 of my MacPro, and in DiskUTILITY I

  • To CR or not to CR, A Tip....

    I am relatively new to LV so likely all of you gurus know about this... I built a vi to capture a number of waveforms and write them to a binary file on an RTOS system, based on an external trigger turning ON. When the trigger turned OFF this state t

  • Can't copy and paste files using RDP session in server 2012

    I'm running windows 8, but I have also verified on a windows 7 machine as well. We have server 2012 installed on a machine I use remote desktop to get into. I cannot copy files from my local pc and use paste to get them to the server. I could do this

  • Add Custom Field to VA01

    Hi Experts, I have to add one field to screen in transaction VA01. I have the below details: Program Name: SAPMV45A Screen Number where field is tobe added: 8459 ( Its properties says as Subscreen) I didnot find a enhancement name that include a scre