My phone went blank and now will only show the apple logo I have tried to reset it and that doesnt work HELP!!!!

My iPhone is frozen. It was working find about a hour ago and then for no reason the screen went to the apple logo. I have tried to reset it and that doesnt work. When I press the power/lock button and the center key it turns off but then it comes right back to the apple logo screen and wont go any further. Please help I dont have my stuff saved and would like to keep the stuff i do have on it!!! Every once in awhile the screen will go black for a few seconds then the apple logo pops right back up! I dont know what to do.....

Try to set it up as new device, explained here:
How to back up your data and set up as a new device
First without using the backup, in case it contains corrupt data.
If it works after that, use the backup to restore from.

Similar Messages

  • I dropped my iPhone 5 outside in the rain all night and now it only shows the apple logo on my phone , any idea what my best options would be?

    PPlease help me I don't know what my next step should be without having to break the bank

    You should never try to turn on or charge a wet iPhone until it has dried for a week or so.
    If you have tried to turn it on or charge it, then the damage is done.
    You can buy an out of warranty replacement.  I believe it is $249-ish in the U.S

  • Accidentally cancelled my 5.1.1 update and now my screen shows the apple logo and then it turns black and then the logo over and over again i cant turn it on fully

    accidentally cancelled my 5.1.1 update and now my screen shows the apple logo and then it turns black and then the logo over and over again i cant turn it on fully

    Check out this Apple article -> iOS: Unable to update or restore
    Can you put the iPhone into recovery mode? Do you see an error number when trying to restore the iPhone?

  • I updated my ipod touch4 and it said i had to plug it up to itunes which i did then when i plugged it in it said i had to restore which i did and i was very upset and it restored it and now its frozen on the apple logo how do i fix it? ps button dont work

    I updated my ipod touch4 and it said i had to plug it up to itunes which i did then when i plugged it in it said i had to restore which i did and i was very upset and it restored it i guess and now its frozen on the apple logo how do i fix it? ps my ipod home button doesnt work.

    Try as much as you can. When it says to place in recovery mode use this program instead.
    RecBoot: Easy Way to Put iPhone into Recovery Mode
    - iOS: Not responding or does not turn on
    - If not successful and you can't fully turn the iPod fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.

  • Will only show the apple logo thats it I can do noithing else

    my ipod only shows the apple logo and willl not do anything else how do i fix it?

    Try to Reset your device. 
    Press and hold both the Sleep/Wake button and the Home button for at least ten seconds, until the Apple logo appears (ignore the Slide to Power Off that shows up first).

  • My ipod all of a sudden blacked out and now it only shows the apple icon. When i press the on/off or home button it still remains with the apple icon. I tried plugging it to my lap top and going to i tunes but it says there is an error in the device

    I was looking through my pictures and when i tapped to see a specific one my ipod blacked out. Now the screen only shows the apple icon and I cant go anywhere. I tried preshing the on/off and home button but it won't work. I even pressed both at the same time for 10 seconds and still nothing... I connected it to my lap top and went to my itunes account but it tells me that the device that i just plugged in has an error. I already tried plugging it back in several times and it still won't work. I don't know what else to do. I havn't had it for a whole year yet so its still insured to the apple company right? at least thats what I heard

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • My phone went blank.  It still had 41% battery life.  I have tried to reset by holding down the sleep button and botton on top until the Apple Icon appears but then after that, nothing.  Any ideas?

    I had just checked my phone and it had 41% battery life left. A few minutes later, it simply went blank and won't do anything. I tried reseting it by pushing down on the wake/sleep button and the button on top until the Apple logo appeared, but that didn't help.  Any ideas?

    Try:
    - Reset the iOS device. Nothing will be lost       
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Restore from backup. See:                                                
    iOS: How to back up                                                                                     
    - Restore to factory settings/new iOS device.             
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar                                      

  • Dropped my iPhone in snow and now it will only show the apple logo when plugged in

    I dropped my iPhone4s in the snow the other day, consequently it got wet. I could see the condensation in the camea and flash and the screen turned black however the phone still worked as when my friend called me it vibrated but I couldn't answer it because of the screen. The flash also was constantly on so it seemed like everything was working inside the phone but just not the screen.
    As soon as I got home I left the phone in rice for 2 days.
    I got the phone out and plugged it in to charge. The apple logo showed up and the phone vibrated but en the apple logo disappeared and the screen turned black again. I unplugged the phone and plugged it in again and the same thing happened with the logo again but no vibration.
    If I take the phone out of the plug it will just stay as a black screen.
    Any suggestions as to what is ring with it or what I could do to fix this?

    You've most likely cooked it. Make an appointment at the genius bar. Take the phone and your credit card with you. An out of warranty replacement will cost you $199.

  • My iPad 2 has frozen - it will only show the Apple logo. Any help?

    My Ipad 2 has frozen andjs shows the Apple lgog. Ant thoughts?

    Hold down the on/off  and the home button for about 30 sec, if should restart.

  • HT4623 I switch off my iPhone during update and now it only shows the apple icon?

    I switched off my I phone during a update , now it will not switch on properly, only apple icon appears?

    Reset, hold both Home and Power buttons until the iPhone restarts. This usually takes about 10 seconds of holding both buttons. If still problem you should Restore your iPhone with iTunes on computer. Here are simple steps. Open iTunes on computer. Connect iPhone to computer. Hold both home and power buttons until iTunes recognizes iPhone in Recovery Mode. Usually takes about 20 seconds of holding both buttons. Click Restore Button of iTunes.

  • Ipod only showing the apple logo and will not do anything else. 1st GEN

    my ipod will only show the apple logo when plugged in to my computer i have a dell running xp but i have tried other computers and it will not do anything but show this symbol. my computer does not recognise that it is plugged in. ive tried the apple support fix-it but it does not do anything period. the buttons do not work when plugged in or not. the only thing it does is light up when plugged in. my other ipod works perfectly no problems so this leads me to believe that its not the computers i have used. just think the ipod has had it

    Mine did the same thing last week after trying to update it via wi-fi. I then spent 11 hours Sunday updating my itunes on the laptop then restoring my ipod. Now all it does is beep as if it is just plugged in and flash the white apple logo. It beeps constantly. My computer at first didn't recognize it, then it did but said I needed to unlock it,(since I can't get the home screen up, I can't.) and now it doesn't recognize it at all. I've tried both computers.

  • I can no longer see my iphone on my computer. the ipone is gone blank only showing the apple logo

    my iphone no longer shows up on my computer, the iphone screen has gone blank only showing the Apple logo. I am unable to make and receive calls. Can someone help me with this problem please?

    Your iphone is shown at the top of the page.
    You can also simply click View>Show Sidebar and it will look about the same as it did before.

  • HT201412 Hello I made a update on my ipod to the ios 6 and its just been showing the apple logo then goig off and repeating that any ideas or help please?

    I made a update to the ios 6 and now its just showing the apple logo and going off to black and repeating tat any help please?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar              

  • HT4061 I was software updating of my iphone when the updating complete and start installing the wi fi connection suddenly disconnected and it couldn't be completed. Now my phone doesnot display anything its like empty. it only shows  the apple logo. help

    Hi all,
    i was upgrading my iphone to ios6.1.2; the upgrading had been completed and starting to install but suddenly the wi fi connection lost and the installation couldn't be completed. Now my phone is dead....it only shows the apple logo....can't do anything..help me out..

    Press the button at the top right and the home button together for 30 seconds, when you see the apple logo, let  them go.
    if you see a picture of the itunes symbol and a whitye usb chord then connect the device to a computer and perform a restore. 

  • HT4623 while updating to ios6 my phone stopped mid way and will not continue or come on its only showing the apple logo. Anyone else having this problem

    While downloading iOS6 my phone stopped mid stream now its stuck on the apple logo and wont turn off or on or do anything. Is anyone else having this problem

    If your iPhone is listed in iTunes, click Restore on the Overview page and follow the instructions on screen.
    Should iTunes not detect your iPhone, try the following:
    Turn the device completely off and remove the USB cable from your iPhone while keeping the other end of the cable plugged into your computer.
    Now take your phone and press the home button.
    While you keep the Home button pressed, reconnect the USB cable to your iPhone
    Continue pressing the home button until the "Connect to iTunes" logo appears on your iPhone
    Now follow the instructions on your screen to restore your iPhone
    For more details check out http://support.apple.com/kb/HT1414
    Hope this helps,
    Chris

Maybe you are looking for

  • Error while creating cluster view

    Hi all, Requirement is to create cluster view copying cluster view VC_TABWU01  into custom view. CV VC_TABWU01 has two data base views V_T093C_10 and V_T093U_01 I copied them both in to ZT093U_01 and ZT093C_10 and created a CV Z_TABWU01. Field depend

  • Crystal Reports hanging in Enterprise

    Just suddenly we are facing issues with some of the crystal reports . they were working fine in Business objects up to yesterday but today they are hanging , even when we try to open/modify parameter they hang. we are using Crystal report 2008 and BO

  • New Agent and Image-safe Data

    Just built new images and used the latest agent from May 24, 2010/ZDM7SP1IR4HP4 (Agent v7.0.173.100324) - it appears that this new agent is not respecting a specified Restore Mask. I'm basing this on the observation that freshly imaged machines are r

  • Date Class Interfaces

    Hello all, I am creating a presentation and need to speak intelligently on Date Class interfaces. Could anyone give me a description of some of these and what their purpose would be? Also, can you provide any examples? Thanks, Seawall

  • My subscription should be active begining today bu...

    My subscription should be active begining today 04/07 but i have 0 min listed The money were taken from my account but there are 0 min listed Please advise