My photos will not keep the filter on when I enlarge them. When I show the thumbnails of them in the photos app, I can see the filters, but I can't when I enlarge them. (I have iOS 7). How can I fix this?

When I open the Photos app, and I see all the thumbnails of the photos I have taken, I see the filters on the photos that should have filters. For some reason, when I enlarge a photo with a filter to full screen, the filter is removed. But when I go back to the thumbnails, the filter is restored. How can I fix this?

I suggest either learning to use the iPhone or going back to a $15 phone if these are the most important features of a phone to you. Start here: http://www.apple.com/support/iphone/

Similar Messages

  • Forgot passcode to iPad. Has not been connected to itunes. Tried to erase from "find my phone". But it is offline. Tried to restore it. But itunes said it couldn't because it had a passcode. How do I fix this?

    Forgot passcode to iPad. Has not been connected to itunes. Tried to erase from "find my phone". But it is offline. Tried to restore it. But itunes said it couldn't because it had a passcode. How do I fix this?

    Them try:
    Placing your device into recovery (DFU-Device Firmware Upgrade) mode:
    Follow these steps to place your iOS device into recovery mode. If your iOS device is already in recovery mode, you can proceed immediately to step 6.
       1. Disconnect the USB cable from the iPhone, iPad, or iPod touch, but leave the
           other end of the cable connected to your computer's USB port.
       2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds
           until the red slider appears, then slide the slider. Wait for the device to turn off.
                  * If you cannot turn off the device using the slider, press and hold the
                    Sleep/Wake and Home buttons at the same time. When the device turns off,
                    release the Sleep/Wake and Home buttons.
      3. While pressing and holding the Home button, reconnect the USB cable to the
           device. The device should turn on. Note: If you see the battery charge warning,
           let the device charge for at least ten minutes to ensure that the battery has some
           charge, and then start with step 2 again.
      4. Continue holding the Home button until you see the "Connect to iTunes" screen.
           When this screen appears you can release the Home button:
      5. If necessary, open iTunes. You should see the following "recovery mode" alert:
      6. Use iTunes to restore the device.
    If you don't see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
    Additional Information:
    If you have a problem getting into recovery mode then try: RecBoot: Easy Way to Put iPhone into Recovery Mode.
    Note: When using recovery mode, you can only restore the device. All user content on the device will be erased, but if you had previously synced with iTunes on this computer, you can restore from a previous backup. See this article for more information.

  • I tried to download the itunes update and at first it would say i was missing msvcr80.dl so I completely uninstalled itunes and its components, then reinstalled it. Now it says I'm missing"Applle Application Support" How do I fix this?

    I tried to download the itunes update and at first it would say i was missing msvcr80.dl so I completely uninstalled itunes and its components, then reinstalled it. Now it says I'm missing"Applle Application Support" How do I fix this?

    With the Error 2, let's try a standalone Apple Application Support install. It still might not install, but fingers crossed any error messages will give us a better idea of the underlying cause of the issue.
    Download and save a copy of the iTunesSetup.exe (or iTunes64setup.exe) installer file to your hard drive:
    http://www.apple.com/itunes/download/
    Download and install the free trial version of WinRAR:
    http://www.rarlab.com/
    Right-click the iTunesSetup.exe (or iTunes64Setup.exe), and select "Extract to iTunesSetup" (or "Extract to iTunes64Setup"). WinRAR will expand the contents of the file into a folder called "iTunesSetup" (or "iTunes64Setup").
    Go into the folder and doubleclick the AppleApplicationSupport.msi to do a standalone AAS install.
    Does it install properly for you?
    If instead you get an error message during the install, let us know what it says. (Precise text, please.)

  • The sound effects on my apps have quit. How do I fix this?

    The sound effects on my apps have quit. How do I fix this?

    If you lose sounds for keyboard clicks, games or other apps, email notifications and other notifications, system sounds have been muted.
    System sounds can be muted and controlled two different ways. The screen lock rotation can be controlled in the same manner as well.
    Settings>General>Use Side Switch to: Mute System sounds. If this option is selected, the switch on the side of the iPad above the volume rocker will mute system sounds.
    If you choose Lock Screen Rotation, then the switch locks the screen. If the screen is locked, you will see a lock icon in the upper right corner next to the battery indicator gauge.
    If you have the side switch set to lock screen rotation then the system sound control is in the task bar. Double tap the home button and in the task bar at the bottom, swipe all the way to the right. The speaker icon is all the way to the left. Tap on it and system sounds will return.
    If you have the side switch set to mute system sounds, then the screen lock rotation can be accessed via the task bar in the same manner as described above.
    This support article from Apple explains how the side switch works.
    http://support.apple.com/kb/HT4085

  • I have an Airport Extreme as my router and am using time capsule to extend the network in my new house. My ISP is only providing me 4-5 ip addresses and wants me to set up my router to issue out new ip addresses for all my devices.How do I fix this?Help

    I have an Airport Extreme as my router and am using time capsule to extend the network in my new house. My ISP is only providing me 4-5 ip addresses and wants me to set up my router to issue out new ip addresses for all my devices.How do I fix this?Help.
    They said I need to change my settings to NAT settings. I haven't been able to figure out or find anything. I have also spoken to Apple Support on the phone for hours without being able to figure out how to do this ( i don't think he knew much either lol.) Please help me because I've got about 15-20 devices in my house that require to be connected to the internet and this is just making things ridiculously slow and painful for me.
    Thanks!

    It is on DHCP & NAT under router mode yet my isp is still the one issuing ip addresses to my devices instead of the router issuing them

  • The password I use for installing downloaded applications or installing basically anything isn't working but I didn't change it or let alone touched it. How do I fix this? I'm on an iMac 21.5 inch, Mid 2011 and Mac OS X Version 10.7.3

    The password I use for installing downloaded applications or installing basically anything isn't working but I didn't change it or let alone touched it. How do I fix this? I'm on an iMac 21.5 inch Mid 2011 and Mac OS X Version 10.7.3

    I've no idea why it has stopped working, but you could reset it:
    http://osxdaily.com/2011/08/24/reset-mac-os-x-10-7-lion-password/

  • The password I use for installing downloaded applications or installing basically anything isn't working but I didn't change it or let alone touched it. How do I fix this?

    The password I use for installing downloaded applications or installing basically anything isn't working but I didn't change it or let alone touched it. How do I fix this?

    iMac 21.5-inch Mid 2011
    Mac OS X Version 10.7.3

  • I have a MacBook Pro, and will not let me open a file because it says I do not have permission.  How do I fix this?

    I have a MacBook Pro and it will not let me open a file that I have used several times in the past because it says that I do not have permission to use it.  How do I fix this?

    Oops, my bad.  The repair disk permissions in Disk Utility doesn't actually fix the User home folders.  To do that boot into the recovery partition and when the recovery desktop appears select Utilities -> Terminal. Enter “resetpassword” and press return - don't worry you're not actually going to reset your password!
    Ensure that your username is selected from the “Select user account” menu, then under “Reset Home Directory Permissions and ACLs” click the “Reset” button.
    Click on the Apple menu and restart your computer.

  • One of my apps was pushed to the side of my screen to where I can no longer see it, however, when I do an app expose it pops up. Unfortunately as soon as I click on it it disappears again. How do I fix this?

    On my lap top one of my apps was pushed to the right side of my screen to where I can no longer see it, however, when I do an app expose it pops up. Unfortunately as soon as I click on the app it disappears again. How do I fix this?

    Try relaunching the Finder. Type command, option and esc (three keys together), click on Fidner, then Relaunch.

  • I keep getting The requested URL "/zumablitz/?ref=bookmarks&count=0", is invalid. Reference #9.1ed83bd0.1296679780.83aff6a ....everytime I try to go to any of the games I play..Have tried everything, how do I fix this?

    The requested URL "/zumablitz/?ref=bookmarks&count=0", is invalid.
    Reference #9.1ed83bd0.1296679780.83aff6a , happens all the time now , how do I fix this?

    As you can see below, when I right click, I have no such option.  In the User Account Settings, I'm operating as the "System Administrator".
    Any other suggestions?

  • My personal hotspot disappeared after I upgraded my iphone 4s to iOS 8, how do I fix this?

    After upgrading my iPhone 4s to iOS 8.0 the Personal Hotspot disappeared even after I upgraded again to iOS 8.0.2 its still not there. How do I fix this.

    Hello there, george.
    The following Knowledge Base article offers up some great steps for troubleshooting Personal Hotspot:
    iOS: Troubleshooting Personal Hotspot
    http://support.apple.com/kb/ts2756
    Thanks for reaching out to Apple Support Communities.
    Cheers,
    Pedro.

  • My iMessage doesn't work correctly after the upgrade to iOS 7 how do I fix this?

    I updated my phone with the latest upgrade to iOS 7 and my iMessage is not working on my phone or my iPad. How can this be fixed?  iMessage will start to send the message but it will not go. And if others send me iMessages then I don't get them. Please tell me how to fix this issue..

    Hi Charles. please read this article...Lightroom mobile unavailable to Education memberships | Kivuto
    Creative Cloud memberships purchased from a third-party provider (e.g. Kivuto) do not provide access to Creative Cloud services, including Lightroom mobile.
    Guido

  • Firefox22 get plc4.dll error, click ok and firefox starts. Did clean reinstall of everything related to Firefox but still have problem. How do I fix this?

    Was using Firefox 21, after 20, etc. Automatically updated Firefox to version 22 and problem appeared. I get the error message, click OK and Firefox runs normally. I reinstalled version 22..same problem. I removed everything after copying bookmarks to html file. I removed application data, extensions, folders--everything. I download a fresh copy of 22, installed it, imported my bookmarks and installed new copies of my extensions. SAME PROBLEM. I get plc4.dll not found error. I copied plc4.dll from Thunderbird to Firefox folder. Then I get nspr4.dll error. I copied this too from Thunderbird to Firefox, then I get xpcom.dll not found error. I copied this as well and get NS_CSTringContainerInit2_P not found in xul.dll. BUT FIREFOX STILL LOADS and runs normally after I click OK. I also did a Malware scan to make sure this wasn't a factor. How do I resolve this crap?

    I did exactly what you describe , no improvement. I was surprised.

  • HT1727 i was told i have two libreries how do i fix this?

    i made the mistake to move a lot of my files to an external drive now when i connect my iphones to my computer i get the mesege that i have another librery can someone help me fix this issue thanks

    Tools > Clear Recent History
    Time Range to Clear: Everything
    Cache - needs to be check-marked

  • HT201269 I used iTunes to backup up my iPhone 4 version 7.0.6 bought a new iPhone 5 and when I connect the new phone I get "iTunes could not connect to this iPhone. You do not have permission."  How do I fix this issue?

    Itunes 11.1.5
    Mac OS X 10.7.5
    IPhone 4 7.0.6
    IPhone 5 7.0.6
    Ikeep getting this error when I attach the new phone.  After it would not work I did a Icloud back up of my old phone and restored it on the new phone, but I have other music and apps on my Itunes that I would like the option to sync and I like to be able to backup my phone on my Mac.  What do I need to do to get the new phone attached back to this itunes?
    iTunes could not connect to this iPhone. You do not have permission.

    Im having the same problem after installing ios7.1
    Checked the usb status and it sees an iphone ( 4s ) attached,
    Repaired disc permissions
    updated and reset iphone
    and itunes
    reinstalled mavericks from scratch
    phone alert saying " TRUST THIS COMPUTER?"
    hit trust
    same alert keeps appearing
    again and again
    itunes keeps wittling on about "iTunes could not connect to this iPhone. You do not have permission."
    what the actual F*** is going on and can anybody help ??????

Maybe you are looking for