My plus and minus volume control doesn't work.. Is there any way of turning them on or off? Or is my phone faulty?

My plus and minus volume control doesn't seem to work.
Can I switch the volume on?

Hi Timjazzhair,
Go to Settings ==> Sounds and in 'Ringer and Alert' set 'Change with Buttons' to YES.
Woops! Meg beat me to it!

Similar Messages

  • I backed up my phone before i went on vacation. I dropped my phone in a pool and now it doesn't work, is there any way that i can get the pictures that I took on vacation off of the phone?

    I backed up my phone before i went on vacation. I dropped my phone in a pool and now it doesn't work, is there any way that i can get the pictures that I took on vacation off of the phone?

    IF you had icloud backups and Camera Roll turned on in Settings on the wet phone, then you can restore that backup to an iOS device, but not a computer.
    http://support.apple.com/kb/HT1766?viewlocale=en_US&locale=en_US
    Once you get a replacement phone...
    Go to Settings>General>Reset and tap Erase All Content and Settings.  This will erase your device.  Then you will go through the setup screens again as you did when your device was new, and when given the option, select Restore from iCloud Backup.
    This link gives another overview of backup and restore:
    http://support.apple.com/kb/HT4859?viewlocale=en_US&locale=en_US

  • HT201401 The volume buttons on the side of my iPhone 4S do not work . Is there a way to turn them on or off or are they broken

    Volume button don't work . Can they be turned on and off?

    If the iPhone falsely senses it is docked due to short in the charging port it can disable Volume buttons. Shorting in charging port can be due to dust, debris, etc. If no Warranty, clean with toothbrush and small amount of Isopropyl Alcohol. Never hurts to try a Restore with current iTunes on your computer, too.

  • HT201269 I just synced my new iphone through itunes and it deleted my new pictures.  is there any way to get them back?

    I just syned my new iphone through itunes and it deleted all of my new pictures.  is there anyway to get them back?

    Do you sync your iPhone with iTunes every once in a while? If yes, there are chances that iTunes has taken last backup of your photos, contacts, etc. that you want back.
    Connect your iPhone with your PC. launch iTunes, right click on your device and click on "Restore from Backup". Choose the latest backup to proceed.
    If you configured iCloud for backup before you restored your iPhone. Go to Settings -> iCloud -  > and login using your Apple ID. Once you've logged in, all the photos, contacts, mail, messages should be back on your iPhone. This may take a while (depending on your network).
    Alternatively, if you are only now setting up your iPhone, choose 'Restore from iCloud Backup' in the setup screen. Login with Apple ID and the iPhone will be restored from the latest iCloud backup.

  • When I insert headphones and then I remove them, volume control doesn't works.

    When I insert headphones and then I remove them, volume control doesn't work more, and I have to operate on system preferences=>sound=>output volume. Whay does it happens and  how can I fix it?

        Yes, I am using 09 with out issues.  Just have to remember to use "open with 09" or open pages 09 first then my document.
      I create some amazing cards and posters with 09 that when on a PC I would have to use both Word and Publisher to create.  Flipping back and forth. 
      Apple if you're  listening please, give us back our layout options and even add a few more design options like beveled and 3D text.

  • My beats studio 2013 work fine on my ipad but the mic/ volume control doesn't work on my iphone 5

    My beats studio 2013 work fine on my ipad but the mic/ volume control doesn't work on my iphone 5. Can anyone help me?

    Thanks, daniel.early79!
    I have an iPhone5 bought in late Dec 2012.
    I've noticed on rare occassions that the volume down button some times would not respond.
    Starting yesterday, the volume down button would not respond more consistently.
    Sometimes a reset would fix it, sometimes a reset network would fix it, but the problem would come back.
    Came across this thread, and pressing gently on the upper right hand corner fixed it!
    I remember seeing some video on Youtube or iFixit that shows how to replace the power button. It appears that the volume buttons and the power buttons are tied in together on the same piece of connector. I supposed taking the iphone in and out of cases may have warped or twisted the connector inside the case ever so slightly that the sensor for the down volume button got shifted.
    The down volume button works now, after doing the trick you suggested. I'll wait and see if it comes back before taking it in for warranty repair.

  • Volume control doesn´t work with iphone 3gs

    Hi, the volume control doesn´t work with my ihpone 3gs, i´m using the apple headset, any suggestions???

    ´Till the moment it is, i just recently received a notification with a software update, but i tried with another 3gs with the same characteristics and it worked.

  • Volume control doesn't work

    Had 2 kernel panics recently, and been noticing a string of strange issues, one of which is that the Volume control doesn't work, or specifically, it doesn't affect many applications.
    For example, when using Chrome, if I want to use the volume control to icrease or decrease volume on a movie (YouTube etc), the hardware controller keys (F10 - F12) do not have any affect on volume, but I am able to change it using the software interface of the current player.
    Something has gone haywire with my laptop... disks are unmounting as well (USB & FireWire 800), major settings seem to have returned to default (trackpad and other), and installed software seems to have disappeared (eg, Paragon NTFS). I am concerned!
    Help, please!
    I am still using 10.6.8.
    Peter

    I am having the exact same problem. I just did a complete re-install of max os x and did all of the updates..my hard drive had crashed so i had to replace it. lot's of fun.. and after the last upgrade i can't use my sound at all.. the sound shows that it's all the way up but it has the "no Smoking" sign as well..
    i have tried to restart.. change options and whatever else i could .. i did notice that when i enable the option to show the sound icon on the main bar that there is just a blank spot where it should be.. and i can't change it form there either because it just doesn't show..
    any one seen this before.. ?
    all my other Mac's work fine..
    please help..

  • Volume control doesn't work on AOL radio

    The Volume control doesn't work on AOL radio. I does work in iTunes and with music. Is there a way to reset AOL radio?

    To be honest Im not quite sure why this volume indicator is not visible on the screen but in my opinion its really not a serious issue
    I mean the sound is working properly and this is only a indicator which shows you a current sound level
    However, I think its something wrong with an process which cannot be started or a registry issue

  • Volume control doesn't work with headphones plugged in

    When I connect headphones the volume control doesn't work correctly. It should play only through the headphones, but it doesn't. In fact the volume control will bounce back and forth between operating correctly and not working correctly ... And will eventually stop the music. Frustrating!

    ´Till the moment it is, i just recently received a notification with a software update, but i tried with another 3gs with the same characteristics and it worked.

  • I have just upgraded to the latest version of OSX as invited by Apple. Since then iTunes will not play and my volume controls have stopped working - in Preferences the sound controller is not able to find any input or output devices. What is going on?

    I have just upgraded to the latest version of OSX as invited by Apple. Since then iTunes will not play and my volume controls have stopped working - in Preferences the sound controller is not able to find any input or output devices. What is going on?

    Please read this whole message before doing anything.
    This procedure is a diagnostic test. It’s unlikely to solve your problem. Don’t be disappointed when you find that nothing has changed after you complete it.
    The purpose of the test is to determine whether the problem is caused by third-party software that loads automatically at startup or login, or by a peripheral device. 
    Disconnect all wired peripherals except those needed for the test, and remove all aftermarket expansion cards. Boot in safe mode* and log in to the account with the problem. The instructions provided by Apple are as follows:
    Shut down your computer, wait 30 seconds, and then hold down the shift key while pressing the power button.
    When you see the gray Apple logo, release the shift key.
    If you are prompted to log in, type your password, and then hold down the shift key again as you click  Log in.
    *Note: If FileVault is enabled under OS X 10.7 or later, or if a firmware password is set, or if the boot volume is a software RAID, you can’t boot in safe mode. Safe mode is much slower to boot and run than normal, and some things won’t work at all, including wireless networking on certain Macs. The next normal boot may also be somewhat slow.
    The login screen appears even if you usually log in automatically. You must know your login password in order to log in. If you’ve forgotten the password, you will need to reset it before you begin. 
    There will be no audio output in safe mode. The question to be answered by the test is whether any devices are listed in the Sound preference pane. After testing, reboot as usual (i.e., not in safe mode) and verify that you still have the problem. Post the results of the test.

  • Is there any way to turn off the auto formatting in Pages?  I just want to type a letter and add pictures and titles, and Pages keeps changing font sizes and doesn't let me "Do it my way".  I HATE this!

    Is there any way to turn off the auto formatting in Pages?  I'm using a blank document, so I figured I could write my letter and add pictures any way I wanted to.  But NO!  Pages keeps changing the font size!  I typed a large heading as a title, and when I try to change to a smaller font for the body of the letter, it changes the size back to the larger size!  I am getting SO FRUSTRATED!  I've spent over an hour trying to get the stupid program to let me just type my letter!  Can anyone help?

    The only one left is the "unsubmitted text" dialogue, which would not be a problem if I were not a Facebook user; after updating the "Richard is..." field (which does not require a manual submit to actually send) I get the above message. This is obviously Safari just not realising that the info has been sent and is therefore (I imagine) one for Apple themselves to answer!!
    You're welcome Rich. Glad to help.
    Not being a Facebook User, I'm not sure how to respond to the error situation. However, this would be something to report to Apple as a bug via the Safari Menu. First, open to the page in question, then select "Report Bugs to Apple".
    Mahalo for the and Aloha from Big Island.

  • Is there any way to turn off the volume rocker of the side of the iPad?

    Is there any way to turn off the volume rocker of the side of the iPad?
    Please help!!!!!! I forever have the square with the volume control on my screen because my volume rocker does not work.

    You could try a reboot:  Press and hold BOTH the power and home buttons at the SAME time for at least 10 seconds (ignore the red slider to shut down) until the Apple Logo appears, then let go of both buttons and your iPad should restart.  If that doesn't get rid of the volume control box on your screen, it's time to make an appointment with the Genius Bar at your Apple Store, and they can send your iPad off for service.

  • My MacBook Pro is not recognizing my external hard drive.  The hard drive is listed in disk utilities but an icon does not pop up and I cannot access the data.  Is there any way to resolve this?

    My MacBook Pro is not recognizing my external hard drive.  The hard drive is listed in disk utilities but an icon does not pop up and I cannot access the data.  Is there any way to resolve this?

    WE know Disk Warrior is more reliable, hence more useful, and should be in any disk mechanics toolchest.
    For the record, I don't know anything of the kind. I have yet to see evidence that Disk Warrior is useful at all.
    What I do know is that you seem to take every opportunity you get to promote it in these forums. Do you work for Alsoft?
    Let me be a little more explicit. My opinion is that Disk Warrior is a waste of money if one has backups. If a journaled HFS directory is so badly corrupted that it can't be repaired by Disk Utility, then the volume should be reformatted and restored from backup, which has the same effect as running DW, but is probably faster and doesn't cost $99.

  • Hi am having problems with iTunes,I have all my music on my 4s but I bought the iPhone 5 today.us there any way that I can transfer music over to my new phone without using the library?as it doesn't seem to be on my PCM anymore.

    Hi am having problems with iTunes,I have all my music on my 4s but I bought the iPhone 5 today.is there any way that I can transfer music over to my new phone without using the library?as it doesn't seem to be on my PC anymore.i reset my pc and save my iTunes to a hard drive but can't access it.Need help please

    " When I did this, my library showed all the music I have "purchased" from itunes but did not have the music that I downloaded a long time ago through itunes from my old CDs."
    Correct.
    " How can I get that music to show up in my library now on my new computer?  "
    Copy it from your old computer or your backup copy of your old computer.
    The sync is one way - computer to ipod.

Maybe you are looking for

  • PO history not populated using BAPI_ACC_DOCUMENT_POST

    Hi, I am using the BAPI u2013 u2018BAPI_ACC_DOCUMENT_POSTu2019 for simulating down payment requests(F-47). I have successfully posted the document using this and related tables are also updated. However in the associated PO, the PO history tab do not

  • MS SQL Server 2012 Developers Freeze At ODBC Setup

    I am attempting to create an ODBC connection using my local computer's Admin Tools-ODBC Connection interface. I can select the MS SQL Server driver type, enter the odbc name I want to call the connection , then click browse so to look for sql databas

  • Data Block (Reference column) URGENT~~ Plz help!

    Hi: i have 3 data block created. Two of them are master-detail. i didn't add on any relationship on third one yet. set "number of records" to be 8 in both 2nd and 3rd datab lock. i need the third one to synchonize with the data in 2nd data block all

  • Seeing:  'Missing reverse index on remove: null' errors

    Hi, I'm seeing the following error being logged on a couple of our cache servers: 2007-05-15 16:03:10.799 Tangosol Coherence AE 3.2.2/371 <Error> (thread=DistributedCacheWorker:3, member=2): Missing reverse index on remove: null I've not found any po

  • Airport Guest Network - Connects but no internet

    I'm using and Airport Extreme Base Station (A1354), software version 7.6.4. The secure networks are fine and work perfectly to serve up an internet connection. However, the guest network (which is currently set to no password) connects just fine but