Need help im stuck right now

Question

Ok so I have built a function that will increase in increments that is specify and I am outputting it to a device to control it. Now this is the part i need help with I want to to hold at the setpoint that I can specify for a period of time then slowly decrease can anyone help im usisng labview 7.1
Attachments:
Niks Test.vi ‏167 KB

Answer 1

In that case, it can be greatly simplified.
The "Add 0" function obviously isn't doing you any good.
If you don't need it for timing, you can remove the Wait function.
The "Add 1" function and feedback node can be replaced with the "i" (iteration terminal).
A good rule of thumb for loops is: "If you know how many times it will run before it starts, use a For Loop.  If the number of times it runs is uncertain, use a While Loop."
It looks to me like you want to generate an array that goes from Init+0.001 to SetPoint by steps of 0.001.  The attached VI will do this. 
I realize this doesn't solve your problem yet, but I think it puts us a step towards figuring out what to do next.
Can you check this out and tell us what else is needed?
Attachments:
Niks%20Test[1].vi ‏8 KB