Need urgent help with Error -200018

Question

hi all,
I'm trying to generate analog signals using 8 channels of pxi 6733 (basically from this generation), and it works well (sample rate 1MHz, with 10000 samples per buffer).
At the same time, I want to fetch the generated analog signals using pxi 5105 (basically using niScope Stream to Disk Queues Win32 File IO_Basic.vi from here), and it runs with no problem. (sample rate 20MHz).
BUT, when I try to get them running together at the same time, I got the error -200018:
"A DAC conversion is started before the data to be converted were available.
Decrease the output frequency to increase the period between two DAC conversions, or reduce the size of the output buffer to the data faster (faster) to write.
When using an external clock, check whether the signal contains noise or voltage spikes."
And I couldn't find any helps for this error, I've tried to reduce the clock rate of pxi 5105, but doesnt help.
Any helps are much appreciated.
Regards,
Yan.

Answer 1

Mystogan wrote:
1. I'm using non regenerative buffer.
2. I think I'm creating output using onboard buffer.
This contradicts. Non regenerative generation means that you have to refill the buffer in a required time frame (depending on buffer size and clock speed of generation). So if you generate a signal with 10kHz, you have to refill the buffer with 20kB/s. This is the load for the bus system.
Look into the specification of the PXIe1082. On page 1-7, you'll see the setup for the PXIe bus in the chassis and how it distributes to the different slots.
Taking your numbers into account, you have 1MHz generation (so 2MB/s) and 20MHz acquisition (40MB/s) as bus load. Adding some overhead, it is something which should be supported in the chassis in any combination of used slots (since all slots do have x4, with MUXing up to two slots, so leaving transferrate of x2 for each slot).
So the next questions are:
What kind of controller are you using?
How does your software write data to the generation task? Is it possible that the loop performing this is starving in your application software?
Norbert 
CEO: What exactly is stopping us from doing this?
Expert: Geometry
Marketing Manager: Just ignore it.