Nike + iPod logged run with incorrect date

I recently uploaded a run on 01/01\07. It incorrectly was logged in my run history with 02\01\07 despite both my PC and iPod Nano having the correct date and time. How might I rectify this error?

I don't think it's possible to change the info fed to the Nike Plus site.
I've found the website to be rather buggy overall, and it definitely doesn't play nice with Safari. Too bad--you'd think Apple would have worked with Nike to make an Apple-friendly site, not that overblown Flash site they've created.

Similar Messages

  • Can Nike+ ipod receiver work with 2 sensors?

    I have a nike+ ipod sport kit, with a receiver and sensor that work well together, however i recently bought a second sensor and cant seem to link it to the original receiver. ive tried the suggestions on the apple website, and even exchanged the second sensor thinking it was broken -- please help!!

    Yes, you can connect two devices at the same time.

  • IDoc with incorrect data is expected to fail but it  does not

    Hi All,
    The Job CQM_CR_O_IF103_IN_INOVIS_ORDER3 got cancelled as result of a short dump. In the initial investigation we found that the IDoc 0000000012089824 had an incorrect information i.e. it had a material which did not
    exist. The IDoc is expected to fail and give an error message but has not done so.
    We also observed the IDoc does not fail when the incorrect materialhappens to be the last material in the IDoc.
    The workaround was to fail the IDoc manually and then the subsequent jobs runs successfully.
    Would like to know why the IDoc is not failing when it has incorrect
    data.
    Thanks & Regards,

    Hello,
    the idoc fails only if there is a hard error in the segment, means i.e. if there is a wrong transaction type or missing ... But I think that the system behavior is correct, because the idoc cannot fail because a product is "just" wrong. This is no hard error, you should then get an error in the transaction that i.e. the product does not exists. You can try to use badi CRMXIF_ORDER_MAP to check the products, but then please make sure that note 1644057 is implemented.
    BR
    Rene

  • IDoc with incorrect data is expected to fail but does not

    Hi All,
    The Job CQM_CR_O_IF103_IN_INOVIS_ORDER3 got cancelled as result of a short dump. In the initial investigation we found that the IDoc 0000000012089824 had an incorrect information i.e. it had a material which did not
    exist. The IDoc is expected to fail and give an error message but has not done so.
    We also observed the IDoc does not fail when the incorrect materialhappens to be the last material in the IDoc.
    The workaround was to fail the IDoc manually and then the subsequent jobs runs successfully.
    Would like to know why the IDoc is not failing when it has incorrect
    data.
    Thanks & Regards,

    Hello,
    the idoc fails only if there is a hard error in the segment, means i.e. if there is a wrong transaction type or missing ... But I think that the system behavior is correct, because the idoc cannot fail because a product is "just" wrong. This is no hard error, you should then get an error in the transaction that i.e. the product does not exists. You can try to use badi CRMXIF_ORDER_MAP to check the products, but then please make sure that note 1644057 is implemented.
    BR
    Rene

  • Demantra - can it run with two Data Models in parallel?

    Hello,
    we face the following situation: we have items that have to planned on a daily basis; many other items, however, only need weekly planning.
    Demantra only allows one base time unit in its data model. If we choose "daily" for all products, the system size will increase enormously.
    If we choose "weekly" for all products, we can not plan our daily products for specific days in the week.
    The idea is now to set up a Demantra System with two data models in parallel. Is this possible? Would they reside in different databases or database users?
    The Business Modeller allows to create new models, but can they run in parallel? If they can, how would the user access the different data models?
    Thanks for any hints on this! 

    Can you please elaborate on this issue?
    Thanks

  • Registered with incorrect date of birth when first turn iPad on

    Hi please help, I registered with the incorrect date of birth when first turned on the iPad, and now when I try to register to set up a iPad account the systems keeps saying can't register as date of birth does not meet age requirement even though putting in the correct dob. Please advise how can I change the original set up dob details. Thanks

    Read this for the instructions.
    http://www.ehow.com/how_8493711_change-birth-date-itunes.html

  • Camera is coding photo with incorrect date-how do I adjust?

    My iPhone, as well as my MacBook are set to the correct date and time, but when I import photos from the phone, they are coded with a date 1 year in the future. (e.g. photos today are marked 12/31/08). Because of this, they are not showing up in the album Last 12 Months. How can I fix this? Thanks.

    I encountered the same thing on photos I took New Year's Eve around 8 pm US Eastern time. And actually, it seems that they were not just one year, but also two hours advanced. However, photos I took BEFORE New Year's Eve were correctly dated.
    I just took another photo to check it out. It came across completely right — 1/1/08 around 22:00 Eastern.
    Was this the first time you had used the camera on your iPhone (maybe a Christmas present like mine)? If not, did photos from earlier dates import correctly?
    You posted at 3:55 pm in what was presumably your local time. What is your time zone? Is it possible that you took your photos after midnight 1/1/08 in UTC/Greenwich time?
    I fixed my photos by doing a batch date change in iPhoto. Click on "last import" or maybe an event that shows 2008 dates. Then hit command(Apple)-A to select all the photos. and then pull down the Photos menu and select "Adjust Date and Time...". You adjust using the date on the first photo, and iPhoto will apply the same time change to all.
    Note to Apple: this is a nasty little issue, don't let it fester! Fix the iPhone's encoding of the operating system date and time on JPEG photo captures on these "cusp" dates.
    Good luck,
    Andrew

  • Ipod nano running with Vista

    Anyone heard of Ipod/itunes crashing Vista. Have upgraded to Vista, running Raid 1 (mirror 2 HDs). Each time we plug in our brand new nano and try and do the updates, etc. it has crashed one hard drive. Not sure if the HD itself is bad or if it just broke the Raid. Let me know what a solution could be. Now scared to plug the nano back in for fear of this happening again.

    I've got a RAID 0 configuration, and have suffered data loss whenever I connect my ipod.
    Let's hope Apple find a solution soon. It's shocking that they dont report this as a known issue.

  • System won't boot with incorrect date/time

    Hey, I setup a computer back home for VNC, however there was a power outage and now the BIOS has reset. Unfortunately it defaults the date to 2099 for some reason, anyway now the computer won't boot (I can't remember the exact error). Anyway the trouble is I can't access that computer now, and it has no monitor hooked up, is there anyway I can force a boot with just keyboard and without setting the correct date in the BIOS (no one with access to the computer could do this).
    Appreciate any help.

    You can try to just press F1.
    I have a similar issue with my home server, the battery on the motherboard is dead so when the pc is powered off for a while it will not remember the clock. When trying to boot the system in such a case it spits out an error where it offers to "ignore" the error if you press F1.
    In my case I need to wait until my pc beeps before pressing F1, basically you need to get past the BIOS stage.
    With a bit of luck it might work for you too.
    Also I hope you have some ntp service running on your system to make sure the date gets set correctly on your system on bootup.
    Last edited by Neburski (2014-02-19 12:35:00)

  • Does anyone know if the Nike+iPod kit works with the new 2G Nano?

    The reason I ask is that Gizmodo says the bottom dock attachment is offset on the 2G Nano.

    I can confirm that you have a good ipod nano with a "bad" firmware.
    EACH TIME I use my 2Gb ipod with the sport kit it freezes ! Without sport kit..no problem at all !
    My ipod nano with firmware 1.1.1. freezes when:
    - I press the end session button after a long session (in this case it maintains the training also after the reset). with short sessions..no problem.
    - If I forget to not set the hold button during session, the armband "press" without control some combination of buttons which freezes the ipod (session lost after reset)
    - If I press /<< button instead of menu to return to the previous screen at the end of the session. (session lost after reset)
    - Without receiver inserted I have pressed to activate sport kit - ipod require the receiver - I have pressed to return to the previous screen and ipod freezes.
    Why Apple doesn't insert a "timerized autosave data sessions" to avoid to loose sessions in case of freezing and reset ?
    Best Regards

  • Ipod showing up with incorrect name

    I just plugged in my iPod (after using it for months with no problem) and suddenly the iPod is showing the wrong name. It should show up with the name I gave it obviously, but suddenly it shows up as a network share name that my company has. It also shows the stats as being a network share, i.e. no songs, the available space on the network share. It's almost as if it is not truly reading the iPod. The iPod is functioning normally otherwise.
    I haven't tried it unplugged from the network, because it used to work just fine when attached while I'm at work. Any ideas while iTunes would suddenly show the iPod as incorrect.
    IBM Thinkpad   Windows XP Pro  

    See this Article: “Strange iPod Behavior within Windows”

  • IMovie 09 with incorrect dates from iPhoto video clips ?

    Hello. I just noticed that the majority of dates in my iMovie 09 for my iPhoto video clips all show the date for 1903. I need to go back and change the date in too many video clips to count. Is there an easier way to go back to the orginal dates? Thank you.

    NeddySeagoon - wondering if you found the answer to this?
    I too have iPhoto videos showing up in iMovie fine, but the dates are wrong in iMovie (correct in iPhoto).
    Also, I have updated video titles in iPhoto, but those titles are not showing up consistently in iMovie. Perhaps related issue, I'm not sure.
    Any idea if this could be a permissions issue? (Video is stored on an external drive). Or something else?
    Thanks!

  • Accounting Log filling up with useless data

    I am getting my ACS Accounting logs filled with useless data from about 12 devices. I think I have found the cause - I just don't know how to fix it.
    The accounting data has a username we have not used for months, and I stumbled upon this by looking at various show commands on the devices that are causing the problem.
    When I do a "sh aaa sessions", I see this:
    CE-WIN-IDF16-3750-Stack1#sh aaa session
    Total sessions since last reload: 189
    Session Id: 1
       Unique Id: 127
       User Name: *not available*
       IP Address: 0.0.0.0
       Idle Time: 0
       CT Call Handle: 0
    Session Id: 354
       Unique Id: 263
       User Name: cenetmgmt
       IP Address: 10.62.7.15
       Idle Time: 0
       CT Call Handle: 0
    Session Id: 626
       Unique Id: 410
       User Name: leehoyle
       IP Address: 10.62.7.15
       Idle Time: 0
       CT Call Handle: 0
    I would LOVE to get rid of that Session ID: 354 if I could. I can't seem to find a suitable "clear" command. Any help out there?
    Thansk in advance!
    Lee Hoyle

    I am not trying to access anything I keep getting the message that my cloud is full than go to it to find that is is full of things from my computer and pictures from the Sims game spent 3 hours yesterday as it kept telling me that Verizon was not available. Why is my cloud not backing up my phone but randomly backing up my computer which I do not need. This is using the desktop Icon. I have not even opened it on my desktop until I tried to delete the stuff on it it did this on its own.

  • Nike+ ipod app on iphone 4s

    Good evening everyone I have a problem I can't solve and I've tried to google many times but I can't find an answer.
    I have an iphone 4s and I'm using the app Nike + ipod with sensor (it was a present). Everything's OK but the app can't sync with my account on nikeplus.com. the app can connect to the web site but once I log in... there isn't nothing, only my workouts with the other app. I think that it only works with the newest app, nike+ running.
    I can't undestand why. I've tried everything but it doesn't sync anyway. I've thought the reason is that this app (Nike + ipod) works only with ipods.
    Can it be possible? Is there a solution?
    thank you very much
    zulfia85
    Italy

    I would contact nike never had problems moving from ipod to iphone4

  • Two people running with sensors = interference?

    Hi,
    When I run on my own the distance data for a particular run is correct, but when I run with my partner (who also has a Nike+ kit) my data becomes distorted and the distance becomes longer. Is this a known problem? Is it possible for one sensor to interfere with another? Any solutions?
    Thanks,
    Ben

    I read about this a while ago and after you've "linked" your iPod with a sensor, there should not be any interference, as the communication uses a unique serial number for each sensor. In my experience, I've run with several others with Nike+iPods many times with no problem.
    The only time it becomes an issue is when you need to link your iPod to a new sensor. I have multiple sensors in different shoes, so each time I change shoes, I have to re-link my iPod to the other sensor. If there are other Nike+iPods around when you select "Link", you get a message that "The Nike+iPod has detected multiple sensors. Step away from the other Nike+iPod users." The first time I got that message was just before the start of a race, and couldn't help but laugh at the wording. Sure enough, I walked away from the crowd and it linked with my other sensor just fine. But the phrasing "Step away from the other iPod users!" kept me chuckling the entire race.

Maybe you are looking for