Nokia 5530 Cell Info - How to enable?

I travel alot and I rely on Cell info to know the place where I am at that moment using my old Nokia phone(6021).
In my new Nokia 5530, I do not see any where to set the Cell Info.
Is it that I am looking at a different place or is there any other utility that gives the Cell Info?
FYI I have not enabled GPRS because I don't require it. I only want the Cell info.

Can't offer any advice on this because I have never tried it. As far as I am concerned Cell Info Display flashes on and off from time to time. For what it is worth, I don't think you can.

Similar Messages

Cell Info Display Problem

Past 2 days , my Nokia N71 cell info display gets stuck only showing one area or doesn't show at all, even though moving to another area doesn't change. To update cell info display i need to restart my phone or i need to go settings then i select cell info display then change to off then again on. But i have also Nokia 5700 XM but it doesn't face the same problem and it is also subscribed to same network as n71.
my N71 fimware is V 2.0642.1.05
Please someone give the solution to the problem.
Best Regards

Hi Yogeshwar,
The Cell info display now a days displays only some Offers that are dished out by the Operator. Once upon a time it was showing the AREA where you are but thats no more there I think. Not atleast on the Vodafone network in India. And its the same on all handsets, not only Nokia X1-01. Recently I had contacted Vodafone in this regard and was told that the duration for which the info is flashed can not be increased.
As for the signal problem hope that the Antenna is not covered by any other object.. Refer Pg.No. 7 of the User_Guide ...Else you may have to get the phone inspected by Nokia Care...

How to switch off 'Cell Info' in Lumia 925

I recently bought Lumia 925. I am getting constsnt messages pertaining to 'Cell Info'. They keep on appearing once in every few seconds & pile up in a huge number. You can not make a call unless you acknowledge all of them, which takes huge time, alternatively I have to switch the phone off & on & make a call after re-boot!!
I was using Nokia E 63 earlier. It had a setting facility for 'Cell Info' on or off. I do not find any setting facility for 'Cell Info' in Lumia 925.
Please guide me how to set the Cell Info off, or I will have to discard this Lumia 925

Thanks everybody for the suggestions!
a) I tried with SIM of other service provider : There were no troublesome flash messages. b) I contacted my service provider: Airtel: After trying for tremendous patience with support number 121, somehow I could convey the message about what was happening. My call was transferred to a senior person, who promised me that these 'Flash' messages would stop in half an hour. It did not happen. Once again through 121, once again the promises, nothing happens. I personally visited Airtel support centre. Again nothing happens. c) I tried my old E 63 & switched off Cell Info with the same SIM. I am not able to use Lumia 925 because of Flash messages accumulating every few seconds.
Conclusions: I have to change my service provider Or Phone Or Both. – Now I may go for the last option with frustrations.

Cell Broadcast reception on iPhone - is it possible ? How to enable it ?

Hello, all.
I'm working in a company that develops software for mobile operators, such as SMSC, USSDC, Customer care, Billing, etc...
One of our products is Cell Broadcast center.
Our clients use Cell Broadcast to give different services to their subscribers, such as location based discounts. For example, in some areas with low traffic a cell broadcast message is broadcasted - "Discount 20%". The subscribers see such messages on their phone and prefer to call from "cheaper" areas.
The problem is that these messages are not displayed on iPhone.
I've checked through all menues on iPhone and iPhone 3G, and couldn't find anything like "Cell Info Display" \ "Cell Broadcast" (like on Nokia phones), "Channels" (like on windows mobile Samsung), "Info services" (like on Motorola) or anything like this.
At the same time I know that iPhone is able to receive Cell Broadcast messages, since it's able to receive data on sim-card related cell broadcast channels (such as 1000h) and pass it to sim-card.
So my question is - can Iphone be configured to receive ordinary text Cell Broadcast messages (on channels 0-999) and show them on the title screen or in Messages (Mail) menu ???
Maybe there is some "secret code" to enable cell broadcast (like the one used to change SMSC address on iPhone) ???
Best regards,
Yury

I second that! It was a very useful function on my Nokia back then. Now I'm a proud owner of the iPhone 3G and it'd be really great having an opportunity of recieving broadcast messages on Apple's cell-phone as well.

TS1424 My Apple ID has been disabled, it won't let me updated my previous purchases. No reason for why it has been disabled or how to enable it again. I reset my password, security questions and billing info. Nothing- Anybody has seen this before?...

My Apple ID has been disabled, it won't let me updated my previous purchases. No reason for why it has been disabled or how to enable it again. I reset my password, security questions and billing info. Nothing… I even called Apple SUpport 1-800 # and they said they can't help me...Anybody has seen this before?...

You need to contact itunes support.
http://www.apple.com/support/contact/
There is NO telephone support for itunes. Use the link above.

How to get the cell info?

You all know that, on our mobile we used to get the cell info ( Tower Name ). How to access that in our J2ME application?
John

Hello txflwr48! I regret the difficulties you've been having while activating your new phone. I'd love to help, but I recommend that we take our conversation to direct message instead of here in the public forum. If you have not yet gotten your device activated, please follow these steps to follow my handle (DionM_VZW) send me a direct message: http://vz.to/1gBiqkv
DionM_VZW
Follow us on Twitter www.twitter.com/vzwsupport

How to enable HTML formatted emails in nokia e72?

Can anybody tell me that how to enable HTML formatted emails in nokia e72? I Owned a E71 & it has such a feature that I can activate HTML formatted email & Non-HTML formated emails. But I don't find any feature in Nokia E72. I receive all the mails as text messages. I use Other Emails Thanks in advace!

No supporting stuff here, amigo. This e-mail procedure is a safety precaution. Html might contain malicious code. Try Profimail for a while.
http://www.lonelycatgames.com/?app=profimail
‡Thank you for hitting the Blue/Green Star button‡
N8-00 RM 596 V:111.030.0609; E71-1(05) RM 346 V: 500.21.009

How to enable macro's again (Lock Selected Cells)

Hi All,
I am using the EPM addin for excel for demand planning. I would like to lock certain cells in the by clicking the following option on the formatting sheet:
However, I get the following error:
I did not disable any macro's manually, so I do not know how this comes. Can anyone tell me how to enable these macro's again?
KR,
Kristof

I tried to do so on another workbook and here another macro seems to fail as well.
When trying to add a specific member in the formatting sheet, the following error occurs:
I think that somewhere, all macro's are disabled but I cannot find any way to reverse this...
Kristof

How to enable instant messaging in Nokia E72?

Hello,
As per Nokia E72 user guide, the phone does support IM(Instant Messaging). However I am not able to locate it? Could someone help me with IM set up?
Thanks
venks

svenks wrote:
I lookedup menu->messaging, but I do not see any instant messaging option. I also saw the guide but not sure how to enable the option. I only see
New Message,Inbox,Myfolders,Drafts,Sent,Outbox,Reports options .
Please assist.
Thanks
venks
Since IM is firmware it must be somewhere. Did you check all other folders for IM? Reset the phone or update with Nokia Software Updater. There are alternatives like Fring. Download with OVI store. You can find IM there too.
‡Thank you for hitting the Blue/Green Star button‡
N8-00 RM 596 V:111.030.0609; E71-1(05) RM 346 V: 500.21.009

How to enable Tenant Info porperty in load balacing system object

Dear All,
Thanks in Advance
i created one system object using template Portal tenant system,but when i select the Tenant Info in the Property list its display disable.so anyone have idea how to enable the property.
thanks & regards
chittya

Hi,
To avoid all this mess, best way will be do discontinue the delta and do a full pull. That way you'll ensure that you'll get the full data from R3. Then reinit the delta and then reset the delta. This might take time depending on the data volume. Suggest you do this during a quiet time as you'll have less risk of losing any transaction data at the time of resetting the delta.
Cheers,
Kedar

Cell info display on Nokia 701

Hi every body, My Nokia 701 is not displaying cell info i.e name of area or name of tower covering my phone even though I set info display to on in pull down notification menu right from time of purchase. Is this problem specific to my phone. My old phone Nokia X3-00 was showing cell info with 2G sim. Now I am having 3G sim inserted into my phone 701. But cell info display is off either with 2G or 3G coverage.

I jsut checked it on my c3 00 with vodafone and it started showing some special offers on home screen.
But I tried the same on my 701 with aircel and it doesn't show any of that.
-------------------If this post helped you, click on accept as solution.------------------
-----------------------------Appreciate by clicking on white star.----------------------------

How to enable Cell Broadcast message in Iphone5

Hello!!
I work at True Corp. in Thailand. I would like to use Cell Broadcast System by using Iphone5 for receving Cell Broadcast message from Radio Site. I cannot find Cell Broadcast setting in Iphone5, I am not sure I have to new software from Apple or not?
How to enable Cell Broadcast function in Iphone5?
Note: Reference from this Website https://smscellbroadcast.wordpress.com/tag/iphone/
Thank you

In your case, you need to reset the router to factory defaults, at which point the SSID will be set to broadcast and it cannot be disabled. To know more about why there is no option to disable the SSID broadcast anymore on the Cloud firmware, click here.

Nokia X1-01 Cell Info Display Problem

My X1-01 sw version 05.27 ,26-05-11,RM -713, Language: MG
The problem is that it does not display Cell Info display correctly. Only few times it shows, But only for sometime. Is this bug fixed in the latest version 5.44 ???? and it also has the signal problem .. If i put it in my pocket , the whole signal goes away in both sims....

Hi Yogeshwar,
The Cell info display now a days displays only some Offers that are dished out by the Operator. Once upon a time it was showing the AREA where you are but thats no more there I think. Not atleast on the Vodafone network in India. And its the same on all handsets, not only Nokia X1-01. Recently I had contacted Vodafone in this regard and was told that the duration for which the info is flashed can not be increased.
As for the signal problem hope that the Antenna is not covered by any other object.. Refer Pg.No. 7 of the User_Guide ...Else you may have to get the phone inspected by Nokia Care...

How to enable log gathering in Nokia Suite?

Feeling a bit dumb here. All the instructions I've read suggest to enable log gathering by double-clicking enable_logs.js, which should prompt some sort of a dialog window. The problem is, I can't run .js files, I can only view them in Notepad, Firefox, etc. How exactly is this thing done?

Hi,
We have created FAQ for log collecting with new versíon 3.2:
How can i send the log files with the Nokia Suite 3.2?
Disconnect your device from your computer and exit Nokia Suite from File > Exit. Enable log gathering by double-clicking the enable_logs.js file in installation folder, normally C:\Program Files\Nokia\Nokia Suite. Then open Nokia Suite again and reconnect your device. Try to reproduce the error and click Help > Send feedback in Nokia Suite menu and fill in the description of the bug. Log files and system information will be automatically included in the feedback. You can also add screen shots and other files by choosing Add file (maximum size 5 MB).
Please let us know for the result.
Br
Mahayv

How to enable SIM card slot of Nokia 6235

I have Nokia 6235 but its SIM card slot is not enabled..... Can anyone help me how to enable this....

hey quangteomedia,
the driver which you require can be located here : http://consumersupport.lenovo.com/us/en/DriversDownloads/drivers_list.aspx?CategoryID=132245
WW Social Media
Important Note: If you need help, post your question in the forum, and include your system type, model number and OS. Do not post your serial number.
Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"!
Follow @LenovoForums on Twitter!
Have you checked out the Community Knowledgebase yet?!
How to send a private message? --> Check out this article.

Nokia 5530 Cell Info - How to enable?

Similar Messages

Maybe you are looking for