Nokia Software Updater will not start at all

I have updated Nokia PC Suite today.
Everything is working except Nokia Software Updater.
The program will not run - it just hangs there?
Please help.
Solved!
Go to Solution.

I have found out how to solve the problem.
Download and run Nokia PC Suite Cleaner - then download and run Nokia PC Suite then download and run Nokia Software Updater.
It worked for me.

Similar Messages

  • 3 Beeps After Software Update, Will Not Start

    Late 2012 Mac Mini.  Updated OS X with Software Update, upon restart it is instead beeping 3 beeps in a row, silence, then 3 beeps in a row again, for hours.  It's getting hot near the power cord.  Screen is black.  I finally powered down successfully by holding power button.
    I've seen older posts saying this signals faulty RAM in Powerbooks.  I did upgrade the RAM to 16 GB myself when I bought the Mac mini, it has always worked fine (apart from snowy screens when it first awakes or starts which eventually go away and I understand this update was supposed to address...).
    Have I voided my warranty by installing the RAM myself?
    What to do?

    John, thanks.  I ran the Apple Hardware Test, and the memory tested fine.  The three beeps at start up has not returned since the original restart after the software update, so who knows what it was...
    John Galt wrote:
    Run Apple Hardware Test. Run the extended tests. If it fails OWC will replace it at no charge. A failure could be temperature related but in any event OWC memory is guaranteed for life. Remove and re-seat each of the modules to verify they are properly installed.
    Rember, the free GUI front end for memtest is another memory test utility to consider.
    The display may or may not be related to anything. It will be difficult to draw any conclusion without another display to substitute.
    Tommy Boyo wrote:
    And concerning RAM, I've noticed I can't get the Mac to ever utilize even half of it... so I don't understand what the benefit is.
    Correct, there is no benefit of additional RAM unless and until your system and what you do with it requires more than you have. OS X manages its resources efficiently, and there is no way to change how it does that.
    I'm still getting snow when starting or awakening the Mac when the monitor has not been recently on, so there may be some interaction between the monitor and the Mac mini.  (MultiSync LCD2470 monitor.)  Because when the monitor has been running for a while I can restart the Mac without getting snow, usually.   Turning the monitor off and on about three or four times usually gets rid of the snowy image and I get a picture.  Every now and then it will abruptly turn to complete snow after having been on for hours, so who knows... I understood the snow problems were a common problem with the Intel integrated graphics and the recent software update(s) were meant to address it.  It didn't help in my case.
    At least I'm back to the original functionality from before the software update...

  • HT5654 Just tried 3 times to update iTunes on my PC running Vista.  There was an error.  It stopped the installation.  Now iTunes will not start at all.  The error message tells me to reinstall which I tried but did not work.  What should I do?

    Just tried 3 times to update iTunes on my PC running Vista.  There was an error.  It stopped the installation.  Now iTunes will not start at all.  The error message tells me to reinstall which I tried but did not work.  What should I do?

    Hello, Jdragone. 
    Thanks for the question.  Start with completely uninstalling iTunes and all of it's components in the order specified in the article below.  Once this is done, download and install iTunes.
    Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
    http://support.apple.com/kb/HT1923
    If you receive any errors when uninstalling any components of iTunes, try the steps in the article below for each component that gives you an error.
    "The feature you are trying to use is on a network resource that is unavailable" alert appears when removing Apple software in Windows
    http://support.apple.com/kb/TS3704
    Cheers,
    Jason H.

  • HT201401 4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out l

    4s with latest software update will not power off, text will only vibrate, iPod only works with earphones. When I sync it with iTunes it works until power save mode starts, then back to not powering down, making text sounds, or playing iPod out loud.

    The Basic Troubleshooting Steps are:
    Restart... Reset... Restore from Backup...  Restore as New...
    Restart / Reset
    http://support.apple.com/kb/ht1430
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414
    If you try all these steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
    Be sure to make an appointment first...

  • Firefox will not start at all ... not even profile mananger will start

    After an auto overnight reboot initiated by a Windows update (XP 5.1 SP3) Firefox will not start at all ... not even Profile Manager ... all that happens is a few seconds of hourglass on the cursor and then nothing ... this is happening on two different computers at the same time ... identical symptoms ... any advice?
    == After overnight reboot by auto Windows update

    I had the problem after I restarted the computer when Firefox indicated that was needed to install updates. After that every attempt to start Firefox resulted in no response at all. I went to my program list and found Firefox Safe Mode. That started OK. I then closed it. After that Firefox started OK.
    Bob G.

  • Pages 09 (updated) will not start up using Lion OSX

    iWork Pages 09 (updated) will not start up using Lion OSX. It did work at one time but now it won't. I reinstalled iWork several times with updates but the applications say to reinstall or check the developer.  I'm using an i-Mac Intel with updated downloads for all applications.  Thank You in Advance for your thoughts to solving this concern.

    What else have you been doing just before this problem started? Any other updates on the computer? If you need to reinstall iWork which some has when upgrading to Lion after a complete uninstall.
    To uninstall correctly iWork, go to Yvans iDisk :
    <http://public.me.com/koenigyvan>
    Download :
    For_iWork:iWork '09:uninstall iWork '09.zip
    Expand the archive and run the script.
    Now you can instal iwork again and do the updates.

  • The apple software updater will not update

    the apple software updater will not update the following apps
    iTunes
    Quicktime player
    iCloud
    <Re-Titled By Host>

    There is a tech note on what to do when an install or update fails.
    Often due to prior copies and cache of those on your system.
    Some you have to uninstall but it will leave behind files and folders that then have to be manually removed.
    Clone Windows just in case.
    Run chkdsk
    Cleanup
    Use CCleaner or similar and repair the Registry might help too.
    I just did a clean install Windows 10 Preview, and the one app I most feared installing installed and seems to be fine, iTunes 12.01+
    http://www.apple.com/support/itunes/install/

  • My HP laptop will not start at all.

    I have a HP G6000 laptop that will not start at all , i turn on the power and only see the blue light on , the screen is still black , minutes later my laptop restarts , but again with only the blue light on with the screen still black , anyone got any suggestions on how to resolve the problem , thanks.

    found a solution ! , not pertinent though :
    1. turn laptop on
    2.hold the " FN " key and run your finger across all of the top keys ( F1 F2 ... )
    3. after a few seconds while doing this your laptop will turn on , worked for me

  • Satellite L450D-13U will not start at all

    Yesterday the screen on my L450D when blank and then the machine closed down.
    Now it will not start at all.
    There are no lights on display when the power cable is attached.
    When the start button is pressed all that happens is there is a momentary flash of the On light (not sure if that's the right name) and the DVD light.
    You can also hear the fan starting up but that immediately goes off.
    That's all that happens.
    I've tried without the battery, tried discharging the battery.
    Has my laptop just died?
    Is there any hope or should I just move on?

    I will agree with checking your RAM.
    The best way to do so before you buy anything is to check each stick.
    Remove the battery and AC cord, and press the power button several times to make sure the system is fully discharged.
    Once it is discharged, ground yourself and pull the RAM cover. Remove the top stick ONLY. Plug the laptop back in, and try to boot it.
    If you get nothing, swap the stick you pulled for the one that is still in the system, and try again.
    After that, if it still does not want to boot up, take it to a shop. It could be something as simple as the BIOS battery being dead, or a burnt out power mosfet.

  • Ipod touch will not start at all

    ipod touch will not start at all...I have tried everything...it got really hot and then went dead

    What does: " will not boot at all, it is blocked " mean?

  • Update will not start automatically

    it will not start the update. It says update will start up automatically. It does not... I have shut down my firewall, it starts up a searchporthole ? NKVD ? and Advertising.... I have tried many times with or with out firewall... I have updated to date all XP software.
    What is wrong ?

    If you use ZoneAlarm Extreme Security then try to disable Virtualization.
    *http://kb.mozillazine.org/Browser_will_not_start_up#XULRunner_error_after_an_update
    See:
    *[[/questions/880050]]

  • Firefox will not start at all

    New versions of Firefox will not start and only bring up the crash reporter. I've tried starting in safe mode, I've deleted/created new Profiles and I've uninstalled/installed Firefox over and over. I can still download 28.0 and it has no problem opening. Below is the latest Crash ID from 35.0
    Crash ID: bp-4ac8fb2d-9a2a-4a6a-a9e4-06cc42150125

    hello sid.robinson, this crash is caused by the "Digital Guardian" software by Verdasys that is running on your computer. Please see if there's an update available for that program.

  • Nokia software updater does not recognize Windows ...

    I tried to install nokia software updater to my pc,WIN7 ultimate,and installation cannot begin,because its does not recognize OS.

    Taugis,
    If the method as described by Rider5512 does not prove to be the solution you require, Microsoft does have an official Windows 7 Support Forum located here http://tinyurl.com/9fhdl5 . It is supported by product specialists as well as engineers and support teams. You may want to also check the threads available there for additional assistance and feedback.
    Also to get your questions answered on the most common challenges around application compatibility when coming from a legacy operating system, why changes were made along the way, compatibility technologies inside the OS and methods for getting incompatible applications to run on Windows 7, please go here: http://tinyurl.com/yfa2yyz
    Jessica
    Microsoft Windows Client Team

  • Finder folder with question mark, now will not start at all!!!

    Hey guys, I was working in Avid and i opened up Quicktime, all of a sudden i got a crash log. So i restarted, upon restart i got the finder folder with the blinking question mark. I tried restarting with the OS9 cd by holding down the C button, no luck there. So i moved onto the next step, resetting the PRAM, no luck there (just sat on black for numerous minutes until i let up, then the folder came back). Then I moved onto resetting th PMU, now it will not start up at all. I restart, and all i see is a black screen, nothing. Any help appreciated. Thanks in advance.
    The machine im workin on is a Powermac G4 (quicksilver), OS9, 1.5 G Ram, machine bases around Avid Editing system
    Rhyno

    Ok let me clarify this.
    1)system crashed restarted and got the folder with the ?
    2) tried to boot from the OS 9 CD no luck? it did not boot?
    3)reset pram and still the flashing ?
    4) Reset the PMU chip and the mac is dead won't start up at all?
    a couple of ideas too...
    did you press the pmu button more than once?
    Check to make sure the power cord is plugged in correctly etc.
    Check the Pram battery to see if it might be dead it should read between 3.3v and 3.7v
    also try to restart the computer without other devices plugged into it (USB Firewire, keyboard, even monitor.
    hmm...
    iBook G4   Mac OS X (10.4.3)  

  • My mac book will not start at all

    Suddenly my mac book pro will not turn off.  first it started with the computer cutting off rather than going to sleeep then it started cutting off while I was using it.  I became worried that there was a problem and went to back up the hard drive on an external hard drive but suddenly the computer would not start at all.  before that happened i would get the gray screen with the dial and a bar underneath.  Help!

    See if these support articles help:
    http://support.apple.com/kb/TS1587
    http://support.apple.com/kb/TS1367
    Ciao.

Maybe you are looking for

  • Stuff on Floppies-only have CD-drive, help?

    So, I'd like to re-install a program onto my iBook from the original software disks... yes they're on floppies. No, I don't want a newer version of the software because the newer version got rid of my keyboard short-cuts and doubled the size of every

  • About LDB

    Hai Gurus, I  am new to ABAP.  and I wants to know about LDB concepts. 1. What is LDB and where it is used ? 2. I wants to step by step process with using SE36 ? (With Demo) Please Help Me..

  • Problems with Premiere Pro- Quits unexpectedly

    Hello, I have several key problems on Adobe Premiere CS6" The following problem happens when I not only edit, but save, and export my project into a video file. "Adobe Premiere Elements Has Encountered A Problem and Needs To Close - We Are Sorry For

  • Attempting to Import iphoto book to i-photo

    I would like to post several iphoto books to iweb. I am using iphoto in ilife 08. 1. I installed ilife and i believe it imported all my photo files. 2. I created a book. 3. I have attempted to post the book for others to view. Each Time I hit save as

  • *My* new iPad is also TOO HOT!

    I just want to post here too that my iPad runs SOOOOOO VERY hot! I mean, I'm no scientist... but I can say it gets hot enough that it HURTS TO HOLD. Not very Apple, but I am sure they will address this issue. I just wanted to post to say that little