Orange crusty stuff in the dock connector!

Hi,
Earlier today my iPhone 4's home button decided to play up until it decided to stop completely. A few minutes after this, my phone kept on saying 'This Accesory is not compatable with iPhone' or something like this. SO... I connected the phone to my Mac to do a restore and just as iTunes was about to restore the phone, it said the phone wasn't connected. I unplugged the phone and now there is some orange cursty stuff in the dock connector and on the cable and the phone is extremely hot even after disconnecting it. Does anyone know what this could be? And also my warranty ran out on the 25th July

Sounds like corrosion. I suppose it's possible the battery could be leaking. You may want to take it in. If you're really nice to the genius, they may replace it for you. An out of Warranty replacement is $199.
It could just be corrosion. Clean it out good with a dry toothbrush. If something is shorting the dock connector, it might explain the heat.  Also, check all of your cables and docking accessories for signs of rust.

Similar Messages

  • HT204291 my ipad2 thinks it is airplaying to the Dock Connector

    my ipad2 thinks it is airplaying to the Dock Connector any fix? I shut off bluetooth, reset all settings, blew out the dock connector with a can of air and held down the top switch and round button, already.

    turn the volme bar down no you can see the orange bit, then lock the screen. Leav eyour phone/ipad/ipod for a few minutes then turn the volume bar up and go into your iphone/ipad and it should work, otherwise all youll have todo is give the charging point a good hard blow/compressed air which should also work.
    if not book in and see the apple genuis'

  • How do you get sound through the dock connector to a PC or Mac?

    Where I work they have blocked the Pandora website. (Along with just about every other online radio site.) They don't mind if we listen to music, as long as it's not streamed online through their network.
    I have both a PC & a Mac on my desk.
    What I would like to do is listen to my Pandora app from my iPhone by plugging the dock connector into a Mac or PC. This would keep the battery drain to a minimum & allow for better quality.
    When I plug in the dock connector the phone starts charging & iTunes want's to sync. I can run the Pandora app, but no sound comes through the computer.
    Does anyone know how to get the audio to come from the dock connector & play through the computers sound card?

    You have several choices:
    1. Composite AV Cable: has a dock connector on one end and USB, RCA line out and RCA composite video on the other. It also comes with an AC Adaptor.
    2. Component AV Cable: same as the Composite AV Cable but with RCA component video.
    3. Universal Dock: has a dock connector socket on it and a line out socket.
    4. iPhone 3G Dock or the (original iPhone Dock): same as the Universal Dock but designed just for the iPhone.
    All you need is somewhere to plug the line out into.

  • Hairline In the Dock Connector

    Hi ,
    I have just bought an Ipod nano 5th gen [brand new]and as soon as i was going to connect it to my pc for syncing i noticed a line in the middle of the dock connector of the ipod , the line starts from the inside and continues to the outside and returning back inside [looks like a mountain has been drawn]. This line or watever its called is on the silver plated surface of the D. Connector . My other 8gb version doesn't have any such thing.
    Also it works fine and everything but that line...........
    So what do u think i should and if u were in my place what would u do ?
    Thanks alot

    Apple does not read these forums. These are user-to-user forums where everyday folk post questions and offer answers to each other. You need to call Apple Support.
    Did you even bother to read the links I posted? Through a Google search I found the following:
    http://www.arabcomputers.com.sa/ I can't read Arabic. Unknown if there is a support link.
    Apple service briefly suspended in Saudi Arabia

  • Trouble with the dock connector??

    I have no clue why my Ipod is doing this or if its the cord. Ill plug my Ipod into the computer, and nothing happens. If I lift the cord up right where it plugs into my ipod it'll start charging. So unless i use the case to wrap the cord up over the screen and hook the cord to the belt clip to keep a constant pull on it, it won't connect or charge. Though i have used another cord and i still had to do this to charge it.
    Can anyone tell me why it's doing this? and how I would fix it?

    Have you tried cleaning the dock connector slot on the iPod? You may have a problem with the dock connector and it needs replacement. If you have an Apple store nearby you might want to make an appointment at their Genius Bar.

  • HT201270 Apple please fix this the dock connector in my car effects the airplay on my phone no matter what I try to fix it it always goes to play music on the dock connector in my car even when I do not ask it to! The iPhone selection is no choice.

    If anyone could help or try to fix this, please help it is such a hassle!

    Apple is not here.
    Clean the dock connector on your device with a soft, dry brush.

  • Is there a difference between the earphone output and the audio output of the docking connector, or is it in fact the same signal ?

    Is there a difference between the earphone output and the audiooutput of the docking connector of the iphone 4, or is it in fact the same signal ?

    One basic difference is that the LTE frequencies each is able to operate on are different. After that, it is pretty much the same phone. Others might be able to add to this.

  • Can I tranasfer photos FROM my iPhone4s to my iMac using the dock connector?

    Can I tranasfer photos FROM my iPhone4s to my iMac using the dock connector? Not WiFi or the cloud.
    The manual is no help. Neither is FAQ's.    
    Thank you.
    Jerry

    Yes, if you're talking about the photos in the camera roll.
    Plug it in and open iPhoto. It should appear like any other digital camera.

  • That white plastic thing that covers the dock connector

    I just got my iPod mini back from a repair with Apple. It's a different iPod and it works great, but the little piece of white plastic that I used to cover the dock connector doesn't fit this one. Is this a problem? It seems like the connection could easily become dirty if it's not protected.

    No, it's not a problem. Most iPods don't have a cover, just the earlier models.

  • Does the dock connector give a signal OUT

    I'm thinking of buying a CD head unit for my car, that plays MP3s/WMA and has a USB and Aux in. I understand that the headphone jack gives an inferior signal (it's slightly affected by circuitry or something). The seller has told me that the dock connector to USB will not only carry the music, but will charge the ipod.
    So, this post title says it all, can the dock connector send the music to the USB?

    There are a number if you look on ebay. The one I'm looking at is from Virtual Reality Soundlabs - the VRCD300. About £75 in the Uk or $100 in the US. The manufacturers tell me that the USB will plays Mp3s (nut not wma or aac) from the ipod.

  • Output level of the dock connector

    Hi, when I plug a remote control or if a use a dock station using the dock connector, the output level of my Ipod are very low. I put the volume level at 100% but it sound like the volume was at 50%. I'm not using the max volume setting.
    Someone else have this problem?

    I had the same problem and found the following solution:
    1)In Itunes I chose all my song (CTRL+A)
    2)Under the file tab choose show info (or simply press CTRL+I)
    3)Chosse the settings tab folder
    4) Adjust the volume
    Your computer will then update all your song - in my case 3000 wich took 15 minutes. Then I connected the Ipod who basically transferred all the songs again which took about 40 minutes.
    When i plugged it in to the docking station the volume is much higher, and the amplifier in the Ipod will not distort the music. (If this does not work - check that sound control is turned off on your Ipod settings.)

  • 2nd Gen iPod fit the dock connector of of 3rd Gen Color iPod?

    So I have a 2nd Gen iPod (4 round buttons) dock connector 40GB and want to get the new universal dock with the IR sensory so I can control it with the remote. In the description of the new dock it says it is compatible with my model but doesn't say it comes with that particular dock apdapter. However it says that it does come with a the dock adapter for the 40GB color display. My question is does mine have the same physical dimensions as the 40GB color display model? And so will it fit into the dock adaptors that come with the dock or do I need to get some additional adaptor? I thought that they were identical in size, though on Apples "Identifying different iPod models" page it doesn't list the physical dimensions of them. If anyone knows this that would be great.

    hi Zachary!
    good lord. something appears to have gone horribly wrong with the footnoting on the Universal Dock KB doc:
    Learn about iPod Universal Dock
    okay ... here's what i think is going on.
    it's saying that five different adapters come with the dock.
    five of the adapters listed in the table have little superscript "1"s next to them (adapters 3-7).
    the first of those two "bullet point" notes below the table says "Included with the iPod Universal Dock".
    sooooooo ... my thought is that the five adapters you get with the dock are adapters 3, 4, 5, 6 and 7.
    but your 40G four-round-button ipod is a dock connector ipod according to this document:
    Identifying different iPod models
    which i think, according to the table on the Universal Dock page, means that you need a number 2 adapter, and so you're going to have to get an additional three pack of adapters for it.
    ... that all sounds plausible, but i'd prefer it if someone with both a universal dock and a 40GB dock connector ipod could actually tell us which adapter they have to use ...
    love, b

  • Does the Nano 6th stay turned on when on the dock connector?

    Does the newest mini Nano 6th stay turned on when on the dock or connector cable?
    Can it be used as a clock all night to see the time or does it "time out" and turn off?

    I am confused.  Time Machine is software, did you mean Time Capsule?
    Turn off the Time Capsule to see what happens then.

  • Has the dock connector changed?

    I'm wanting to connect to the socket on the bottom of my video iPod (I believe that's 5th generation) but the accessory says it works with 3rd generation. The information dates back to mid 2004, but it does not say "3rd generation or later" just "3rd generation" (which may have been the current model back then!) Is my connector the same as that used on 3rd generation and since - i.e. will the plug fit?

    No. I live in Norway. I have an MB, but it is not fitted with iPod connector or anything. I plugged the dock into the same connection as the CD changer on the back of the Sony using a splitter with flip to change from CD changer to iPod. The splitter i bought in an electronic shop for under £10

  • Okay so I have a Seagate Backup Plus Drive External Hard Drive and I'm trying to get it to backup Applications and stuff on the dock such as iPhoto, and Photo Booth.

    It's one of these External Hard Drives. I go to the Finder folder and go to the "Seagate Backup Plus Drive" to see what's in there and what I assume is that backups but the only thing that seems to be in there is folders from everything that is Desktop and a few Documents. The Applications folder seems to be empty and there are no folders for Photo Booth or iPhoto. Everything from GarageBand and iTunes seems to have been backed up according to the Seagate Backup folder when it is plugged in and opened. How do I get this thing to backup everything from Photo Booth and iPhoto? And by the way, I can't seem to access Time Machine the way you get it to where you can go back in time and see all of your stuff from previous dates. I don't know if this is important or a crucial part but I seem to not be able to access the actual time Machine Layout.

    Simple on that one - Download Carbon Copy and follow the steps below:
    if you have access to an external USB enclosure use it, or you can buy one for $10...
    install your new ssd in the usb enclosure - connect to your macbook...
    open disk utility and format/erase your ssd - mac os extended journaled.
    open carbon copy - clone your drive with it - source (your old drive) + destination (your ssd).
    once the clone is done, turn your macbook off - take old hard drive out - install new ssd in....
    turn your macbook on - if boot time is more than 40 secs to desktop - go to system preferences - startup disk and select your new ssd as the startup disk - restart your macbook - should be about 14 sec boot time now.
    install your old hard drive in your usb external enclosure and use it as a backup drive.
    good luck

Maybe you are looking for

  • When I try to open something in a new tab, Firefox instead opens a file called as untitled.

    When I try to open something in a new tab, Firefox instead opens a file tab called "untitled." Anything that would automatically open new nab instead opens a file tab called "untitled." "Untitled appears to be empty. == This happened == Every time Fi

  • Weird folder icon with question mark

    for the past twenty four hours, my computer has not been booting up. it finally chimes that it's on,but it won't go any further than the screen with the tiny folder icon in the middle that shows the finder icon and then a question mark. any answers t

  • Trial or demo for Mac OS X Lion...

    To improve management and integration with our Active Directory infrastructure; we're thinking of setting up a Lion server on our network in the Apple recommended "Golden Triangle". However, for obvious reasons, we would like to try before we buy. Is

  • UDF reqiured for the below reqiurement

    Hi ALL, Can any one help me out by sending the javacode for the below reqirement. My sender data is coming from database.So based on  2 fields i have to spilt the idocs at target side. my reqirement is 1)Material number and 2)Batch Case 1: For the sa

  • Summarizing Cross Tab totals as Average

    Hello, I have summarized fields in a cross tab report as sum of, however want to average the total of one of them- is there a way to do this? Thanks, WA