Out of band Clocking between MWR-2941

Question

Good morning I'm having problems configuring out
of band clocking between two MWR-2941
I have configured one MWR-2941 to
Remote
recovered-clock slave
interface Virtual-Cem 0/24
cem 0
     xconnect 10.10.10.2 7600 encapsulation mpls
network-clock select 1 PACKET-TIMING
network-clock-select hold-timeout 900
the Master Router is getting it clock signal from an E1/T1 interface
MASTER
controller E1 0/0
clock source internal
cem-group 0 unframed
description Clocking-Signal
controller E1 0/13
clock source line
cem-group 0 unframed
interface CEM0/0
description Clocking-Signal
no ip address
cem 0
  xconnect 172.16.20.26 7600 encapsulation mpls
interface CEM0/13
no ip address
cem 0
  xconnect 172.16.20.26 11591 encapsulation mpls
with this configuration i can't get any clocking at the remote site. I have configured this between a Cisco 7609 and the MWR-2941 without problem, but in the Cisco 7609 I can create another virtual-cem interface. But I can't find a way to create a virtual-cem in the MWR-2941 that should be working as the clock master.
Any help will be greatly appreciated.
Thank you very mucy.

Answer 1

Thank you for your attention ,
I did not see such out put of my sho mac add command ,
I sent a image of my current topology , it may be useful , please find it.
I used router instead of cisco layer 3 switches (SVI for user access vlan is configured on router as sub interfaces) , and On my NAC Server I created a vlan mapping rule that map unauthenticated vlan to one of my access vlan ,
I have a problem with my Managed subnet !! I have to put my Managed Subnet as default gateway for my client because if I put the router SVI cisco nac agent client does not pop up at all !!!
I read different documents about that and all of them said that your client default gateway must be SVI , but it does not work,
best regard