Picture "mms" email sent multiple times when sending to another phone

I sent a picture using gmail to a friend's cell phone (Verizon) to [email protected] so they can get is as an MMS text. They received the message, but about a day or two later they received the message again about 15 times. I went into my sent folder and deleted the message and that seemed to stop it from being sent. This has happened multiple times. Anyone know why it would be doing this? Hopefully MMS will be added in a future update it would make it so much easier to send and receive pics.

Not sure why and although I've done this only a few times, I have not experienced the same but I haven't used a Gmail account for this. Do you access another email account on your iPhone besides your Gmail account? If so, try using another account for sending all MMS via email to see if the same occurs.

Similar Messages

  • Dps file automatically opening multiple times when working on another file in the same folio?

    dps file automatically opening multiple times when working on another file in the same folio? Can anybody please help

    Can you try resetting your preferences first and see if that helps - see Troubleshooting 101: Replace, or "trash" your InDesign preferences

  • Email being sent multiple times when actions are triggered after creating an incident. Anyone has a resolution?

    Email being sent multiple times (3 times) when actions are triggered after creating an incident.
    Below is the snip of "Scheduled Actions" of the created Incident.

    Hi Ritesh
    Email is triggered based upon conditions and you set
    on closer look it is 3 different email on three 3 different requirement for e.g
    email triggered to reporter on new status
    email trigerred to processor on Proposed solution and New status
    Therefore, check the start condition for above 2 email actions and refer below blog
    Sending E-Mail from Support Message
    Thanks
    Prakhar

  • Asked to enter PIN multiple times when sending Digitally Signed emails

    Hey everyone, I have been having a very difficult time trying to figure out why my co-workers and myself are being asked to enter our PIN multiple times when digitally signing emails.  My co-workers are looking to me for a solution, however
    I just cannot seem to find any information on as to why this is happening.  Could anyone possibly shed some light on why this may be happening?  Thanks in advanced!!! 
    P.S. We are using Outlook 2013

    Hi,
    Let's troubleshoot this issue by the following steps:
    1. Start Outlook in Safe Mode to determine whether it's 3rd-party add-ins related:
    Press Win + R, type "outlook.exe /safe" in the blank box, press Enter.
    If no issue in Safe Mode, disable the suspicious add-ins to verify which on caused the problem.
    2. Go to Control Panel and search for "Manage computer certificates" then open it, find the certificate and right click on it, choose Properties -> under General tab select "Enable all purposes for this certificate" -> Apply ->
    OK.
    3. If you create a new Outlook profile, does this issue persist? A new profile will provide a new environment for the account and it will not remove any information from the old profile. A profile corruption may be the source of this issue.
    How to create and configure email profiles in Outlook
    http://support.microsoft.com/kb/829918/en-us
    Regards,
    Melon Chen
    TechNet Community Support
    It's recommended to download and install
    Configuration Analyzer Tool (OffCAT), which is developed by Microsoft Support teams. Once the tool is installed, you can run it at any time to scan for hundreds of known issues in Office
    programs.
    Manage computer certificates

  • The same email sent multiple times

    I have seen this topic a few times but as yet have not read an answer to the issue. It appears that occassionally an email will be sent multiple times to the same recipient. This is very annoying for the recipient, but more importantly can become very expensive if this is happening whilst roaming. Does this only happen if the signal is poor at the point of sending? Replies welcomed.

    that is your problem.
    You are saying: run this workflow whenever the incident is updated with the sole criteria that the incident has the status resolved.
    What is happening is then that the workflow runs the first time and applies the template. This updates the incident which then triggers the workflow. This goes on until one of the runbooks has updated the incident to status closed. Then the criteria is no
    longer true.
    change the changed from to include the criteria
    status NOT EQUAL resolved.
    http://codebeaver.blogspot.dk/

  • Same emails sent multiple times

    I have three iphones 3G in my company, all set up with Exchange. With all of them, we have the same problem: when the user sends or replies to an email, the recipient gets multiple copies of the same email (anywhere between 2 and 50, mostly 2 to 5). Any suggestions?

    I have experienced this a couple of times over the past week. In one instance I kept getting a pop-up that the email could not be sent each time an attempt was made. Unfortunately, the email WAS sent so the recipient received several copies until I deleted it from the Outbox.
    In all the cases here the email included an attachement.

  • Emails sent multiple times

    OK, Ipad 4 and when we send an email from the ipad the recipients are getting 10-15 copies in their inbox. These are emails via our gmail account and they have pics attached.
    Ideas? Fixes?
    Thanks

    I have experienced this a couple of times over the past week. In one instance I kept getting a pop-up that the email could not be sent each time an attempt was made. Unfortunately, the email WAS sent so the recipient received several copies until I deleted it from the Outbox.
    In all the cases here the email included an attachement.

  • Why does my iphone only send one picture multiple times when i select multiple photos to send?

    why does my iphone send one picture multiple times when i select multiple photos to send (via message or email)?

    Are you sending via Camera itself?
    That is, selecting a picture, then select forward link symbol from bottom left
    then select another picture,
    Each time make sure you see the blue check mark at bottom right of each selected picture.
    The number of " # Photos Selected" should be displayed at the top.
    Then select Mail or Message and transmit.

  • Receiving the same text message multiple times when person only sent it once. How can I make it stop?s from

    I received the same message multiple times and the person that sends it only did it once. Also, I have trouble getting texts from non iPhone using friends.

    It's actually probably a carrier (or hardware) issue on the sender's end. Tell the sender to pull the battery from their phone (or reset it if the battery is non-removable). I've seen this issue with certain HTC phones (HTC did release an update which solved the issue on my Thunderbolt). As far as I knew, I only sent the message once. However, it would show up multiple times on the receiver's phone. Pulling my battery would solve the problem for a while. It did take the software update to stop it permanently.

  • How can I have the title of the document be in the email subject line automatically when sending?

    How can I have the title of the document be in the email subject line automatically when sending?

    It can be done if you use a script, like this one:
    this.mailDoc({cTo: "[email protected]", cSubject: this.title});

  • Why does the Creative Cloud app steal focus multiple times when it starts up?

    I am running Windows 8.1. When my system boots up, I've set Creative Cloud to launch at startup. I like to have the CC app running in the background so I can keep all of my apps up to date.
    The problem is that the CC app steals the operating system's focus multiple times when it launches. For example, right after I log in to Windows, I'll usually launch Chrome. If I start typing something in the address bar, I am interrupted halfway through as the CC app launches and steals the focus. So then I reset the OS focus to Chrome and start typing again. And then CC usually steals the focus again after a couple of seconds.
    I've verified that it is CC by disabling launch-at-startup. Doing this makes the problem go away.
    This is completely obnoxious and unnecessary. If an app launches in the background, it shouldn't steal the focus once, let alone twice. This is software development 101. We are paying good money and should not have to deal with problems like this.

    Here you go:
    https://creative.adobe.com/share/a943d4fa-a03e-4f8f-a49e-d22019257dea
    David

  • Aperture recently started listing Facebook albums multiple times when trying to select an album to share to.

    Aperture recently started listing Facebook albums multiple times when trying to select an album to share to.

    I've seen this duplication once or twice before - in my case it was with SmugMug.
    Try removing the Facebook account from within Aperture, and then re-adding it. It should resolve the issue.

  • Is there any way to have FaceTime ring multiple times when someone wants to talk? Unless I am at my computer I would never I would never know someone wants to talk.

    Not sure of the protocol and apologize if I have repeated my question which is "Is there any way to have Facetime ring (alert) multiple times when someone wants to talk? Unless I am at my computer, I would never know someone wants to make contact."

    I reposted the question here where I'm getting advice:
    http://discussions.apple.com/thread.jspa?threadID=1302031&tstart=0
    S.

  • Customer is getting created multiple tims when it has multiple sites

    Hi,
    I developed customer conversion.
    when I load data through conversion in R12 Customer is getting created multiple tims when it has multiple sites.
    what are the things I have to take care to prevent this.
    Please suggest me If any one has Idea.
    Thanks & Regards,
    Narendra.

    Hi Gabriel,
    Thanks for taking time to reply to my post.
    When one of my collegue giving the print, there is only one spool which is getting created, but when I run the program there are multiple spools are getting created.
    -Pradeep

  • Redirect internal email sent to a distribution list to another user mailbox

    Dear all,
    We are running on Exchange 2010 and would like to know if it would be possible to redirect email sent to a distribution list to another mailbox if source is internal, meaning from address is *@company.com
    Let me explain: We have a DL like [email protected] and a ticketing system which checks a mailbox [email protected] on a regular basis.
    We would like to redirect only the messages from our users to helpdesk in order to automatically create cases for their problems. 
    Have been checking EMC and ADUC but couldn't find anything related to this.
    Kind regards,
    Tudor.

    Hi,
    Yes, creating transport rule will achieve the goal.
    Glad to know that we have solved this problem.
    Have a nice day : )
    Thanks
    Mavis
    Mavis Huang
    TechNet Community Support

Maybe you are looking for