Problem with iPhone 4s when ran out of battery and charged.  Siri keeps talking and I could not use my iphone.

Problem with iPhone 4s when ran out of battery.  After charging and on main screen, Siri keeps telling me what I have on my main screen.  I selected any icon and it's not responding except Siri telling me what it is.   Nothing is happening. I cannot even move to next screen.   I cannot use my phone totally. I need help. I turned off and on and not working.

It's not Siri that is talking, it is one of the accessibility features. If you can't go to Settings to change the accessibility settings you will have to restore the phone from Recovery mode: http://support.apple.com/kb/HT1808

Similar Messages

  • Hello there, i have a major issue with my iphone 3g, it ran out of battery yesterday and now it won't charge or turn on at all, can anyone help??

    hello there, i have a major issue with my iphone 3g, it ran out of battery yesterday and now it won't charge or turn on at all, can anyone help??

    Apple Does Not recommend that. Please Read.
    http://support.apple.com/kb/HT1490
    From that article
    "Portables with built-in batteries"
    Current Apple portable computer batteries are pre-calibrated and do not require the calibration procedure outlined in this article. These computers use batteries that should be replaced only by an Apple Authorized Service Provider.
    MacBook 
    MacBook (13-inch, Late 2009) and later
    MacBook Air
    MacBook Air (all models)
    MacBook Pro
    MacBook Pro with Retina display (all models)
    MacBook Pro (13-inch, Mid 2009) and later
    MacBook Pro (15-inch, Mid 2009) and later
    MacBook Pro (17-inch, Early 2009) and later
    Thanks.
    Allan Mac wrote:
    Apple recommend calibrating the battery when you buy a new Macbook and then every few months, or monthly if it used on mains all the time. This, as Apple says is to keep the battery operating at maximum efficiency. When the battery discharges and shuts the macbook down, it still has reserve power for a good number of hours. There is also a logic board battery to hold various settings.
    I rather think I will take Apples advice on using their equipment not yours, but I would be intrigued to discover what is it you know that Apple doesnt about its batteries?
    Allan

  • IPhone 4S never rans out of battery?

    This is generally not a bad thing but my iPhone 4S never rans out of battery...
    The longest my phone has been on 1% before going on a charger was around 30minutes and only recently this has happend, usually it would take about 5 minutes for my iPhone to transition from 1% to a dead battery.
    The solution would help so I can actually find out when my phone would die instead of rushing to the nearest charger asap.

    Without knowing what kind of games you were playing and for how long, my gut reaction is, sure, this is entirely possible...

  • Trying to upgrade to 10.6 so my iPhone could synch...I'm getting this error message "Problem with this Windows (XP) Installer package.  A program required for this install to complete could not be run."  Any ideas?

    I had iTunes 10.2.1.1 but needed to upgrade to 10.6 so my iPhone could synch...I'm getting this error message "Problem with this Windows (XP) Installer package.  A program required for this install to complete could not be run."  Any ideas?

    This has been fixed.  Answer is that I needed to go to "Apple Software Update" and repair it.  (From my Control Panel).

  • In the middle of the installation processing, this has appeared: "There is a problem with the windows installer package. A program is required for this install to complete could not be run." my question is, what is that specific program?

    in the middle of the installation processing, this has appeared: "There is a problem with the windows installer package. A program is required for this install to complete could not be run." my question is, what is that specific program?

    Let's try the following user tip with that one:
    "There is a problem with this Windows Installer package ..." error messages when installing iTunes for Windows

  • Problem with saving a pdf file to computer. Continually get an error message " This document could not be saved. There was a problem reading this document (21).

    Need advice on a saving file issue. I'm having problem with saving a .pdf file to computer. Continually get an error message " This document could not be saved. There was a problem reading this document (21). This is new as this error message just recently started to pop-up.

    More information about this issue can be found here:
    https://forums.adobe.com/thread/1672655
    A "quick" fix that worked for me was to uninstall Adobe... then download the base install for Adobe Reader 11.0.
    Then download each of the individual updates and run them sequentially. 
    I've installed back up to the last security update which is version 08 and have been able to do normal Save As operations.
    You will have to disable automatic updates in order to stay at version 08 until Adobe resolves this issue in a later release.
    http://www.adobe.com/support/downloads/product.jsp?product=10&platform=Windows
    Adobe Reader 11.0 - Multilingual (MUI) installer    AdbeRdr11000_mui_Std
    Adobe Reader 11.0.01 update - Multilingual (MUI) installer    AdbeRdrUpd11001_MUI.msp
    Adobe Reader 11.0.02 update - All languages    AdbeRdrSecUpd11002.msp
    Adobe Reader 11.0.03 update - Multilingual (MUI) installer    AdbeRdrUpd11003_MUI.msp
    Adobe Reader 11.0.04 update - Multilingual (MUI) installer    AdbeRdrUpd11004_MUI.msp
    Adobe Reader 11.0.05 security update - All languages    AdbeRdrSecUpd11005.msp
    Adobe Reader 11.0.06 update - Multilingual (MUI) installer    AdbeRdrUpd11006_MUI.msp
    Adobe Reader 11.0.07 update - Multilingual (MUI) installer    AdbeRdrUpd11007_MUI.msp
    Adobe Reader 11.0.08 security update - All languages    AdbeRdrSecUpd11008.msp

  • When I try to use the Smart Brush I keep getting this message "Could not use the Smart Brush tool because it is not a valid Photoshop document"

    When I try to use the Smart Brush I keep getting this message "Could not use the Smart Brush tool because it is not a valid Photoshop document". Can someone please help me fix this? It's never done this before until now...

    First go to the editor preferences>general and click this button, then restart the editor and try again. If that doesn't do it, more info, like your version of PSE and your operating system:

  • I keep trying to update my iphone and i get a message saying iTunes could not restore my iPhone because the backup system failed

    'm trying to sync/update my iPhone on my windows computer in iTunes and I keep getting and error message saying iTunes could not restore the iPhone because the backup session failed.

    Disable your firewall/security software.
    This is asked and answered everyday.  Using the forum search bar on the right side of this page often will find an answer very quickly.

  • When trying to install iTunes I get an error message saying something like "there is a problem with this windows installer package. A program required for this (install/setup) to complete could not be run. Contact your support personel or package vendor."

    I'm trying to install iTunes to my laptop and I get the message listed above in the topic area. How do I fix this?

    Try the following user tip:
    "There is a problem with this Windows Installer package ..." error messages when installing iTunes for Windows

  • IPhone 4s 16GB ran out of battery at 3pm?

    I was playing games for quite a bit, but 3pm from a full charge on the morning? Come on. Is there possibly something wrong with the phone?

    Without knowing what kind of games you were playing and for how long, my gut reaction is, sure, this is entirely possible...

  • My husband and I have the same itunes password.  When I tried to set up his own, it said that I could not use his email address because it is a back up address on mine.  How can I change that....can't find the right place to go.  Thanks

    My husband and I have the same itunes password.  When I tried to set up a separate one for him, it said that his email address was used as a backup on my phone so it could not have its own address.  Where do I go to remove his address as my backup address....thanks

    Hi theirmimi,
    Go to Manage your Apple ID (on a computer) and sign in with your Apple ID. Then you can edit the email information on your account:
    https://appleid.apple.com/cgi-bin/WebObjects/MyAppleId.woa/
    Cheers,
    GB

  • My iPod 3rd generation just ran out of battery, so I plugged it in, and I got a blank white screen and I don't know what to do. Please help!

    I just got a white creen and I don't know what to do! Help! I don't want to reset my iPod!

    Restart...
    Press and hold the Sleep/Wake button until the red slider appears. Slide your finger across the slider to turn off iPad. To turn iPad back on, press and hold the Sleep/Wake until the Apple logo appears.
    Keep this handy:   http://manuals.info.apple.com/en_US/iPod_touch_iOS4_User_Guide.pdf

  • Cracked screen on ipod touch can't get in to it. did a back up with it and tried to put it on new ipod touch 5 and now it keeps talking and won't let me in or turn off.  how can i restore to nothing

    Cracked ipod touch screen and it won't let me in or turn off.  Tried to back it up and put on new ipod touch 5 and now it's not working and doing the same thing. I tried to restore to orginal  but it won't let me any suggestions?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar                                              
    When the above says to restore via iTunes, restore to factory settings/new iPod, not from backup

  • Could not update his iphone to os 5

    My husband could not update his iphone to os 5 from his computer (due to itunes not being upgradeable) so he jumped on mine and upgraded, he later mentioned the warning about losing all content. He did back up on his computer, thinking he could go to his computer to get all his info and apps back after upgrading. UGH! So now I am wondering, can that backup that is on his old mac be transferred to my Mac book Pro, and fix the problem. If so can some kind soul direct me to easy instructions?

    My husband could not update his iphone to os 5 from his computer (due to itunes not being upgradeable) so he jumped on mine and upgraded, he later mentioned the warning about losing all content. He did back up on his computer, thinking he could go to his computer to get all his info and apps back after upgrading. UGH! So now I am wondering, can that backup that is on his old mac be transferred to my Mac book Pro, and fix the problem. If so can some kind soul direct me to easy instructions?

  • Itunes could not connect to iphone because pairing record is missing???

    I have just upgraded to iphone 4s from iphone 4 and when i connect it to my itunes i get the message "itunes could not connect to iphone 'iphone' because pairing record is missing. Any clues what i've missed???
    Also my when i try to backup my iphone 4 to icloud it keeps stopping saying 'incomplete'???

    Try disconnecting your phone from your computer, quit iTunes, connect you phone to your computer again, the re-launch iTunes.

Maybe you are looking for

  • WLS10 PRE CLASSPATH and apache commons

    Hi, Our web application requires latest versions of apache-commons especially commons-lang.jar, After reading through thread; came to know that if we add PRE CLASSPATH entry for latest versions of these jar, application work as expected, and our appl

  • Open a txt file in a real time PXI target

    I want to open and read a txt file when targeting to a PXI, running a real time OS. The file is saved in a specific directory of the real time machine. When I run the typical Labview (version 7.1) examples there is alwasys an error message.

  • WD Passport not mounted and not seen in Disk Utility, but something seen in Terminal

    Hi, I have a WD 1TB Passport external hard drive.  THe light comes on and the disc spins, but I can't see the hard drive in disk utilitiy or anywhere else.  I know that it connects.  I saw a post about using terminal to mount using code, but it never

  • Do u  need a screen protector for the Iphone

    I know it might be a stupid question but alot of my friends have the Iphone 4 and they say they dont need a screen protector because the screen doesnt scratch like other smartphone and phone screens. Anyone know if this is true? Eric   

  • Html Email format

    Hi everybody can you tell me what kind of format do i have to save my html file to be able to insert it in an email ??? Many Thanks Chilli