Product Group capacity can not be seen in MF50 output

Question

Dear All,
I can not see the product group in 'total capacity' subscreen in output of planning table MF50.
In MF50 the input parameter i am entering is product group and plant.
In the scheduling tab of input parameters detailed scheduling and capacity planning is tick.
For some product groups i can see in output as "Product Groups / Total Capacity" and also in the rows below it shows "Prod.Grp XYZ" then requirement and available quantity rows. After which the production line rows follows.
For some product groups when enter in initial selection screen of MF50 with same input parameters in output i do not see Product group but i can see "Total Capacity Data" and then the rows starts with production lines. But no information on capacity of product group.
The setup of all product group is same and are created with MM01.
Regards,
Vero.

Answer 1

Hi Rupesh,
Thanks for reply.
In 'Control Tab' i am not selecting any parameter. So in output i can see all materials  in 'Material Data' section which are included in product group  irrespective of requirements.
I have issue in upper half section of 'Total Capacity Data'. I can see the different production line rows with Requirement / Available rows with capacity values in each period. Unit is %.
But i do not see 1st row for Product group row with 2 subsequent rows (requirement / available) with unit KG.
I can see these rows only for some product groups but not for all.
For the product groups for which i do not see these rows have capacity requirement in selected periods which can be seen in same output in production lines rows. (where selection in input screen is product group and plant)
Regards,
Vero