RAM Croaking - Help me spend $!

Question

Ha!
Thought that would get the collective attention!
My PC3200 TCCD PQI Turbo Platinums are getting ready to bite the dust.
After quite a few not so great OC attempts & generally unstable performance, I got my thumbs out & ran 'em through MemTest and....
Instant errors!
I guess you really can kill TCCD based 3200's by thrashing them @ 280mhz+ for 18 months.
Long story short, I have determined that they are practically useless above 215 or thereabouts.
Here's some criteria - Need some decent stuff that will OC well with my Neo4 Plat & Opty 165. 1GB kit preferred but will consider 2GB (2, 1GB modules so I can keep 1t timings) if the results are good enough - i.e., can get above 250 mhz @ 1:1.
Don't try to "sell" me on flashing lights or any of that stuff - performance for $, not "bling".
The "floor" is now open....!

Answer 1

Think you made a wise choice 
No other memory vendors support staff do this kinds of tests and share results (that I have seen) :
Ram: OCZ PC4000 Platinum EB 2GB Kit (3-3-2-8)
Bios Rev: 1.9 from MSI Taiwan Site.
CPU: X2 4200+ Manchester
Vid Card: XFX 7800GT
Power Supply: GameXtream 700W (Beta)
Ref RyderOCZ Cell Menu
High Performance Mode.........................  Manual
Aggressive Timing.............................  Disabled
Dynamic Overclocking..........................  Disabled
Adjust CPU FSB Frequency......................  250
HT Frequency.............................. ....  4x
HT Width.................................. ....  16 16
CPU Spread Spectrum ..........................  Disabled
SATA Spread Spectrum..........................  Disabled
PCI-E Spread Spectrum.........................  enable
PCI-E Clock.................................. .  100 MHz
SSE/SSE2 Instructions.........................  enabled
Cool 'N' Quiet................................  Disabled
Adjust CPU Ratio..............................  x9 (to keep CPU @ Stock)
Adjust CPU Vid................................  1.350V
Extra CPU Voltage.............................  By CPU VID
Memory Voltage................................  2.55V
NF4 Voltage................................ ...  1.50V
DRAM Configuration
Timing Mode...................................  Manual
Memclock Index Value (MHz)....................  200
CAS Latency (Tcl).............................  3T
Min RAS# active time (Tras)...................  8T
RAS# to CAS# delay (Trcd).....................  3T
Row precharge time (Trp)......................  2T
Row to Row delay (Trrd).......................  3T
Row Cycle time (Trc)..........................  10T
Row refresh cyc time (Trfc)...................  16T
Read to Write delay (Trwt)....................  3T
Write recovery time (Twr).....................  3T (which gives 2)
Write to Read delay (Twtr)....................  Auto (anything else won't boot)
Refresh Period (Tref).........................  1x3120 Cycles
User Config Mode..............................  Manual
Bottom of 32-Bit[31:24] IO....................  D0
1T/2T Memory Timing...........................  1T
Read Preamble Value...........................  6ns
Async Latency Value...........................  6ns (This results in 8ns)
S/W Memory Hole Remapping.....................  Disabled
H/W Memory Hole Remapping.....................  Disabled
MTRR Mapping Mode.............................  Continuous