Re-Capturing Media with original settings but with Stereo not Mono Selected

Question

Hi,
I am trying to re-capture about 17 hours of interviews that I just shot in Africa over the past month. It has all been digitized with the audio set to Mono instead of Stereo (in my jet lagged mindset I forgot to set to Stereo)! I need the stereo setting as I always had a wireless lav on the subject and a wired lav on the interpreter and I need to be able to split them out in the sequence. I have already built sequences with all the interviews and a timecode window burn for my client, which sounds fine for simple timecode logging, so I would like to reconnect so that all of those sequences will remain intact.
So when I try to go recapture, whether I delete the original clip OR just make it offline and save the new captured clip to a different location, it automatically captures in Mono, as that is what is set in the original clip under Audio Tracks in the browser. It will not let me change that setting in the Browser, and stereo is definitely selected under Audio Clip settings in Log and Capture.
I have to think there is a way to do this so that I can save my original clip information, without having to reset all new in and out points and recapture it all with the exact same name to a different drive so it works in my sequences.
I don't need to recapture the 18 or so hours of b-roll thank goodness! As it was all shot with a mono shotgun.
Also, when I go to recapture the clip a warning comes up and says I am trying to capture media shot in Non Drop Frame on a device set to Drop Frame..etc etc etc.
I did shoot in non drop frame but I have not changed anything on my deck (Sony DSR-11) and don't even think there is a switch to go between the two. If I try to simply capture a new clip I get no such warning? It seems to play fine regardless but I wonder if I will have issues down the road integrating the new clips in with the b roll.
Many Thanks,
Any help is greatly appreciated,
Peter Mallamo

Answer 1

If both tracks are in the sequence, then just select one side, and in FCP's Modify menu (audio submenu there), pan all to one side, then select the other track and pan all to the other... you can change the stereo to mono and mono to stereo too in that same menu... no need to recapture at all. Do this mono to stereo move simply by selecting the clips in the sequence, and checking on or off the stereo pair selection...
Jerry
Message was edited by: Jerry Hofmann