Reading Ultra II SD Cards?

I have recently changed my digital camera to a DSLR with a SanDisk 2GB Ultra II Secure Digital Card and find that I cannot read this card, getting the message "you have inserted a disk containing no volumes that MAC OS X can read....." The camera, card reader and computer works correctly with normal SD Cards. How can I use Ultra II SD Cards?

My SanDisk Ultra II 1 gb card works fine with my iMac and MacBook so I don't think it's the card unless yours is defective. A good first step would be to format the card in the camera. Also, the camera that I use that card in offers two levels of formatting. If yours does, be sure to try both.
Clint

Similar Messages

  • PCI Ultra ATA66 controller card compatible with G4 tower?

    I hope this makes sense. Here goes. I purchased an IDE ATA133 card on Ebay but was sent a IDE ATA66 card instead. It came with a ribbon with black ends not grey nor blue. I installed it with a Maxtor 200GB drive connected to it without jumpers. After rebooting, my G4 chimes normally but with black screen. What did I do wrong? Or is this card not for my G4?

    "I guess the ATA100 card will work fine correct?"
    If you mean large drive support, it may provide that or may require a firmware update to do so. You should check the manufacturer's web site for specifics. All ATA-133 cards do provide 48-bit LBA for large drive support. I'd return the Ultra ATA-66 card to the eBay seller, although many refuse to pay for return shipping, even when the mistake is their own, either through ignorance or deliberate misrepresentation. In cases such as this, it's sometimes more cost-effective to swallow the loss and keep the incorrect part.
    "Will adding a jumper apply for a ATA100 card as well? I'll need a blue and gray ribbon correct?"
    If you use an 80-conductor ribbon cable with color-keyed connectors, set the drive configuration jumper to CS and connect the drives to the cable as you wish (in terms of physical placement in the computer). If the ribbon cable doesn't have color-keyed connectors, set the jumper for the device connected to the end connector as Master and the drive (if any) connected to the middle connector as Slave.

  • SanDisk Ultra II PC-Card

    Hi everyone
    I keep hearing about problems with PC-Cards mediareaders. So I just wanted to hear from people with experience on this specific product.
    I only use SanDisk Ultra II CF-Cards.
    Best regards
    Sofus Bech

    I've been using Sandisk Ultra II CF cards in my 350D with no problem. And I recently purchased a Delkin 32-bit cardbus CF reader. Much more compact than my Lexar firewire CF reader and just as fast if not faster transfers. The combo is well worth it. And I own 3 Ultra II CF cards with no problems experienced.

  • How can I make my mac book pro read a SDHC memory card

    Can someone tell me how to make my mac book pro read an SDHC memory card?

    http://support.apple.com/kb/HT3553

  • How to read data from credit card reader

    Guys,
    We are planning to implement CASH DESK (FPCJ) interface,
    The requirement is when the user wants to pay his bill using his credit card by swiping on credit card machine (MAGTEK Made in TAIWAN) , I want read those detail and fill sap screen fields in FPCJ tcode like card number, name, expiration date and cvv number.
    Can someone please provide guidelines on how to interface with an external card
    reader to automatically get the card details into SAP when the card is
    swiped?
    Is there any event in FQEVENTS?
    I found one event 6065 and when I try to debug by putting the breakpoint in the function module it's not stopping me there, I mean it's trigger that event,
    could someone please help me to get those details...
    Thanks
    M
    Edited by: BABU P on Jul 9, 2008 4:14 PM

    Friends,
    I am able to read the the credit card details ,
    my next question is, How to activate the PAYMENT program to send credit card details to the 3rd party system .
    we are using 3rd parth system to validate the credit card and send back to SAP an authorization code..
    Can any please help to activate the PAYMENT program ,
    we created the RFC Destination(SM59) type TCPIP and given program id as: "paycard" gateway and gatewayservice,
    when click on test connection it is giving me below error.
    Logon     Connection Error
    Error Details     Error when opening an RFC connection
    Error Details     ERROR: program paycard not registered
    Error Details     LOCATION:
    Error Details     DETAIL: TP paycard not registered
    Error Details     COMPONENT: SAP-Gateway
    Error Details     SUBRC: 0
    Error Details     RELEASE: 700
    Error Details     TIME: Wed Jul 23 14:47:38 2008
    Error Details     VERSION: 2
    can any one help me to activate the paycard program..
    Thanks
    M

  • IPhoto cannot read my Kingston 8GB card

    I posted an issue under iMac
    https://discussions.apple.com/message/17073733#17073733
    that probably should have been posted to this iPhoto community. I have a new Kingston 8 GB SD card that formatted fine in my Canon SD-1200 digital camera. The problem is I cannot get the card to mount on my Apple iMac running OS X 10.7.2 with iPhoto 9.2.1. What is weird is I can get my wife's Apple MacBook Pro to mount the card. 
    My iMac does not not have card slot so I have to use an iConnect USB adaper that works fine on the iMac with a Kingston 2 GB SD card.  I maintain iPhoto on on the iMac so I am dead in the water because I cannot get the iMac to mouth the Kingston 8 GB SD card
    I now suspect the iConnect SD Card Reader/Writer may be the weak sister

    I agree the weak sister is the iConnect SD Card Reader.  As a test the 8 GB Kingston SD card can be read using the card reader slot on the Mac Book Pro; however, the same MBP cannot read the 8 GB card using the iConnect Reader. 
    I pulled this data from the MBP's System Information and it looks like the Alcor Micro Corp device is the problem child.  Maybe Santa will put a new reader in my stocking
    Mass Storage Device:
      Product ID:          0x6331
      Vendor ID:          0x058f  (Alcor Micro, Corp.)
      Version:          1.02
      Serial Number:          058F0O1111B
      Speed:          Up to 480 Mb/sec
      Manufacturer:          Generic
      Location ID:          0x26200000 / 3
      Current Available (mA):          500
      Current Required (mA):          250
    Internal Memory Card Reader:
      Product ID:          0x8403
      Vendor ID:          0x05ac  (Apple Inc.)
      Version:          98.33
      Serial Number:          9833
      Speed:          Up to 480 Mb/sec
      Manufacturer:          Apple
      Location ID:          0x26500000 / 2
      Current Available (mA):          500
      Current Required (mA):          500

  • Photoshop Elements 10 has suddenly stopped being able to read from camera memory card

    For no apparent reason Photoshop Elements 10 can no longer read from my camera card reader. This happens both when I load the card in to my PC card reader or when I load to a card reader connected via USB.
    I get the message "Elements Organiser cannot obtain files from this device. Please ensure that this deviCS is connected properly, or that the batter is charged and try again.
    This happens despite the pictures loading and even the first one shows as a thumbnail.  I can get around this by loading the photos in to Windows 7 and then bring them in to Elements from their file location.
    Any suggestions will be greatly appreciated.

    Please disregard this. I tried everything but restarting my computer & when I did, it downloaded all my messages.

  • My n82 is not reading my pictures from card

    hy, I have a nokia n82, everything is working just fine, but this phone is not reading my picters from card, not even one of theme, pictures from phone memory are opened.
    Everything else is working from card, music, videos, office doc., pictures...no. can anyone help me? maybe i did something wrong...a setup or something?????

    babdi, I think the hard reset is not the solution to ALL problems let's first try some things before recommending doing hard resets for all problems.
    in this case the likely problem is a corruption with the Gallery database in the Memory card. But it's hard to pin down.
    There are several things to try I wouldn't keep doing RESETs of the device as you may not solve the problem and you are wiping all your settings, and files.
    The problem is either in the \private folder in the Memory Card or some other file in the \sys or \system folders there.
    You can try deleting some folders or backing up YOUR files from the memory card then re-formatting. Just don't make a copy of ALL the contents from the memory card, only the files you put there. The other files will/should be recreated automatically.
    640K Should be enough for everybody
    El_Loco Nokia Video Blog

  • Any one know when the iPad4 will be able to read 64gb exFAT memory cards?

    Any one know when the iPad4 will be able to read 64gb exFAT memory cards?

    Currently, the camera connection kit/iPad http://support.apple.com/kb/HT4101 can't read SDXC cards formatted ExFAT, and although not specified in the above link, 32GB cards are the max size. Next week when iOS 7 is released, maybe that will change.
     Cheers, Tom

  • Leopard does not support reading/writing to SD card via network?

    I have a Pixma MX700. I can read and write to SD cards using the card reader built into this machine ... IF I use Windows XP. Leopard will mount the card and allow me to view it contents but the minute I try to import a file to my iMac, I get error code 1401.
    I've been told by Canon support that the new MP Navigator EX driver for Leopard disables reading from the memory card over a network. They claim Leopard does not support this function and reading the posts from others having the same issue using different multi-function printers, this would appear to be a Leopard issue, not a Canon issue.
    Can anyone confirm this and/or offer a fix?
    Thanks!

    Hi,
    Could you check for SAP Note   1952701 - DBSL supports new HANA version number
    Regards,
    Gaurav

  • TS1292 i can not read my i tunes card,can someone help

    i can not read my i tunes card,can someone help

    If the page that you posted from doesn't help then you will need to try contacting iTunes Support (you will probably need to give them images of the front and back of the card, and possibly its receipt) : http://www.apple.com/support/itunes/contact/ - click on Contact iTunes Store Support on the right-hand side of the page, then iTunes Cards And Codes

  • Can't read Sony SxS memory card.

    Just discovered that my new $3000 MacBook Pro can't read my Sony SxS 64 GB memory card (XDCAM camera). Another "victory" of form over function! Can someone suggest a workaround? The built-in SD slot is useless to me...

    Get an external card reader that supports your card
    Sony make one, and Amazon sell it.

  • How can I get my new ipad 4 to read my compact flash cards? If not can I download the images directly from my camera?

    how can I get my new ipad 4 to read my compact flash cards? If not, can I download the images directly from my camera?

    Tom, thanks for your quick reply. I'm a commerical photographer using Canon 5D mk2's mostly and have in the past just downloaded images to a mac book for backup. I really liked the compact size of the Ipad and just got the retina model with the camera connection kit and seem to be hearing that CF readers can't be used with it b/c they draw too much power. Seems like I remember reading I could use a cord that might have come with my cameras to download directly to the Ipad. I haven't tried it yet as I can't find the connection but then you just said it can't be done? 
       I'm COMPLETLY lost as to your "first pluging in a flash drive to my computer, advice. Do you mean Ipad when you say computer?  "then put your movie/photo files into the folder." HOW????????
         Then plug it into the Ipad??????     TOTALLY lost.
    Also your saying just "do a google search for a reader doesn't work b/c NONE are able to work with the newer Ipads b/c they use TOO much power or so everyone says everyone that have tried.
       Hope you can help a little more b/c I'm really getting frustrated with all the conflicting advice!
    Thanks, Dennis  [email protected]

  • I cannot read a SD photo card on my MacBook Air.  It is in DCIM format.  Suggestions?

    I cannot read my SD photo card on my MacBook Air.  It is in DCIM format.  Suggestions?

    You gave no indications IF or when it was working or with which Mac before this, .....SD card failure is somewhat 'common'
    Verify with another SD card first.
    Are you now stating that you cannot format your SD card?  As mentioned above, format the SD card in your Camera, not on your Mac

  • Does the SD - X D slot on HP C410c PREMIUM FAX AIO Printer recognize and read SDHC and SDXC cards?

    Does the SD - X D slot on  HP C410c PREMIUM FAX AIO Printer recognize and read SDHC and SDXC cards? 

    Does the SD - X D slot on  HP C410c PREMIUM FAX AIO Printer recognize and read SDHC and SDXC cards? 

Maybe you are looking for

  • Pls help me this is an urgent  requirement on  ALV GRID

    Hi all   Here i am sendig my requirement pls help me on coding .. Report Assignment For ELTPs: Selection criteria : Circle id : Select option without interval and mandatory SPR Id :  Select option without interval Project Status :  Parameter Output r

  • Variable output on ELVIS board

    Hi, I need a little help from anyone experienced with ELVIS board. I'm new to LabView, and specially to DAQ tools. I have vi that is designed to drive small DC motor using ELVIS board and Variable output. it's capable of driving small DC and changing

  • Photoshop will not save edits

    Photoshop CC 2014 will not save edits and has to be closed via Control alt delete and the edits are lost- hopin someone can help. thanks,John

  • Charging my itouch on a machine without itunes on it

    If I want to charge my itouch on my laptop which does not have itunes loaded on it (windows 7 64 bit) can I just plug it into one of the usb ports or will there be issues if it doesn't find itunes software to sync with?

  • Removing a purchase resuisition from ME55 list

    Dear friends, I've created a purchase requisition wich had a release strategy Z1-10. I've released it via ME55. Then I've created a purchase order in reference to this purchase requisition and done MIGO and MIRO as well. After that, this release stra