Receiver Agreement error

Question

Hi friends,
I have few scenarios on jdbc-rfc.. for now i can say 6 similar kind at the receiver.. and the rfc is also same..
Now first interface is sucessfull. for the second one i am trying to create new receiver agreement then it is saying it is already exits,,, now what to do.. for this..
for each and evey scenario i have use the same comunication channel then my first scenario out is going to second one..i have faces this... here i can create onley one receiver agreement. please tell me how can we create many receiver agreement

Answer 1

Create the Interface mapping-Here your target Interfae will have "N number of Message Interfaces" for each N message Types. Use the 1:N Mapping done as before.
Now go ahead with other configuration. In Interface Determination select the RB_SPLIT/Extended option use this Interface Mapping over there. If multiple Receivers are required , then go with conditions.
Here i am giving 2 possible ways based on your requirement
In both of the following cases you need to have 2 separate message mappings and 2 interface mappings
Source1_message----
target1_messages - Message mapping(1)
Source1_message----
target2_message - Message mapping(2)
Source1_interface -
target1_interface - use mapping(1)
Source1_interface -
target2_interface - use mapping(2)
1.If 2 receiver messages will be going to same receiving system
a)In Receiver determination no need to specify any condition to determine receiving systems(bcoz you have only one receiving system)
b)But you need to give condition in interface determination.In this case one interface determination is enough
2.If 2 receiver messages will be going to different receiving systems
a)You need to give condition in receiver determination to determine receiving systems
b)In this case, 2 interface determinations required one for each receiving system without any condition
For example
Sender
Service: Source system1
Interface:Source1_interface
Receiver
Service: Receiver1
Inbound interface interface mapping
Target1_interface Source1_interface_to_ Target1_interface
Same as this do for receiver2
Check the following links:
/people/jin.shin/blog/2006/02/07/multi-mapping-without-bpm--yes-it146s-possible
http://help.sap.com/saphelp_nw2004s/helpdata/en/42/f3b31d48fb1bc8e10000000a11466f/frameset.htm
Note: reward points if solution found helpfull
Regards
Chandrakanth.k