Record Level Adjust for Audio in Voice Memo or Video Recorder

I would like to request that Apple allow me to adjust the record audio volume level when recording in Voice Memo or Video Recorder modes. Often I find that the audio is distorting and most times I cannot step back far enough to avoid distortion levels. While I love the ability to SEE the audio level in Voice Memo mode, I am hoping that it is only a matter of firmware upgrade to be able to ADJUST the record level.
Also, if it is possible, it would be great to see some indication of audio level when recording video... something simple like a bar graph with green, yellow and red bars with the highest level reached sticking for a few seconds so that I can tell what the level is.
An alternate solution (if none of the above is possible in a firmware update) would be to automatically adjust the recording level to prevent audio distortion.
Thanks for the great iPod and here's hoping for a great firmware update in the near future!

Thanks, I've submitted my recommendation to Apple.

Similar Messages

  • Can't adjust recording level with M-Audio Fast Track Pro

    I downloaded the appropriate driver for my M-Audio Fast Track Pro interface & everything looks fine... BUT I can't adjust the Recording level at all. I am not sure if this is an issue with the M-audio device, or garage band??? It is driving me crazy, since I just want to make some music and can't even hear what is being recorded. ???

    Thanks, .... Yes to all of the above. I am wracking my brain & will call M-Audio tomorrow. Everything looks perfect on the interface & on garage band - but, even though the Fast track Pro shows up in my sound preferences & I can select it as the input & output source, etc., when I go to its window, even hooked up, it says no "device is not connected." Then it details that there are "no input controls" under sound in system preferences. I have two working usb cords & it does the same on either. I think this is the problem & have no idea how to fix it. I just want to plug it all in and record & have lost So much time . Hmmmmm???

  • Audio Level Adjustment for Multicam Clip

    Greetings,
    I have 2 issues while some audio tweaking for a Multicam edit.  I have assigned the audio for a single angle to apply to the entire sequence.   There are some clips in the sequence where, at times, I cannot adjust the level of the audio.  It will show the level when clicking with the selector, but it cannot be dragged up or down.   Stranger still, if I select it within a series of clips and use CTRL -/+ to change levels, it is unchanged even though all the others changed.  There is nothing differnent about the clips in question (they are not Compound Clips or anything.) 
    Restarting seems to often fix the above problem.  But it seems to be happening enough that it's a real inconvenience.  Also I am having similar issues with the audio level meter freezing up intermittently.  Sometimes when I toggle audio skimmer it can correct it for a while, but once it starts, a restart is inevitable.   Does anyone have any workarounds for making this work properly? 
    One last question that is not a glitch but a functionality I hope exists but cannot find.  Given that I have one angle of audio for the entire clip, I want very badly - and feel like it should be possible - to make adjustments to the audio as I would if it were one continuous clip; for instance, to be able to select a range across the clip transitions and adjust levels accordingly.  So far the best workaround is to select all the clips and use CTRL -/+ to adjust.  But this allows less control, because I must then go in and adjust sections of clips on the ends that I did not want changed.   Would love to  know if anyone knows a way! 
    Thanks for your time and assistance!
    Brian

    I would think it would be easiest to open the muticlip in the Angle Editor where you would have a clear view of each individual angle and its audio.
    Russ

  • Since I upgraded to os 7 my voice memos are not recording and syncing with Itunes.

    In the app the recordings show 0 time and when I sync with Itunes there is no recording listed at all. Any thoughts?

    I found the answer, at least it worked for me.
    Here ya go:
    1) open the Voice Memos app on your iPhone
    2) on any memo: click the little blue arrow on the right
    3) Click the next arrow in the top most box this will put you in the "Label" screen
    4) From the "Label" screen: click the arrow next to "Custom"
    5) In the Custom screen: give the memo a name (click Done)
    6) Click the left arrow (top left) to go back to your memos.
    You'll see that you memo as a name. I changed mine from "4:25 PM" to "Fishcakes".
    7) Sync your iPhone and you are good to go.
    NOTE: If for some reason this doesn't work, go back into the same "naming" list on your Iphone voice memos app, and try one of the standard labels instead of a custom one. With one that wouldn't sync, I changed it to "Memo" and then synced it again, and then it worked.

  • Voice Memos have stopped Recording on iphone 4S

    Appreciate advice for eliminating this problem:
    Needle not moving when I record voice memos on iphone 4S.
    No sound in playback.
    Was working great until last week.

    Try restarting your iPhone by holding down the on/off and the home buttons at the same time until you see the Apple logo. 

  • Voice memos won't record

    Aside from my issues with my 4S not playing videos - I can't seem to record Voice memos either.  I hit the red record button, it beeps for like a second then stops.  Siri works fine, I've no issues with making calls so it's not a mic problem - help me out please.  I'm thinking a restore might be necessary or a trip to the Apple Store which'll be heaving this time of the year....

    I had the same problem, but after importing all my 600 photos to my computer and deleting them from the phone, the voice memo worked like a charm.  I couldn't take any more pictures either until I deleted them from the phone.

  • Line In Recording Level Adjustment

    I am recording from a tape recorder to the hard drive. I have done this a lot over the years. Suddenly I am no longer able to adjust the line in recording level. I have always before gone to Control Panel/Hardware and Sound/Sound (recording tab), Click Line In, then click on Levels. When I adjust the level, either lower or higher, it does nothing to change the sound level. Can aynone please tell me why this feature isn't working any longer on my computer. Could some other setting have gotten changed? Where should I look? Thanks!!!!

    Have you tried to discuss it with mixer manufacturer?
    I mean they know own product very well and have best experiences with it.
    I presume they have tested it on different hardware platforms and different operating systems so I believe they are the right address where you can ask for help.
    In control panel you have standard options for sound but maybe you need something specific for connected mixer.

  • Audio level setting for music tracks in dance recital video project

    I am editing dance recital using the CD music tracks and editing in the audience clapping, some of the music tracks have lower audio level than others.
    I am setting up the audio levels between -3dB (for the lower audio tracks) up to -6dB (for the higher ones) including the audience clapping. I am making the adjustments by listening to the tracks on fixed output volume level.
    My question is if the final output (DVD) will have the the same adjusted audio levels I am hearing, or should I just stick to fixed level (-6dB) for all the tracks? If so is -6dB ideal for DVD output?

    Thanks for your reply Steve,
    I normally watch DVDs on different sound system than the TV, however, from your answer I gather you're setting the master level -18 to -20db. If it is so, are you setting the individual tracks below that, and in my case where the audio levels of the original music fluctuate from high to low, would you set them all on the same level or adjust to hear them out the same?

  • Iphone 6 (Verizon,64GB,space gray)  microphone works for text dictation and Siri but stopped working for calls and voice memos.

    My iphone 6 the micorphone has stoppped working unless I speak loudly right into it and its still not clear during calls and voice memos. But it works just fine for Siri and text dictation. I use the earbuds for work so not sure how long its been going on. Only change is I updated to iOS 8.1.3. Not sure if I should exchange my phone or if its a software glitch since the same mic seems to work for some things and not others. Any ideas would be apreciated.
    iPhone 6
    Space Gray
    64GB
    Verizon

    Try to reset the phone by holding the sleep and home button for about 10sec, until the Apple logo comes back again. You will not lose any data by resetting, but it can cure some glitches.
    If this does not help, setting it up as new device would be the next step:
    How to erase your iOS device and then set it up as a new device or restore it from backups

  • How much recording time on my iphone 4 voice memo?

    How much recording time on iphone4 voice memo?

    I would suggest that it depends on how much free space you have on the phone. I have done voice memos of over an hour before, and have read of other users reporting larger ones. I do not believe there is any documented source of what size you can do.

  • No Compass, Voice control or Video recording on my new iphone 3Gs

    I had a 8GB 3G iPhone that was stolen, so I buy a new one a 3GS 16GB.
    I restore my backup from my stolen iPhone, but now I dont have Compass, Voice Control, Video Recording or any of the apps from the 3GS in my new phone.
    What can I do, where do I download them?
    Thanks

    don't be sorry,. it's a lesson learnt yea ? but im amazed you didnt see the BIG SHINY "S" on the side of the box was missing !! hope u get the 3GS you paid for

  • Is there an app that allows for things like aperture effects on video recording?

    Title says it all, I'm looking for an app where when video recording on my iPhone, it can focus on me, but blur out the background

    I think it would be easier to buy a post-production app like iMovie, and edit that, then.

  • Audio low on playback from video recording on iphone 5S

    I went to a concert last night and recorded a few performances on my phone using the video option on the camera.  When I played back the video, the sound was extremely low.  The volume was at the highest while recording.  Does anyone know how to fix this? Do I need to install another video recording app with better sound.  Help!

    Hello Krae_29
    Check out the article below to troubleshooting issues with the microphone picking up sound.
    iPhone: Microphone issues
    http://support.apple.com/kb/ts5183
    Regards,
    -Norm G.

  • Voice memos are not recorded properly on my Ipod touch. It records voice memos but I cannot hear them.Please Help.

    I record class lectures but for the last couple of days I have been unable to hear the recordings. The sound is practically nonexistent. Perhaps it is a problem with the speakers but  I am unable to determine a problem.

    When you recored the memo did you get a good signal on the VU meter?
    Try using headphone to rule out a speaker problem.

  • Is there a way to switch off by default the video on FaceTime? I only ever use this app for audio/calls and hate the video being on. I especially hate that if I leave the app open to receive calls it means the camera and green light are on.

    My issue is that I can't find a way to have the camera switched off when the app is open and so this means if I want the app open all day to receive calls then the camera is going to be on the whole time. Even if it didn't potentially drain the battery, or add to the CPU usage or whatever else may cause any problems whatsoever (wheel of death!), I just don't want the camera on as I don't see myself ever wanting to use the video call feature but I would use the audio/call multiple times throughout the day to make and receive calls. The camera being on when the app is open is enough to prevent me from using the app. Also ever since seeing that episode of criminal minds where if you saw the green light on above the screen then it meant the killer was watching you!
    Basically I just can't believe there isn't a way to disable the camera whilst having the app running. I know when initiating an audio call the camera goes away, but I would like the camera away the whole time. To me it just would make sense that if you click the video option then the camera is on, and if you click the audio option then the camera goes off. It just seems waaaaay to basic a thought for apple to have missed... Let's face it, we're not all as pretty as the people in the apple adverts and don't want to see our ugly mugs staring back as us when we work all day at our macs!

    I have exactly the same concern. It seems it would be a simple fix for Apple to allow users to turn off the camera (and even the mic) while keeping FaceTime open -- especially now that it turns out FaceTime must remain open in order to send and receive iPhone calls on a Mac.
    I like to think this new functionality of FaceTime will be baked into a future release of Yosemite, as the current setup has that not-quite-finished feel of a work in progress. In the meantime, there's nothing like a little piece of Post-It stuck over the camera to keep the NSA from watching your face as you type a post to the Apple Support Communities.

Maybe you are looking for

  • 2.0.2 Patch Draining My Battery

    I just updated my iPhone 3G last night with the 2.0.2 patch. This afternoon, while on my way to lunch, my phone shows only 10% battery left, after no usage all day. The Wi-Fi is off, Blue Tooth is off, screen brightness is at lowest level. Before thi

  • I deleted a very important paper that i really need to get back is there any way that i can????

    I deleted a very important paper on pages that I really need to get back. Is there a way????? PLEASE HELP ME!!!!!!!

  • Birthdays in Notification Center.

    I have an iPhone 4 and (regretably) upgraded to iOS6.  I synced my contacts with my facebook account including many birthdays that went along with it. However, now birthdays appear in my notification center everyday. I have tried the obvious, I've un

  • BI Source System connection to ECC

    Hi experts, I have a BI 7.0 fresh install and I'm trying to connect ECC 6.0 client dev100 (golden client) to BI so I can activate BI Content. However, the client 100 goes to the BI folder instead of the SAP folder when I create source system in AWB.

  • Image Processor: Include ICC Profile?

    I shot jpg sRGB. Should I include the ICC profile when extracting images? The images will be uploaded to zenfolio.com and made available for print sales. Looking for guidelines and what you folks do. Thank-you.