Reducing plots shown in legend causes error

Question

I am using a waveform chart for a classic scope display, channel 0, channel 1 and math. Sometimes however I would like to set up the scope so the math channel is configured on the waveform, but not displayed, and not displayed in the legend either. It's easy enough to set it up to not be visible on the waveform, but making it not visible on the legend, either by reducing the number of plots shown, or by changing the legend height, so that in effect, the number of plots shown is reduced--either method makes later attempts to modify settings for the math channel cause an error (setting the active Y scale = 2 causes an error, since math is the 3rd scale, or 2nd w/ 0-based indexing).
Is there any way to make it not visible in the legend without causing an error for active scale or other properties I would like to set?

Answer 1

First, I was confused in my statement on Scales versus Plots. You were correct in your reply, and I went back and looked at my code, which was actually using the Active Plot as you said it should have been, not Active Scale. I do use separate scales for each plot, hence my confusion, but that was not directly related to the problem I was having.
Second, your example was most helpful--thanks for posting that.
Third, after seeing that your example worked as desired, I tried to make it line up with my version of reality It didn't, so I started to look into the differences.
- I am using a dynamic signal waveform graph instead of the kind you used.
- I rewrote your example with a cut and paste of the waveform graph I was using. The property nodes had to then be re-selected properly since the names didn't correspond on a 1 to 1 basis changing over to the dynamic signal graph (for instance Plot.PlotName -> Plot.Name)
- After some hair pulling, I tracked down the errors I was having and was able to reproduce them in simplified form using your example.
As it turns out, the root cause of the errors I was having is not having data displayed. I was trying to set up the graph and plots, colors, names, etc... before writing data. As you can see from the modified example, that doesn't work real well, unless you write an almost null array (1 set of zeroes) to the indicator. A lot of the confusion came from getting errors sometimes when trying to set the Active Plot, and not getting them other times--no reproduceability.
In the attached example, you can see that by setting math visible in the plot legend, you can modify the name and color, but then setting it invisible then visible again erases all the settings for that plot, so long as no data is displayed on the graph for it. With no data, and no visibility in the legend, trying to modify the active plot settings results in errors. I'm not sure whether this is a 'bug' or a memory management feature of dynamic waveforms, but it has definitely caused me quite a few headaches in the last few days. I think the short of it will be to initialize with a set of zeroes and that should take care of things. Thanks again for posting your example.
Attachments:
Show-hide plot.vi ‏158 KB