Refurbishment processing - problem while installing the equipment.

Question

Dear Experts,
I am testing the refurbishment cycle, while doing this I am facing a problem.
Process is as below:
The equipment is damaged and needed replacement.
I have created the material master and serial number.
I have changed the valuation type of the damaged equipment to C3 using tcode IQ02 and dismantled the equipment using IE4N.
After saving the above transaction I got notification, material document number for GR of the damaged equipment into warehouse under the valuation type C3.
Now I am trying to install the equipment in replacement of the damaged equipment.
I have created the reservation with movement type 201 and with reference to the reservation installing the equipment using IE4N with GI.
I have entered the following data in IE4N installation:
Material number,serial number which is under valuation type C1.
Reservation number and line item number
Top Functional location.
While saving this transaction I am getting the following messages in application log:
1. This is warning message
Configuration- and validation check not possible
Message no. CCMM049
Diagnosis
For a local configuration check the configuration and effectivity data of the top reference equipment (counterpart of  access node in the allowed configuration) is considered. However, the system cannot find a reference equipment for the assembly to be installed.
System Response
Configuration and effectivty data cannot be taken into account.
2. This is Error message:
No function identifier maintained. Configuration check not possible
Message no. CCMM043
I am not able to proceed further.
I could not find an appropriate note also in OSS.
If I am performing both the transactions separately i.e., Goods Issue against the reservation and changing the Functional Location in the Equipment master of the serial number, then it is happening correctly.
But I want this to happen like Dismantle because both the transactions can be posted at the same time.
Please help me out in solving this error.
Thanks and Regards,
Praveen.

Answer 1

Hi thyagi,
thanks for your reply.
I have done the chages in OMPL1 earlier, and run the transaction successfully.
For analysing this problem I went to  transaction CCM2, there in the Equipment GAP there is filed FID. This field is empty.
Here if I am maintaing anything like the equipment number or functional location. The if I run the transaction IE4N there a new error message is coming as below:
1. This is Error message
FID  deviates from FID FCLT-UTY of previously installed object
Message no. CCMM038
2. This is Warning message:
Function identifier FCLT-UTY of Structure Gap  will be used for configuration check
Message no. CCMM037
3. This is Warning message:
Configuration- and validation check not possible
But I want to understand this. Why it is behaving like this and more over I dont have iPPE inteface also.
If I change the message type will there be any problem?
Please clarify.
Regards,
Praveen.