Remove hard drive in Quicksilver 2002?

Hi,
I am trying to add a second internal hard drive to a dual Quicksilver 2002 ... I cannot figure out how to unclip the dual bay to add new drive. So far I have taken out the mounting screw, but it is still not budging. I have also pushed down on the left-sided plastic hinge with no luck. Does anyone know how to remove it?
Thank you for any advice. (The online manual does not match this model. The drives stack together vertically.)
Cheers!
Dawn

The drive bay is held by a couple of prongs in back which go in slots and a single flat-head screw in front. If you've removed the screw, which may be hidden under the wide grey cable, lift the front of the drive assembly and pull it toward you. If there's an empty drive mounting plate next to the U-shaped bracket, it is held in exactly the same way, and you can see how it works. Sometimes the bracket gets stuck after years in place and need some gentle persuasion.

Similar Messages

Hard Drive For Quicksilver 2002

I've been reading through the docs and think I've got a handle on expanding my Quicksilver 2002 - but just wanted to double-check before I started buying things willy-nilly.
It's my understanding that Quicksilvers have no drive capacity limit and that I can install a Serial ATA-300 500 GB hard drive with no problem, as long as I have a PCI card like this one. Can I still keep my old drive as an extra that the SATA card will see?
I'm currently running two external drives and would like to consolidate inside the machine. Thanks for any help.

Hi
Yes, the PCI card will allow you to install SATA drives greater than 120GB. Note this is true regardless of whether your Quicksilver has a drive capacity limit or not, as the limit exists within the ATA controller on the logic board, which won't be used by any SATA drives connected to the SATA controller on the PCI card.
Yes, you can keep your old ATA drive, but it will remain connected to the ATA controller on the logic board, not the SATA controller on the PCI card. Basically any existing ATA drives must be connected to the onboard ATA controller, whilst any new SATA drives must be connected to the SATA controller on the PCI card.
The two external drives are probably ATA rather than SATA and have been mounted in external firewire enclosures. Note you'll only be able to have two ATA drives and two SATA drives inside the computer, not three ATA drives. This may be a problem if you already have one internal ATA drive and two external ATA drives (in firewire enclosures) . You'd have to buy an ATA PCI card rather than a SATA PCI card, or keep one of the ATA drives external.

Multiple itunes libraries on same computer and removable hard drives

I have multiple itunes libraries, one resides on my internal hard drive on my computer and the other on a removable hard drive that I pug into the ocmputer via a USB cable, can itunes recognize both libraries at once, and how do I get it to do that?

That *****, apple should add a feature that allows multiple libraries.....hopefully they will in thenext release of iTunes.

IPod Touch Doesn't Show Up In My Computer Removable Hard Drive

So, unlike my 1st Gen Nano, my IPT doesn't show up as a removable hard drive. How do I fix that?

Sure you can, a portable device for music, videos, podcasts, etc.
Sorry, no you cannot use it like some of the previous iPods have been able to be recognized as mass storage devices.

Moving Photos on removable hard drive

If I have my photos on a removable hard drive and must re-install PE-8. Will my catalog including tags still be intact?

Glad you had success. You can check to see how many preview files have been built by checking the Lightroom 5 Catalog Previews.lrdata folder with File Explorer:
/Users/[user name]/Pictures/Lightroom/Lightroom 5 Catalog Previews.lrdata
Right-click on the folder and select 'Properties.' Next to 'Contains' will be the file count representing the number of built previews. It should be the same as the number of pictures (100,000) or slightly more.
Creating previews for 100,000 image files will take a long time! My Windows 7 i7-860 processor system with 21 mp Canon 5D MKII raw files takes about 3 seconds to build one standard preview. Using this number for 100,000 previews:
100,000 x 3 seconds = 300,000 sec. = 5,000 min. = 83 hours = 3.5 days!

Moving my itunes library to a removable hard drive.

I have moved my itunes library to a removable hard drive. Every time I try to trash my old itunes file and access the removable HD, I cant find it from iTunes. the only thing I can get it to do is to reload (duplicate) the entire 30gb library on the HD I want it off of. Now I have 2 duplicate versions of my library, but still can't get it to keep the files on the HD. Can someone help?
Mark

Hey Mark -
I think it's helpful to understand how this whole process works, and along the way, maybe we'll find where things went wrong for your situation.
iTunes can take as much or as little control of your library as you like, and different settings may be turned on or off for you as it's not always standardized.
If you'd like your entire iTunes Library to be transferred to one centralized, organized location (wherever - a local directory or an external drive, whatever you like), here's what you need to do (and if it's not too late, here's what you need to go "back" and do to make this transition smoother).
- Open iTunes with the default library (where you had it).
- Select iTunes, Preferences, Advanced, and ensure that "Keep iTunes Media folder organized" and "Copy files to iTunes Media folder when adding to library" are both checked. This ensures that your music files are actually going TO the iTunes folder (and not, for example, just being referenced in a downloads folder which you'll probably move or delete later, breaking all those links) and that iTunes will sort your media by Artist\Album\Track Number Song.xxx instead of just moving the file as-is to a different spot.
- Select File, Library, Organize Library and check "Consolidate files" and "Reorganize files in the folder 'iTunes Media'". These two marks take anything up-to-this-point and consolidates them into the one location, then uses its sorting structure to file it all away.
Then, Mark, I think it's appropriate to exit iTunes, take that entire library folder (YourUsername\Music\iTunes\) and put it wherever you'd like it to go. To tell iTunes where your new library is, hold the Option key and click on the iTunes application, then "Choose Library" and reference your new location.
I think it's important to follow the preliminary steps first. I've run into instances with customers where they've moved their Library file, referenced it by Choosing the new Library, and then thought everything was fine, only to find two weeks later when they try to play an audio file that the file isn't found - and this happens because the user moved the library FILE but didn't have a consolidated library TO move - the files were spread out all over the computer.
I hope that's helpful to you. I know it may be too late to "undo" yourself back to the beginning and do those organizational steps, but it's at least useful to know the process and how it might help you in the future.
Best of luck.

Itunes purchased to removable hard drive

As I have a laptop, the laptop has become slow due to my purchased being stored on it. I have a removable hard drive, so is there a way I can move my purchased to the removable hard drive and also to set-up itunes to automatically save future purchased to the removable hard drive.

redandblack wrote:
the laptop has become slow due to my purchased being stored on it.
How do you know that is the reason it has become slow? Unless your hard drive is getting very close to full, having songs on it is usually not a problem.
I have a removable hard drive, so is there a way I can... set-up itunes to automatically save future purchased to the removable hard drive.
Well if you really want to, repoint your iTunes Music folder to the removeable drive by going to Edit > Preferences > Advanced.
Once you do this, never start up iTunes without having the drive in place, or it will default back to the local drive and leave you with a chore.

Is it possible to install windows 7 on my macbook from a removable hard drive using boot camp? How would I do this?

Is it possible to install windows 7 on my macbook from a removable hard drive using boot camp?
How would I do this?

If you have Lion installed, and run Boot Camp, it will create the boot flash for you, just followe the tutorial on screen. As far as I remember, this was not possible prior to Lion.

How to copy files from a removed hard drive

Hi removed my hard drive from my Dv9408nr laptop because the screen won't power on, and but my question is there a way to copy the files from my removed hard drive to another laptop. Is there a cord the fits into the hard drive connector slot to a usb or some other cord that goes to a laptop so I can copy my files to another laptop, so I can recover my files?

Hi,
Something like this should work and you can have an external HDD at the end
http://www.google.com.au/products/catalog?q=hdd+enclosure+2.5+usb+2.0&hl=en&biw=1680&bih=849&prmd=im...#
Regards.
BH
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

"Original file not found" error after copying from removable hard drive

ok, I have all my itunes library on a removable hard drive, and I want to copy it all to my new computer. so, I plugged the hard drive in, copied all the files into itunes, and when I played one of them, it worked. then, I tried to play it again, but an error message came up saying "The song 'Re-hash'could not be used because the original file could not be found. Would you like tyo locate it?" and I clicked 'Yes'. then a browser came up, where i could select either the files itunes music, itunes library, or itunes music library. none of them work. help please?

This worked although it was very clumsy (we had almost 3,000 files that had to be deleted and redownloaded. I could not figure out a way to sort all of the 'exclamation points' together so it took an hour or so to scan through the entire library list and delete each file individually and/or in small groups.) The download was very straight forward. In my experience (with iTunes match turned on,) we did NOT loose our playcounts.
Going through all those files I noticed several common themes that may have triggered the problem: 1) multiple artists, 2) special characters in the song title, artist and/or album name - particularly umlauts (we have quite a few german songs in our library.) 3) very long title, artist and/or album names.
I hope that someone from Apple is aware of these issues and working on them....

Transfer application from removed hard drive

After replacing a failing hard drive; I need to transfer applications from removed hard drive to newly installed hard drive. What is needed to do so and what is the best method of tranferring applications? Thank you.

So the drive that was failing s still working enough to mount, that's good. Purchase an external enclosure or a dock to mount the OS drive on the desktop. In your Utilities folder open Migration Assistant and select to migrate your applications "from another disk". Follow the prompts and let it do it's thing. MS Office applications haven't worked for me after migrating but a simple reinstall of Office took care of that. While you're at it you can also migrate any documents, photos or music from the old drive before it completely dies.

Hello, is there any removable hard drives for the iPad?

Does anyone know if there is a removable hard drive that can be used with an iPad, ie backing up working emails from my laptop but being able to access them on the iPad from the hard drive?

Thanks, the problem I have is, I access a lot of archived emails on my laptop but as we all know this is quite a long winded thing to do when you have to switch a laptop on and off thought out the day.
Thanks for your help.

How can I save my photos on a removable hard drive for easy viewing?

I just got a brand new Macbook Pro and I wanted to transfer some of the photos from my old computer over to my new computer (from a My Passport removable hard drive), but I found that this wasn't possible with how I had saved then with iPhoto. I now have all of my photos on my new computer, but don't want to waste all that space. How can I save the photos I don't want on this computer to my removable hard drive for easy viewing? When I look at the removable hard drive now, it's saved altogether as iPhoto Library, so I can't just see certain ones...

While in iphoto,hold down the command key and select all the pics you want to move. Once all the pics are selected, release the command key and select export from the file menu. Iphoto will present a dialog box where you can select the quality of the pics before exporting. Then export them to whereever you would like. If you want to put them on an external HD then select that.When you wish to view them,you can use preview or right click on any pic and choose which program to open them with.After doing this if you no longer want them in iphoto then delete them and make sure to empty the trash in iphoto after doing so.

[solved] Thunar: no automount for removable hard drives

USB flash drives are automatically mounted by thunar-volman. However, removable USB hard drives are not.
These are the settings of thunar-volman: http://i.imgur.com/24mHHSs.png
In order to mount removable USB hard drives, I have to manually click on the drive in the side pane.
Can someone reproduce that behaviour that automount only works with flash drives but not with removable hard drives?
Installed packages:
~ $ pacman -Q | grep thunar
thunar 1.6.3-1
thunar-volman 0.8.0-1
Last edited by orschiro (2014-01-09 15:10:06)

The removable hard drive is a 1TB external USB drive with an ext4 filesystem. It has nothing to do with permission issues but seem to be a general problem of thunar-volman refusing to mount larger drives. It is also stated here.
I could enable automounting of this drive by running devmon from the udevil package.

Can't share files on a removable hard drive when using Airport Extreme

I connected a removable hard drive to the USB port on the Airport Extreme. I can see the hard drive under Disks in Airport Utility, but cannot view or share the files.
Note: I can share the files when I am connected directly to my MacBook Pro USB port.
Please help.

I have enabled file sharing.
I tried going to afp://10.0.1.1 but get a connection error. I may be doing it wrong. How do I get the proper IP to use?
Thanks

Remove hard drive in Quicksilver 2002?

Similar Messages

Maybe you are looking for