Restore iphone 4S error 1
I have a problem: when jai restore my iphone 4S it crashes at the end and I see an error 1
here is my log file:
update_baseband: querying baseband info
bbupdater: BEGIN: Querying info at stage first
bbupdater: BEGIN: Preparing
bbupdater: Requested boot mode: kBBUBootModeNone
bbupdater: Creating transport, attempts remaining 5...bbupdater: FAILED(kBBUReturnIOError)
bbupdater: Creating transport, attempts remaining 4...bbupdater: FAILED(kBBUReturnIOError)
bbupdater: Creating transport, attempts remaining 3...bbupdater: FAILED(kBBUReturnIOError)
bbupdater: Creating transport, attempts remaining 2...bbupdater: FAILED(kBBUReturnIOError)
bbupdater: Creating transport, attempts remaining 1...bbupdater: FAILED(kBBUReturnIOError)
bbupdater: Creating transport, attempts remaining 0...bbupdater: FAILED(kBBUReturnIOError)
bbupdater: END(kBBUReturnIOError): Preparing
bbupdater: END(kBBUReturnIOError): Querying info at stage first
send_bbupdate_status: sending baseband update status to host
update_baseband: bbupdater error: kBBUReturnIOError
0: RamrodErrorDomain/3ec: update_baseband: failed querying baseband info
1: BBUpdater/10
unable to convert ramrod error 1004
attempting to dump restore log
writing log file: /mnt1/restore.log
This is a Hardware error. Make an appointment at the Genuis Bar to resolve the problem. You can also try restoring without any sim card inside your phone. If it still gives this error, go ahead to the Genuis Bar.
Similar Messages
-
Can't restore iphone, getting error message that my computer doesn't have enough free space (300GB Free)
Good day tyler9ca,
If you are having an issue with being unable to complete a restore of your iPhone, I would suggest that you troubleshoot using the steps in this article -
Resolve iOS update and restore errors in iTunes - Apple Support
Thanks for using Apple Support Communities.
Safe computing,
Brett L -
Can not restore iphone 4 error 3194; 4005
can not restore iphone 4 error 3194; 4005 , please HELP !!!
Error 3194, read here:
http://support.apple.com/kb/ts3694#3000
4005:
http://support.apple.com/kb/ts3694#4000 -
HT4061 cannot restore iphone 4s error 29 keeps coming up
cannot restore iphone 4s error 29 keeps coming up about 2/3rds way through process
See: http://support.apple.com/kb/TS3694#hardware
-
HT201210 how to fix restore iphone 5 error (1)
when i restore iphone 5 with ios 7.0.4 error (1) how to fix ???
Check for hardware issues
Try to restore your iOS device two more times while connected with a cable, computer, and network you know are good. Also, confirm your security software and settings are allowing communication between your device and update servers. If you still see the alert when you update or restore, contact Apple support.
Common errors: 1, 10-47, 1002, 1011, 1012, 1014, 1000-1020. -
I have an Iphone 3. Yesterday it was working fine then Itunes said it had an update. The update was unsucsessful and it said the phone needed to be restored. I went through the restore steps and recieved an error. Any suggestions?
From this support document http://support.apple.com/kb/TS3694
Errors 3000-3999 (3004, 3013, 3014, 3018, 3164, 3194, and so on): Error codes in the 3000 range generally mean that iTunes cannot contact the update server (gs.apple.com) on ports 80 or 443.
Update to the latest version of iTunes.
Verify the computer's date and time are accurate.
Check that your security or firewall software is not interfering with ports 80 or 443, or with the server gs.apple.com.
Follow Troubleshooting security software. Often, uninstalling third-party security software will resolve these errors.
An entry in your hosts file may be redirecting requests to gs.apple.com (see "Unable to contact the iOS software update server gs.apple.com" above).
Internet proxy settings can cause this issue. If you are using a proxy, try without using one.
Test restoring while connected to a known-good network.
Error 3002: If you experience this error while updating an iPod touch (2nd generation) or iPhone 3G, please use the standard update or restore process in iTunes (click Update or Restore).
Error 3014 may indicate that you need to free up more disk space on the computer before trying to restore again.
Error 3194: You may not have the latest version of iTunes installed Update to the latest version of iTunes. If the issue persists, follow the steps above in "Unable to contact the iOS software update server gs.apple.com".
Error 3004: If you are using a Mac, you may be able to resolve an error 3004 by quitting iTunes and using the following command at the command line: dscacheutil -flushcache -
Hi, if someone could help me that would be great. My phone started playing up yesterday and it said it needed restoring so i did. Went funny today again and i tried to restore it but error message 1 came up and now when i am trying error message 23 comes up.
My phone is just completely dead and i cant access it at all i have tried following all the steps on the apple webpage making sure everything is up to date but it still wont work.... If i dont find a solution very soon i am gonna have to go and buy a new phone. Would be greatful if someone could help=)
I havent jailbroken my phone or anything, i have always done the updates and done everything right...You are going to have to provide a little more information in order for anyone to help you. What do you mean "get it back to it's original setting"?
What original setting are you referring to?
GB -
HT201210 how to restore iphone when error has occurred
help!! i am to restore my iphone to syncing to itunes but an error has occurred it is in recovery at the mo but i am stuck i need itunes on it!! help please lol xxx
What was the error
-
HT1222 restoring iphone 3GS - error message 'unknown error -1' occurred.
when restoring my iphone 3gs itunes attempts to restore then come back with error message 'unknown error -1' occurred. what to do now?
Hey Lawrence,
A big THANK YOU!! to you! Your suggestions worked!
Before I changed USB ports (more on that in a sec...), I employed one of your suggestions that you gave to someone else with the same problem...and that was to clean the connector on the bottom of the phone with a soft dry tooth brush. I couldn't believe the amount of lint that came out! Especially what was found in either end...had to do some very careful picking. (Almost enough lint to knit a small sweater!!)
Changing the USB port was the second and final step required for a successful backup. My computer is a laptop, and I did have a USB Bluetooth adapter (for another device) installed. I removed the adapter, plugged the iPhone into that USB port, crossed my fingers...and it worked!!!
Now if I can figure out the rest of this darn program, I might upgrade to a new iPhone!
Again, thank you very much Lawrence!
Rich -
Unable to restore iphone 4s.Error message 2001.
hi
i updated my iphone 4s to ios8. Phone went off due to no battery, when i switch on, its rebooting over and over.Now i tried restoring the phone but the error message 2001 saying i am unable to restore.
Need some advice
Thank youiphone1 wrote:
I had the same problem. To fix it, I first tried a different computer and different USB cable. When the error still appeared on the different computer and different USB cable, I unplugged the USB cable from the iPhone, opened up the iPhone and disconnect the battery from the iPhone main logic board (three screws). I left it unplugged for a few hours. Plugged back in the battery connector and then restored in iTunes. Hope this works for you.
Um, no. Opening up the iPhone voids all support from Apple. Do not make recommendations on this forum that will violate Apple's policies or procedures. -
Tried to restore iPhone 3G - error 1015
I bought a second hand iPhone 3G. It worked fine but had all kind of personal info on it. Wanted to restore to original settings via iTunes, but now I keep getting an error message: 1015 and the phone is not functional any more. It merely shows the charger cable and indicates that I need to reconnect with iTunes. I tried several times, alway get the message: an unnknown error ocurred: 1015
Check this support document http://support.apple.com/kb/TS3694, however the 1015 error generally relates to jailbroken phones or ones where someone is trying to downgrade or install software that is not the latest version.
-
Can't Restore Iphone 5 (Error 2005)
I tried to restore my iphone back to factory settings so i could give it to my mom. But midway through the process, it gave me an error 2005 (saying something is wrong with the USB, which is perfectly fine). Now it's stuck in recovery mode. I've tried it from recovery and dfu mode. I've been through a bunch of pages that are supposed to help, but nothing has helped. Are there any apps besides iTunes that I could use to manually install ios 6.1.4? Thank you
guero311 wrote:
Are there any apps besides iTunes that I could use to manually install ios 6.1.4? Thank you
No -
Can't restore iPhone 4 (Error 4014)
Hello,
My iPhone 4 don't turn on and is only recognize by iTunes as begin in recovery mode.
When trying to restore with iTunes, i always have an "Error 4014"...
I have not found any informations about this error, i tried the "POWER + HOME" combinaison but nothing...
Hopefuly anybody here can help. You are my last hope regarding this issue, although I´m not a complete newby to iPhone problems.
Thanks and kind regardsNo, it's error 4014.
I'm surprised that there is nothing about this on Google. I've only found one reference of "error 4014" in other thread (https://discussions.apple.com/thread/5123621?start=0&tstart=0) but no solutions... -
Firmware upgrade 2.2.1 failed - can't restore iPhone 3G - Error 13 or 1016
I tried to upgrade my iPhone 3G 16GB to Firmware 2.2.1
As a result I cannot access my iPhone again, "restore" via iTunes aborts with Error code 13, sometimes with 1016.
Ok, my XP laptop has only USB 1.1, therefore I installed and activated iTunes 8 on another laptop having WinXP and USB2.0 interfaces. Same result, resore function results in Error code 13 and sometimes in error code 1016.
any help would be highly appreciated!
BTW:
- I tried the deactivation/activation of the computer -> doesn't help
- Reset of the iPhone with wake/sleep button + home button -> doesn't helpHello Condor2000x,
Welcome to the Discussions Boards.
If you've tried the steps in TS1275, including a different computer, you may need to have the iPhone serviced.
You can find the service options for your region here:
http://www.apple.com/de/support/serviceassistant/overview.html
Hope that helps,
Charles H. -
Restoring iPhone with Error: 16
My iPhone 4, randomly shown me a message last night to restore my iPhone via iTunes as it cannot receive calls or messages. So i backed it up etc, and tried to restore the phone. Unfortunately, i then came across a problem (Error:16) and it is now in recovery mode and will not restore.
It connects fine to my iTunes but on the last moment of the restore the error message shows up, I am using a Mac and my software is all up to date (as i made sure i checked before even starting the restore) and I have followed all different ways, i'm still sat with the iPhone 4 in recovery mode.
Has anyone come across this problem and can you help me?Check for hardware issues
Related errors: 1, 3, 10, 11, 12, 13, 14, 16, 20, 21, 23, 26, 27, 28, 29, 34, 35, 36, 37, 40, 1000, 1002, 1004, 1011, 1012, 1014, 1667, or 1669.
These errors mean that your device or computer may have a hardware issue that's preventing the update or restore from completing.
Check that your security software and settings aren't preventing your device from communicating with the Apple update server.
Then try to restore your iOS device two more times while connected with a cable, computer, and network you know are good.
Confirm that your security software and settings are allowing communication between your device and update servers.
If you still see the error message when you update or restore, contact Apple support.
Maybe you are looking for
-
I have an iMac less than 1 year old with lion o/s and numbers. i have been spoiled in the printing of spread sheets on PC's. I find it impossible to print only 1 page when printing a single page spread sheet. The result is my spread sheet spread over
-
Hi , I'm newbies to weblogic. Currently I need to use JMS to asychronous messaging. version I used is weblogic 705. The environment is clustering. There is one Admin server, and 2 managed servers by multicastin
-
No LTE toggle in my iPhone 5 but works perfectly on my iPad(4thgen). Any help please?
-
My Macbook Pro has lost the keyboard lighting - only 18 months old
Macbook Pro has lost keyboard lighing - only 18 months old. I am an O.A.P. Is there an enexpensive way of fixing this?
-
Jtds and SQL server 2000(Personal Edition) problem
My application need to work in standalone mode without being connected to the network. I've installed SQL Server 2000(Personal Edition) on Windows XP platform. I've Tomat 4.1 installed on the same machine. My applciation based on jsps and servlets ru