Rogue detection with Prime 2.1

Question

Hi@all,
i know many questions in the last days, but i must say, the last WCS works better as the compination Prime 2.1 and 5760 ;).
My problem, we have a huge campus and at peaks ~ 1500 rogue-aps. 
In my new configuration (2x 5760 and Prime 2.1), the wlc see the rogue-aps but in the security dashboard at the prime no rogue are listet.
The 5760 are in the same mobility/rf-group, the polling interval at the Prime are 15 minutes.
Maybe some one has a similar problem and could help.
regards
  René

Answer 1

Hi
Do you see the rogue AP on 5760 itself ? "show wireless wps rogue ap summary" output shows you the identified rogue APs. If you can't see anything there, then you may not enable Rogue AP detection on your controller. See whether in your 5760 configuration, the first line below is configured (which will enable rogue detection). Second line is to increase the threshold to minimize false detection. Refer 5760 RRM config guide for more details.
wireless wps ap-authentication
wireless wps ap-authentication threshold 50
This document describe some of the best practices of 5760 configuration including rogue detection as well.
Cisco 5760 IOS Wireless LAN Controller Configuration Best Practices
HTH
Rasika
**** Pls rate all useful responses ****